VEPGL-PETCOLLARPositive Pet collar

Positive Pet Vibration Training Collar Instruction Manual Getting Started Included In Your Package Positive Pet Trainer Nylon Collar Strap Micro USB Charging Cable Remote Control 3. Place it on Your Pet The Positive Pet comes with a nylon collar strap that can be trimmed down to fit your pet, or you may use your own standard-size collar. To insert the collar strap, push the sliding door on the side of the device in the direction of the arrow. Insert the strap and slide the door back into place. To turn ON the Positive Pet Collar, hold the power button for 1–2 seconds or until the blue LED flashes and you feel the vibration motor activate. To turn OFF the Positive Pet Collar, hold the power button for 1–2 seconds or until the blue LED flashes. The blue indicator light will flash for about 5 seconds. Insert the nylon collar strapActivation Interchangeable Magnetic Vibration Plates 2. Power On & Off 1. Charge it Up Before getting started, charge your Positive Pet Collar for at least 5 hours until the blue charging indicator light turns off. The blue LED will light up and remain on while charging. To access the charging port, push the sliding door in the direction of the arrow. 3 Magnetic Plates Charging Port LED Indicator Light SMOOTH PLATE for short-haired pets ROUND BUMPS for medium-haired pets POINTY BUMPS for long-haired pets NOTE: The Positive Pet Trainer should be positioned on the collar so that the bumps on the magnetic vibration plates sit against your pet’s neck. When placed on your pet properly, the LED indicator on the Positive Pet Trainer should face out. Activate the device using the remote. When the device is activated the blue LED indicator light will flash. A single press of the remote will activate the Positive Pet vibration motor. The device will activate continuously with constant pressure on the remote button. The remote will activate the Positive Pet up to 55 feet (16m) away. Positive Pet Vibration Training Collar Instruction Manual Note This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. Caution Changes or Modifications not expressly approved by the party responsible could void the user’s authority to operate this device. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ©2020 Good Life, Inc. DESIGNED IN OREGON MADE IN CHINA 4. Tips for Best Results - When fitting the Positive Pet collar, leave two fingers’ width between the nylon strap and your pet’s neck. - If the collar is too long, cut the nylon strap to the proper length, and carefully seal the cut end with a flame as needed. - Check the collar periodically to ensure a proper fit. - Consistency is key to proper training. More Details Toll Free: 1-800-657-8214 Outside US: 1-541-245-4488 Website: ultimatebarkcontrol.com Email: [email protected] We’re Here to Help CONTACT US ISED Statement CE Statement This device complies with contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. The simplified EU declaration of conformity referred to in Article 10(9) shall be provided as follows: Hereby, Good Life, Inc. declares that the radio equipment type Positive pet collar UBC-PPD and UBC-PPC is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: ultimatebarkcontrol.com/pages/declarations. The frequency range: 433.92MHz, the max. power is 10dBm. FCC Statement Model Numbers: UBC-PPC; UBC-PPD FCC ID: VEPGL-PETCOLLAR IC: 11708A-PETCOLLAR

K-MarkIndustrialLimited.C5266091_X8_Ed.1 1/1 LetterofAuthorization Company:K-MarkIndustrialLimited. Address:FlatA,7/F.,MaiOnlnd.Bldg.,17-21,KungYipSt.,KwaiChung,HongKong ProductName:PositivePetCollar ModelNumber:UBC-PPC,UBC-PPD FCCIdentifier:VEPGL-PETCOLLAR WeauthorizeLGAITechnologicalCenterS.A.,RondadelaFontdelCarme,s/n, 08193Bellaterra,Spain,toactonourbehalfonallmattersconcerningthe abovenamedequipment. AnyindividualwithinLGAITechnologicalCenterS.A.isauthorizedtoactonour behalfandtakeactionontheapplication. WedeclarethatauthorizeLGAITechnologicalCenterS.A.,RondadelaFontdel Carme,s/n,08193Bellaterra,Spain,isallowedtoforwardallinformation relatedtotheapprovalprojecttotheFederalCommunicationCommissionand todiscussanyissuesconcerningtheapprovalapplication.Anyandallacts carriedoutbyLGAITechnologicalCenterS.A.onourbehalfshallhavethe sameeffectasactsofourown. Name:RichardTamDate:2020.11.19 Title:ProjectManager Signatureofapplicant:

K-MarkIndustrialLimited.C5266091_X10_Ed.1 1/1 OfficeofEngineeringTechnology FederalCommunicationsCommission 7435OaklandMillsRoad Columbia,MD21046 Date: 2020.11.19 Subject:RequestforConfidentiality FCCID:VEPGL-PETCOLLAR ToWhomItMayConcern, PursuanttotheprovisionsofSections0.457and0.459ofCommission'srules (47CFR0.457,0.459),wearerequestingtheCommissiontowithholdthefollowing attachment(s)asconfidentialdocumentfrompublicdisclosure. ExhibitsLong-Term Confidentiality Short-Term Confidentiality IDLabel/LocationNoNo AttestationStatementNoNo ExternalPhotosNo BlockDiagram Schematics TestReportNoNo TestSetupPhotosNo User’sManual InternalPhotos PartsList/TuneUp RFExposureInfo OperationalDescription CoverLetter(s)NoNo SDRSoftware/SecurityInfoNo Abovementioneddocumentcontainsdetailedsystemandequipmentdescriptionare consideredasproprietaryinformationinoperationoftheequipment.Thepublic disclosureofabovedocumentsmightbeharmfultoourcompanyandwouldgive competitoranunfairadvantageinthemarket. Itisourunderstandingthatallmeasurementtestreports,FCCIDlabelformatand correspondentduringcertificationreviewprocesscannotbegrantedasconfidential documentsandthoseinformationwillbeavailableforpublicreviewoncethegrantof equipmentauthorizationisissued. Sincerely, Signature: Name:RichardTam Title: ProjectManager

FCC ID: VEPGL-PETCOLLAR

Page1 of 3 InternalPhotosof EUT TX EUT-1 EUT-2 FCC ID: VEPGL-PETCOLLAR Page2 of 3 EUT-3 EUT-4 433.92MHZRFTransmitting Antenna 433.92MHZ RF Transmitting module PT4450 Page3of3 EUT-5 EUT-6 --------------------Thisisthelastpageofthereport.------------------

Report No.: E20200923215201-6-G3 Application No.: E20200923215201 Page 1 of 20 DIRECTIONS OF TEST 1. This station carries out test task according to the national regulation of verifications which can be traced to National Primary Standards and BIPM. 2. The test report merely corresponds to the test sample. It is not permitted to copy extracts of these test result without the written permission of the test laboratory. 3. If there is any objection concerning the test, the client should inform the laboratory within 15 days from the date of receiving the test report. Report No.: E20200923215201-6-G3 Application No.: E20200923215201 Page 2 of 20 TABLE OF CONTENTS 1. TEST RESULT SUMMARY ............................................................................................................................ 3 2. GENERAL DESCRIPTION OF EUT ................................................................................................................. 4 2.1. APPLICANT .............................................................................................................................................. 4 2.2. MANUFACTURER ................................................................................................................................... 4 2.3. FACTORY ................................................................................................................................................. 4 2.4. BASIC DESCRIPTION OF EQUIPMENT UNDER TEST ...................................................................... 4 3. LABORATORY AND ACCREDITATIONS ........................................................................................................ 6 3.1. LABORATORY ......................................................................................................................................... 6 3.2. ACCREDITATIONS ................................................................................................................................. 6 3.3. MEASUREMENT UNCERTAINTY ........................................................................................................ 6 4. LIST OF USED TEST EQUIPMENT AT GRGT .................................................................................................. 7 5. RADIATED SPURIOUS EMISSIONS .............................................................................................................. 8 5.1 LIMITS ........................................................................................................................................................... 8 5.2 TEST PROCEDURES .................................................................................................................................... 8 5.3 TEST SETUP .................................................................................................................................................. 9 5.4 DATA SAMPLE ........................................................................................................................................... 10 5.5 TEST RESULTS ........................................................................................................................................... 11 6. 20DB BANDWIDTH ................................................................................................................................... 15 6.1 LIMITS ......................................................................................................................................................... 15 6.2 TEST PROCEDURES .................................................................................................................................. 15 6.3 TEST SETUP ................................................................................................................................................ 15 6.4 TEST RESULTS ........................................................................................................................................... 15 7. TRANSMISSION TIME ............................................................................................................................... 16 7.1 LIMITS ......................................................................................................................................................... 16 7.2 TEST PROCEDURES .................................................................................................................................. 16 7.3 TEST SETUP ................................................................................................................................................ 16 7.4 TEST RESULTS ........................................................................................................................................... 16 8. APPENDIX: PHOTOGRAPH OF THE TEST ARRANGEMENT ........................................................................... 20 Report No.: E20200923215201-6-G3 Application No.: E20200923215201 Page 3 of 20 1. TEST RESULT SUMMARY Standard Item Limit / Severity Result Part 15,Subpart C (15.231) Conducted Emissions §15.207 N/A 1) Transmission Time §15.231 §15.231(a) (3) PASS 20DB Bandwidth §15.231 (c) PASS Radiated Spurious Emission §15.231(b) PASS N/A 1) :EUT received DC power from button battery Report No.: E20200923215201-6-G3 Application No.: E20200923215201 Page 4 of 20 2. GENERAL DESCRIPTION OF EUT 2.1. APPLICANT Name: K-Mark Industrial LTD Address: Flat A,7/F.,Mai On lnd.Bldg.,17-21,Kung Yip St.,Kwai Chung,Hong Kong 2.2. MANUFACTURER Name: Good Life, Inc Address: 887 Gilman Rd., Medford, OR 2.3. FACTORY Name : K-Mark Industrial (Shenzhen) LTD Address : 43 Jinshi Road, niuhu Guangpei community, Guanlan street, Longhua District, Shenzhen 2.4. BASIC DESCRIPTION OF EQUIPMENT UNDER TEST Equipment: Positive Pet collar Model No.: UBC-PPD Adding Model UBC-PPC Model Differences: All the model “UBC-PPC, UBC-PPD”are the same circuit and RF module, just different …

Text truncated - open the document above for the full version.

Report No.: E20200923215201-6 Application No.: E20200923215201 Page 27 of 27 9. APPENDIX: PHOTOGRAPH OF THE TEST ARRANGEMENT RSE（Below 1GHz） RSE（Above 1GHz） --------------------This is the last page of the report. -----------------------