QPRDL-14nano TUNE

DLO |nanoTune USER MANUAL ™ FM Transmitter / FM Radio / Headphone Amp for iPod nano nanotune_manual_GM 1/25/06 6:38 PM Page 1 2|DLO TRANSDOCK MICRO USER GUIDE |3 ©2006 Digital Lifestyle Outfitters nanoTune, Digital Lifestyle Outfitters & DLO logo are trademarks of Digital Lifestyle Outfitters. iPod is a registered trademark of Apple Computer, Inc. All Rights Reserved Printed in Taiwan Contents Quick Start Using your DLO nanoTune The Mode button FM Transmitter mode FM Radio mode iPod mode DLO nanoTune Features Volume Amplifier Powering your iPod nano On and Off with the DLO nanoTune Tuning your nanoTune’s FM Radio in Scan mode Use in your car Use in the home Use as a Desktop Stand Use with charger or sync cable nanoTune as protective case Tips and Troubleshooting Tech Specs Optional accessories (dock, autocharger?) Service and Support nanotune_manual_GM 1/25/06 6:38 PM Page 2 |5 4|DLO TRANSDOCK MICRO USER GUIDE Quick Start Thanks for buying the DLO nanoTune. We’ll get you up and running in 3 easy steps. The nanoTune does a lot, but is simple to use. For more detailed instruc- tions and features, check out Using Your DLO nanoTune [xxx] and DLO nanoTune Features [xxx]. 1. Open your nanoTune’s cover and slide your iPod nano into the compart- ment 2. Press and hold the nanoTune’s Mode button, located on the top right side of the nanoTune, for 3 seconds to turn it on. 3. Press the Mode button again to select the desired function - “FM Transmitter,” “Radio,” or “iPod” mode. Youcan now use the buttons on the sides of the nanoTune to control tuning and volume and other controls depending on the function you wish to use. nanoTune runs in 3 distinct modes: FM Transmitter mode: nanoTune will play your nano over any FM radio. Radio mode:Listen to your favorite radio stations with the push of a button. iPod mode:Listen to your nano’s music [and scroll to next track or previous track] while nanoTune boosts your iPod nano’s volume output and maximizes your iPod nano’s battery life. NANOTUNE  5 LEFT SIDEFRONTRIGHT SIDE Adjustment Screw nanotune_manual_GM 1/25/06 6:38 PM Page 4 6|DLO TRANSDOCK MICRO USER GUIDE |7 Extra Features of the DLO nanoTune The Mode button To turn on your DLO nanoTune (after you have slipped your nano into its cas- ing) simply press and hold the Mode button for 3 seconds. The nanoTune’s display will light up blue and show which mode the nanoTune is in. The different mode displays are: “T 98.3” for FM Transmitter Mode [ lcd graphic] “ 98.3”for FM Radio Mode [lcd graphic] “iPod” for iPod Mode[lcd graphic] Just press the Mode / Power button until you get to the Mode you wish to use. Press and hold the Mode / Power button for 3 seconds to turn off your nanoTune. Headphone Amplifier: The nanoTune amplifies the volume output on your iPod nano by over 25% while at the same time, maximizing your iPod nano’s battery life. Protective Case: The nanoTune performs as a handy protective shell for your nano, and it still allows you access to the nano’s control wheel without having to remove it from the nanoTune, so there is no reason you should ever have to remove your nano from the DLO nanoTune. Dockable & Chargeable: The nanoTune has a pass-through 30-pin design that allows you to dock, sync and charge your nano in Apple’s dock or use it with a car charger or nano synching cable without having to remove your iPod nano from the device. AND a Handy Desktop Stand: The DLOnanoTune can be used as a desktop stand for your nano by simply opening the clear cover and rotating it back underneath the unit. Using your DLO nanoTune DLO nanoTune Control Chart MODE TRANSMITTER RADIOIPOD >Select frequency up Manual tune up/hold to scan up next track <Select frequency down Manual tune down/hold to scan down next track +Volume upControls booster -Volume downControls booster nanotune_manual_GM 1/25/06 6:38 PM Page 6 8|DLO TRANSDOCK MICRO USER GUIDE |9 If you live in a big city with a lot of FM radio stations, finding an “empty” FM frequency can be tricky. Here are some tips for finding an empty station: •Be sure to search the entire spectrum of FM frequencies, from 88.1 to 107.9. Don’t just look to the low end of the dial. There are often empty FM stations in the 100’s that will work great. •When using scan on your car radio, if you’re tuner stops on 101 and then jumps to 103, look in the 102 frequencies for empty stations. •Try scanning to a strong station, then backing down two frequencies - for example 103.5 to 103.1. You can often find empty frequencies this way. If that frequency is taken, scan to the next station and try again. The nanoTune’s FM Transmitter lets you wirelessly play your iPod nano’s music on any FM radio. The nanoTune has two tuning buttons on its right side so you can play your iPod nano on any FM frequency, from 88.1 to 107.9. 1.Turn on your radio (car stereo, home stereo, or whatever radio you are using) and set it to FM radio mode. Find an FM frequency with no signal or radio station. For more help with this, read Finding Empty Radio Frequencies [pg xxx]. 2.Turn on your nanoTune by holding down the Mode button for 3 seconds. 3. Your nanoTune should default to FM Transmitter mode, which is indicated onthe nanoTune display by a frequency with the transmitter icon to its left, e.g. “T 88.5”. 4. Select and play a song from your nano. 5. Match the FM frequency on your nanoTune with the empty FM station on your radio using the tuning buttons on the right side of the nanoTune (top button tunes up, bottom button tunes down). You should hear most of the static go away when you do this. Now your radio has found the nanoTune’s signal. 6.To control the overall volume of your music while using the nanoTune, use your radio’s volume control, not the nanoTune or the nano volume control. Using nanoTune in FM Transmitter mode Finding Empty Radio Frequencies nanotune_manual_GM 1/25/06 6:38 PM Page 8 10|DLO TRANSDOCK MICRO USER GUIDE |11 Using nanoTune in iPod mode You can listen to your iPod nano while…

Text truncated - open the document above for the full version.

Confidentiality Request FCC ID QPRDL-14 Product nano TUNE Model DL-14 Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, the Applicant hereby requests confidential treatment of information accompanying this Application as outlined below. Schematics Block Diagram Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457, disclosure of this Application And all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Signature: (Name / Date)

Compliance Certification Services Inc.Report No.60206402-RP1 External Photo ( Model: DL-14 )

Company : JOW TONG TECHNOLOGY CO., LTD. Model : DL-14 Product : nano TUNE nano TUNE Model No: DL-14 FCC IDQPRDL-14 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: [1] this device may not cause harmful interference and [2] this device must accept any interference received, including interference that may cause undesired operation. S/N Made in Taiwan Label Here

Compliance Certification Services Inc.Report No.60206402-RP1 Internal Photo Compliance Certification Services Inc.Report No.60206402-RP1 Compliance Certification Services Inc.Report No.60206402-RP1

Compliance Certification Services Inc. Report No.: 60206402-RP1 FCC ID: QPRDL-14 Date of Issue: February 24, 2006 Note: This report shall not be reproduced except in full, without the written approval of Compliance Certification Services Inc. This document may be altered or revised by Compliance Certification Services Inc. personnel only, and shall be noted in the revision section of the document. Page 1 FCC CFR 47 PART 15 SUBPART C TEST REPORT For nano TUNE Model Number : DL-14 Issued to JOW TONG TECHNOLOGY CO., LTD. 46, Lane 337, Chung Cheng Rd., Yung Kang City, Tainan County 710, Taiwan, R.O.C. Issued by Compliance Certification Services Inc. Ta i n a n L a b . No. 8, Jiu Cheng Ling, Jiaokeng Village,Sinhua Township, Tainan Hsien 712, Taiwan R.O.C. TEL: 886-6-580-2201 FAX: 886-6-580-2202 Compliance Certification Services Inc. Report No.: 60206402-RP1 FCC ID: QPRDL-14 Date of Issue: February 24, 2006 Page 2 TABLE OF CONTENTS 1. TEST RESULT CERTIFICATION .................................................................................. 3 2. EUT DESCRIPTION ........................................................................................................ 4 3. TEST METHODOLOGY................................................................................................. 5 3.1 EUT CONFIGURATION................................................................................... 5 3.2 EUT EXERCISE............................................................................................. 5 3.3 GENERAL TEST PROCEDURES......................................................................... 5 3.4 FCC PART 15.205 RESTRICTED BANDS OF OPERATIONS.............................. 6 3.5 DESCRIPTION OF TEST MODES........................................................................ 6 4 INSTRUMENT CABLIBRATION ................................................................................. 6 5 FACILITIES AND ACCREDITATIONS ...................................................................... 7 5.1 FACILITIES.................................................................................................. 7 5.2 EQUIPMENT................................................................................................. 7 5.3 LABORATORY ACCREDITATIONS AND LISTINGS................................................ 7 5.4 TABLE PF ACCREDITATIONS AND LISTINGS...................................................... 8 6 SETUP OF EQUIPMENT UNDER TEST ..................................................................... 9 6.1 SETUP CONFIGURATION OF EUT..................................................................... 9 6.2 SUPPORT EQUIPMENT................................................................................... 9 7 FCC PART 15.239 REQUIREMENTS ......................................................................... 10 7.1 20 DB BANDWIDTH..................................................................................... 10 7.2 BAND EDGES MEASUREMENT............................................................. 12 7.3 RADIATED EMISSIONS................................................................................. 16 7.4 POWERLINE CONDUCTED EMISSIONS............................................................ 23 APPENDIX 1 PHOTOGRAPHS OF TEST SETUP ......................................................... 24 Compliance Certification Services Inc. Report No.: 60206402-RP1 FCC ID: QPRDL-14 Date of Issue: February 24, 2006 Page 3 1. TEST RESULT CERTIFICATION Applicant JOW TONG TECHNOLOGY CO., LTD. Address 46, Lane 337, Chung Cheng Rd., Yung Kang City, Tainan County 710, Taiwan, R.O.C. Equipment Under Test nano TUNE Model Number DL-14 Date of Test February 23, 2006 ~ February 24, 2006 APPLICABLE STANDARDS STANDARD TEST RESULT FCC 47 CFR Part 15 Subpart C No non-compliance noted The above equipment was tested by Compliance Certification Services Inc. The test data, data evaluation, test procedures, and equipment configurations shown in this report were made in accordance with the procedures given in ANSI C63.4 and the energy emitted by the sample EUT tested as described in this report is in compliance with conducted and radiated emission limits of FCC Rules Part 15.239. The test results of this report relate only to the tested sample identified in this report. Approved by: Reviewed by: Feb. 20, 2006 Feb. 20, 2006 Alex Chiu Jeter Wu Manager Section Manager Compliance Certification Services Inc. Compliance Certification Services Inc. Compliance Certification Services Inc. Report No.: 60206402-RP1 FCC ID: QPRDL-14 Date of Issue: February 24, 2006 Page 4 2. EUT DESCRIPTION Product nano TUNE Model Number DL-14 Model Difference N/A Power Supply DC 3.3V 0.5W Operate Frequency 88.1 ~ 107.9MHz Transmit Power N/A Modulation Technique FM Number of Channels 199 Channel Remark: This submittal(s) (test report) is intended for FCC ID: QPRDL-14 filing to comply with Section 15.239 of the FCC Part 15 Subpart C Rules. Compliance Certification Services Inc. Report No.: 60206402-RP1 FCC ID: QPRDL-14 Date of Issue: February 24, 2006 Page 5 3. TEST METHODOLOGY The tests documented in this report were performed in accordance with ANSI C63.4 and FCC CFR 47 Part 15 Subpart C. 3.1 EUT CONFIGURATION The EUT configuration for testing is installed on RF field strength measurement to meet the Commissions requirement and operating in a manner that intends to maximize its emission characteristics in a continuous normal application. 3.2 EUT EXERCISE The calibrated antennas used to sample the radiated field strength are mounted on a non-conductive, motorized antenna mast 3 or 10 meters from the leading edge of the turntable. 3.3 GENERAL TEST PROCEDURES Conducted Emissions The EUT is placed on the turntable, which is 0.8 m above ground plane. According to the requirements in Section 7.1 of ANSI C63.4.Conducted emissions from the EUT measured in the frequency range between 0.15 MHz and 30MHz using CISPR Quasi-Peak detector mode. Radi…

Text truncated - open the document above for the full version.

Compliance Certification Services Inc. Report No.: 60206402-RP1 FCC ID: QPRDL-14 Date of Issue: February 24, 2006 Page 24 APPENDIX 1 PHOTOGRAPHS OF TEST SETUP Radiated Emission Setup Photos Compliance Certification Services Inc. Report No.: 60206402-RP1 FCC ID: QPRDL-14 Date of Issue: February 24, 2006 Page 25