PX91200Access Point

ACCESS POINT i User Guide Access Point ACCESS POINT ii Table of Contents 1. INTRODUCTION ................................................................................ 1 1.1 P RODUCT FEATURES.............................................................................................1 1.2 N ETWORK OVERVIEW...........................................................................................2 1.2.1 Infrastructure Mode ......................................................................................2 1.2.2 Microcells and Roaming ...............................................................................3 1.3 N ETWORK SERVICE SET IDENTIFICATION (SSID) OVERVIEW................................4 1.4 C HANNEL SERVICES OVERVIEW............................................................................5 1.5 R EQUIREMENT FOR A WIRELESS CONNECTION.......................................................5 2. INSTALLATION AP ............................................................................ 6 2.1 P ACKAGE CONTENTS.............................................................................................6 2.2 N OTICE.................................................................................................................6 2.3 I NSTALLATION DIAGRAM......................................................................................6 2.4 P HYSICAL DESCRIPTION........................................................................................7 2.5 C ONNECTING TO THE NETWORK...........................................................................7 2.6 AP C ONFIGURATION (INSTALL THE SNMP MANAGER) ........................................7 2.7 D EFAULT SETTING.................................................................................................8 3. SPECIFICATION ................................................................................. 9 3.1 H ARDWARE SPECIFICATION...................................................................................9 3.2 IEEE 802.11 F UNCTIONALITY SUPPORT.............................................................10 4. CONFIGURATION AP ...................................................................... 11 4.1 S ETTING UP ACCESS POINTS IP ADDRESS........................................................... 11 5. INSTALLING SNMP MANAGER .................................................... 13 5.0.1 U SING SNMP APPLICATION............................................................................14 5.1 F ILE MENU..........................................................................................................15 5.1.1 Connection to Access Point ........................................................................16 5.1.2 Find Access Point .......................................................................................17 5.2 S ETUP MENU.......................................................................................................19 5.2.1 Bridge..........................................................................................................20 5.2.2 IP Configuration .........................................................................................21 ACCESS POINT iii 5.2.3 Wireless LAN...............................................................................................22 5.2.4 Privacy Options ..........................................................................................23 5.2.5 Operational Settings ...................................................................................24 5.2.6 Advance Operational Setting ......................................................................26 5.2.7 Authorized MAC addresses .........................................................................29 5.2.8 SNMP Traps ................................................................................................30 5.2.9 Authorization ..............................................................................................31 5.3 C OMMANDS MENU.............................................................................................32 5.4 I NFORMATION MENU...........................................................................................33 5.4.1 Wireless Statistics........................................................................................34 5.4.2Ethernet Statistics ........................................................................................35 5.5 T RAP MENU........................................................................................................36 5.6 N ETWORK MENU................................................................................................38 5.7 W INDOW MENU..................................................................................................40 5.8 H ELP MENU........................................................................................................41 6. TUTORIAL ........................................................................................ 42 6.1 P ACKET FRAGMENTATION...................................................................................42 6.2 E NCRYPTION.......................................................................................................43 Authentication Type .............................................................................................44 How is encryption key generated? .......................................................................44 6.3 S UBNETTING.......................................................................................................45 7. TROUBLESHOOTING...................................................................... 46 7.1 C HECKING VALID IP ADDRESSES........................................................................49 7.2 C ONNECTION TROUBLESHOOTING......................................................................50 7.3 R ESETTING THE ACCESS POINT..............................…

Text truncated - open the document above for the full version.

AT76C510 "Bridge-on- a-Chip" Solution Ethernet PHY device Ethernet MAC Processor Ethernet DSSS Radio BasebandProcessor Contol Frequency Synthesizer QModem RF/IF Conve rter Tx/Rx Switch ARM CPU 802.11 MAC Processor Shared MEM Shared MEM WINMATE’s WLAN ACCESS POINT SOLUTION

Report No.: 023L104FI Page : 1 of 8 Version:1.0 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (2) EUT Photo

WinMate Communicaiton INC. 9F, No. 175, Ta-Tung Road, Sec. 1 Hsi-Chih, Taipei Hsien, Taiwan, R.O.C. TEL: 886-2-2648-5758, FAX: 886-2-2648-5161 http://www.winmate.com/ FCC ID.: PX91200 LabelLoc The FCC ID and DoC Label will be placed on the equipment as shown in the photograph below. Access Point Model No.: WN1200 F F C C C C I I D D : : P P X X 9 9 1 1 2 2 0 0 0 0 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. S/N: Made in Taiwan Access Point WINMATE Model No.: WN1200 TESTED TO COMPLY WITH FCC STANDARDS FOR HOME OR OFFICE USE S/N: Made in Taiwan

Report No.: 023L104FI Page : 2 of 8 Version:1.0 (3) EUT Photo (4) EUT Photo Report No.: 023L104FI Page : 3 of 8 Version:1.0 (5) EUT Photo (6) EUT Photo Report No.: 023L104FI Page : 4 of 8 Version:1.0 (7) EUT Photo (8) EUT Photo Report No.: 023L104FI Page : 5 of 8 Version:1.0 (9) EUT Photo (10) EUT Photo Report No.: 023L104FI Page : 6 of 8 Version:1.0 (11) EUT Photo (12) EUT Photo Report No.: 023L104FI Page : 7 of 8 Version:1.0 (13) EUT Photo (14) EUT Photo Report No.: 023L104FI Page : 8 of 8 Version:1.0 (15) EUT Photo

Report No. 023L104FI Page : 5 of 42 Version:1.0 1. GENERAL INFORMATION 1.1. EUT Description Product Name : Access Point Trade Name : WINMATE FCC ID. : PX91200 Model No. : WN1200 Frequency Range : 2412MHz to 2462MHz Channel Number : 11 Chip Rate : 1Mbps, 2Mbps, 5.5Mbps, 11Mbps Type of Modulation : Direct Sequence Spread Spectrum Antenna type : Soldered on PCB Operator Selection of Operating Frequency : By software Power Adapter : WN10A-050 Cable Out: Non-shielded, 1.8m Frequency of Each Channel: Channel Frequency Channel Frequency Channel Frequency Channel 1: 2412 MHz Channel 2: 2417 MHz Channel 3: 2422 MHz Channel 4: 2427 MHz Channel 5: 2432 MHz Channel 6: 2437 MHz Channel 7: 2442 MHz Channel 8: 2447 MHz Channel 9: 2452 MHz Channel 10: 2457 MHz Channel 11: 2462 MHz Note: 1. This device is a 2.4GHz Access Point included a 2.4GHz receiving function, a 2.4GHz transmitting function for the desktop/ laptop computers. Direct Sequence device with 11 channels. 2. Regards to the frequency band operation; two rate that were included the lowest、middle and highest frequency of channel were selected to perform the test, then shown on this report. 3. These tests were conducted on a sample of the equipment for the purpose of demonstrating compliance with Part 15 Subpart C Paragraph 15.247 for spread spectrum devices. 4. This device is a composite device in accordance with Part 15 regulations. The function receiving was measured and made a test report that the report number is 023L104F under Declaration of Conformity. 1.2. Operational Description EUT is an USB interface 2.4GHz wireless LAN with 11 channels. This device provided four kind of transmitting speed 1,2,5.5 and 11Mbps. The device of RF carrier is DQPSK, DB PSK and CCK. The device adapts direct sequence spread spectrum modulation. The soldered on PCB antenna printed on PCB provides diversity function to improve the receiving function. Data can be transmitted by the radio signal connect to the Internet or Local network.

Report No. 023L104FI Page : 1 of 42 Version:1.0 Test Report Product Name : Access Point Model No. : WN1200 FCC ID.: PX91200 Applicant : WINMATE Communication INC. Address : 9F., No. 175, Ta-Tung Road, Sec. 1, Hsi-Chih,Taipei Hsien, Taiwan, R.O.C. Date of Receipt : Mar. 1, 2002 Date of Test : Apr. 8, 2002 Report No. : 023L104FI The test results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by NVLAP any agency of the U.S. Government Report No. 023L104FI Page : 3 of 42 Version:1.0 TABLE OF CONTENTS Description Page 1. GENERAL INFORMATION .....................................................................................................5 1.1. EUT Description............................................................................................................................5 1.2. Operational Description ................................................................................................................5 1.3. Tested System Details....................................................................................................................6 1.4. Configuration of tested System .....................................................................................................7 1.5. EUT Exercise Software .................................................................................................................7 1.6. Test Facility ...................................................................................................................................8 2. Conducted Emission....................................................................................................................9 2.1. Test Equipment List.......................................................................................................................9 2.2. Test Setup ......................................................................................................................................9 2.3. Limits ............................................................................................................................................9 2.4. Test Procedure .............................................................................................................................10 2.5. Test Result of Conducted Emission.............................................................................................11 3. Peak Power Output ...................................................................................................................12 3.1. Test Equipment............................................................................................................................12 3.2. Test Setup ....................................................................................................................................12 3.3. Test Condition .............................................................................................................................12 3.4. Limit ............................................................................................................................................12 3.5. Test Result of Peak Power Output...............................................................................................13 4. RF Exposure Evaluation ...........................................................................................................14 4.1. Friis Formula ...............................................................................................................................14 4.2. EUT Operation condition ............................................................................................................14 4.3. Test Result of RF Exposure Evaluation.......................................................................................15 5. Radiated Emission .....................................................................................................................16 5.1. Test Equipment............................................................................................................................16 5.2. Test Setup ....................................................................................................................................16 5.3. Limits ..........................................................................................................................................17 5.4. Test Procedure .............................................................................................................................17 5.5. Test Result of Radiated Emission................................................................................................18 6. Band Edge ..................................................................................................................................25 6.1. Test Equipment............................................................................................................................25 6.2. Test Setup ....................................................................................................................................25 6.3. Test Condition .............................................................................................................................26 6.4. Limit ............................................................................................................................................26 6.5. Test Procedure .............................................................................................................................26 6.6. Test Result of Band Edge ............................................................................................................27 7. Occupied Bandwidth ......................................................................................................…

Text truncated - open the document above for the full version.

Report No.: 023L104FI Page : 1 of 3 Version:1.0 Attachment 1: EUT Test Setup Photographs Front View of Conducted Test Back View of Conducted Test Report No.: 023L104FI Page : 2 of 3 Version:1.0 Front View of Radiated Test Back View of Radiated Test Report No.: 023L104FI Page : 3 of 3 Version:1.0 Front View of Radiated Test (Horn)