QW3-BTGPS01Bluetooth GPS Receiver

Quick User’s Guide Introduction The Bluetooth GPS receiver uses Bluetooth wireless transfer technology and the built-in active antenna to provide a high-sensitivity signal tracking function. This device allows users to transfer data via satellite to PDA’s, smart phones and notebook PCs equipped with a Bluetooth transfer interface. The scope of application covers vehicle navigation, security systems, GIS and other related fields. Package Check the contents in the package before use. 1. Bluetooth GPS receiver 2. Car charger 3. User’s manual Overview External Antenna In Power Switch DC In Bluetooth Status Indicator GPS Status Indicator Battery Status Indicator LED Indication Indicator Status Change Status Flashing Battery low Always on Bluetooth connected Blue LED Bluetooth Connection Off Bluetooth not connected Flashing GPS active Green LED GPS Connection Always on GPS inactive Flashing Charging started; determining battery condition Always on Charge in progress Red LED Power Off Charge inactive Using an external antenna This device is equipped with a built-in antenna and does not need additional an antennal for running the GPS. You will need an external antenna to help you search and receive signals only when the device is blocked from receiving satellite signals. Getting started Step 1: Charging your battery 1. You must charge the battery before using the device for the first time. Please charge the battery with the car charger that comes with the device. After connecting the charger to the device, the red LED indicator on the device will flash because while it determines the type of battery installed on the device. After determining the battery, the charging process will start, and the red LED indicator will be illuminated at all times until the battery is fully charged. 2. When the battery is fully charged, the red LED indicator will go out. Caution! 1. The blue LED will flash at all times if the battery is low. 2. Do not charge non-chargeable batteries, as this will damage the product. Step 2: Bluetooth connection 1. Switch on your Bluetooth GPS receiver. The battery indicator (red LED) will go out. 2. Enable the Bluetooth device on your PDA or notebook PC according to the instructions. Then connect it to the Bluetooth GPS receiver. 3. The Bluetooth indicator (blue LED) is always ON if it is successfully connected to your PDA or notebook PC. You can confirm the connection with the Bluetooth software on your PDA or notebook PC. The Bluetooth indicator (blue LED) will go out if there is not connection. Caution! Some Bluetooth devices require an authorization code. This code is “0000”. Step 3: GPS 1. The GPS indicator (green) will keep flashing during positioning and after positioning is completed. Confirm positioning from your navigation software before use. 2. The GPS indicator will be illuminated at all times when the GPS is inactive. FCC Statement The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. User Information This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation. To comply with FCC RF exposure requirement, this device and its antenna must be co-located or operating in the conjunction with any other antenna or transmitter. The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc.. Other trademarks and trade names are those of their respective owners.

SPORTON International Inc. PAGE NUMBER : A1 OF A3 TEL : 886-2-2696-2468 ISSUED DATE : July 05, 2005 FAX : 886-2-2696-2255 APPENDIX A. Photographs of EUT SPORTON International Inc. PAGE NUMBER : A2 OF A3 TEL : 886-2-2696-2468 ISSUED DATE : July 05, 2005 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A3 OF A3 TEL : 886-2-2696-2468 ISSUED DATE : July 05, 2005 FAX : 886-2-2696-2255

SPORTON International Inc. PAGE NUMBER : A1 OF A7 TEL : 886-2-2696-2468 ISSUED DATE : July 05, 2005 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A2 OF A7 TEL : 886-2-2696-2468 ISSUED DATE : July 05, 2005 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A3 OF A7 TEL : 886-2-2696-2468 ISSUED DATE : July 05, 2005 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A4 OF A7 TEL : 886-2-2696-2468 ISSUED DATE : July 05, 2005 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A5 OF A7 TEL : 886-2-2696-2468 ISSUED DATE : July 05, 2005 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A6 OF A7 TEL : 886-2-2696-2468 ISSUED DATE : July 05, 2005 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A7 OF A7 TEL : 886-2-2696-2468 ISSUED DATE : July 05, 2005 FAX : 886-2-2696-2255

FCC ID: QW3-BTGPS01 Issued on July 05, 2005 Report No.: FR551804 SPORTON International Inc. TEL : 886-2-2696-2468 FAX : 886-2-2696-2255 FCC TEST REPORT CATEGORY : Mobile PRODUCT NAME : Bluetooth GPS Receiver FCC ID. : QW3-BTGPS01 FILING TYPE : Certification BRAND NAME : Formosa Teletek MODEL NAME : FB-GP01 APPLICANT : Formosa Teletek Corporation No. 358, Hwaya 2nd Gueishan Shiang, Taoyuan, Taiwan MANUFACTURER : Formosa Teletek Corporation No. 358, Hwaya 2nd Gueishan Shiang, Taoyuan, Taiwan ISSUED BY : SPORTON INTERNATIONAL INC. 6F, No. 106, Sec. 1, Hsin Tai Wu Rd., His Chih, Taipei Hsien, Taiwan, R.O.C. Statements: The test result in this report refers exclusively to the presented test model / sample. Without written approval of SPORTON International Inc., the test report shall not be reproduced except in full. Certificate or Test Report could not be used by the applicant to claim the product endorsement by CNLA and any agency of U.S. government. The test equipments used to perform the test are calibrated and traceable to NML/ROC or NIST/USA. 1190 ILAC MRA FCC ID: QW3-BTGPS01 Issued on July 05, 2005 Report No.: FR551804 SPORTON International Inc. Page No. : i TEL : 886-2-2696-2468 Issued Date: July 05, 2005 FAX : 886-2-2696-2255: Table of Contents HISTORY OF THIS TEST REPORT .....................................................................................................................II CERTIFICATE OF COMPLIANCE.......................................................................................................................III 1. GENERAL DESCRIPTION OF EQUIPMENT UNDER TEST...........................................................................1 1.1. Applicant ......................................................................................................................................................................................... 1 1.2. Manufacturer ................................................................................................................................................................................... 1 1.3. Basic Description of Equipment under Test.................................................................................................................................... 1 1.4. Features of Equipment under Test ................................................................................................................................................. 1 1.5. Table for Carrier Frequencies ......................................................................................................................................................... 2 2. TEST CONFIGURATION OF THE EQUIPMENT UNDER TEST .....................................................................3 2.1. Connection Diagram of Test System .............................................................................................................................................. 3 2.2. The Test Mode Description............................................................................................................................................................. 3 2.3. Description of Test Supporting Units .............................................................................................................................................. 3 3. GENERAL INFORMATION OF TEST ..............................................................................................................4 3.1. Test Facility ..................................................................................................................................................................................... 4 3.2. Standards for Methods of Measurement......................................................................................................................................... 4 3.3. Frequency Range Investigated ....................................................................................................................................................... 4 3.4. Test Distance .................................................................................................................................................................................. 4 3.5. Test Software .................................................................................................................................................................................. 4 4. LIST OF MEASUREMENTS .............................................................................................................................5 4.1. Summary of the Test Results.......................................................................................................................................................... 5 5. TEST RESULT ..................................................................................................................................................6 5.1. Test of Hopping Channel Bandwidth .............................................................................................................................................. 6 5.2. Test of Hopping Channel Separation.............................................................................................................................................. 9 5.3. Test of Number of Hopping Frequency......................................................................................................................................... 12 5.4. Test of Test of Dwell Time of Each Frequency ............................................................................................................................. 14 5.5. Maximum Peak Output Power ...................................................................................................................................................... 21 5.6. Test of Band Edges Emission...........................................................................................................…

Text truncated - open the document above for the full version.

FRONT VIEW REAR VIEW