TQ6BTSHS102Bluetooth Stereo handset

BlueTone ™ BTSHS102 User Manual . 1 Bluetooth Stereo Headset User Manual Model：BlueTone ™ BTSHS102 BlueTone ™ BTSHS102 User Manual . 2 Declaration: Without written permission from original manufacturer, reproduction, transfer, distribution or storage of part or all of the contents in this document in any form is prohibited。 The company reserves rights to make any changes and improvements to the product described in this document without prior notice. Notice ： Please make sure your mobile phone supports bluetooth profiles and network operator supports the functions described in this manual, otherwise the relative functions can not be realized on this Stereo Headset device. Safety z Use the charger that comes with package. z Check the laws and regulations on the use of mobile phones in the areas where you drive. Always give full attention to driving and pull off the road and park before making or answering a call if driving conditions require. z Do not allow children to play with your Bluetooth car Stereo Headset since it contains small parts that could become detached and create a choking hazard z This device contains a Li-polymer battery. Please keep it away from fire anytime (including discarding the device) or the battery may explode z The Stereo Headset, especially the embedded battery must be properly disposed or may be recycled, contact your local recycling centers for disposal methods. BlueTone ™ BTSHS102 User Manual . 3 Certification and Safety Approvals This product has been tested and found to comply with Bluetooth BQB requirements, part 15 of FCC rules, R&TTE Directive（99/5/EC） or CE marked requirements. Warning：Users should not make changes or modify the device in any way. Changes or modifications without expressly approved by the party responsible for compliance could void the user’s authority to operate the device. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/ TV technician for help. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. RF exposure warning · The equipment complies with FCC RF exposure limits set forth for an uncontrolled environment. The equipment must not be co-located or operating in conjunction with any other antenna or transmitter. BlueTone ™ BTSHS102 User Manual . 4 1. INTRODUCTION ................................................................................................................................ 5 1.1 BLUETOOTH TECHNOLOGY.................................................................................................................. 5 1.2 PRODUCT FEATURES............................................................................................................................ 5 1.3 PACKAGE CONTENT............................................................................................................................. 6 1.4 OVERVIEW........................................................................................................................................... 6 1.5 KEY PRESS DURATION DEFINITIONS................................................................................................... 6 2. USING YOUR STEREO HEADSET.................................................................................................. 7 2.1 BATTERY CHARGING AND USAGE....................................................................................................... 7 2.1.1 Battery Charging......................................................................................................................... 7 2.1.2 Battery Information..................................................................................................................... 7 2.2 TURN ON/OFF STEREO HEADSET........................................................................................................ 7 2.3 AV MODE FUNCTIONS........................................................................................................................ 8 2.3.1 Connecting your Stereo Headset with AV Dongle ..................................................................... 8 2.3.2 Connecting your Stereo Headset with USB Dongle ................................................................... 8 2.3.3 Use AV Mode in your handset....................................................................................................9 2.3.4 AV Mode Operations.................................................................................................................. 9 2.4 CALL FUNCTIONS...................................................................................…

Text truncated - open the document above for the full version.

Shanghai Flaircomm Technologies Date: June 6, 2006 Federal Communications Commission Authorization and Evaluation Division FCC ID: TQ6BTSHS102 Confidentiality Request Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, the Applicant hereby requests confidential treatment of information accompanying this Application as outlined below: 1. Schematics 2. Block Diagram 3. Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457, disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Dawen Yang/engineer Shanghai Flaircomm Technologies

Data June 14, 2006 To: Federal Communications Commission, Authorization & Evaluation Division, 7435 Oakland Mills Road, Columbia, MD 21046 SuZhou EMC laboratory of QuitTek Technology (Suzhou) Co., Ltd. No.99 Hongye Rd., Suzhou Industrial Park Loufeng Hi-Tech Development Zone., SuZhou, China To Whom It May Concern: The Shanghai Flaircomm Technologies, the undersigned, hereby authorizes QuitTek Technology (Suzhou) Co., Ltd., to act on the behalf of the Shanghai Flaircomm Technologies. Solely in matters relating to the application for an FCC equipment authorization for FCC ID: TQ6BTSHS102 including the signing of documents in connection with this Application. Necessary acts carried out by Shanghai Flaircomm Technologies. On out behalf of the Shanghai Flaircomm Technologies. In connection with the Application shall have the same effect as acts of Shanghai Flaircomm Technologies. Shanghai Flaircomm Technologies. Also hereby certify that no party to this application is subject to a denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 853(a) Yours Sincerely, Mr Dawen Hardware engineer

Bluetooth Stereo handsets (BTSHS102) (1) EUT Photo (2) EUT Photo

11 111P000012A0 技术要求: 1. 材质: 透明PP贴纸 2. 印刷色:80%黑色,耐磨,不脱落 3. 成品不保留黑线框,切边应平直 4. 公差:0.5 5. Size:30*5mm 4R-2 机身标贴(透明PP) 1:1 2:1 慧翰信息技术有限公司 200600606 (BTSHS102) FCC ID:TQ6BTSHS102 FCC ID:TQ6BTSHS102

Bluetooth Stereo handsets (BTSHS102) FCC Label Position FCC Label Position

Bluetooth Stereo handsets (BTSHS102) (1) EUT Photo (2) EUT Photo (3) EUT Photo (4) EUT Photo (5) EUT Photo 6) EUT Photo (7) EUT Photo

Report No. 066L049 Page: 1 of 3 Version: 1.0 RF Exposure Evaluation declaration Product Name : Bluetooth Stereo handsets Model No. : BTSHS102 FCC ID. : TQ6BTSHS102 Applicant : Shanghai Flaircomm Technologies Address : No211 North Urumqi Road, Suite 616, Shanghai 200040 P.R. China Date of Receipt : April 20, 2006 Date of Declaration: June 13, 2006 Report No. : 066L054 The declaration results relate only to the samples calculated. The declaration shall not be reproduced except in full without the written approval of QuieTek Corporation. Report No. 066L049 Page: 2 of 3 Version: 1.0 1. RF Exposure Evaluation 1.1. Limits According to FCC 1.1310: The criteria listed in the following table shall be used to evaluate the environment impact of human exposure to radio frequency (RF) radiation as specified in 1.1307(b) LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) Frequency Range (MHz) Electric Field Strength (V/m) Magnetic Field Strength (A/m) Power Density (mW/cm 2 ) Average Time (Minutes) (A) Limits for Occupational/ Control Exposures 300-1500 -- -- F/300 6 1500-100,000 -- -- 5 6 (B) Limits for General Population/ Uncontrolled Exposures 300-1500 -- -- F/1500 6 1500-100,000 -- -- 1 30 F= Frequency in MHz Friis Formula Friis transmission formula: Pd = (Pout*G)/(4*pi*r 2 ) Where Pd = power density in mW/cm 2 Pout = output power to antenna in mW G = gain of antenna in linear scale Pi = 3.1416 R = distance between observation point and center of the radiator in cm Pd id the limit of MPE, 1 mW/cm 2 . If we know the maximum gain of the antenna and the total power input to the antenna, through the calculation, we will know the distance r where the MPE limit is reached. 1.2. Test Procedure Software provided by client enabled the EUT to transmit and receive data at lowest, middle and highest channel individually. The temperature and related humidity: 18°Cand 78％ RH. Report No. 066L049 Page: 3 of 3 Version: 1.0 1.3. Test Result of RF Exposure Evaluation Product : Bluetooth Stereo handsets Test Item : RF Exposure Evaluation Test Site : AC-3 Test Mode : Transmitter Antenna Gain Antenna Gain: The maximum Gain measured in fully anechoic chamber is 0dBi or 1.0 in linear scale. Output Power Into Antenna & RF Exposure Evaluation Distance: Channel Channel Frequency (MHz) Output Power to Antenna (mW) Power Density at R = 2.5 cm (mW/cm 2 ) 1 2402.00 1.1117 0.0142 6 2441.00 0.9550 0.0122 11 2480.00 0.8472 0.0108 The power density Pd (4th column) at a distance of 2.5 cm calculated from the Friis transmission formula is far below the limit of 1 mW/cm 2 .

Report No. 066L054-RF-US-P05V01 Page: 1 of 45 Version:1.0 Test Report Product Name : Bluetooth Stereo handsets Model No. : BTSHS102 FCC ID. : TQ6BTSHS102 Applicant : Shanghai Flaircomm Technologies Address : No211 North Urumqi Road, Suite 616, Shanghai 200040 P.R. China Date of Receipt : April 20, 2006 Issued Date : June 13, 2006 Report No. : 066L054-RF-US-P05V01 The Test Results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by NVLAP any agency of the U.S. Government Report No. 066L054-RF-US-P05V01 Page: 2 of 45 Version:1.0 Test Report Certification Issued Date: June 13, 2006 Report No.: 066L054-RF-US-P05V01 Product Name : Bluetooth Stereo handsets Applicant : Shanghai Flaircomm Technologies Address : No211 North Urumqi Road, Suite 616, Shanghai 200040 P.R. China Manufacturer : Shanghai Flaircomm Technologies Model No. : BTSHS102 FCC ID. : TQ6BTSHS102 Rated Voltage : AC 120V/60Hz Working Voltage : DC 3.7V Trade Name : Flaircomm Applicable Standard : FCC CFR Title 47 Part 15 Subpart C: 2005 ANSI C63.4: 2003 CISPR 22: 2005 Test Result : Complied The Test Results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by NVLAP any agency of the U.S. Government Documented By : ( Mandy Liu ) Tested By : ( Alex Chiu ) Approved By : (Gene Zhang) Report No. 066L054-RF-US-P05V01 Page: 3 of 45 Version:1.0 TABLE OF CONTENTS Description Page 1. GENERAL INFORMATION ...............................................................................................................5 1.1. EUT Description......................................................................................................................................5 1.2. Operational Description...........................................................................................................................7 1.3. Tested System Details..............................................................................................................................8 1.4. Configuration of Tested System ..............................................................................................................9 1.5. EUT Exercise Software ...........................................................................................................................9 1.6. Test Facility ...........................................................................................................................................10 2. CONDUCTED EMISSION ................................................................................................................ 11 2.1. Test Equipment ......................................................................................................................................11 2.2. Test Setup ..............................................................................................................................................11 2.3. Limits.....................................................................................................................................................12 2.4. Test Procedure .......................................................................................................................................12 2.5. Uncertainty ............................................................................................................................................12 2.6. Test Result of Conducted Emission .......................................................................................................13 3. PEAK POWER OUTPUT ..................................................................................................................19 3.1. Test Equipment ......................................................................................................................................19 3.2. Test Setup ..............................................................................................................................................19 3.3. Limit .....................................................................................................................................................19 3.4. Uncertainty ............................................................................................................................................19 3.5. Test Result of Peak Power Output .........................................................................................................20 4. RADIATED EMISSION .....................................................................................................................21 4.1. Test Equipment ......................................................................................................................................21 4.2. Test Setup ..............................................................................................................................................22 4.3. Limits.....................................................................................................................................................22 4.4. Test Procedure .......................................................................................................................................23 4.5. Uncertainty ............................................................................................................................................23 4.6. Test Result of Radiated Emission ..........................................................................................................24 5. BAND EDGE .......................................................................................................................................42 5.1. Test Equipment .......................…

Text truncated - open the document above for the full version.

Bluetooth Stereo handsets (BTSHS102) Test Mode : Mode 1: Transmitter Description : Front View of Conducted Test Test Mode : Mode 1: Transmitter Description : Back View of Conducted Test Test Mode : Mode 1: Transmitter Description : Front View of Radiated Test for Under 1GHz Test Mode : Mode 1: Transmitter Description : Back View of Radiated Test for Under 1GHz Test Mode : Mode 1: Transmitter Description : Front View of Radiated Test for Above 1GHz Test Mode : Mode 1: Transmitter Description : Back View of Radiated Test for Above 1GHz