U9R-W2CBW009SWLAN-Bluetooth Module

Wi2Wi, Inc. Rev.1.1 Data Sheet, WLAN-Bluetooth Module– W2CBW009S Dated: October 20, 2009 Product Datasheet Revision 1.1 October 20, 2009 Wi2Wi, Inc. Rev.1.1 Data Sheet, WLAN-Bluetooth Module– W2CBW009S Dated: October 20, 2009 The content of this document is to be treated as strictly confidential and is not to be disclosed, Reproduced or used, except as authorized in writing by Wi2Wi, Inc. Copyright © 2009 Wi2Wi, Inc. Page 2 of 20 Table of Contents 1 General Description...........................................................................................................3 2 Features ..............................................................................................................................4 3 System Description ............................................................................................................5 3.1 Block Diagram ..........................................................................................................................5 3.2 Pin Description .........................................................................................................................5 4 Electrical Characteristics..................................................................................................8 5 WLAN External Host Interfaces....................................................................................10 5.1 SDIO Interface........................................................................................................................10 5.2 SDIO Protocol Timing Diagrams ............................................................................................11 5.3 G-SPI Interface.......................................................................................................................12 6 Bluetooth External Interfaces.........................................................................................13 6.1 UART Interface.......................................................................................................................13 6.2 PCM Interface ........................................................................................................................14 7 Antenna and Clock ..........................................................................................................14 8 Software Specifications ...................................................................................................15 8.1 Wireless LAN..........................................................................................................................15 8.2 Bluetooth ................................................................................................................................16 9 WLAN Software Architecture........................................................................................17 9.1 Host Processor.......................................................................................................................18 10 Manufacturing Notes.......................................................................................................18 10.1 Physical Dimensions and Pin Locations ................................................................................18 10.2 Storage and Baking Instructions ............................................................................................19 10.3 Recommended Reflow Profile................................................................................................19 11 Disclaimers .......................................................................................................................19 11.1 Data Sheet Status ..................................................................................................................19 12 Certifications ....................................................................................................................20 13 References.........................................................................................................................20 13.1 Specifications .........................................................................................................................20 13.2 Trademarks, Patents and Licenses .......................................................................................20 13.3 Other ......................................................................................................................................20 Wi2Wi, Inc. Rev.1.1 Data Sheet, WLAN-Bluetooth Module– W2CBW009S Dated: October 20, 2009 The content of this document is to be treated as strictly confidential and is not to be disclosed, Reproduced or used, except as authorized in writing by Wi2Wi, Inc. Copyright © 2009 Wi2Wi, Inc. Page 3 of 20 List of Figures: Figure 1: Block Diagram .......................................................................................................... 5 Figure 2: SDIO Protocol Timing ............................................................................................ 11 Figure 3: Software Architecture.............................................................................................. 17 Figure 4: Physical Dimensions and Pin Locations for a Dual Antenna Device ..................... 18 Figure 5: Reflow Profile ......................................................................................................... 19 List of Tables: Table 1: Pin Description ........................................................................................................... 5 Table 2: Electrical Characteristics ............................................................................................8 Table 3: SDIO Pin Map ..........................................................................................................11 Table 4: SDIO Timing Data.................................................................................................... 12 Table 5: GSPI Pin Map ..............…

Text truncated - open the document above for the full version.

Wi2Wi, Inc. FCC ID: U9R-W2CBW009S Report Number: R1003232-247 Page 81 of 83 FCC Part 15.247 Test Report 18 Exhibit C - EUT Photographs 18.1 EUT – Top View 18.2 EUT – Bottom View Wi2Wi, Inc. FCC ID: U9R-W2CBW009S Report Number: R1003232-247 Page 82 of 83 FCC Part 15.247 Test Report 18.3 EUT on the Supporting Board View 1 18.4 EUT on the Supporting Board View 2

Wi2Wi, Inc. FCC ID: U9R-W2CBW009S Report Number: R1003232-247 Page 77 of 83 FCC Part 15.247 Test Report 16 Exhibit A - FCC Equipment Labeling Requirements 16.1 FCC ID Label Requirements As per FCC §2.925, (a) Each equipment covered in an application for equipment authorization shall bear a nameplate or label listing the following: (1) FCC Identifier consisting of the two elements in the exact order specified in §2.926. The FCC Identifier shall be preceded by the term FCC ID in capital letters on a single line, and shall be of a type size large enough to be legible without the aid of magnification. Example: FCC ID XXX123. XXX—Grantee Code 123—Equipment Product Code As per FCC §15.19, (a) In addition to the requirements in part 2 of this chapter, a device subject to certification, or verification shall be labeled as follows: (3) All other devices shall bear the following statement in a conspicuous location on the device: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. (4) Where a device is constructed in two or more sections connected by wires and marketed together, the statement specified above is required to be affixed only to the main control unit. If the EUT is integrated within another device then a label affixed to the host shall also state, “Contains FCC ID: XXXXXX” (5) When the device is so small or for such use that it is not practicable to place the statement specified under paragraph (a) of this section on it, the information required by this paragraph shall be placed in a prominent location in the instruction manual or pamphlet supplied to the user or, alternatively, shall be placed on the container in which the device is marketed. However, the FCC identifier or the unique identifier, as appropriate, must be displayed on the device. 16.2 FCC ID Label and Label Location

Wi2Wi, Inc. FCC ID: U9R-W2CBW009S Report Number: R1003232-247 Page 83 of 83 FCC Part 15.247 Test Report 18.5 EUT without shielding View ***** END OF REPORT *****

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. This report must not be used by the customer to claim product certification, approval, or endorsement by NVLAP*, NIST, or any agency of the Federal Government. * This report may contain data that are not covered by the NVLAP accreditation and are marked with an asterisk “*” (Rev.2) FCC PART 15.247 TEST AND MEASUREMENT REPORT For Wi2Wi, Inc. 2107 N. 1 st Street, Ste.540, San Jose, CA 95131, USA FCC ID: U9R-W2CBW009S Model:W2CBW009-S Report Type: Original Report Product Type: Wireless 802.11b/g and Bluetooth Module Test Engineers: Jerry Huang Report Number: R1003232-247 Report Date: 2010-08-09 Reviewed By: Victor Zhang Test Engineer, RF Lead Prepared By: (84) Bay Area Compliance Laboratories Corp. 1274 Anvilwood Avenue, Sunnyvale, CA 94089, USA Tel: (408) 732-9162 Fax: (408) 732-9164 Wi2Wi, Inc. FCC ID: U9R-W2CBW009S Report Number: R1003232-247 Page 2 of 83 FCC Part 15.247 Test Report TABLE OF CONTENTS 1 General Description ..................................................................................................................................................... 5 1.1 Product Description for Equipment Under Test (EUT) ....................................................................................... 5 1.2 Mechanical Description of EUT .......................................................................................................................... 5 1.3 Objective.............................................................................................................................................................. 5 1.4 Related Submittal(s)/Grant(s) .............................................................................................................................. 5 1.5 Test Methodology................................................................................................................................................ 5 1.6 Measurement Uncertainty.................................................................................................................................... 5 1.7 Test Facility ......................................................................................................................................................... 6 2 System Test Configuration.......................................................................................................................................... 7 2.1 Justification.......................................................................................................................................................... 7 2.2 EUT Exercise Software ....................................................................................................................................... 7 2.3 Equipment Modifications .................................................................................................................................... 7 2.4 Special Accessories ............................................................................................................................................. 7 2.5 Local Support Equipment .................................................................................................................................... 7 2.6 EUT Internal Configuration Details .................................................................................................................... 7 2.7 Interface Ports and Cabling ................................................................................................................................. 7 3 Summary of Test Results............................................................................................................................................. 8 4 FCC §15.247 (i) & § 2.1091 RF Exposure .................................................................................................................. 9 4.1 Applicable Standard ............................................................................................................................................ 9 4.2 MPE Prediction.................................................................................................................................................... 9 4.3 MPE Results ........................................................................................................................................................ 9 5 FCC §15.203 – Antenna Requirements...................................................................................................................... 10 5.1 Applicable Standard .......................................................................................................................................... 10 5.2 Antenna Connector Construction....................................................................................................................... 10 6 FCC §15.207 - Conducted Emissions ......................................................................................................................... 11 6.1 Applicable Standard .......................................................................................................................................... 11 6.2 Test Setup .......................................................................................................................................................... 11 6.3 Test Equipment List and Details........................................................................................................................ 11 6.4 Test Procedure ................................................................................................................................................... 12 6.5 Test Setup Block Diagram..........................................................…

Text truncated - open the document above for the full version.

Wi2Wi, Inc. FCC ID: U9R-W2CBW009S Report Number: R1003232-247 Page 78 of 83 FCC Part 15.247 Test Report 17 Exhibit B - Test Setup Photographs 17.1 Radiated Emission below 1 GHz Front View @ 3 Meter 17.2 Radiated Emission below 1 GHz Rear View @ 3 Meter Wi2Wi, Inc. FCC ID: U9R-W2CBW009S Report Number: R1003232-247 Page 79 of 83 FCC Part 15.247 Test Report 17.3 Radiated Emission above 1 GHz Front View @ 3 Meter 17.4 Radiated Emission above 1 GHz Front View @ 3 Meter Wi2Wi, Inc. FCC ID: U9R-W2CBW009S Report Number: R1003232-247 Page 80 of 83 FCC Part 15.247 Test Report 17.5 AC Line Conducted Emission Front View 17.6 AC Line Conducted Emission Side View