WUS00029RFID Tag

USER MANUAL Contents PREFACE Trademarks FCC Compliance Copyright Statement ID‐S100 Introduction Features Hardware LED Indicators Data Connections Antennas Orientation Environmental Limits CUSTOMER SERVICE airPointe Customer Support USER MANUAL PREFACE Trademarks airPointe of New Hampshire and the airPointe of New Hampshire logo are trademarks of airPointe of New Hampshire. All other product names are copyright and registered trademarks or trade names of their respective owners. Information in this document is provided solely to enable system and software implementers to use the airPointe of New Hampshire system. There are no express or implied copyright licenses granted hereunder to design or fabricate any integrated circuits or integrated circuits based on the information in this document. airPointe of New Hampshire reserves the right to make changes without further notice to any products herein. airPointe of New Hampshire makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does airPointe of New Hampshire assume any liability arising out of the application or use of any product, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. The user of this system is cautioned that any changes or modifications to this system, not expressly approved by airPointe of New Hampshire could void the warranty. FCC COMPLIANCE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: ‐‐Reorient or relocate the receiving antenna. ‐‐Increase the separation between the equipment and receiver. ‐‐Connect the equipment into an outlet on a circuit different from that which the receiver is connected. ‐‐Consult the dealer or an experienced radio/TV technician for help. ‐‐Changes or modifications not expressly approved by airPointe of New Hampshire could void the user’s authority to operate the equipment USER MANUAL This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. PREFACE COPYRIGHT STATEMENT Copyright © 2009 airPointe of New Hampshire. All Rights Reserved. This document, as well as the hardware and firmware described therein, are furnished under license and may only be used or copied in accordance with the terms of such license. The information in these pages are furnished for informational use only, are subject to change without notice, and should not be construed as a commitment by airPointe of New Hampshire, airPointe of New Hampshire assumes no responsibility or liability for any errors or inaccuracies that may appear in these pages. Every effort has been made to supply complete and accurate information. However, airPointe of New Hampshire assumes no responsibility for its use, or for any infringements of patents or other rights of third parties, which would result. airPointe of New Hampshire 35E Industrial Way Suite 101 Rochester, NH 03867 USER MANUAL ID‐S100 INTRODUCTION airPointe delivers software and hardware solutions that enable healthcare organizations to streamline operations, improve quality‐of‐care, reduce costs and generate additional revenue. airPointe develops an innovative next generation Intelligent Real‐Time Location System (i‐RTLS) which can gather data on high‐value assets within an organization, including medical equipment, clinical staff, patients and visitors. An active tag is placed on an item or person that requires monitoring. The battery powered active tags can transmit information throughout a secure wireless router network. Information, or data, that is intelligently and automatically collected from each tag will identify the asset type, the location, movement timestamp and other desired device attributes. This data allows items to be easily located anywhere within the wireless network, as well as their proximity relationship to each other. FEATURES ‐ Battery life of 4 years ‐ Hermetically sealed ‐ Auto‐Detect ‐ Small form factor HARDWARE The tags are incased in a 4” x 1.25” x 0.3” (10.6cm x 3.2cm x 0.8cm) UL rated ABS Cellcore plastic housing and contain the internal components of a RF transmitter and battery source. LED Indicators USER MANUAL None on this model Data Connections Internal, all programming will be done at airPointe. ID‐S100 Antennas Internal. ORIENTATION When possible, the tags should be placed on assets in the highest least obstructive manner. This will optimize the readers’ ability to receive the most accurate data from the tag. ENVIRONMENTAL LIMITS Humidity: Submersible in water (hermetically sealed) Temperature: 0° C to 70°C If device is exposed to temperatures or humidity levels outside of the parameters above, it may cause the device to not function properly. USER MANUAL CUSTOMER SERVICE AIRPOINTE CUSTOMER SUPPORT airPointe gives the ability to intended parties to contact airPointe directly if any problems should arise. ‐Customer Support Via Phone: 603.994.2200 Via Email: [email protected] Via the Web: www.airpointe.com/support

EJ1727-2 AirPointe of New Hampshire Bonsai External Pictures EJ1727-2 AirPointe of New Hampshire Bonsai External Pictures EJ1727-2 AirPointe of New Hampshire Bonsai External Pictures

EJ1727-2 AirPointe of New Hampshire Bonsai Internal Pictures EJ1727-2 AirPointe of New Hampshire Bonsai Internal Pictures

Curtis-Straus LLC is accredited by the American Association for Laboratory Accreditation for the specific scope of accreditation under Certificate Number 1627-01. This report may contain data which is not covered by the A2LA accreditation. ____________________________________________________________ ____________________________________________________________ Curtis-Straus LLC, a wholly owned subsidiary of BV CPS One Distribution Center Circle, #1 • •• • Littleton, MA • •• • TEL (978) 486-8880 • •• • FAX (978) 486-8828 page 1 of 18 Test Report Curtis-Straus LLC, a wholly owned subsidiary of BV CPS Report No EJ1727-2 Client AirPointe of New Hampshire Address 35E Industrial Way Suite 101 Rochester, NH 03867 Phone 603-994-2200 Items tested Bonsai X1 FCC ID WUS00029 FRN 0018228197 Equipment Type Part 15 Security/Remote Control Transmitter Equipment Code DSC FCC Rule Parts 47 CFR 15.231(e) Test Dates January 11/25, 2010 Results As detailed within this report Prepared by Matthew Burman – Test Engineer Authorized by Mairaj Hussain – EMC Supervisor Issue Date March 24, 2010 Conditions of Issue This Test Report is issued subject to the conditions stated in the ‘Conditions of Testing’ section on page 17 of this report. Test Report for AirPointe of New Hampshire • •• • Report No. EJ1727-2 April 28, 2010 ______________________________________________________________________ ____________________________________________________________ Curtis-Straus LLC, a wholly owned subsidiary of BV CPS One Distribution Center Circle, #1 • •• • Littleton, MA • •• • TEL (978) 486-8880 • FAX (978) 486-8828 page 2 of 18 Contents Contents..................................................................................................................................2 Summary.................................................................................................................................3 Test Methodology ....................................................................................................................3 Product Tested - Configuration Documentation .......................................................................4 Modifications Required for Compliance ................................................................................4 Test Results ............................................................................................................................5 Fundamental Emission.........................................................................................................5 Bandwidth ............................................................................................................................6 Restricted Bands..................................................................................................................7 Harmonics and Spurious Emissions.....................................................................................9 Timing Requirements / Duty Cycle Correction Factor.........................................................10 Line Conducted Emissions.................................................................................................12 Measurement Uncertainty......................................................................................................13 Test Equipment Used ............................................................................................................15 Product Documentation .........................................................................................................16 Conditions Of Testing ............................................................................................................17 Form Final Report REV 7-20-07 (DW) Test Report for AirPointe of New Hampshire • •• • Report No. EJ1727-2 April 28, 2010 ______________________________________________________________________ Release Control Record Issue No. Reason for change Date Issued 1 Original Release April 28, 2010 _____________________________________________________________ Curtis-Straus LLC, a wholly owned subsidiary of BV CPS One Distribution Center Circle, #1 • •• • Littleton, MA • •• • TEL (978) 486-8880 • •• • FAX (978) 486-8828 page 3 of 18 Summary This test report supports an application for certification of a transmitter operating pursuant to 47 CFR 15.231(e). The product is the Bonsai X1. The operating frequency range is 300.5- 346.5MHz. It is powered by +3VDC coin cell batteries. The manufacturer is setting the power levels for two different frequency ranges as detailed in the fundamental emission section. The frequencies between 320.5 and 336.5MHz are not used. We found that the product met the above requirements with modification (see Modifications Required for Compliance section on page 4). Don Proulx from AirPointe was present during the testing. The test sample was received in good condition. Test Methodology Testing was performed according to ANSI C63.4-2003. Radiated emissions were maximized by rotating the device around its three orthogonal axes, as well as varying the test antenna’s height and polarity. Frequency range investigated: 30MHz – 3.5GHz Measurement distance: 30-3500MHz 3m The receiver portion of this device is subject to the Verification authorization procedure as per 15.101(b). The associated digital circuitry is also subject to the Verification authorization procedure as per 15.101(a). A separate test report has been issued to AirPointe of New Hampshire in order to cover both of these requirements. Test Report for AirPointe of New Hampshire • •• • Report No. EJ1727-2 April 28, 2010 ______________________________________________________________________ _____________________________________________________________ Curtis-Straus LLC, a wholly owned subsidiary of BV CPS One Distribution Center Circle, #1 • •• • Littleton, MA • •• • TEL (978) 486-8880 • •• • FAX (978) 486-8828 page 4 of 18 Product Tested - Configuration Documentation EUT Configuration Work Order: J1727 Comp…

Text truncated - open the document above for the full version.

EJ1727-2 AirPointe of New Hampshire Bonsai Setup Pictures Measurements below 1GHz EJ1727-2 AirPointe of New Hampshire Bonsai Setup Pictures Measurements above 1GHz