YW2-FOLZKFLEXZAGGkeys FLEX

FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. To assure continued compliance, any changes or modifications not expressly approved by the party Responsible for compliance could void the user’s authority to operate this equipment. (Example- use only shielded interface cables when connecting to computer or peripheral devices). RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Declaration of Conformity Hereby, Wagons Digital Co., Ltd. declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. IC Statement - English: " This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device." - French:" Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement."

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 2 Rev 2.0 2206 Ringwood Avenue San Jose, CA 95131 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Project and Product Certification Representative Authorization Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (current) 1.0 1.0 Nov-14-2006 Revised wording (current) 1.0 2.0 Sept–25-2007 SCS-F18: Project and Product Certification Representative Authorization Letter Page 2 of 2 Rev 2.0 Wagons Digital Co., Ltd. 2011-09-20 To: SIEMIC, INC. 2206 Ringwood Avenue, San Jose, CA 95131 USA Dear Sir/Madam, Re: Project and Product Certification Representative Authorization Letter We, Wagons Digital Co., Ltd. hereby authorize SIEMIC, INC. to act as a Certification Body for certifying for the following project(s): (ZAGGkeys FLEX, FOLZKFLEX) We affirm that between SIEMIC and Wagons Digital Co., Ltd. any difference in understanding, including test plan, measurement methods, applicable standards and relevant procedures and processes have been resolved prior to commencement of testing activities. Sincerely, Signature KEI YAU LAM/ Marketing Manager E-mail : [email protected] Phone : 852-31176172 Fax : 852-31176172 Address : Flat/Rm.1701, 17/F., Henan Building, 90 Jaffe Road, Wanchai, Hongkong

Wagons Digital Co., Ltd. Date:2011-09-20 To: Federal Communications Commission 7435 Oakland Mills Road Columbia, MD FCC ID: YW2-FOLZKFLEX To Whom It May Concern: This letter is to ascertain that Wagons Digital CO., LTD. Product ZAGGkeys FLEX, has been the units used for conducting FCC compliance testing, the DoC part will be tested by FCC recognized test lab. If you have any question or concerns, pls. contact us. Sincerely, Signature KEI YAU LAM/ Marketing Manager E-mail : [email protected] Phone : 852-31176172 Fax : 852-31176172 Address : Flat/Rm.1701, 17/F., Henan Building, 90 Jaffe Road, Wanchai, Hongkong

SCS-F19: Confidentiality Request Letter Page 1 of 2 Rev 2.0 2206 Ringwood Avenue San Jose, CA 95131 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Confidentiality Request Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (current) 1.0 1.0 Nov-14-2006 Adding CFR 2.459 1.0 2.0 August – 11 - 2008 SCS-F19: Confidentiality Request Letter Page 2 of 2 Rev 2.0 Wagons Digital Co., Ltd. 2011-09-20 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Subject: Permanent Confidentiality Request for FCC ID: YW2-FOLZKFLEX We hereby request confidential treatment of information accompanying this application as outlined below: - Block Diagram - Schematic Diagram - Circuit Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Signature KEI YAU LAM/ Marketing Manager E-mail : [email protected] Phone : 852-31176172 Fax : 852-31176172 Address : Flat/Rm.1701, 17/F., Henan Building, 90 Jaffe Road, Wanchai, Hongkong

Report No.: TB-FCC112054 Page: 3 of 9 TB-RF-075-1.0 Appendix III EUT External Photographs Photo 1 Appearance of EUT Photo 2 Appearance of EUT Report No.: TB-FCC112054 Page: 4 of 9 TB-RF-075-1.0 Photo 3 Appearance of EUT Photo 4 Appearance of EUT Report No.: TB-FCC112054 Page: 5 of 9 TB-RF-075-1.0 Photo 5 Appearance of EUT

Report No.: TB-FCC112054 Page: 2 of 9 TB-RF-075-1.0 Appendix II ID Label Location FCC ID LOCATION

Shenzhen Meihua Electronic Technology Co., Ltd. Report No.: TB-FCC112054 Page: 1 of 56 TB-RF-074-1.0 Room 505, East DingXin Bldg., LiuXian Road, XiLi Town, Nanshan, Shenzhen, China Tel: +86 75526292087 Fax: +86 75526751700 FCC Radio Test Report FCC ID: YW2-FOLZKFLEX Report No. : TB-FCC112054 Applicant : Wagons Digital Co., Ltd. Equipment Under Test (EUT) EUT Name : ZAGGkeys FLEX Model No. : FOLZKFLEX Serial No. : N/A Brand Name : ZAGG Receipt Date : 2011-09-13 Test Date : 2011-09-14 to 2011-09-20 Issue Date : 2011-09-21 Standards : FCC Part 15, Subpart C(15.247)/ Canada RSS-210:2010 Test Method : ANSI C63.4:2003 Conclusions : PASS In the configuration tested, the EUT complied with the standards specified above, The EUT technically complies with the FCC requirements Test/Witness Engineer : Approved& Authorized : This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in the report. Report No.: TB-FCC112054 Page: 2 of 56 TB-RF-074-1.0 Contents CONTENTS.............................................................................................................................................2 1. GENERAL INFORMATION ABOUT EUT.............................................................................4 1.1 Client Information.................................................................................................................4 1.2 General Description of EUT (Equipment Under Test)...................................................4 1.3 Block Diagram Showing The Configuration of System Tested.....................................6 1.4 Description of Support Units..............................................................................................6 1.5 Description of Test Mode....................................................................................................7 1.6 Test Facility...........................................................................................................................7 2. TEST SUMMARY.......................................................................................................................8 3. CONDUCTED EMISSION TEST.............................................................................................9 3.1 Test Standard and Limit......................................................................................................9 3.2 Test Setup.............................................................................................................................9 3.3 Test Procedure.....................................................................................................................9 3.4 Test Equipment Used........................................................................................................10 3.5 EUT Operating Mode........................................................................................................10 3.6 Test Data.............................................................................................................................10 4. RADIATED EMISSION TEST................................................................................................13 4.1 Test Standard and Limit....................................................................................................13 4.2 Test Setup...........................................................................................................................14 4.3 Test Procedure...................................................................................................................15 4.4 EUT Operating Condition.................................................................................................15 4.5 Test Equipment..................................................................................................................16 5. RESTRICTED BANDS REQUIREMENT.............................................................................29 5.1 Test Standard and Limit....................................................................................................29 5.2 Test Setup...........................................................................................................................29 5.3 Test Procedure...................................................................................................................29 5.4 EUT Operating Condition.................................................................................................30 5.5 Test Equipment..................................................................................................................30 6. NUMBER OF HOPPING CHANNEL....................................................................................33 6.1 Test Standard and Limit....................................................................................................33 6.2 Test Setup...........................................................................................................................33 6.3 Test Procedure...................................................................................................................33 6.4 EUT Operating Condition.................................................................................................33 6.5 Test Equipment..................................................................................................................33 7. AVERAGE TIME OF OCCUPANCY.....................................................................................35 7.1 Test Standard and Limit....................................................................................................35 7.2 Test Setup...........................................................................................................................35 7…

Text truncated - open the document above for the full version.

Report No.: TB-FCC112054 Page: 8 of 9 TB-RF-075-1.0 Appendix V EUT Test Photographs Photo of Setup for Radiated Emission (Above 1 GHz) Photo of Setup for Radiated Emission (Bellow 1 GHz) Report No.: TB-FCC112054 Page: 9 of 9 TB-RF-075-1.0 Photo of Setup for Conducted Emission