VF6KINYOBT120HP Wireless Mini Speaker S6000

FCC INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. RF Exposure: A distance of 20 cm shall be maintained between the antenna and users, and the transmitter may not be co-located with any other transmitter or antenna. CANADA INFORMATION Industry Canada Statement: This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device. This equipment should be installed and operated with a minumum distance of 20 cm between the radiator and your body. Avis d’Industrie Canada: Cet appareil est conforme à la norme CNR-210 des règlements d’Industrie Canada. Son fonctionnement est sujet aux deux conditions suivantes: 1) Cet appareil ne doit pas provoquer d’interférences et 2) Cet appareil doit accepter toutes les interférences, y compris celles pouvant entraîner son dysfonctionnement. Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le radiateur et votre corps.

KINYO CO., LTD No. 287, Nioupu Rd., Hsinchu City 30091, Taiwan FCC Confidentiality Request Number: CF303 Version: V05 Date: 17-07-2013 (Permanent or also called long term confidentiality is the normal method to keep certain docuements confidential, and may apply to schematics, block diagrams, operational description and bill of materials.) To: Federal Communications Commission Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 Pursuant to 47 CFR Section 0.459(a) & (b), we, (the applicant / grantee) Company name KINYO CO., LTD Address No. 287, Nioupu Rd., Hsinchu City30091, Taiwan City Hsinchu Country Taiwan request for this certification filing under: Grantee Code Product Number FCC ID:VF6KINYOBT1 VF6 BT-120 to maintain permanent confidentiality for the following documents submitted within this application: (please cross what is applicable, or add other documents, provide the file name and description) Exhibit File Name Description Operational Description explaining the functioning of the block diagram Block Diagrams showing the systematic building blocks of the EUT Schematics Diagrams showing components, their values and interconnection Above materials crossed contain secrets, proprietary and technical information, which would customarily be guarded from competitors under 47 CFR, section 0.457(d)(2). Disclosure or publication or any portion of this company confidential material to other parties could cause substantial competitive harm and provide unjustified benefits for competitors. We understand that pursuant to 47 CFR section 0.457(d)(1)(ii) disclosure of the applicant and all accompanying documentation will not be made before the date of the grant. The documents indicated as confidential above, are not publicly available elsewhere. Attestation: City and Country: Date: Name: (this must be a person) Function: Signature: (or official company stamp) Hsinchu，Taiwan 2013.07.18 Yao,Yuchi Electric Engineer

KINYO CO., LTD No. 287, Nioupu Rd., Hsinchu City 30091, Taiwan FCC Authorization Letter Number: CF304 Version: V03 Date: 17-07-2011 We, (the approval holder) Company name KINYO CO., LTD Address No. 287, Nioupu Rd., Hsinchu City 30091, Taiwan City Hsinchu Country Taiwan declare that the following representative (agent): Name (person) Ruby.zhang Company name Compliance Certification Services Inc. Address No.10-1 Mingkeda Logistics park, No.18 Huanguan South Road. Guan Lan Town, Baoan District, Shenzhen, China City Shenzhen, Country China is hereby authorized to apply the following equipment for certification on our behalf: Product Description HP wireless Mini Speaker S6000 Type or Model(s) BT-120 Tradename or Brand(s) HP We also authorize Teleconformity (Mr. M. Koop, Manager Certification, Address: Rietven 31, 7534NH Enschede, the Netherlands) to apply and sign this application for certification, registration or filing on our behalf (as representative agent or certifier). Attestation: City and Country: Date: Name: (this must be a person) Function: Signature: (or official company stamp) Hsinchu，Taiwan 2013.07.18 Yao,Yuchi Electric Engineer

Report No: C130620Z16-RP1 Page 1 / 3 External Photos of EUT Report No: C130620Z16-RP1 Page 2 / 3 Report No: C130620Z16-RP1 Page 3 / 3

Label Location

Report No: C130620Z16-RP1 Page 1 / 4 Internal Photos of EUT Report No: C130620Z16-RP1 Page 2 / 4 Report No: C130620Z16-RP1 Page 3 / 4 Report No: C130620Z16-RP1 Page 4 / 4

MPE Calculation FCC ID: VF6KINYOBT120 Remark: Average ≤ Peak, which means that calculating the power density applying Peak power is worst case. The worst case operation mode generating the highest power in each frequency range is taken for calculation. Transmitting in DSS or DTS mode, calculating with highest power of both: Frequency range:2402-2480MHzTypical use distance: d ≥20cm Power density limit for mobile devices at 2.4 GHz: S ≤1mW/cm 2 Maximum measured conducted power (Peak): Pconducted =2.63 dBm =1.83mW Antenna Gain: G = 0dBi =1on the linear scale Calculation: P radiated = P conducted + G linear =2.63dBm +0dBi =2.63dBm =1.83mW Power density S = (P radiated ) / (4π x d 2 ) =1.83/5026 =0.0004mW/cm 2 <1=> below limit

Report No.: C130620Z16-RP1 FCC ID: VF6KINYOBT120 Page 1 / 60 FCC 47 CFR PART 15 SUBPART C TEST REPORT For HP wireless Mini Speaker S6000 Model: BT-120 Brand: HP Test Report Number: C130620Z16-RP1 Prepared for KINYO CO., LTD No.287,Nioupu Rd., Hsinchu City 30091, Taiwan Prepared by COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. No.10-1, Mingkeda Logistics Park, No.18, Huanguan South Rd., Guan Lan Town, Baoan District, Shenzhen China TEL: 86-755-28055000 FAX: 86-755-28055221 Issued Date: July 12, 2013 Note: This report shall not be reproduced except in full, without the written approval of Compliance Certification Services Inc. This document may be altered or revised by Compliance Certification Services Inc. personnel only, and shall be noted in the revision section of the document. The client should not use it to claim product endorsement by TAF, A2LA, NVLAP, NIST or any government agencies. The test result of this report relate only to the tested sample identified in this report. Report No.: C130620Z16-RP1 FCC ID: VF6KINYOBT120 Page 2 of 60 This report shall not be reproduced except in full, without the written approval of Compliance Certification Services. Revision History Rev. Issue No. Revisions Effect Page Revised By 00 C130620Z16-RP1 Initial Issue ALL Anna Liu Report No.: C130620Z16-RP1 FCC ID: VF6KINYOBT120 Page 3 of 60 This report shall not be reproduced except in full, without the written approval of Compliance Certification Services. TABLE OF CONTENTS 1. TEST RESULT CERTIFICATION .....................................................................................4 2. EUT DESCRIPTION..........................................................................................................5 3. TEST METHODOLOGY....................................................................................................6 3.1 DESCRIPTION OF TEST MODES ................................................................................6 4. FACILITIES AND ACCREDITATIONS .............................................................................7 4.1 FACILITIES....................................................................................................................7 4.2 ACCREDITATIONS .......................................................................................................7 4.3 MEASUREMENT UNCERTAINTY ................................................................................7 5. SETUP OF EQUIPMENT UNDER TEST ..........................................................................8 5.1 SETUP CONFIGURATION OF EUT .............................................................................8 5.2 SUPPORT EQUIPMENT .............................................................................................8 6. FCC PART 15.247 REQUIREMENTS ..............................................................................9 6.1 20dB BANDWIDTH........................................................................................................9 6.2 PEAK POWER.............................................................................................................14 6.3 PEAK POWER SPECTRAL DENSITY ........................................................................15 6.4 BAND EDGES MEASUREMENT ................................................................................17 6.5 FREQUENCY SEPARATION ......................................................................................27 6.6 NUMBER OF HOPPING FREQUENCY ......................................................................30 6.7 TIME OF OCCUPANCY (DWELL TIME) .....................................................................33 6.8 SPURIOUS EMISSIONS .............................................................................................40 6.9 POWERLINE CONDUCTED EMISSIONS ..................................................................58 Report No.: C130620Z16-RP1 FCC ID: VF6KINYOBT120 Page 4 of 60 This report shall not be reproduced except in full, without the written approval of Compliance Certification Services. 1. TEST RESULT CERTIFICATION Product: HP wireless Mini Speaker S6000 Model: BT-120 Brand: HP Tested: June 20~July 12 ,2013 Applicant: KINYO CO., LTD No.287,Nioupu Rd., Hsinchu City 30091, Taiwan Manufacturer: Chwen Ho Chung Elec.(sz) Co.,Ltd. No.5,Tianwan Road,Tianliao Village,Gongming Town,Guangming New District, Shenzhen City,Guangdong Province,518132,China APPLICABLE STANDARDS STANDARD TEST RESULT FCC 47 CFR Part 15 Subpart C No non-compliance noted We hereby certify that: The above equipment was tested by Compliance Certification Services Inc. The test data, data evaluation, test procedures, and equipment configurations shown in this report were made in accordance with the procedures given in ANSI C63.4:2009 and the energy emitted by the sample EUT tested as described in this report is in compliance with conducted and radiated emission limits of FCC Rules Part 15.207, 15.209 and 15.247. The test results of this report relate only to the tested sample EUT identified in this report. Approved by: Reviewed by: Tom Gan Supervisor of EMC Dept. Compliance Certification Service Inc. Ruby Zhang Supervisor of Report Dept. Compliance Certification Service Inc. Report No.: C130620Z16-RP1 FCC ID: VF6KINYOBT120 Page 5 of 60 This report shall not be reproduced except in full, without the written approval of Compliance Certification Services. 2. EUT DESCRIPTION Product HP wireless Mini Speaker S6000 Model Number BT-120 Brand HP Model Discrepancy N/A Identify Number C130620Z16-RP1 Power Supply DC3.7V Supplied by the Battery or DC 5V Supplied by the PC Received Date June 20, 2013 Frequency Range 2402 ~ 2480 MHz Transmit Power GFSK : 2.29dBm 8DPSK : 0.09dBm Modulation Technique FHSS (GFSK for 1Mbps, π/4-DQPSK for 2Mbps, 8DPSK for 3Mbps) Number of Channels 79 Channels Antenna Specification PCB Antenna with 0dBi gain (Max) Note: This submittal(s) (test report) is intended for FCC ID: VF6KINYOBT120 f…

Text truncated - open the document above for the full version.

Report No.: C130620Z16-RP1 FCC ID : VF6KINYOBT120 Page 1 / 2 PHOTOGRAPHS OF THE TEST CONFIGURATION RADIATED EMISSION TEST Report No.: C130620Z16-RP1 FCC ID : VF6KINYOBT120 Page 2 / 2 CONDUCTED EMISSION TEST