WWMDN427V3150Mbps Wireless N USB Adapter

PW-DN427 Wireless N USB Adapter Rev: 2.0.0 1910020432 I FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/ TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: The manufacturer is not responsible for any radio or tv interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment. FCC RF Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment has been SAR-evaluated for use in hand. SAR measurements are based on 5mm spacing from the body and that compliance is achieved at that distance. II CE Mark Warning This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. National restrictions This device is intended for home and office use in all EU countries (and other countries following the EU directive 1999/5/EC) without any limitation except for the countries mentioned below: Country Restriction Reason/remark Bulgaria General authorization required for outdoor use and public service France Outdoor use limited to 10 mW e.i.r.p. within the band 2454-2483.5 MHz Military Radiolocation use. Refarming of the 2.4 GHz band has been ongoing in recent years to allow current relaxed regulation. Full implementation planned 2012 Italy If used outside of own premises, general authorization is required Luxembourg None General authorization required for network and service supply(not for spectrum) Norway Implemented This subsection does not apply for the geographical area within a radius of 20 km from the centre of Ny-Ålesund Russian Federation Only for indoor applications Note: Please don’t use the product outdoors in France. CONTENTS Package Contents .................................................................................................... 1 Chapter 1 Introduction .......................................................................................... 2 1.1 Product Overview ............................................................................................ 2 1.2 Main Features .................................................................................................. 2 1.3 LED Status ...................................................................................................... 2 Chapter 2 Installation Guide ................................................................................. 3 2.1 Hardware Installation ....................................................................................... 3 2.2 Software Installation ........................................................................................ 3 2.2.1 Overview ............................................................................................................. 3 2.2.2 Installation Guide ................................................................................................ 3 2.3 Uninstall Software ............................................................................................ 8 2.3.1 Uninstall the utility software from your PC .......................................................... 8 2.3.2 Uninstall the driver software from your PC ......................................................... 8 Chapter 3 Configuration ........................................................................................ 9 3.1 Configuration of Utility ...................................................................................... 9 3.1.1 Site Survey ........................................................................................................ 10 3.1.2 Profile ................................................................................................................ 10 3.1.3 Link Information ................................................................................................ 22 3.1.4 Advanced .......................................................................................................... 24 3.1.5 About ................................................................................................................. 25 3.1.6 An example for application ............................................................................... 25 3.2 Configure with Windows XP Wireless Zero Configuration ......…

Text truncated - open the document above for the full version.

PROWARE TECHNOLOGIES CO., LTD. Date: 2012-07-17 FCC ID: WWMDN427V3 To the attention of Federal Communications Commission Authorization and Evaluation Division Confidentiality Request Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, the Applicant hereby requests confidential treatment of information accompanying this Application as outlined below: Schematics Block Diagram Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457, disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely yours, Name of authorized signer: Yongquan Wang Title of authorized signer: Product Dept. Manager Company Name: PROWARE Technologies Co., Ltd. Tel: 86-755-26525554 Fax: 86-755-26508930 Web site: WWW.PROWARE.COM.CN

PROWARE TECHNOLOGIES CO., LTD. Date: 2012-07-17 A U T H O R I Z A T I O N L E T T E R To whom it may concern: We, the undersigned PROWARE Technologies Co., Ltd hereby authorize Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch (BV CPS Taoyuan) of Taiwan to act on our behalf in all matters relating to all processes required in FCC approval and any communication needed with the national authority. Any and all acts carried out by BV CPS Taoyuan on our behalf shall have the same effects as acts of our own. If you have any questions regarding the authorization, please don’t hesitate to contact us. Thank you! Sincerely yours, Name of authorized signer: Yongquan Wang Title of authorized signer: Product Dept. Manager Company Name: PROWARE Technologies Co., Ltd. Tel: 86-755-26525554 Fax: 86-755-26508930 Web site: WWW.PROWARE.COM.CN

Page 1 CONSTRUCTION PHOTOS OF EUT Page 2

Page 3 Page 4

TA Technology (Shanghai) Co., Ltd. Test Report Report No. RXA1206-0418SAR01R1 Page 1 of 63 TESTING No. L2264 OET 65 TEST REPORT Product Name 150Mbps Wireless N USB Adapter Model PW-DN427 FCC ID WWMDN427V3 Client Proware Technologies Co Ltd. TA Technology (Shanghai) Co., Ltd. TA Technology (Shanghai) Co., Ltd. Test Report Report No. RXA1206-0418SAR01R1 Page 2 of 63 GENERAL SUMMARY Product Name 150Mbps Wireless N USB Adapter Model PW-DN427 FCC ID WWMDN427V3 Report No. RXA1206-0418SAR01R1 Client Proware Technologies Co Ltd. Manufacturer Proware Technologies Co Ltd. Reference Standard(s) IEEE Std C95.1, 1999: IEEE Standard for Safety Levels with Respect to Human Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz. SUPPLEMENT C Edition 01-01 to OET BULLETIN 65 Edition 97-01 June 2001 including DA 02-1438, published June 2002: Evaluating Compliance with FCC Guidelines for Human Exposure to Radio frequency Electromagnetic Fields Additional Information for Evaluation Compliance of Mobile and Portable Devices with FCC Limits for Human Exposure to Radio frequency Emissions. KDB 248227 D01 SAR meas for 802 11 a b g v01r02: SAR Measurement Procedures for 802.11a/b/g Transmitters. KDB 447498 D02 SAR Procedures for Dongle Xmtr v02: SAR Measurement Procedures for USB Dongle Transmitters. Conclusion This portable wireless equipment has been measured in all cases requested by the relevant standards. Test results in Chapter 7 of this test report are below limits specified in the relevant standards. General Judgment: Pass (Stamp) Date of issue: August 3 rd , 2012 Comment The test result only responds to the measured sample. Approved by Director Revised by SAR Manager Performed by SAR Engineer TA Technology (Shanghai) Co., Ltd. Test Report Report No. RXA1206-0418SAR01R1 Page 3 of 63 TABLE OF CONTENT 1. General Information ........................................................................................................................ 4 1.1. Notes of the Test Report.......................................................................................................... 4 1.2. Testing Laboratory ................................................................................................................... 4 1.3. Applicant Information ............................................................................................................... 5 1.4. Manufacturer Information ......................................................................................................... 5 1.5. Information of EUT................................................................................................................... 6 1.6. The Maximum SAR 1g Values ................................................................................................... 7 1.7. Test Date ................................................................................................................................. 7 2. SAR Measurements System Configuration ..................................................................................... 8 2.1. SAR Measurement Set-up ....................................................................................................... 8 2.2. DASY5 E-field Probe System .................................................................................................. 9 2.2.1. EX3DV4 Probe Specification ............................................................................................ 9 2.2.2. E-field Probe Calibration ................................................................................................. 10 2.3. Other Test Equipment ............................................................................................................10 2.3.1. Device Holder for Transmitters ....................................................................................... 10 2.3.2. Phantom ..........................................................................................................................11 2.4. Scanning Procedure ..............................................................................................................11 2.5. Data Storage and Evaluation ................................................................................................. 13 2.5.1. Data Storage...................................................................................................................13 2.5.2. Data Evaluation by SEMCAD ......................................................................................... 13 3. Laboratory Environment................................................................................................................ 15 4. Tissue-equivalent Liquid ............................................................................................................... 16 4.1. Tissue-equivalent Liquid Ingredients...................................................................................... 16 4.2. Tissue-equivalent Liquid Properties ....................................................................................... 16 5. System Check ............................................................................................................................... 17 5.1. Description of System Check ................................................................................................. 17 5.2. System Check........................................................................................................................ 18 6. Operational Conditions during Test ............................................................................................... 19 6.1. General Description of Test Procedures................................................................................ 19 6.2. Position of Module in Portable Devices.................................................................................. 20 6.3. Picture of Host Product ........................................................…

Text truncated - open the document above for the full version.

Report No.: RF110701C18C 1 of 54 Report Format Version 5.0.0 Reference No.: 110701C18 & 120629C17 FCC TEST REPORT REPORT NO.: RF110701C18C MODEL NO.: PW-DN427 FCC ID: WWMDN427V3 RECEIVED: Jul. 1, 2011 TESTED: Jul. 11 ~ 25, 2011 & Jul. 10, 2012 ISSUED: Jul. 13, 2012 APPLICANT: Proware Technologies Co Ltd. ADDRESS: 2nd F1 East Wing,South Section,Factory Building 24,Science&Technology Park,Shennan Rd,Nanshan District,Shenzhen ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS: No. 47, 14th Ling, Chia Pau Vil., Lin Kou Dist., New Taipei City, Taiwan, R.O.C. This report is for your exclusive use. Any copying or replication of this report to or for any other person or entity, or use of our name or trademark, is permitted only with our prior written permission. This report sets forth our findings solely with respect to the test samples identified herein. The results set forth in this report are not indicative or representative of the quality or characteristics of the lot from which a test sample was taken or any similar or identical product unless specifically and expressly noted. Our report includes all of the tests requested by you and the results thereof based upon the information that you provided to us. You have 60 days from date of issuance of this report to notify us of any material error or omission caused by our negligence, provided, however, that such notice shall be in writing and shall specifically address the issue you wish to raise. A failure to raise such issue within the prescribed time shall constitute your unqualified acceptance of the completeness of this report, the tests conducted and the correctness of the report contents. Unless specific mention, the uncertainty of measurement has been explicitly taken into account to declare the compliance or non-compliance to the specification. This report should not be used by the client to claim product certification, approval, or endorsement by TAF or any government agencies. Report No.: RF110701C18C 2 of 54 Report Format Version 5.0.0 Reference No.: 110701C18 & 120629C17 TABLE OF CONTENTS RELEASE CONTROL RECORD...................................................................................4 1. CERTIFICATION.................................................................................................5 2. SUMMARY OF TEST RESULTS.........................................................................6 2.1 MEASUREMENT UNCERTAINTY......................................................................6 3. GENERAL INFORMATION.................................................................................7 3.1 GENERAL DESCRIPTION OF EUT....................................................................7 3.2 DESCRIPTION OF TEST MODES......................................................................8 3.2.1 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL......................9 3.3 DESCRIPTION OF SUPPORT UNITS..............................................................11 3.3.1 CONFIGURATION OF SYSTEM UNDER TEST...............................................11 3.4 GENERAL DESCRIPTION OF APPLIED STANDARDS...................................12 4. TEST TYPES AND RESULTS...........................................................................13 4.1 RADIATED EMISSION AND BANDEDGE MEASUREMENT............................13 4.1.1 LIMITS OF RADIATED EMISSION AND BANDEDGE MEASUREMENT.........13 4.1.2 TEST INSTRUMENTS......................................................................................14 4.1.3 TEST PROCEDURES.......................................................................................15 4.1.4 DEVIATION FROM TEST STANDARD.............................................................15 4.1.5 TEST SETUP....................................................................................................16 4.1.6 EUT OPERATING CONDITIONS......................................................................16 4.1.7 TEST RESULTS................................................................................................17 4.2 CONDUCTED EMISSION MEASUREMENT....................................................30 4.2.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT..................................30 4.2.2 TEST INSTRUMENTS......................................................................................30 4.2.3 TEST PROCEDURES.......................................................................................31 4.2.4 DEVIATION FROM TEST STANDARD.............................................................31 4.2.5 TEST SETUP....................................................................................................31 4.2.6 EUT OPERATING CONDITIONS......................................................................31 4.2.7 TEST RESULTS................................................................................................32 4.3 6dB BANDWIDTH MEASUREMENT................................................................34 4.3.1 LIMITS OF 6dB BANDWIDTH MEASUREMENT..............................................34 4.3.2 TEST SETUP....................................................................................................34 4.3.3 TEST INSTRUMENTS......................................................................................34 4.3.4 TEST PROCEDURE.........................................................................................34 4.3.5 DEVIATION FROM TEST STANDARD.............................................................34 4.3.6 EUT OPERATING CONDITIONS......................................................................34 4.3.7 TEST RESULTS................................................................................................35 4.4 CONDUCTED OUTPUT POWER.....................................................................39 4.4.1 LIMITS OF CONDUCTED OUTPUT POWER MEASUREMENT......................39 4.4.2 TEST SETUP...........................…

Text truncated - open the document above for the full version.

Report No.: RF110701C18C 1 of 2 Report Format Version 5.0.0 Reference No.: 110701C18 & 120629C17 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST Report No.: RF110701C18C 2 of 2 Report Format Version 5.0.0 Reference No.: 110701C18 & 120629C17 RADIATED EMISSION TEST