XU8WN8020AWIRELESS N LAN CARD

TRENDnet WIRELESS N LAN CARD WN8020A USER’S MANUAL 1. Overview WN8020A is high performance and cost effective 802.11b/g/n WLAN USB module. WN8020A is embedded with Ralink RT3070 a highly integrated MAC/BBP and 2.4GHz RF single chip with 150Mbps PHY rate supporting. It fully complies with IEEE 802.11n draft 3.0 and IEEE 802.11b/g feature rich wireless connectivity at high standards, cost-effective, throughput from extended distance. Optimized RF architecture and baseband algorithms provide superb performance and low power consumption. WN8020 is designed t support standard based features in the areas of security, quality of service and international regulation, giving end users the greatest performance anytime in any circumstance. 2. Product Spec. Chip Set Ralink RT3070 Operation Voltage 3.3V Network Standards IEEE802.11b, IEEE802.11g and IEEE802.11n Modulation Technology OFDM, and CCK Data Rate Up to 150Mbps Operating Frequencies 2.412~2.472 GHz Antenna Type SWIVEL TYPE1/4 DIPOLE ANTENNA With RP-SMA Antenna Gain 2.0dBi Channel Bandwidth 20MHz and 40MHz Frequency Stability <5ppm @ Room Temperature +25 OFDM Output Power 15dBm (Typ.) @EVM<3%, all channel CCK Spectral Mask @Pout=18dBm -37dBc (Typ.) @ 11~22MHz -60dBc (Typ.) @ 22~33MHz 2f Harmonics -55dBm (Typ.) LO Leakage Peak Power -64dBm (Typ.) @Transmit State Receiver sensitivity (PER<10%) -65dBm [Typ.] @ HT40M, MCS7 -71dBm [Typ.] @ 54M, OFDM -85dBm [Typ.] @ 11M, CCK -90dBm [Typ.] @ 1M, CCK RF Port Impedance 50Ω±10% USB Differential Port Impedance 90Ω±10% Temperatures(AMBIENT) Operation: 0~60, Storage:-20~70 Hardware Installation ➢Connect the two hex screws to the WN8020 board . ➢The two round head screws are in the WN8020 board. ➢Connect the antenna’s cable to the connector on the card. USA - Federal Communications Commission (FCC) FCC Radiation Exposure Statement CAUTION: • The radiated output power of WiFi Module 802.11bgn devices is far below the FCC radio frequency exposure limits. Nevertheless, WiFi Module 802.11bgn devices should be used in such a manner that the potential for human contact during normal operation is minimized. To avoid the possibility of exceeding the FCC radio frequency exposure limits, you should keep a distance of at least 20 cm between you (or any other person in the vicinity) and the antenna. Interference Statement These devices comply with Part 15 of the FCC Rules. Operation of the devices is subject to the following two conditions: (1) The devices may not cause harmful interference, and (2) The devices must accept any interference that might cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If the equipment is not installed and used in accordance with the instructions, the equipment might cause harmful interference to radio communications. There is no guarantee, however, that such interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception (which can be determined by turning the equipment off and on), the user is encouraged to try to correct the interference by taking one or more of the following measures: • Relocate this device. • Increase the separation between the device and the receiver. • Connect the device into an outlet on a circuit different from that of other electronics. • Consult the dealer or an experienced radio technician for help. Modification warning statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. The end product will be labeled as “Contains Transmitter Module with FCC ID: X8UWN8020A” or “Contains FCC ID: X8UWN8020A.”

TRE We, (the approval holder) Company name Addresss City Country neT TRFNDnet Inc 20675 M<1nhattan Place Un1ted States declare that the following representative (agent): Name (person) Company name Addresss City Country Cerpass Technology Corporation YuanQu St., Nankang Dis. Tcupe1 Ta:wan. R 0 C FCC Authorization Letter Number: CF304 Version: V01 Date: 01-02-201 0 is hereby authorized to apply the following equipment for certification on our behalf: Product Description Type or Model(s) WlnELESS N LAN C/\RD WN302GA Tradename or Brand(s) TRFNDnet ------------------------------------------------------------------- We also authorize Teleconformity, Mr. M. Koop, (address: Rietven 31, 7534NH Enschede, Netherlands) to process this application. Attestation: Function: -~~ignatu--.:;----I _ _ (or official company stamp) ~ ___ j Sr i-'roou::t Manaqe' ~ -/~ ~ ----- --------I

Date: 2011-06-10 Subject: Ad Hoc Mode Function Declaration FCC ID: XU8WN8020A To Whom it may concern, This device is acting as slave and operating in the 2.4 GHz (2412 – 2462 MHz) band. Ad Hoc function is supported but not able to operate on non-US frequencies. Please contact the one signed below or the authorized agent for this filing. Thank you. Regards, Ms. Delia Feng (Authorized Representative) Cerpass Technology Corporation 2F-11, No. 3, YuanQu St., Nankang Dis., Taipei City Taiwan, R.O.C. Phone: +886-2-2655-8100 ext.5206 Fax: +886-2-2655-8200 Email: [email protected]

[company header optional] FCC Declaration of Conformity Number: CF302 Version: V01 Date: 01-02-2010 DoC We, (legal entity within the US, such as importer or manufacturer) Company Name: TRENDNET, Inc. Address: 20675 Manhattan Place, Postal/Zip: 90501 City: Torrance State/Province:California, Country: United States Contact Person: Mr. Ms. Name: Wen Tsai Function:Sr. Product Manager Email: [email protected] Web: Phone:+1-310-961-5500 Fax: +1-310-961-5511 declare for the equipment identified by: Product Description WIRELESS N LAN CARD Type or Model(s) WN8020A Tradename or Brand(s) TRENDnet that: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired op- eration. The following documents are subject to this declaration: Test Firm or Laboratory: Test Report Number: Date of issue: Cerpass Technology Corporation TEFD1103135-A Apr. 26, 2011 Attestation: City and Country: Date: Name: (this must be a person) Function:Signature: (or official company stamp) Torrance, CA90501 2011/04/18 Wen Tsai Sr. Product Manager

CERPASS TECHNOLOGY CORP. Report No.: TEFI1103135-A Cerpass Technology Corp. Issued Date : Apr. 26, 2011 Tel:886-2-2655-8100 Fax:886-2-2655-8200 Page No. : A1 of A3 Appendix A. Photographs of EUT

Label & Location

CERPASS TECHNOLOGY CORP. Report No.: TEFI1103135-A Cerpass Technology Corp. Issued Date : Apr. 26, 2011 Tel:886-2-2655-8100 Fax:886-2-2655-8200 Page No. : A2 of A3 CERPASS TECHNOLOGY CORP. Report No.: TEFI1103135-A Cerpass Technology Corp. Issued Date : Apr. 26, 2011 Tel:886-2-2655-8100 Fax:886-2-2655-8200 Page No. : A3 of A3

CERPASS TECHNOLOGY CORP. Report No.: TEFI1103135-A Cerpass Technology Corp. Issued date : Apr. 26, 2011 Tel:886-2-2655-8100 Fax:886-2-2655-8200 Page No. : 1 of 92 FCC TEST REPORT According to FCC Rules and Regulations Part 15 Subpart C Applicant : TRENDnet, Inc. Address : 20675 Manhattan Place, Torrance, CA90501 Equipment : WIRELESS N LAN CARD Model No. : WN8020A FCC ID. : XU8WN8020A Trade Name : TRENDnet Laboratory Accreditation ‚ The test result refers exclusively to the test presented test model / sample., ‚ Without written approval of Cerpass Technology Corp., the test report shall not be reproduced except in full. ‚ The EUT is also considered as a kind of computer peripheral, because the connection to computer is necessary for typical use. It has been verified to comply with the requirements of FCC Part 15, Subpart B, Class B (DoC). The test report has been issued separately. CERPASS TECHNOLOGY CORP. Report No.: TEFI1103135-A Cerpass Technology Corp. Issued date : Apr. 26, 2011 Tel:886-2-2655-8100 Fax:886-2-2655-8200 Page No. : 2 of 92 Contents 1. Report of Measurements and Examinations .................................................................................... 5 1.1 List of Measurements and Examinations ................................................................................... 5 2. Test Configuration of Equipment under Test ................................................................................... 6 2.1 Feature of Equipment under Test ............................................................................................... 6 2.2 RF Characteristics ...................................................................................................................... 6 2.3 Carrier Frequency of Channels .................................................................................................. 7 2.4 Test Mode and Test Software ..................................................................................................... 7 2.5 Description of Test System ......................................................................................................... 7 2.6 Connection Diagram of Test System .......................................................................................... 7 2.7 General Information of Test ........................................................................................................ 8 2.8 Measurement Uncertainty .......................................................................................................... 8 2.9 History of this test report ............................................................................................................ 9 3. Antenna Requirements ..................................................................................................................... 10 3.1 Standard Applicable ................................................................................................................. 10 3.2 Antenna Construction and Directional Gain ............................................................................. 10 4. Test of Conducted Emission ............................................................................................................ 11 4.1 Test Limit .................................................................................................................................. 11 4.2 Test Procedures ....................................................................................................................... 11 4.3 Typical Test Setup .................................................................................................................... 12 4.4 Measurement Equipment ......................................................................................................... 12 4.5 Test Result and Data ................................................................................................................ 13 4.6 Test Photographs ..................................................................................................................... 19 5. Test of Radiated Emission ............................................................................................................... 20 5.1 Test Limit .................................................................................................................................. 20 5.2 Test Procedures ....................................................................................................................... 20 5.3 Typical Test Setup .................................................................................................................... 21 5.4 Measurement Equipment ......................................................................................................... 21 5.5 Test Result and Data ................................................................................................................ 22 5.6 Test Photographs ..................................................................................................................... 58 6. 6dB Bandwidth Measurement Data ................................................................................................. 59 6.1 Test Limit .................................................................................................................................. 59 6.2 Test Procedures ....................................................................................................................... 59 6.3 Test Setup Layout .................................................................................................................... 59 6.4 Measurement Equipment ......................................................................................................... 59 6.5 Test Result and Data ................................................................................................................ 59 7. Maximum Peak Output Power ...........................…

Text truncated - open the document above for the full version.

Test Result of RF Exposure Evaluation . Product: WIRELESS N LAN CARD . Test Item: RF Exposure Evaluation Data . Test site: OATSI-SD Antenna Gain Frequency Range: 2.412-2.462 GHz Antenna type: Dipole Antenna Antenna Gain: 2 dBi EUT Operation condition Software provided by client enabled the EUT to transmit and receive data at lowest, middle and highest channel individually. Output Power into Antenna & RF Exposure Evaluation Distance Test Date: May. 21, 2010 Temperature: 25 Atmospheric pressure: 1022 hPa Humidity: 66% Modulation Standard Channel Frequency (MHz) Output Power to Antenna (dBm) Power Density (S) (mW/cm 2 ) 802.11b (11Mbps) 01 2412 15.26 0.011 06 2437 15.35 0.011 11 2462 15.27 0.011 802.11g (54Mbps) 01 2412 15.03 0.010 06 2437 15.33 0.011 11 2462 15.14 0.010 802.11n HT20 (65Mbps) 01 2412 15.42 0.011 06 2437 15.12 0.010 11 2462 14.98 0.010 802.11n HT40 (130Mbps) 03 2422 15.53 0.011 06 2437 15.58 0.011 09 2452 15.41 0.011 The MPE is calculated as 0.011 mW / cm 2 < limit 1 mW / cm 2 . So, RF exposure limit warning or SAR test are not required.

CERPASS TECHNOLOGY CORP. Report No.: TEFI1103135-A Cerpass Technology Corp. Issued date : Apr. 26, 2011 Tel:886-2-2655-8100 Fax:886-2-2655-8200 Page No. : 19 of 92 4.6 Test Photographs Front View Rear View CERPASS TECHNOLOGY CORP. Report No.: TEFI1103135-A Cerpass Technology Corp. Issued date : Apr. 26, 2011 Tel:886-2-2655-8100 Fax:886-2-2655-8200 Page No. : 58 of 92 5.6 Test Photographs Front View Rear View