YKGRCUFORC UFO

FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an e xperienced radio/TV technician for help.

Mindscope Products Inc. P.O. Box 9525, Glendale CA 91226, United States DATE :2013-09-06 Nemko Canada Inc 303 River Road Ottawa, Ontario, Canada K1V 1H2 Attn: Director of Certification Authority to Act as Agent On our behalf, I appoint Hans.Hu of Global United Technology Services Co., Ltd. 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District Shenzhen Guangdong to act as our agent in the preparation of this application for equipment certification. I certify that submitted documents properly describe the device or system for which equipment certification is sought. I also certify that each unit manufactured, imported or marketed, as defined in the Federal Communications Commission’s regulations will have affixed to it a label identical to that submitted for approval with this application. For instances where our authorized agent signs the application for certification on our behalf, I acknowledge that all responsibility for complying with the terms and conditions for certification, as specified by Nemko Canada Inc, still resides with Mindscope Products Inc. and P.O. Box 9525, Glendale CA 91226, United States Dated this / Day of 09/06/2013 / Agency agreement expiration date: 09/06/2014 By: Balanchi George Signature Printed Title: President On behalf of : Mindscope Products Inc. Telephone: 626.398.2000

Mindscope Products Inc. P.O. Box 9525, Glendale CA 91226, United States 2013-09-06 Equipment Autorisation Division Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: YKGRCUFO Product Name: RC UFO Request for Confidentiality Pursuant to Sections 0.457 and 0.459 of the commissions rules, we hereby request that the following documents be held confidential:  Schematics  Block diagram  Operational Description These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our competitors. Dated this 09/06/2013 By: Balanchi George Signature Printed Title: President On behalf of : Mindscope Products Inc. Telephone: 626.398.2000

Mindscope Products Inc. Product Name:RC UFO Model:47664 FCC ID: YKGRCUFO Label size: 1.3cm*4cm

Global United Technology Services Co., Ltd. Report No: GTSE13080142701 Authorized Signature: Robinson Lo Laboratory Manager This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the GTS product certification mark. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This report may only be reproduced and distributed in full. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of GTS International Electrical Approvals or testing done by GTS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by GTS International Electrical Approvals in writing. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” FCC REPORT Applicant: Mindscope Products Inc. Address of Applicant: P.O. Box 9525, Glendale CA 91226, United States Equipment Under Test (EUT) Product Name: RC UFO Model No.: 47664 FCC ID: YKGRCUFO Applicable standards: FCC CFR Title 47 Part 15 Subpart C Section 15.227:2012 Date of sample receipt: August 27, 2013 Date of Test: August 27-September 04, 2013 Date of report issued: September 05, 2013 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. Report No.: GTSE13080142701 Global United Technology Services Co., Ltd. Project No.: GTSE130801427RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 2 of 12 2 Version Version No. Date Description 00 September 05, 2013 Original Prepared By: Date: September 05, 2013 Project Engineer Check By: Date: September 05, 2013 Reviewer Report No.: GTSE13080142701 Global United Technology Services Co., Ltd. Project No.: GTSE130801427RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 3 of 12 3 Contents Page 1 COVER PAGE........................................................................................................................................... 1 2VERSION .................................................................................................................................................. 2 3CONTENTS .............................................................................................................................................. 3 4TEST SUMMARY ..................................................................................................................................... 4 5GENERAL INFORMATION ...................................................................................................................... 5 5.1C LIENTINFORMATION.......................................................................................................................... 5 5.2G ENERALDESCRIPTION OF E.U.T. ...................................................................................................... 5 5.3E.U.T O PERATION MODE.................................................................................................................... 5 5.4T ESTFACILITY.................................................................................................................................... 6 5.5T ESTLOCATION.................................................................................................................................. 6 5.6O THERINFORMATION REQUESTED BY THE CUSTOMER......................................................................... 6 6TEST INSTRUMENTS LIST ..................................................................................................................... 7 7TEST RESULTS AND MEASUREMENT DATA...................................................................................... 8 7.1A NTENNA REQUIREMENT: .................................................................................................................... 8 7.2R ADIATEDEMISSION........................................................................................................................... 9 7.2.1Field Strength Of The Fundamental Signal ............................................................................... 10 7.2.2Spurious Emissions ................................................................................................................... 10 7.320 DBBANDWIDTH............................................................................................................................ 11 Report No.: GTSE13080142701 Global United Technology Services Co., Ltd. Project No.: GTSE130801427RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 4 of 12 4 Test Summary Test Item Section in CFR 47 Result Antenna requirement 15.203 Pass Field strength of the fundamental signal 15.227 (a) Pass Spurious emissions 15.227/15.209 Pass 20dB Bandwidth ANSI C63.4/15.215 Pass Pass: The EUT comply with the essential requirements in the standard. Report No.: GTSE13080142701 Global United Technology Services Co., Ltd. Project No.: GTSE130801427RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 51810…

Text truncated - open the document above for the full version.