
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that maycause undesired operation. Any changes or modifications (including the antennas) made to this device that are not expressly approved by the manufacturer may void the user's authority to operate the equipment. FCC RF Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --- Reorient or relocate the receiving antenna. --- Increase the separation between the equipment and receiver. --- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ---Consult the dealer or an experienced radio/TV technician for help.
Compliance Certification Services Inc. Report No: 41102005 Date of Issue: February 25, 2005 Page 1 Total Page: 3 Rev. 00 EXTERNAL PHOTOGRAPHS OF EUT
Compliance Certification Services Inc. Report No: 41102005 Date of Issue: February 25, 2005 Page 2 Rev. 00 INTERNAL PHOTOGRAPHS OF EUT Compliance Certification Services Inc. Report No: 41102005 Date of Issue: February 25, 2005 Page 3 Rev. 00
Compliance Certification Services Inc. Report No.: 41102005-RP1 FCC ID: PQY-4710874201309 Date of Issue: February 25, 2005 Note: This report shall not be reproduced except in full, without the written approval of Compliance Certification Services Inc. This document may be altered or revised by Compliance Certification Services Inc. personnel only, and shall be noted in the revision section of the document. Page 1 Total Page: 25 Rev. 00 FCC 47 CFR PART 15 Subpart C TEST REPORT For Mini Mouse Presenter set Model: OPMP-2461 Trade Name: CELLINK Issued to CELLINK CO, LTD 4F, No.100, Sec.1, Hsin Tai Wu Rd., Hsi-Chin, Ta i p e i , Ta i w a n , R . O . C . Issued by Compliance Certification Services Inc. No. 81-1, Lane 210, Bade Rd. 2, Luchu Hsiang, Taoyuan Hsien, (338) Taiwan, R.O.C. TEL: 886-3-324-0332 FAX: 886-3-324-5235 Compliance Certification Services Inc. Report No.: 41102005-RP1 FCC ID: PQY-4710874201309 Date of Issue: February 25, 2005 Page 2 Rev. 00 TABLE OF CONTENTS 1. TEST RESULT CERTIFICATION............................................................................................... 3 2. EUT DESCRIPTION ...................................................................................................................... 4 3. TEST METHODOLOGY ............................................................................................................... 5 3.1 EUT CONFIGURATION..................................................................................................................... 5 3.2 EUT EXERCISE................................................................................................................................. 5 3.3 GENERAL TEST PROCEDURES.......................................................................................................... 5 3.4 FCC PART 15.205 RESTRICTED BANDS OF OPERATIONS..................................................... 6 3.5 DESCRIPTION OF TEST MODES........................................................................................................ 6 4. INSTRUMENT CALIBRATION................................................................................................... 7 5. FACILITIES AND ACCREDITATIONS ..................................................................................... 8 5.1 FACILITIES ...................................................................................................................................... 8 5.2 EQUIPMENT..................................................................................................................................... 8 5.3 LABORATORY ACCREDITATIONS AND LISTING............................................................................... 8 5.4 TABLE OF ACCREDITATIONS AND LISTINGS.................................................................................... 9 6. SETUP OF EQUIPMENT UNDER TEST .................................................................................... 10 6.1 SETUP CONFIGURATION OF EUT...................................................................................................... 10 6.2 SUPPORT EQUIPMENT .............................................................................................................. 10 7. FCC PART 15.249 REQUIREMENTS.......................................................................................... 11 7.1 BAND EDGES MEASUREMENT ............................................................................................... 11 7.2 SPURIOUS EMISSION ................................................................................................................ 17 7.3 POWERLINE CONDUCTED EMISSIONS................................................................................. 24 APPENDIX 1 PHOTOGRPHS OF TEST SETUP .............................................................................. 25 Compliance Certification Services Inc. Report No.: 41102005-RP1 FCC ID: PQY-4710874201309 Date of Issue: February 25, 2005 Page 4 Rev. 00 2. EUT DESCRIPTION Product Mini Mouse Presenter set Trade Name CELLINK Model Number OPMP-2461 Model Discrepancy N/A Power Supply Power by 2 x AAA Rechargeable Batteries (2.4V) Frequency Range 2402 ~ 2480 MHz Modulation Technique GFSK Antenna Gain -8 dBi Antenna Designation Printed PCB Antenna Remark: This submittal(s) (test report) is intended for FCC ID: PQY-4710874201309 filing to comply with Section 15.207, 15.209, 15.249 (FCC Part 15, Subpart C Rules.) Compliance Certification Services Inc. Report No.: 41102005-RP1 FCC ID: PQY-4710874201309 Date of Issue: February 25, 2005 Page 5 Rev. 00 3. TEST METHODOLOGY The tests documented in this report were performed in accordance with ANSI C63.4 and FCC CFR 47 2.1046, 2.1047, 2.1049, 2.1051, 2.1053, 2.1055, 2.1057, 15.207, 15.209 and 15.249. 3.1 EUT CONFIGURATION The EUT configuration for testing is installed on RF field strength measurement to meet the Commissions requirement and operating in a manner that intends to maximize its emission characteristics in a continuous normal application. 3.2 EUT EXERCISE The EUT was operated in the engineering mode to fix the TX frequency that was for the purpose of the measurements. According to its specifications, the EUT must comply with the requirements of the Section 15.107 and 15.109 under the FCC Rules Part 15 Subpart B and Section 15.207, 15.209,15.249 under the FCC Rules Part 15 Subpart C. 3.3 GENERAL TEST PROCEDURES Conducted Emissions The EUT is placed on the turntable, which is 0.8 m above ground plane. According to the requirements in Section 13.1.4.1 of ANSI C63.4 Conducted emissions from the EUT measured in the frequency range between 0.15 MHz and 30MHz using CISPR Quasi-peak and average detector modes. Radiated Emissions The EUT is placed on a turn table, which is 0.8 m above ground plane. The turntable shall rotate 360 degrees to determine the position of maximum emission level. EUT is set 3m away from the receiving antenna, which varied from 1m to 4m to find ou…
Text truncated - open the document above for the full version.
Compliance Certification Services Inc. Report No.: 41102005-RP1 FCC ID: PQY-4710874201309 Date of Issue: February 25, 2005 Page 25 Rev. 00 APPENDIX 1 PHOTOGRPHS OF TEST SETUP Radiated Emission Set up Photos
| # | Rule Parts | Frequency Range | Power Output |
|---|---|---|---|
| 1 | 15C | 2.40 GHz - 2.48 GHz | - |

IPod Shuffle FM Transmitter
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter
Bluetooth Stereo Box
Equipment Class
DSS - Part 15 Spread Spectrum Transmitter
Bluetooth USB Adapter
Equipment Class
DSS - Part 15 Spread Spectrum Transmitter
Bluetooth USB Adapter
Equipment Class
DSS - Part 15 Spread Spectrum Transmitter
MINI BLUETOOTH HEADSET
Equipment Class
DSS - Part 15 Spread Spectrum Transmitter