TXRFPT0912Remote Grill Thermometer

Warning: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC IMPORTANT NOTE: Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.

EXHIBIT B - EUT EXTERNAL PHOTOGRAPHS EUT– Full View EUT– Front View EUT– Side View EUT– Top View EUT– Bottom View

EXHIBIT A - FCC ID LABELING AND LOCATION

EXHIBIT C - EUT INTERNAL PHOTOGRAPHS EUT- Battery Remove View EUT- Cover off View EUT– Internal View EUT- Main Board TopView EUT- Main Board Bottom View EUT- RF Module Top View Antenna EUT- RF Module Bottom View EUT- Switch View EUT – Temperature Probe View

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. This report must not be used by the customer to claim product certification, approval, or endorsement by NVLAP*, NIST, or any agency of the Federal Government. * This report may contain data that are not covered by the NVLAP accreditation and are marked with an asterisk “*” (Rev.2) FCC PART 15.231 MEASUREMENT AND TEST REPORT For Yangzhou Fupond Electronic Technology Corp., Ltd. Hangji Industrial Park, Yangzhou, Jiangsu Province, China FCC ID: TXRFPT0912 Report Type: Original Report Product Type: Remote Grill Thermometer(Transmitter) Test Engineer: Sula Huang Report Number: RSZ09112601 Report Date: 2010-01-05 Reviewed By: Merry Zhao EMC Engineer Prepared By: Bay Area Compliance Laboratories Corp. (Shenzhen) 6/F, the 3rd Phase of WanLi Industrial Building, ShiHua Road, FuTian Free Trade Zone Shenzhen, Guangdong, China Tel: +86-755-33320018 Fax: +86-755-33320008 Yangzhou Fupond Electronic Technology Corp., Ltd FCC ID: TXRFPT0912 Report #: RSZ09112601 Page 2 of 18 FCC Part15.231 Test Report TABLE OF CONTENTS GENERAL INFORMATION.......................................................................................................................................3 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ....................................................................................3 EUT PHOTOGRAPH......................................................................................................................................................3 OBJECTIVE...................................................................................................................................................................3 RELATED SUBMITTAL(S)/GRANT(S).............................................................................................................................4 TEST METHODOLOGY..................................................................................................................................................4 TEST FACILITY.............................................................................................................................................................4 SYSTEM TEST CONFIGURATION ..........................................................................................................................5 JUSTIFICATION.............................................................................................................................................................5 SPECIAL ACCESSORIES.................................................................................................................................................5 EQUIPMENT MODIFICATIONS.......................................................................................................................................5 EXTERNAL I/O CABLE..................................................................................................................................................5 CONFIGURATION OF TEST SETUP.................................................................................................................................5 BLOCK DIAGRAM OF TEST SETUP................................................................................................................................5 SUMMARY OF TEST RESULTS...............................................................................................................................6 CFR47 §15.203 - ANTENNA REQUIREMENT.........................................................................................................7 STANDARD APPLICABLE..............................................................................................................................................7 CFR47 §15.205, §15.209, §15.35(C) & §15.231(E) - RADIATED EMISSIONS.......................................................8 MEASUREMENT UNCERTAINTY....................................................................................................................................8 EUT SETUP..................................................................................................................................................................8 EMI TEST RECEIVER SETUP.........................................................................................................................................8 TEST EQUIPMENT LIST AND DETAILS...........................................................................................................................9 TEST PROCEDURE........................................................................................................................................................9 APPLICABLE STANDARD..............................................................................................................................................9 CORRECTED AMPLITUDE & MARGIN CALCULATION...................................................................................................9 TEST RESULTS SUMMARY..........................................................................................................................................10 TEST DATA................................................................................................................................................................10 CFR47 §15.231(C) – 20 DB BANDWIDTH TESTING ............................................................................................14 REQUIREMENT...........................................................................................................................................................14 TEST EQUIPMENT LIST AND DETAILS.........................................................................................................................14 TEST PROCEDURE…

Text truncated - open the document above for the full version.

EXHIBIT D - TEST SETUP PHOTOGRAPHS Radiated Emission – Stand Front View (Below 1 GHz) Radiated Emission – Stand Rear View (Below 1 GHz) Radiated Emission – Stand Front View (Above 1 GHz) Radiated Emission – Stand Rear View (Above 1 GHz)