WL6-TABC7CA1Wireless Motherboard

TA70CA1 Motherboard Guide 1 FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: n Reorient or relocate the receiving antenna. n Increase the separation between the equipment and receiver. n Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. n Consult the dealer or an experienced radio/ TV technician for help. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2 RF Exposure Warning This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmittermust be installed to provide a separationdistance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: "Contains FCC ID: WL6-TABC7CA1 ” Information for the OEMs and Integrators The following statement must be included with all versions of this document supplied to an OEM or integrator, but should not be distributed to the end user. 1) This device is intended for OEM integrators only. 2) Please see the full Grant of Equipment document for other restrictions. This radio transmitter FCC ID: WL6-TABC7CA1 has been approved by FCC to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. 3 Antenna List No. Manufacturer Part No. Antenna Type Peak Gain 1 JEM 13H130- JV6070 PIFA Antenna 2.98 dBi for 2.4GHz 2. WGT 13H130- JV6050 PIFA Antenna 2.48 dBi for 2.4GHz Note: The antenna connector is I-PEX type. 4 Motherboard layout Main components No. Name No. Name A Charger IC E WiFi/BT IC B Front facing camera F GPS IC C Rear facing camera G Audio Codec D CPU+PMIC+DDR+EMMC Ｈ Microphone 5 System connectors No. Name No. Name 1 Battery Connector 5 Speaker Connector 2 WiFi Antenna Connector 6 Speaker Connector 3 GPS Antenna Connector 7 Side Key FPC Connector 4 LCD Connector 8 TP Connector 6 I/O Ports No. Name No. Name 1 3G card slot 4 Micro SD card slot 2 Micro USB port 5 Micro HDMI port 3 Headphone plug 7 Features Processor l Intel Clovertrail+ Z2520 l Up to 1.2GHz, Dual core Memory l 8bit, LP DDR2 Mobile RAM PoP l 1GB / 2GB (optional) Storage l Single eMMCv4.4.1 l Default 8GB Wireless l Wi-Fi 802.11 b/g/n l Wi-Fi hotspot l Bluetooth 2.1+EDR support Display l LVDS interface l Resolution: 1024(H) × 3 (RGB) × 600(V) pixels l Support 5-points multi-touch Cameras l Front camera: 2.0 M Ø MIPI-CSI Ø Mirror mode Ø Support 4:3 aspect ratio Ø Support Indicate l Rear camera: 5.0 M Ø MIPI-CSI Ø Normal non-mirror mode Ø Support 16:10 aspect ratio Ø Auto-focus 8 Input/Output l 1 x micro-USB 2.0, OTG port (Type A/B) l 1 x Mic/head phone jack combo l 1 x micro-HDMI 1.4 l 1 x micro-SD card slot (128M-32G) l 1 x 3G card slot Speaker & Mic l Build-in Speaker x 2 l Internal Analog MIC x 1

Report No.: 13C0051R-RFUSP74V00 Page : 1 of 7 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (2) EUT Photo WLAN+Bluetooth GPS

ELITEGROUP COMPUTER SYSTEMS CO., LTD. FCC ID.: WL6-TABC7CA1 No.239, Sec. 2, Ti Ding Blvd., Taipei, Taiwan.Tel : +886-2-2161-1177 FCC ID Label

ELITEGROUP COMPUTER SYSTEMS CO., LTD. FCC ID.: WL6-TABC7CA1 No.239, Sec. 2, Ti Ding Blvd., Taipei, Taiwan.Tel : +886-2-2161-1177 The FCC ID Label will be placed on the equipment as shown in the photograph below.

Report No.: 13C0051R-RFUSP74V00 Page : 2 of 7 (3) EUT Photo (4) EUT Photo Report No.: 13C0051R-RFUSP74V00 Page : 3 of 7 (5) EUT Photo (6) EUT Photo WLAN+Bluetooth IC Report No.: 13C0051R-RFUSP74V00 Page : 4 of 7 (7) EUT Photo – GPS IC (8) EUT Photo Report No.: 13C0051R-RFUSP74V00 Page : 5 of 7 (9) EUT Photo (10) EUT Photo Report No.: 13C0051R-RFUSP74V00 Page : 6 of 7 (11) EUT Photo (12) EUT Photo Report No.: 13C0051R-RFUSP74V00 Page : 7 of 7 (13) EUT Photo (14) EUT Photo

Report No. 13C0051R-RFUSP74V00 Page: 1 of 3 Version: 1.0 RF Exposure Evaluation declaration Product Name : Wireless Motherboard Model No. : TA70CA1 FCC ID : WL6-TABC7CA1 Applicant : ELITEGROUP COMPUTER SYSTEMS CO., LTD. Address : No.239, Sec. 2, Ti Ding Blvd., Taipei, Taiwan Date of Receipt : Nov. 27, 2013 Date of Declaration: Dec. 24, 2013 Report No. : 13C0051R-RFUSP74V00 The declaration results relate only to the samples calculated. The declaration shall not be reproduced except in full without the written approval of QuieTek Corporation. Report No. 13C0051R-RFUSP74V00 Page: 2 of 3 Version: 1.0 1. RF Exposure Evaluation 1.1. Limits According to FCC 1.1310: The criteria listed in the following table shall be used to evaluate the environment impact of human exposure to radio frequency (RF) radiation as specified in 1.1307(b) LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) Frequency Range (MHz) Electric Field Strength (V/m) Magnetic Field Strength (A/m) Power Density (mW/cm 2 ) Average Time (Minutes) (A) Limits for Occupational/ Control Exposures 300-1500 -- -- F/300 6 1500-100,000 -- -- 5 6 (B) Limits for General Population/ Uncontrolled Exposures 300-1500 -- -- F/1500 6 1500-100,000 -- -- 1 30 F= Frequency in MHz Friis Formula Friis transmission formula: Pd = (Pout*G)/(4*pi*r 2 ) Where Pd = power density in mW/cm 2 Pout = output power to antenna in mW G = gain of antenna in linear scale Pi = 3.1416 R = distance between observation point and center of the radiator in cm Pd id the limit of MPE, 1 mW/cm 2 . If we know the maximum gain of the antenna and the total power input to the antenna, through the calculation, we will know the distance r where the MPE limit is reached. 1.2. Test Procedure Software provided by client enabled the EUT to transmit and receive data at lowest, middle and highest channel individually. The temperature and related humidity: 18°Cand 78％ RH. Report No. 13C0051R-RFUSP74V00 Page: 3 of 3 Version: 1.0 1.3. Test Result of RF Exposure Evaluation Product : Wireless Motherboard Test Item : RF Exposure Evaluation Test Site : No.3 OATS BT Output Power Into Antenna & RF Exposure Evaluation Distance (2.98dBi): Output Power to Antenna (mW) Power Density at R = 20 cm (mW/cm2) 2.6363 0.001042 Note: Power density is much lower than the limit (1 mW/cm2). WLAN Output Power Into Antenna & RF Exposure Evaluation Distance (2.98dBi): Output Power to Antenna (mW) Power Density at R = 20 cm (mW/cm2) 292.4152 0.115540 Note: Power density is much lower than the limit (1 mW/cm2).

Report No. 13C0051R-RFUSP03V00 Page: 1 of 64 FCC Test Report Product Name Wireless Motherboard Model No. TA70CA1 FCC ID. WL6-TABC7CA1 Applicant ELITEGROUP COMPUTER SYSTEMS CO., LTD. Address No.239, Sec. 2, Ti Ding Blvd., Taipei, Taiwan Date of Receipt Nov. 27, 2013 Issued Date Dec. 24, 2013 Report No. 13C0051R-RFUSP03V00 Report Version V1.0 The Test Results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by TAF or any agency of the U.S. Government Report No. 13C0051R-RFUSP03V00 Page: 2 of 64 Test Report Certification Issued Date: Dec. 24, 2013 Report No.: 13C0051R-RFUSP03V00 Product Name Wireless Motherboard Applicant ELITEGROUP COMPUTER SYSTEMS CO., LTD. Address No.239, Sec. 2, Ti Ding Blvd., Taipei, Taiwan Manufacturer ELITEGROUP COMPUTER SYSTEMS CO., LTD. Model No. TA70CA1 FCC ID. WL6-TABC7CA1 EUT Rated Voltage DC 3.7V (Power by Battery) EUT Test Voltage AC 120V/ 60Hz Trade Name ECS / JP SA COUTO, S.A. Applicable Standard FCC CFR Title 47 Part 15 Subpart C: 2012 ANSI C63.4: 2003, ANSI C63.10: 2009 Test Result Complied The Test Results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by TAF or any agency of the U.S. Government Documented By : ( Senior Adm. Specialist / Genie Chang ) Tested By : ( Assistant Engineer / Alan Chen ) Approved By : ( Director / Vincent Lin ) Report No. 13C0051R-RFUSP03V00 Page: 3 of 64 TABLE OF CONTENTS Description Page 1. GENERAL INFORMATION ...............................................................................................................5 1.1. EUT Description......................................................................................................................................5 1.2. Operational Description...........................................................................................................................7 1.3. Tested System Details..............................................................................................................................8 1.4. Configuration of Tested System ..............................................................................................................8 1.5. EUT Exercise Software ...........................................................................................................................8 1.6. Test Facility .............................................................................................................................................9 2. CONDUCTED EMISSION ................................................................................................................10 2.1. Test Equipment ......................................................................................................................................10 2.2. Test Setup ..............................................................................................................................................10 2.3. Limits.....................................................................................................................................................11 2.4. Test Procedure .......................................................................................................................................11 2.5. Uncertainty ............................................................................................................................................11 2.6. Test Result of Conducted Emission .......................................................................................................12 3. PEAK POWER OUTPUT ..................................................................................................................14 3.1. Test Equipment ......................................................................................................................................14 3.2. Test Setup ..............................................................................................................................................14 3.3. Limit ......................................................................................................................................................14 3.4. Test Procedure .......................................................................................................................................14 3.5. Uncertainty ............................................................................................................................................14 3.6. Test Result of Peak Power Output .........................................................................................................15 4. RADIATED EMISSION .....................................................................................................................17 4.1. Test Equipment ......................................................................................................................................17 4.2. Test Setup ..............................................................................................................................................17 4.3. Limits.....................................................................................................................................................18 4.4. Test Procedure .......................................................................................................................................19 4.5. Uncertainty ............................................................................................................................................19 4.6. Test Result of Radiated Emission ..........................................................................................................20 5. RF ANTE…

Text truncated - open the document above for the full version.

Report No.: 13C0051R-RFUSP74V00 Page : 1 of 4 Attachment 1: EUT Test Setup Photographs Front View of Conducted Test Back View of Conducted Test Report No.: 13C0051R-RFUSP74V00 Page : 2 of 4 Front View of Radiated Test Back View of Radiated Test Report No.: 13C0051R-RFUSP74V00 Page : 3 of 4 Front View of Radiated Test (Horn) Back View of Radiated Test (Horn)