TKZAWAPN2403WIFI ROUTER

www.asiarf.com TEL: +886-2-29213598 FAX: +886-2-29214445 1F, No.2, Lane 45, Shuiyuan Street, Yonghe City Taipei County 234 Taiwan, R.O.C. page: 1 AWAPN2403.a Portable Pocket 11n/g/b 300Mbps with USB AP Router USB connect Web camera, Hard disk, WiFi USB dongle, 3G dongle 1. Description: The Tiniest Portable Pocket 300Mbps AP Router can be linked with Web Camera, LTE, USB WiFi LAN Card, 3G USB, Wimax as WAN, Hard disk, Printer. 2. Features:  Advanced Multi-Functions USB 2.0 port: Web camera, LTE , USB WiFi LAN Card, 3G USB, Wimax as WAN, Hard disk, Printer  Supports DDNS  Gaming Optimized: Giga LAN Ethernet (Optional)  Multiple Wireless network BSSID (4 groups)  MIMO 300Mbps  Portable Pocket Tiny size 86(L) x 55(W) x 17(H) mm  Supports WEB based management and configuration.  Supports UPnP, IGMP Snooping & Proxy.  Supports Dynamic DNS, NTP client service.  Supports Log table and remote Log service.  Supports Setup Wizard mode.  Supports Wireless schedule.  Compatible with IEEE 802.11b/11g/11n Specifications.  Supports IEEE 802.3x full duplex flow control on 10/100M Ethernet interface.  Supports bridging, routing and WISP functions between wireless and wired Ethernet interfaces.  Supports IEEE 802.1x, 64-bit and 128-bit WEP, WPA, WPA2 encryption/decryption and WPA with Radius.  Supports DHCP server to provide clients auto IP addresses assignment and static DHCP functions.  Supports DHCP client, static IP, PPPoE, PPTP, L2TP of WAN Interface.  Supports firewall security with port filtering, IP filtering, MAC filtering, port forwarding, URL Filtering and DMZ hosting functions.  Supports AP mode, Client mode, WDS, AP+WDS and Universal Repeater.  Supports QoS which controls the bandwidth by IP or MAC address.  Supports Denial-of-Service.  Supports WPS (Wi-Fi Protected Setup). www.asiarf.com TEL: +886-2-29213598 FAX: +886-2-29214445 1F, No.2, Lane 45, Shuiyuan Street, Yonghe City Taipei County 234 Taiwan, R.O.C. page: 2  Supports WAPI (Wireless Authentication Privacy Infrastructure).  Supports Green Ethernet, IEEE802.3az draft2.0, EEE (Energy Efficient Ethernet). 3. Specification: Hardware Chipset RT3052 for 2T2R 300Mbps Operation Mode 3 sections switch, Client, AP/Bridge, Router Interface RJ45 x 2: 1 WAN, 1 LAN Reset and WPS button 1 button RF output and Antenna 2 inner Antennas Sensitivity -76dBm @ 54Mbps: 11g -91dBm @ 11Mbps: 11b -74dBm @ 135Mbps: 11n Power Consumption Voltage: 5V±5% Dimension, L x W x H 89 (L) x 58(W) x 15(H)mm Weight 15g Radom Material ABS Operating Temp 0°C~ +50°C Storage -10°C~ +65°C Humidity 5%~98% non-condensing Software Standard IEEE 802.11b/g, 802.11n Radio type IEEE 802.11g: OFDM(64-QAM, 16-QAM, QPSK, BPSK) IEEE 802.11b: DSSS(CCK/DQPSK/DBPSK) Data Rate IEEE 802.11n: 300Mbps IEEE 802.11g: 54Mbps IEEE 802.11b: 11Mbps Access Protocol CSMA/CA Number of operation channel 2.412~2.462GHz (Canada, FCC) / 11 Channels 2.412~2.484GHz (Japan, TELEC) / 14 Channels 2.412~2.472GHz (Euro, ETSI) / 13 Channels WAN  DHCP Client  Static IP  PPPoE (for ADSL)  L2TP www.asiarf.com TEL: +886-2-29213598 FAX: +886-2-29214445 1F, No.2, Lane 45, Shuiyuan Street, Yonghe City Taipei County 234 Taiwan, R.O.C. page: 3  PPTP Networking  DHCP Client/Relay/Server  Dynamic DNS  NTP Client  DNS Cache/Proxy  Firewall:  MAC/IP/Port Filter  Virtual Server  DMZ  Content Filter WIFI  2 Transmit and 2 Receive paths (2T2R)  20MHz/40MHz bandwidth  Support Multiple SSID  Support Hidden SSID  Support WPS  Clock rate up to 400MHz Legacy and High Throughput Modes  High security: WEP64/128,TKIP, WPA,WPA2 AES, mixed, 802.11i  802.1X Authentication with RADIUS Client  QoS-WMM, WMM-PS  Support WDS Security WEP 64/128、WPA、WPAII、WPA-PSK、802.1x support OS support Windows 7, Vista32/64, XP32/64, 2000, Linux 2.6, Mac 10.4 4. Package Content  AWAPN2403.a  Power Adaptor  Quick Installation guide  CD-ROM (Driver, User Manual) 5. Order Information 1. 300Mbps 2T2R with embedded antennas with USB port. AWAPN2403.a FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device must be installed to provide a separation distance of at least 20 cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter. NOTE 1: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

AsiaRF Co., Ltd Model: AWAPN2403 REPORT NO.: STR13038472I-1 FCC PART 15.247 EXHIBIT 2 - EUT EXTERNAL PHOTOGRAPHS EUT View 1 EUT View 2 AsiaRF Co., Ltd Model: AWAPN2403 REPORT NO.: STR13038472I-1 FCC PART 15.247 EUT View 3 EUT View 4 AsiaRF Co., Ltd Model: AWAPN2403 REPORT NO.: STR13038472I-1 FCC PART 15.247 EUT View 5 EUT View 6 AsiaRF Co., Ltd Model: AWAPN2403 REPORT NO.: STR13038472I-1 FCC PART 15.247 EUT View 7 EUT View 8

AsiaRF Co., Ltd Model: AWAPN2403 REPORT NO.: STR13038472I-1 FCC PART 15.247 EXHIBIT 1- PRODUCT LABELING Proposed FCC ID Label Format FCC ID: TKZAWAPN2403 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Specifications : Text is Black in color and justified. Labels are printed in indelible ink on permanent adhesive silk-screened onto the EUT or shall be affixed at a conspicuous location on the EUT. Proposed Label Location on EUT FCC ID Label Location

AsiaRF Co., Ltd Model: AWAPN2403 REPORT NO.: STR13038472I-1 FCC PART 15.247 EXHIBIT 1- PRODUCT LABELING Proposed FCC ID Label Format FCC ID: TKZAWAPN2403 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Specifications : Text is Black in color and justified. Labels are printed in indelible ink on permanent adhesive silk-screened onto the EUT or shall be affixed at a conspicuous location on the EUT. Proposed Label Location on EUT FCC ID Label Location

AsiaRF Co., Ltd Model: AWAPN2403 REPORT NO.: STR13038472I-1 FCC PART 15.247 EXHIBIT 3 - EUT INTERNAL PHOTOGRAPHS EUT Housing and Board View 1 EUT Housing and Board View 2 AsiaRF Co., Ltd Model: AWAPN2403 REPORT NO.: STR13038472I-1 FCC PART 15.247 Solder Board-Component View 1 Solder Board-Component View 2

RF Exposure Requirements Product Description: WiFi Router Model No.: AWAPN2403 FCC ID: TKZAWAPN2403 Acorrding to the KDB-447498 D01 V05, the following RF exposure evaluation shall to demonstrate RF exposure compliance. Wi-Fi (802.11b/g/n) Tx frequency range: 2412~2462MHz Device category: mobile device (Distance: 20cm and >190mm) Maximum Conducted Output Power: 17.34 dBm Maximum Antenna Gain: 1 dBi Maximum EIRP Output Power: 68.24 mW (18.34 dBm) Limit: 1496mW Source-based time-averaged EIRP output power is 68.24 mW < 1496 mW So the transmitter complies with the RF exposure requirements and the SAR is not required.

AsiaRF Co., Ltd. Model: AWAPN2403 REPORT NO.: STR13038472I-1 PAGE 1 OF 120 FCC PART 15.247 FCC Part 15C Measurement and Test Report For AsiaRF Co., Ltd. 3F, No.176, Yongzhen Road, Yonghe District, New Taipei City 234, Taiwan FCC ID: TKZAWAPN2403 FCC Rules: FCC Part 15C Product Description: WiFi Router Tested Model: AWAPN2403 Report No.: STR13038472I-1 Tested Date: 2013-03-18 to 2013-03-27 Issued Date: 2013-04-22 Tested By: Jack Li / Engineer Reviewed By: Lahm Peng / EMC Manager Approved & Authorized By: Jandy so / PSQ Manager Prepared By: SEM.Test Compliance Service Co., Ltd 3/F, Jinbao Commerce Building, Xin'an Fanshen Road, Bao'an District, Shenzhen, P.R.C.（518101） Tel.: +86-755-33663308 Fax.: +86-755-33663309 Website: www.semtest.com.cn Note: This test report is limited to the above client company and the product model only. It may not be duplicated without prior permitted by SEM.Test Compliance Service Co., Ltd AsiaRF Co., Ltd. Model: AWAPN2403 REPORT NO.: STR13038472I-1 PAGE 2 OF 120 FCC PART 15.247 TABLE OF CONTENTS 1. GENERAL INFORMATION ...................................................................................................................................4 1.1 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT)...............................................................................4 1.2 TEST STANDARDS...................................................................................................................................................5 1.3 TEST METHODOLOGY.............................................................................................................................................5 1.4 TEST FACILITY.......................................................................................................................................................5 1.5 EUT SETUP AND TEST MODE.................................................................................................................................6 2. SUMMARY OF TEST RESULTS ...........................................................................................................................7 3. RF EXPOSURE .........................................................................................................................................................8 3.1 STANDARD APPLICABLE.........................................................................................................................................8 3.2 TEST RESULT..........................................................................................................................................................8 4. ANTENNA REQUIREMENT ..................................................................................................................................9 4.1 STANDARD APPLICABLE.........................................................................................................................................9 4.2 EVALUATION INFORMATION..................................................................................................................................9 5. POWER SPECTRAL DENSITY ...........................................................................................................................10 5.1 STANDARD APPLICABLE.......................................................................................................................................10 5.2 TEST EQUIPMENT LIST AND DETAILS...................................................................................................................10 5.3 TEST PROCEDURE.................................................................................................................................................10 5.4 ENVIRONMENTAL CONDITIONS............................................................................................................................10 5.5 SUMMARY OF TEST RESULTS/PLOTS....................................................................................................................11 6. 6DB BANDWIDTH .................................................................................................................................................24 6.1 STANDARD APPLICABLE.......................................................................................................................................24 6.2 TEST EQUIPMENT LIST AND DETAILS...................................................................................................................24 6.3 TEST PROCEDURE.................................................................................................................................................24 6.4 ENVIRONMENTAL CONDITIONS............................................................................................................................24 6.5 SUMMARY OF TEST RESULTS/PLOTS....................................................................................................................25 7. RF OUTPUT POWER ............................................................................................................................................38 7.1 STANDARD APPLICABLE.......................................................................................................................................38 7.2 TEST EQUIPMENT LIST AND DETAILS...................................................................................................................38 7.3 TEST PROCEDURE.................................................................................................................................................38 7.4 ENVIRONMENTAL CONDITIONS............................................................................................................................38 7.5 SUMMARY OF TEST RESULTS/PLOTS....................................................................................................................39 8. FIELD STRENGTH OF SPURIOUS EMISSIONS ...…

Text truncated - open the document above for the full version.

AsiaRF Co., Ltd Model: AWAPN2403 REPORT NO.: STR13038472I-1 FCC PART 15.247 EXHIBIT 4 - TEST SETUP PHOTOGRAPHS Conducted Emission Test Setup Radiation Emission Test Setup (30MHz to 1GHz) AsiaRF Co., Ltd Model: AWAPN2403 REPORT NO.: STR13038472I-1 FCC PART 15.247 Radiation Emission Test Setup (Above 1GHz)