ROL-ASS21110128USB DONGLE

WLAN Card User Manual Version: 0.1 2 FCC Class B Radio Frequency Interference Statement FEDERAL COMMUNICATIONS COMMISSION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/television technician for help. The user should not modify or change this equipment without written approval from Fi Win, Inc. Modification could void authority to use this equipment. Notice 1: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Notice 2: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device. 3 Table of Contents 1. Introduction.......................................................................................................................3 2. Installation.........................................................................................................................3 2.1 OVERVIEW...................................................................................................................3 2.1.1 INSTALL THE WLAN UTILITY/DRIVER.............................................................4 2.1.2 INSTALL WLAN CARD ......................................................................................8 2.2 UTILITY STARTUP CONFIGURATION DETAILS........................................................9 2.2.1. Setting................................................................................................................9 2.2.2. WLAN Management Utility Introduction............................................................10 2.3 UNINSTALL THE WLAN UTILITY / DRIVER.............................................................. 25. 3. Troubleshooting ..............................................................................................29 a. Check the Various Properties of the Card..........................................................29 b. Plug the device first then install the Driver/Utility..................................................31 c. If your notebook or PC has default WLAN card, it cannot configure WiFi WLAN card..........................................................................................................31 4 1. Introduction WLAN Management Utility supports the following: ‧802.11b WLAN Configuration ‧Windows 98SE / ME / 2000 (In Windows XP, we use its default WLAN Utility) 2. Installation 2.1 Overview To establish your wireless network connection, the following steps should be executed. 1. Install the software using the installation CD. 2. Insert the Wireless LAN card. This product is designed for Windows 98SE, Millennium, 2000, and XP. The installation procedure for each platform is similar. Please follow the installation wizard that provided by your system install the software. 5 2.1.1 WLAN Driver/Utility Installation 1. Insert the installation CD into your CD-ROM drive. The setup program will start automatically. 2. Click “Next” to go to next screen. 3. Select the destination folder. To install to the default folder as shown below, click “Next” to go to the next screen. 4. During installation, Driver and Utility files will be copied to your system directory. 5. Select “No” and then click “Finish” to complete the installation (It is recommended to select “Yes” for Windows 98). 6. The shortcut will appear on your desktop. By click this icon, you can run the Utility program. You will also find a shortcut “WLAN Manager” at Start\Programs\Startup Menu as shown below: 7. After click the shortcut, an icon will appear on the bottom right of the screen. Right click that icon and select open, the WLAN Utility will pop-up on the screen. 2.1.2 Install the WLAN card The WLAN driver and utilities are included on the accompanying installation CD. Please follow the installation procedures in Section 2.2. (Your WLAN card will not work properly if the driver and utilities are not installed correctly). Make sure that there is an empty WLAN slot (for example PCMCIA, USB, mini-PCI) for WLAN card. Insert the WLAN Card and the installation will start automatically. When the WLAN card setup task is completed, you can run the WLAN Utility. 6 2.2 Utility Startup Configuration Details WLAN Card has its own management software. Users can control all functions provided by the application named WLAN Utility. The Utility icon will appear on the working bar by double clicking the WLAN Utility shortcut on your desktop. Three colors are used to describe the status of connection and it is shown on the right of working bar. Green…

Text truncated - open the document above for the full version.

REPORT NO. : F462404 SPORTON International Inc. PAGE NUMBER : A1 OF A6 TEL : 886-2-2696-2468 ISSUED DATE : July 31, 2004 FAX : 886-2-2696-2255 APPENDIX A. Photographs of EUT REPORT NO. : F462404 SPORTON International Inc. PAGE NUMBER : A2 OF A6 TEL : 886-2-2696-2468 ISSUED DATE : July 31, 2004 FAX : 886-2-2696-2255

REPORT NO. : F462404 SPORTON International Inc. PAGE NUMBER : A3 OF A6 TEL : 886-2-2696-2468 ISSUED DATE : July 31, 2004 FAX : 886-2-2696-2255 REPORT NO. : F462404 SPORTON International Inc. PAGE NUMBER : A4 OF A6 TEL : 886-2-2696-2468 ISSUED DATE : July 31, 2004 FAX : 886-2-2696-2255 REPORT NO. : F462404 SPORTON International Inc. PAGE NUMBER : A5 OF A6 TEL : 886-2-2696-2468 ISSUED DATE : July 31, 2004 FAX : 886-2-2696-2255 REPORT NO. : F462404 SPORTON International Inc. PAGE NUMBER : A6 OF A6 TEL : 886-2-2696-2468 ISSUED DATE : July 31, 2004 FAX : 886-2-2696-2255

FCC ID: ROL-ASS21110128 Issued on Aug. 2, 2004 Report No.: F462404 SPORTON International Inc. TEL : 886-2-2696-2468 FAX : 886-2-2696-2255 FCC TEST REPORT CATEGORY : Portable Product PRODUCT NAME : USB Dongle FCC ID. : ROL-ASS21110128 FILING TYPE : Certification BRAND NAME : Astarte/SoftGate MODEL NAME : ASS2111/128MB APPLICANT : Astarte Technology 11F, No.166, Dah-Yeh Rd., Peitou 112, Taipei, Taiwan, R.O.C. MANUFACTURER : Same as Applicant ISSUED BY : SPORTON INTERNATIONAL INC. 6F, No. 106, Sec. 1, Hsin Tai Wu Rd., His Chih, Taipei Hsien, Taiwan, R.O.C. Statements: The test result in this report refers exclusively to the presented test model / sample. Without written approval of SPORTON International Inc., the test report shall not be reproduced except in full. Certificate or Test Report could not be used by the applicant to claim the product endorsement by CNLA, NVLAP or any agency of U.S. government. The test equipment used to perform the test are calibrated and traceable to NML/ROC or NIST/USA. Dr. Alan Lane Vice General Manager Sporton International Inc. Lab Code: 200079-0 FCC ID: ROL-ASS21110128 Issued on Aug. 2, 2004 Report No.: F462404 SPORTON International Inc. Page No. : i TEL : 886-2-2696-2468 Issued Date : Aug. 2, 2004 FAX : 886-2-2696-2255 Table of Contents History of this test report....................................................................................................................................ii 1. General Description of Equipment under Test.............................................................................................1 1.1. Applicant..........................................................................................................................................................................................1 1.2. Manufacturer ...................................................................................................................................................................................1 1.3. Basic Description of Equipment under Test ....................................................................................................................................1 1.4. Features of Equipment under Test..................................................................................................................................................1 1.5. Table for Carrier Frequencies .........................................................................................................................................................2 2. Test Configuration of the Equipment under Test.........................................................................................3 2.1. Description of the Test ....................................................................................................................................................................3 2.2. Frequency Range Investigated .......................................................................................................................................................3 2.3. Description of Test Supporting Units...............................................................................................................................................4 2.4. Connection Diagram of Test System ..............................................................................................................................................4 2.5. Test Software ..................................................................................................................................................................................5 3. Test Location and Standards .........................................................................................................................6 3.1. Test Location...................................................................................................................................................................................6 3.2. Test Conditions ...............................................................................................................................................................................6 3.3. Standards for Methods of Measurement .........................................................................................................................................6 3.4. DoC Statement................................................................................................................................................................................6 4. List of Measurements......................................................................................................................................7 4.1. Summary of the Test Results ..........................................................................................................................................................7 5. Test Result .......................................................................................................................................................8 5.1. Test of 6dB Spectrum Bandwidth ( DSSS System ) .......................................................................................................................8 5.2. Test of Maximum Peak Output Power ..........................................................................................................................................11 5.3. Test of Peak Power Spectral Density............................................................................................................................................12 5.4. Test of Band Edges Emission .......................................................................................................................................................15 5.5. Test of AC Power Line Conducted Emission ................................................................................................................................17 5.6. Test of Spu…

Text truncated - open the document above for the full version.