XS5-CAPM667E7ECarrier Access Point

CommScope Era ™ Medium Power Carrier Access Point Installation Guide • M0201AJE_uc • February 2020 DISCLAIMER This document has been developed by CommScope, and is intended for the use of its customers and customer support personnel. The information in this document is subject to change without notice. While every effort has been made to eliminate errors, CommScope disclaims liability for any difficulties arising from the interpretation of the information contained herein. The information contained herein does not claim to cover all details or variations in equipment, nor to provide for every possible incident to be met in connection with installation, operation, or maintenance. This document describes the performance of the product under the defined operational conditions and does not cover the performance under adverse or disturbed conditions. Should further information be desired, or should particular problems arise which are not covered sufficiently for the purchaser's purposes, contact CommScope. CommScope reserves the right to change all hardware and software characteristics without notice. COPYRIGHT © 2020 CommScope, Inc. All Rights Reserved. This document is protected by copyright. No part of this document may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical photocopying, recording, or otherwise without the prior written permission of CommScope. For patents see www.cs-pat.com. TRADEMARKS All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. Names of other products mentioned herein are used for identification purposes only and may be trademarks and/or registered trademarks of their respective companies. Andrew Wireless Systems GmbH, -February 2020 M0201AJE_ucCommScope Era ™ Medium Power Carrier Access Point Installation Guide © February 2020 CommScope, Inc.Page iii TABLE OF CONTENTS Document Overview .................................................................................................................................................................................. 1 Document Revision History .............................................................................................................................................................................. 1 Document Cautions and Notes......................................................................................................................................................................... 2 Abbreviations Used in this Guide ..................................................................................................................................................................... 3 CommScope Part Numbers .............................................................................................................................................................................. 3 Era System Overview ................................................................................................................................................................................. 4 CAP M Overview ........................................................................................................................................................................................ 5 CAP M Connectors and Power LED................................................................................................................................................................... 6 Notch-Filter Connectors ................................................................................................................................................................................... 8 CAP M Hardware Options................................................................................................................................................................................. 8 Single Mounting Bracket ............................................................................................................................................................................ 8 Dual Mounting Bracket .............................................................................................................................................................................. 9 Pole Mounting Kit for Up to 18" Poles ....................................................................................................................................................... 9 Hybrid Fiber Splice Box............................................................................................................................................................................... 9 OCTIS Kits ................................................................................................................................................................................................... 9 Safely Working with Era Hardware .......................................................................................................................................................... 10 RF Safety Cautions .......................................................................................................................................................................................... 10 Précautions de sécurité relatives aux radiofréquences.................................................................................................................................. 10 Health and Safety Precautions ....................................................................................................................................................................... 10 Property Damage Warnings ........................................................................................................................................................................... 11 General Installation Safety Requirements ......................…

Text truncated - open the document above for the full version.

CAP M 6/6/7E/7E – External photos CONFIDENTIAL Page 1/5 External Photos ION-E CAP M 6/6/7E/7E (7835239-xxxx) CAP M 6/6/7E/7E – External photos CONFIDENTIAL Page 2/5 FRONT VIEW CAP M 6/6/7E/7E – External photos CONFIDENTIAL Page 3/5 REAR VIEW CAP M 6/6/7E/7E – External photos CONFIDENTIAL Page 4/5 BOTTOM VIEW TOP VIEW CAP M 6/6/7E/7E – External photos CONFIDENTIAL Page 5/5 LEFT SIDE RIGHT SIDE

CAP M 6/6/7E/7E – Labels CONFIDENTIAL Page 1/4 Labels on product 7835269-0001 7835269-0002 CAP M 6/6/7E/7E – Labels CONFIDENTIAL Page 2/4 Labels location CAP M 6/6/7E/7E – Labels CONFIDENTIAL Page 3/4 Labels on packaging 7835269-0001 7835269-0002 CAP M 6/6/7E/7E – Labels CONFIDENTIAL Page 4/4 Labels location FCC ID: X5S-CAPM667E7E IC: 2237E-CAPM667E7E

CAP M 6/6/7E/7E – Internal photos CONFIDENTIAL Page 1/5 Internal Photos CAP M 6/6/7E/7E (7835269-000x) CAP M 6/6/7E/7E – Internal photos CONFIDENTIAL Page 2/5 CAP M 6/6/7E/7E – Internal photos CONFIDENTIAL Page 3/5 - PCBA 7781249-02 TOP - PCBA 7781249-02 BOT - CAP M 6/6/7E/7E – Internal photos CONFIDENTIAL Page 4/5 - PCBA 7837503-00 TOP - PCBA 7837503-00 BOT CAP M 6/6/7E/7E – Internal photos CONFIDENTIAL Page 5/5 - PCBA 7837504-00 TOP - PCBA 7837504-00 BOT

CAP M 6/6/7E/7E F‐AC CAP M 6/6/7E/7E F‐DC MPE limits for FCC, 1.1310§90.219 (d)(3)(i) ModeFrequencyDuty CyclePower Antenna Gain 9 Directional Antenna Gain 8 EIRP 5 EIRPERP 7 ERPDistance DPD 6 PD Limit MarginERP Limit PD/PD Limit MHz%dBmdBidBidBmmWdBmWcmmW/cm^2 mW/cm^2dBW 617,0 ‐ 652,0 MH z 1 634.510029.007.010.039.0796236.864.851100.05240.4239.0750.12379 729,0 ‐ 746,0 MH z 2 737.510029.007.010.039.0796236.864.851100.05240.4929.7350.10650 746,0 ‐ 756,0 MH z 3 751.010029.007.010.039.0796236.864.851100.05240.5019.8150.10459 758,0 ‐ 768,0 MH z 4 763.010029.007.010.039.0796236.864.851100.05240.5099.8750.10294 FCC Co‐Location =0.43783< 1 MPE limits for Innovation, Science and Economic Development Canada, RSS‐102 Issue 5 ModeFrequencyDuty CyclePower Antenna Gain 9 Directional Antenna Gain 8 EIRP 5 EIRPDistance DPD 6 PD Limit Magin RSS 102 §2.5.2 Lim. RSS 102 §2.5.2 Marg.PD/PD Limit MHz%dBmdBidBidBmWmW/m^2W/m^2dBWdB 617,0 ‐ 652,0 MH z 1 634.510029.007.010.039.07.9621.100.5242.156.141.078‐8.690.24306 729,0 ‐ 746,0 MH z 2 737.510029.007.010.039.07.9621.100.5242.396.591.194‐8.240.21932 746,0 ‐ 756,0 MH z 3 751.010029.007.010.039.07.9621.100.5242.426.641.209‐8.190.21661 758,0 ‐ 768,0 MH z 4 763.010029.007.010.039.07.9621.100.5242.446.691.222‐8.140.21428 Canada Co‐Location =0.89327< 1 1 TR: 382048TRFWL.pdf 2 TR: 382048‐1TRFWL.pdf 3 TR: 382048‐2TRFWL.pdf 4 TR: 382048‐3TRFWL.pdf 5 EIRP = ( Power dBm + Antenna Gain dBi ) + 10 x Log ( Duty Cycle % / 100 6 PD = EIRP / (4xπxD 2 ) 7 ERP = EIRP ‐ 2,15 8 Directional Antenna Gain = G ANT + 10 x Log (N ANT /N SS ), KDB 662911 D01 §F (2)(e)(i) where (worst case):N ANT = 2 N SS = 1 9 G ANT : customer declaration (see user manual, page 18)

Nemko Spa, 20853 Biassono (MB) - Italy. All rights reserved. T his publication may be reproduced in whole for non-commercial purposes as long as Nemko Spa is acknowledged as copyright owner and source of the material. Nemko Spa takes no responsibility for and will not assume liability for damages resulting from the reader's interpretation of the reproduced material due to its placement and context. Nemko Spa accepts no responsibility for damages, if any, suffered by any third party as a result of decisions made or actions based on this report. This test report may not be partially reproduced, except with the prior written permission of Nemko Spa. The test report merely corresponds to the test sample. The phase of sampling / collection of equipment under test is carried out by the customer. This Test Report, when bearing the Nemko name and logo is only valid when issued by a Nemko laboratory, or by a laboratory having special agreement with Nemko. Report Reference ID: 382048-3TRFWL Test specification: Title 47 – Telecommunication Chapter I – Federal Communications Commission Part 90 – Private land mobile radio services RSS-131 Issue 3 Zone Enhancers RSS-140 Issue 1 Equipment Operating in the Public Safety Broadband Frequency Bands 758-768 MHz and 788-798 MHz Applicant: Andrew Wireless Systems Industriering, 10 – 86675 Buchdorf – Germany Apparatus: Carrier Access Point Model: CAP M 6/6/7E/7E F – AC C AP M 6/6/7E/7E F – DC FCC ID: XS5-CAPM667E7E IC Registration Number: 2237E-CAPM667E7E Testing laboratory: Nemko Spa V ia del Carroccio, 4 – 20853 Biassono (MB) – Italy Name, function and signature Date Tested by: Tessa S. (project handler) 2019-11-26 Reviewed by: Barbieri P. ( verifier) 2019-11-26 Page 2 of 54 Report No. 372462-1TRFWL Table of contents Section 1: Report summary.......................................................................................................... 4 1.1 Test specification .................................................................................................................. 1.2 Statement of compliance ................................................................................................ 1.3 Exclusions ............................................................................................................................ 1.4 Registration number ............................................................................................................. 1.5 Test report revision history ................................................................................................ 1.6 Limits of responsibility ........................................................................................................... Section 2: Summary of test results ............................................................................................. 5 2.1 FCC Part 90, test results....................................................................................................... 2.2 RSS-131 and RSS-140, test results ...................................................................................... Section 3: Equipment under test (EUT) and application details ................................................ 6 3.1 Applicant details ................................................................................................................... 3.2 Modular equipment ............................................................................................................... 3.3 Product details ...................................................................................................................... 3.4 Application purpose .............................................................................................................. 3.5 Certification details ............................................................................................................... 3.6 Composite/related equipment ............................................................................................... 3.7 Sample information ............................................................................................................... 3.8 EUT technical specifications ................................................................................................ 3.9 Accessories and support equipment ..................................................................................... 3.10 Operation of the EUT during testing ...................................................................................... 3.11 EUT setup diagram ............................................................................................................... 3.12 Software version ................................................................................................................... Section 4: Engineering considerations ....................................................................................... 9 4.1 Modifications incorporated in the EUT .................................................................................. 4.2 Deviations from laboratory tests procedures ......................................................................... 4.3 Technical judgment ............................................................................................................... Section 5: Test conditions ......................................................................................................... 10 5.1 Deviations from laboratory tests procedures ....................................................................... 5.2 Test conditions, power source and ambient temperatures .................................................. 5.3 Equipment used for the monitoring of the environmental conditions ................................ 5.4 Measurement uncertainty ................................................................................................ 5.5 Test equipment ..........................................................…

Text truncated - open the document above for the full version.

O N E W O R L D O U R A P P R O V A L Setup photos 382048-1TRFEMC and 382048-2TRFEMC Date of issue: November 21, 2019 Applicant: Andrew Wireless Systems Industriering, 10 – 86675 Buchdorf – Germany Product name: Carrier Access Point Model: CAP M 6/6/7E/7E F-AC; CAP M 6/6/7E/7E F-DC FCC ID: IC Registration number: XS5-CAPM667E7E 2237E-CAPM667E7E Report reference ID: 382048-1TRFEMC and 382048-2TRFEMC Page 2 of 5 Section 1. Setup photos (§15.107 / ICES-003 §6.1) 1.1 Conducted emissions Report reference ID: 382048-1TRFEMC and 382048-2TRFEMC Page 3 of 5 Report reference ID: 382048-1TRFEMC and 382048-2TRFEMC Page 4 of 5 Section 2. Setup photos (§15.109 / ICES-003 §6.2) 2.1 Radiated emissions Report reference ID: 382048-1TRFEMC and 382048-2TRFEMC Page 5 of 5