U5X-RE203Security Panic Transmitter

Resolution RE203 Wireless Panic Transmitter User and Installation Instructions Introduction The RE203 Wireless Panic Transmitter is a wireless 1-button transmitter for security system use. Typical use of this device is for sending a panic alarm to the system. The transmitter is shown in Figure 1. Figure 1: RE203 Successful activation of the transmitter is indicated by a short, bright LED flash. The Wireless Panic Transmitter uses a small lithium coin cell battery, designed to provide long battery life. Transmitter Programming Each RE203 Wireless Panic Transmitter is shipped with a unique serial number pre-programmed into the transmitter. Upon installation, the RE203 must be programmed into the security control panel. The control panel's documentation should be consulted for full instructions. Specifications Dimensions: 1.125 x 1.5 x 0.5” RF transmission frequency: 345.025MHz Operating Temperature: 10º to 120ºF (-12º to 49ºC) Battery Type: CR2032 Lithium Coin Cell FCC Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1.This device may not cause harmful interference. 2.This device must accept any interference that may be received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the Resolution Engineering, Inc could void the user's authority to operate this equipment. FCC ID: U5X-RE203 IC Notice This product meets the applicable Industry Canada technical specifications/Le présent materiel est conforme aux specifications techniques applicables d’Industrie Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. IC: 8310A-RE203

August 20, 2010 RE: U5X-RE203 Confidentiality To Whom It May Concern: The following information is to be held confidential pursuant of 47 CFR Part 0 ｧ0.459 and Section 552(b)(4) of the Freedom of Information Act, because the information provided contains trade secrets and is proprietary. If made public, the information might be used to our disadvantage as in the market place. lSchematics lTechnical Product Description/Operational Description lBlock Diagram Sincerely, Paul Saldin Vice President Resolution Products, Inc.

Exhibit A RE203 External Photo Back

Exhibit B RE203 External Photo Front

Exhibit A RE203 External Photo Back

Exhibit C RE203 Internal Photo Back

Exhibit D RE203 Internal Photo Front

360 Herndon Parkway, Suite 1400 Herndon, VA 20170 Tel: 703-689-0368 Fax: 703-689-2056 Page 1 of 5 Engineering and Testing for EMC and Safety Compliance Radiated Test Data for Model: Wrist Panic for Resolution Engineering RTL Project Number 2010090 Test Engineer: Jon Wilson 360 Herndon Parkway, Suite 1400 Herndon, VA 20170 Tel: 703-689-0368 Fax: 703-689-2056 Page 2 of 5 Radiated Test Data - OATS 1 Test Date: May 21, 2010 Work Order: 2010090 Customer Reference: na Model: Wrist Panic Name: Jon Wilson Limit/Distance: FCC B/3m RTL Barcode# 019540 Emission Frequency (MHz) Test Detector Analyzer Reading (dBuV) Site Correction Factor (dB/m) Emission Level (dBuV/m) Limit (dBuV/m) Margin (dB) Pass/ Fail 345.027 Pk 54.2 29.7 83.9 97.3 -13.4 Pass 690.023 Pk 53.4 -3.3 50.1 77.3 -27.2 Pass 1035.030 Pk 42.4 2.5 44.9 77.3 -32.4 Pass 1380.047 Pk 37.9 8.4 46.3 77.3 -31.0 Pass 1725.048 Pk 32.5 13.1 45.6 77.3 -31.7 Pass 2070.162 Pk 44.3 9.2 53.5 77.3 -23.8 Pass 2415.189 Pk 32.0 10.0 42.0 77.3 -35.3 Pass 2760.216 Pk 31.5 10.2 41.7 77.3 -35.6 Pass 3105.243 Pk 32.3 8.4 40.7 77.3 -36.6 Pass 3450.270 Pk 29.8 9.1 38.9 77.3 -38.4 Pass 360 Herndon Parkway, Suite 1400 Herndon, VA 20170 Tel: 703-689-0368 Fax: 703-689-2056 Page 3 of 5 360 Herndon Parkway, Suite 1400 Herndon, VA 20170 Tel: 703-689-0368 Fax: 703-689-2056 Page 4 of 5 360 Herndon Parkway, Suite 1400 Herndon, VA 20170 Tel: 703-689-0368 Fax: 703-689-2056 Page 5 of 5 Radiated Emissions Test Equipment Part Manufacturer Model Serial Number RTL Bar Code Calibration Due Date Amplifier (20 MHz-2 GHz) Rhein Tech Laboratories, Inc. PR-1040 900905 900905 5/10/2011 Bilog Periodic Antenna (25 MHz-2 GHz) Schaffner Chase CBL6112 2099 900791 12/12/2010 EMI Receiver RF Section (9 KHz-6.5 GHz) Hewlett Packard 85462A 3325A00159 900913 6/8/2010 RF Filter Section (100 KHz-6.5 GHz) Hewlett Packard 85460A 3330A00107 900914 6/8/2010 Spectrum Analyzer Hewlett Packard 8596EM 3826A00144 901215 11/23/2010 Preamplifier 1-26.5 GHz Hewlett Packard 8449B OPT H02 3008A00505 900932 2/22/2011 Horn Antenna, 2.0-4.0 GHz EMCO 3161-02 9804-1044 900772 6/13/2010 Emissions Testing Software Rhein Tech Laboratories, Inc. Automated Emission Tester Rev. 14.0.2 N/A N/A

Resolution Products, Inc. Wireless Panic Transmitter FCC ID: U5X-RE203 Certification Test Report August 20, 2010 U5X-RE203 Resolution Products, Inc.08/20/10Page 1 of 9 Test Report 226 Locust Street, Suite 4 Hudson, WI 54016 Contents 1. Introduction.................................................................................................................................................................3 2. Statement of Compliance............................................................................................................................................3 2.1. FCC Part 2 §2.907................................................................................................................................................3 2.2. FCC Part 2 §2.911................................................................................................................................................3 2.3. FCC Part 2 §2.913................................................................................................................................................3 2.4. FCC Part 2 §2.915................................................................................................................................................3 2.5. FCC Part 2 §2.925................................................................................................................................................3 2.6. FCC Part 2 §2.943, 2.945....................................................................................................................................4 2.7. FCC Part 2 §2.947................................................................................................................................................4 2.8. FCC Part 2 §2.948................................................................................................................................................4 2.9. FCC Part 2 §2.1033..............................................................................................................................................5 3. Discussion of Laboratory Measurements and Rules Compliance...............................................................................6 3.1. FCC Part 15 §15.231(a)(1)..................................................................................................................................6 3.2. FCC Part 15 §15.231(a)(3)..................................................................................................................................6 3.3. FCC Part 15 §15.231(a)(4)..................................................................................................................................7 3.4. FCC Part 15 §15.231(a)(5)..................................................................................................................................7 3.5. FCC Part 15 §15.231(b).......................................................................................................................................7 3.5.1. Raw Field Strength Limits............................................................................................................................7 3.5.2. Duty Cycle Correction Factor and Resulting Limits.....................................................................................7 3.5.3. Measured Radiated Field Strength Data.......................................................................................................8 3.6. FCC Part 15 §15.231(c).......................................................................................................................................9 U5X-RE203 Resolution Products, Inc.08/20/10Page 2 of 9 Test Report 226 Locust Street, Suite 4 Hudson, WI 54016 1.Introduction This device is a handheld wireless transmitter for use in a wireless security system. The unit is powered by a 3V lithium battery. The transmitter is centered at 345.027MHz and is controlled by a SAW resonator. The device measures 1.125 x 1.5 x 0.5” and weighs approximately half an ounce. This transmitter is manually activated via a pushbutton switch. Transmission packets are sent by the device upon valid activation. These packets are 16.15ms in length and are sent with a random spacing of 170ms to 330ms. The device will continue sending packets for the pendency of the alarm condition, as allowed, as long as the switch is held down by the user. Upon release of the switch, 12 packets are sent to signal the release. The unit then goes into sleep mode and will not transmit again until another valid keypress is detected. Three supervisory packets are sent by the device every hour, with the same random spacing described above. Certification is requested under FCC Rules, Part 15, Subpart C, Paragraph 15.231. 2.Statement of Compliance Specific sections of FCC Rules Part 2 that require information or listing are given below. 2.1.FCC Part 2 §2.907 This is an application for certification of original equipment 2.2.FCC Part 2 §2.911 a)This application has been filed electronically using form 731. b)All required information has been supplied in this application and its attachments. c)This application has been electronically signed by an officer of Resolution Products, Inc. d)The technical test data has been signed by the agency performing the testing. e)Signature supplied in appropriate block on form 731. f)Processing fee has been paid by credit card. g)Signatures have been supplied electronically. 2.3.FCC Part 2 §2.913 a)This application has been filed electronically. b)Appropriate fees have been filed electronically. c)Equipment samples shall be supplied as requested. 2.4.FCC Part 2 §2.915 We are requesting a grant of certification. This application shows compliance with the technical standards. 2.5.FCC Part 2 §2.925 A label shall be affixed to each piece of equipment, showing the FCC identifier. The label shall read “FCC ID: U5X- RE203”. The photograph below shows the label and location on t…

Text truncated - open the document above for the full version.


            ! "# $   %     &'(")!   *"+(", -
%..
 
 /% 0 (1(1   2 2      3456789:;5<8=6>?8 

            ! "# $   %     &'(")!   *"+(", -
%..
 
 /% 0 (1(1   2 2      345678947:8;6<=