ROJEXPLORER-500INMARSAT TERMINAL WITH BLUETOOTH

EXPLORER™ 500 User Manual TT 98-122274-Eii Document number: TT 98-122274-E Release date: August 24, 2005 Information in this document is subject to change without notice and does not represent a commitment on the part of Thrane & Thrane A/S. Copyright © 2005 Thrane & Thrane A/S. All rights reserved. FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.This device may not cause harmful interference, and 2.this device must accept any interference received, including interference that may cause undesired operation. Part 15.21 Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Trademark Acknowledgements •EXPLORER is a trademark of Thrane & Thrane A/S. •Bluetooth is a registered trademark of Bluetooth SIG. •Windows and Outlook are registered trademarks of Microsoft Corporation in the United States and other countries. •Inmarsat is a registered trademark of the International Maritime Satellite Organisation (IMSO) and is licensed by IMSO to Inmarsat Limited and Inmarsat Ventures plc. • Inmarsat’s product names are either trademarks or registered trademarks of Inmarsat. • Other product and company names mentioned in this manual may be trademarks or trade names of their respective owners. Note The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment. TT 98-122274-Eiii Company Addresses DenmarkUSA Thrane & Thrane A/S Lundtoftegårdsvej 93 D DK-2800 Kgs. Lyngby Denmark T: +45 39 55 88 00 F: +45 39 55 88 88 www.thrane.com Thrane & Thrane, Inc. 509 Viking Drive, Suites K, L and M Virginia Beach, VA 23452 USA T: +1(866) SATCOMS or +1 (757) 463-9557 F: +1 (757) 463-9581 www.thrane.com Thrane & Thrane Aalborg A/S Porsvej 2 DK-9200 Aalborg SV Denmark T: +45 39 55 88 00 F: +45 96 34 61 01 www.thrane.com TT 98-122274-Eiv Safety Summary1 The following general safety precautions must be observed during all phases of operation, service and repair of this equipment. Failure to comply with these precautions or with specific warnings elsewhere in this manual violates safety standards of design, manufacture and intended use of the equipment. Thrane & Thrane A/S assume no liability for the customer's failure to comply with these requirements. Do Not Operate in an Explosive Atmosphere Do not operate the equipment in the presence of flammable gases or fumes. Operation of any electrical equipment in such an environment constitutes a definite safety hazard. Keep Away from Live Circuits Operating personnel must not remove equipment covers. Component replacement and internal adjustment must be made by qualified maintenance personnel. Do not replace components with the power cable connected. Under certain conditions, dangerous voltages may exist even with the power cable removed. To avoid injuries, always disconnect power and discharge circuits before touching them. Do Not Service Alone Do not attempt internal service or adjustments unless another person, capable of rendering first aid resuscitation, is present. Do Not Substitute Parts or Modify Equipment Because of the danger of introducing additional hazards, do not substitute parts or perform any unauthorized modification to the equipment. Keep Away from Active Antenna Front This device emits radio frequency energy when in transmit mode. To avoid injury, keep a minimum safety distance of 0.6 m from the antenna front. Only Use Approved Batteries from Thrane & Thrane Use of non approved batteries may result in explosion, fire, electrical shock or injury. Observe Marked Areas Under extreme heat conditions do not touch areas of the EXPLORER™ 500 that are marked with this symbol, as it may result in injury. About the Manual TT 98-122274-Ev About the Manual2 Intended Readers This manual is a user manual for the EXPLORER™500. The readers of the manual include anyone who is using or intends to use the EXPLORER™ 500. No specific skills are required to operate the EXPLORER™ 500. However, it is important that you observe all safety requirements listed in the Safety Summary in the beginning of this manual, and operate the EXPLORER™ 500 according to the guidelines in this manual. Manual Overview This manual has the following chapters: •Introduction - an overview of the BGAN services and a brief description of the system. •Getting Started - how to insert SIM card and battery, start up the unit, and how to navigate the display menus. Also a short guide to making the first call. •Using the Display and Keypad - an overview of the display menu system and how to use the menus. •Using the Interfaces - how to set up and use each interface. •Using the Web Interface - how to use the built-in Web interface of the EXPLORER™ 500, including a description of the available menus and settings. Also advanced setup of interfaces using the Web interface. •Maintenance and Troubleshooting – a short troubleshooting guide, how to update software and a description of the error messages that may appear in the handset. Also a list of system messages and information on where to get further help if necessary. TT 98-122274-Evi Table of Contents Safety Summary ........................................................................................ iv About the Manual ....................................................................................... v Chapter 1Introduction Welcome .................................................................................................... 1-1 In This Chapter .......................................................................................... 1-1 The BGAN System ................................................................................... 1-2 The BGAN Services .................................................................................. 1-4 Overview…

Text truncated - open the document above for the full version.

Figure 1 Front view Figure 2 Rear view Figure 3 Top view Figure 4 DC out and Ant connector Figure 5 Side view Figure 6 Side view Figure 7 Connectors Figure 8 Bottom view Figure 9 Battery Figure 10 Battery Figure 11 Battery Figure 12 Battery Figure 13 Battery Figure 14 Battery Figure 15 Battery

Figure 1 Mainboard Figure 2 Mainboard Figure 3 Mainboard Figure 4 Mainboard Figure 5 Mainboard

FCC ID: ROJEXPLORER500 MFA p0580015, d0580056 Sub-part 2.1033(c): Equipment Identification FCC ID: ROJEXPLORER500 Nameplate Drawing Attached, Exhibit 1. Location As Per Label Drawing(s) Date Of Report August 23, 2005 Supervised By: David E. Lee, Quality Assurance Manager FCC ID: ROJEXPLORER500 MFA p0580015, d0580056 The Applicant has been cautioned as to the following: 15.21 Information to User. The users manual or instruction manual for an intentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 15.27(a) Special Accessories. Equipment marketed to a consumer must be capable of complying with the necessary regulations in the configuration in which the equipment is marketed. Where special accessories, such as shielded cables and/or special connectors are required to enable an unintentional or intentional radiator to comply with the emission limits in this part, the equipment must be marketed with, i.e. shipped and sold with, those special accessories. However, in lieu of shipping or packaging the special accessories with the unintentional or intentional radiator, the responsible party may employ other methods of ensuring that the special accessories are provided to the consumer, without additional charge. Information detailing any alternative method used to supply the special accessories for a grant of equipment authorization or retained in the verification records, as appropriate. The party responsible for the equipment, as detailed in § 2.909 of this chapter, shall ensure that these special accessories are provided with the equipment. The instruction manual for such devices shall include appropriate instructions on the first page of text concerned with the installation of the device that these special accessories must be used with the device. It is the responsibility of the user to use the needed special accessories supplied with the equipment. FCC ID: ROJEXPLORER500 MFA p0580015, d0580056 Table Of Contents Rule Description Page . Test Report 1 2.1033(c) General Information Required 2 . Standard Test Conditions and Engineering Practices 5 15.247(b). Maximum Peak Output Power 6 2.1046(a) EIRP Carrier Power (Radiated) 7 2.1051 Unwanted Emissions (Transmitter Conducted) - Bluetooth 9 15.205. Restricted Bands Of Operation 12 2.1053(a) Field Strength of Spurious Radiation 14 1.1307 Environmental Assessment 17 2.1049(c)(1) Emission Masks 18 15.107 A/C Powerline Conducted Emissions 34 FCC ID: ROJEXPLORER500 MFA p0580015, d0580056 Page Number 1 of 37 Required information per ISO/IEC Guide 25-1990, paragraph 13.2: a) Test Report b) Laboratory: (FCC: 31040/SIT) (Canada: IC 2044) M. Flom Associates, Inc. 3356 N. San Marcos Place, Suite 107 Chandler, AZ 85225 c) Report Number: d0580056 d) Client: Thrane & Thrane A/S Lundtoftegardsvej 93D DK-2800 Lyngby, Denmark e) Identification: Explorer 500 FCC ID: ROJEXPLORER500 Description: Immersat Terminal f) EUT Condition: Not required unless specified in individual tests. g) Report Date: September 23, 2005 EUT Received: August 22, 2005 h, j, k): As indicated in individual tests. i) Sampling method: No sampling procedure used. l) Uncertainty: In accordance with MFA internal quality manual. m) Supervised by: David E. Lee, Quality Assurance Manager n) Results: The results presented in this report relate only to the item tested. o) Reproduction: This report must not be reproduced, except in full, without written permission from this laboratory. FCC ID: ROJEXPLORER500 MFA p0580015, d0580056 Page Number 2 of 37 List Of General Information Required For Certification In Accordance with FCC Rules and Regulations, Volume II, Part 2 and to Part 15.247 (Bluetooth) Sub-Part 2.1033 ©(1): Name and Address of Applicant: Thrane & Thrane A/S Lundtoftegardsvej 93D DK-2800 Lyngby, Denmark Manufacturer: Applicant (c)(2): FCC ID: ROJEXPLORER500 Model Number: Explorer 500 (c)(3): Instruction Manual(s): Please See Attached Exhibits (c)(4): Type Of Emission: GFSK (c)(5): FREQUENCY RANGE, MHz: 2400 to 2483.5 (c)(6): Power Rating, W: 0.100 Switchable X Variable N/A (c)(7): Maximum Power Rating, W: 1.0 15.203: Antenna Requirement: X The antenna is permanently attached to the EUT The antenna uses a unique coupling The EUT must be professionally installed The antenna requirement does not apply FCC ID: ROJEXPLORER500 MFA p0580015, d0580056 Page Number 3 of 37 Subpart 2.1033 (continued) (c)(8): Voltages & Currents in All Elements in Final RF Stage, Including Final Transistor or Solid State Device: Composite Unit: Figures are with both Part 25 and Part 15.247 units operating; Collector Current, A = 3.0 Collector Voltage, Vdc = 8.0 Supply Voltage, Vdc = 10 - 16 (c)(9): Tune-Up Procedure: Please See Attached Exhibits (c)(10): Circuit Diagram/Circuit Description: Including description of circuitry & devices provided for determining and stabilizing frequency, for suppression of spurious radiation, for limiting modulation and limiting power. Please See Attached Exhibits (c)(11): Label Information: Please See Attached Exhibits (c)(12): Photographs: Please See Attached Exhibits (c)(13): Digital Modulation Description: ___ Attached Exhibits _x_ N/A (c)(14): Test And Measurement Data: Follows FCC ID: ROJEXPLORER500 MFA p0580015, d0580056 Page Number 4 of 37 Sub-part 2.1033(b): Test And Measurement Data All tests and measurement data shown were performed in accordance with FCC Rules and Regulations, Volume II; Part 2, Sub-part J, Sections 2.1031, 2.1033, 2.1035, 2.1041, 2.1043, 2.1045, and the following individual Parts: 15.209 Radiated emission limits; general requirements 15.211 Tunnel radio systems 15.213 Cable locating equipment 15.214 Cordless telephones 15.217 Operation in the band 160-190 kHz 15.219 Operation in the band 510-1705 kHz 15.221 Operation in the band 525-1705 kHz (leaky coax) 15.223 Operation in the band 1.705-10 MHz 15.225 Operation in the band …

Text truncated - open the document above for the full version.

FCC ID: ROJEXPLORER500 MFA p0580015, d0580056 Page Number 36 of 37. Photograph(s) of Test Setup for Highest Emissions Test Setup: A/C Powerline Conducted Emissions