WUS00036RFID Tag

USER MANUAL Contents PREFACE Trademarks FCC Compliance Copyright Statement ID‐BTM100HS Introduction Features Hardware LED Indicators Data Connections Antennas Orientation Environmental Limits CUSTOMER SERVICE airPointe Customer Support USER MANUAL PREFACE Trademarks airPointe of New Hampshire and the airPointe of New Hampshire logo are trademarks of airPointe of New Hampshire. All other product names are copyright and registered trademarks or trade names of their respective owners. Information in this document is provided solely to enable system and software implementers to use the airPointe of New Hampshire system. There are no express or implied copyright licenses granted hereunder to design or fabricate any integrated circuits or integrated circuits based on the information in this document. airPointe of New Hampshire reserves the right to make changes without further notice to any products herein. airPointe of New Hampshire makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does airPointe of New Hampshire assume any liability arising out of the application or use of any product, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. The user of this system is cautioned that any changes or modifications to this system, not expressly approved by airPointe of New Hampshire could void the warranty. FCC COMPLIANCE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: ‐‐Reorient or relocate the receiving antenna. ‐‐Increase the separation between the equipment and receiver. ‐‐Connect the equipment into an outlet on a circuit different from that which the receiver is connected. ‐‐Consult the dealer or an experienced radio/TV technician for help. ‐‐Changes or modifications not expressly approved by airPointe of New Hampshire could void the user’s authority to operate the equipment USER MANUAL This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. PREFACE COPYRIGHT STATEMENT Copyright © 2009 airPointe of New Hampshire. All Rights Reserved. This document, as well as the hardware and firmware described therein, are furnished under license and may only be used or copied in accordance with the terms of such license. The information in these pages are furnished for informational use only, are subject to change without notice, and should not be construed as a commitment by airPointe of New Hampshire, airPointe of New Hampshire assumes no responsibility or liability for any errors or inaccuracies that may appear in these pages. Every effort has been made to supply complete and accurate information. However, airPointe of New Hampshire assumes no responsibility for its use, or for any infringements of patents or other rights of third parties, which would result. airPointe of New Hampshire 35E Industrial Way Suite 101 Rochester, NH 03867 USER MANUAL ID‐BTM100HS INTRODUCTION airPointe delivers software and hardware solutions that enable healthcare organizations to streamline operations, improve quality‐of‐care, reduce costs and generate additional revenue. airPointe develops an innovative next generation Intelligent Real‐Time Location System (i‐RTLS) which can gather data on high‐value assets within an organization, including medical equipment, clinical staff, patients and visitors. An active tag is placed on an item or person that requires monitoring. The battery powered active tags can transmit information throughout a secure wireless router network. Information, or data, that is intelligently and automatically collected from each tag will identify the asset type, the location, movement timestamp and other desired device attributes. This data allows items to be easily located anywhere within the wireless network, as well as their proximity relationship to each other. FEATURES ‐ Battery life of 4 years ‐ Hermetically sealed ‐ Auto‐Detect ‐ Small form factor HARDWARE The tags are incased in a 3 .2” x 1.6” x 0.5” (8.1cm x 4.1cm x 1.3cm) UL rated ABS Cellcore plastic housing and contain the internal components of a RF transmitter and battery source. LED Indicators USER MANUAL None on this model Data Connections Internal, all programming will be done at airPointe. ID‐ BTM100HS Antennas Internal. ORIENTATION When possible, the tags should be placed on assets in the highest least obstructive manner. This will optimize the readers’ ability to receive the most accurate data from the tag. ENVIRONMENTAL LIMITS Humidity: Submersible in water (hermetically sealed) Temperature: 0° C to 70°C If device is exposed to temperatures or humidity levels outside of the parameters above, it may cause the device to not function properly. USER MANUAL CUSTOMER SERVICE AIRPOINTE CUSTOMER SUPPORT airPointe gives the ability to intended parties to contact airPointe directly if any problems should arise. ‐Customer Support Via Phone: 603.994.2200 Via Email: [email protected] Via the Web: www.airpointe.com/support

2.72 1.72 NOTE 2 1.00 NOTE 2 R.06 4X NOTE 3 RELEASE LINER TO BE CUT HERE .22 NOTE 2 NOTES: MATERIAL: POLYESTER, WHITE, 0.002 THICK1. L-23 ADHESIVE AND RELEASE LINER2. ARTWORK PER FILE: TBD (OR DEFINED ON 3. PURCHASE ORDER) EQUIVALENT/ALTERNATE MATERIALS 4. PERMITTED WITH AIRPOINTE APPROVAL REV.DESCRIPTIONDATEAPPROVED 00E01-PRELIMINARY RELEASE6/4/09M. FOLEY 01E01-PRODUCTION RELEASE6/29/09M. FOLEY 01E02 - ADDED MATERIAL SPECIFICATION02SEPT2009AF 02E01 - ADDED KISS CUT TO RELEASE LINER21JAN2010MF 03E01 - CHANGED FCC ID NUMBER29SEPT2010AF 04E01 - CHANGED FCC ID NUMBER29NOV2010AF D C B A A B C D 1 2 3 4 5 6 7 8 8 7 6 5 4 3 2 1 THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF AIRPOINTE. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF AIRPOINTE IS PROHIBITED. PROPRIETARY AND CONFIDENTIAL NEXT ASSY USED ON APPLICATION DIMENSIONS ARE IN INCHES TOLERANCES: TWO PLACE DECIMAL 0.010 THREE PLACE DECIMAL 0.005 INTERPRET GEOMETRIC TOLERANCING PER ANSI Y-14.5 MATERIAL FINISH DRAWN CHECKED ENG APPR. MFG APPR. Q.A. DATE NAME AIRPOINTE TITLE: SIZE B DWG. NO. REV SCALE: 2:1 UNLESS OTHERWISE SPECIFIED: SEE CARROLL DESIGN WORKMANSHIP STANDARDS. M. FOLEY 6/1/09 LABEL, FCC ID SHEET 1 OF 1 45372020 DO NOT SCALE DRAWING 04 CAD MODEL INFORMATION THIRD ANGLE PROJECTION 45372020

Curtis-Straus LLC is accredited by the American Association for Laboratory Accreditation for the specific scope of accreditation under Certificate Number 1627-01. This report may contain data which is not covered by the A2LA accreditation. ____________________________________________________________ Curtis-Straus LLC, a wholly owned subsidiary of BV CPS One Distribution Center Circle, #1 • •• • Littleton, MA • •• • TEL (978) 486-8880 • •• • FAX (978) 486-8828 page 1 of 21 Test Report Curtis-Straus LLC, a wholly owned subsidiary of BV CPS Report No EJ1727-1 Client AirPointe of New Hampshire Address 35E Industrial Way Suite 101 Rochester, NH 03867 Phone 603-994-2200 Items tested Sushi 433 FCC ID WUS00036 FRN 0018228197 Equipment Type Part 15 Security/Remote Control Transmitter Equipment Code DSC FCC Rule Parts 47 CFR 15.231(e) Test Dates September 23, 2010 Results As detailed within this report Prepared by John Cushing – Test Engineer Authorized by Mairaj Hussain – EMC Supervisor Issue Date 12/1/2010 Conditions of Issue This Test Report is issued subject to the conditions stated in the ‘Conditions of Testing’ section on page 20 of this report. Test Report for AirPointe of New Hampshire • •• • Report No. EJ1727-1 December 1, 2010 ______________________________________________________________________ ____________________________________________________________ Curtis-Straus LLC, a wholly owned subsidiary of BV CPS One Distribution Center Circle, #1 • •• • Littleton, MA • •• • TEL (978) 486-8880 • FAX (978) 486-8828 page 2 of 21 Contents Contents..................................................................................................................................2 Summary.................................................................................................................................3 Test Methodology ....................................................................................................................3 Product Tested - Configuration Documentation .......................................................................4 Test Results ............................................................................................................................5 Fundamental Emission.........................................................................................................5 Bandwidth ............................................................................................................................7 Restricted Bands of Operations ...........................................................................................9 Harmonics and Spurious Emissions...................................................................................11 Timing Requirements / Duty Cycle Correction Factor.........................................................13 Line Conducted Emissions.................................................................................................16 Measurement Uncertainty......................................................................................................17 Conditions Of Testing ............................................................................................................20 Form Final Report REV 7-20-07 (DW) Test Report for AirPointe of New Hampshire • •• • Report No. EJ1727-1 December 1, 2010 ______________________________________________________________________ Release Control Record Issue No. Reason for change Date Issued 1 Original Release December 1, 2010 _____________________________________________________________ Curtis-Straus LLC, a wholly owned subsidiary of BV CPS One Distribution Center Circle, #1 • •• • Littleton, MA • •• • TEL (978) 486-8880 • •• • FAX (978) 486-8828 page 3 of 21 Summary This test report supports an application for certification of a transmitter operating pursuant to 47 CFR 15.231(e). The product is the Sushi 433. The operating frequency is 433.9MHz. It is powered by +3VDC coin cell batteries. Fresh batteries were used during all testing. Line Conducted Emissions was not performed. We found that the product met the above requirements without modification. Don Proulx from AirPointe was present during the testing. The test sample was received in good condition. Test Methodology Testing was performed according to ANSI C63.4-2009 and ANSI C63.10-2009. Radiated emissions were maximized by rotating the device around its three orthogonal axes, as well as varying the test antenna’s height and polarity. The EUT’s antenna cannot be maximized separately. Frequency range investigated: 30MHz – 5GHz Measurement distance: 30-5000MHz 3m This device has no receiver portion. Test Report for AirPointe of New Hampshire • •• • Report No. EJ1727-1 December 1, 2010 ______________________________________________________________________ _____________________________________________________________ Curtis-Straus LLC, a wholly owned subsidiary of BV CPS One Distribution Center Circle, #1 • •• • Littleton, MA • •• • TEL (978) 486-8880 • •• • FAX (978) 486-8828 page 4 of 21 Product Tested - Configuration Documentation EUT Configuration Work Order: K1259 Company: airPointe Company Address: 35E Industrial Way Rochester, NH 03867 Contact: Don Proulx Person Present: Don Proulx MNPNSN EUT: sample 1 EUT Description: Sushi 433 - Active RFID Tag FCC ID: EUT Tx Frequency:433.9MHz Support Equipment: MNSN NONE EUT Ports: Port LabelPort Type No. of ports No. PopulatedCable TypeShieldedFerritesLength Max Length In/Out NEBS TypeUnpopulated Reason NONE Software / Operating Mode Description: EUT is transmitting a 433.92MHz signal every 10 seconds Test Report for AirPointe of New Hampshire • •• • Report No. EJ1727-1 December 1, 2010 ______________________________________________________________________ _____________________________________________________________ Curtis-Straus LLC, a wholly owned subsidiary of BV CPS One Distribution Center Circle, #1 • •• • Littleton, MA • •• • TEL (978) 486-8880 • •• • F…

Text truncated - open the document above for the full version.