C5F7NF9PMO100NCommercial Microwave Oven

Before operating this oven, please read these instructions completely. OPERATING INSTRUCTIONS MICROWAVE OVEN KOM-9P0C 1 PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY (a) Do not attempt to operate this oven with the door opensince open-door operation can result in harmful exposure to microwave energy. It is important not to defeat or tamper with the safety interlocks. (b) Do not place any objectbetween the oven front face and the door or allow soil or cleaner residue to accumulate on sealing surfaces. (c) Do not operate the oven if it is damaged.It is particularly important that the oven door close properly and that there is no damage to the: (1) door (bent), (2) hinges and latches (broken or loosened), (3) door seals and sealing surfaces. (d) The oven should not be adjusted or repaired by anyone except properly qualified service personnel. TABLE OF CONTENTS PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY ................................................................................................................ 1 TABLE OF CONTENTS ...................................................................................................................................... 1 IMPORTANT SAFETY INSTRUCTION............................................................................................................... 2 FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT.......................................................................................................................... 3 GROUNDING INSTRUCTIONS .......................................................................................................................... 3 INSTALLATION................................................................................................................................................... 4 SPECIFICATIONS .............................................................................................................................................. 5 FEATURES DIAGRAM ....................................................................................................................................... 6 OPERATION PROCEDURE ............................................................................................................................... 8 CONTROLS ........................................................................................................................................................ 9 TIME DEFROSTING...................................................................................................................................... 9 COOKING IN ONE STAGE ......................................................................................................................... 10 MEMORY FUNCTION ................................................................................................................................. 11 +30 SEC ...................................................................................................................................................... 12 CHECK FUNCTION..................................................................................................................................... 12 DOUBLE QUANTITY FUNCTION ............................................................................................................... 12 CHILD SAFETY LOCK ................................................................................................................................ 13 POWER SAVE MODE................................................................................................................................. 13 MUTE FUNCTION ....................................................................................................................................... 13 TO STOP THE OVEN WHILE THE OVEN IS OPERATING ....................................................................... 13 ABNORMAL MESSAGE...............................................................................................................................13 COOKING INSTRUCTION ................................................................................................................................ 14 COOKING UTENSILS ....................................................................................................................................... 14 MICROWAVING PRINCIPLES ......................................................................................................................... 15 HOW MICROWAVES COOK FOOD................................................................................................................. 15 COOKING TECHNIQUES ................................................................................................................................. 16 DEFROSTING GUIDE ...................................................................................................................................... 17 DEFROSTING CHART ..................................................................................................................................... 18 COOKING CHART ............................................................................................................................................ 19 REHEATING CHART ........................................................................................................................................ 20 CARE OF YOUR MICROWAVE OVEN ............................................................................................................ 22 USE YOUR MICROWAVE OVEN SAFELY ...................................................................................................... 23 BEFORE YOU CALL FOR SERVICE ............................................................................................................... 24 QUESTIONS AND ANSWERS ...........................................................…

Text truncated - open the document above for the full version.

FCC ID: C5F7NF9PMO100N Note: Components outlined with dotted line is optional and may not be employed in the model Lamp H.V. CapacitorH.V. Transformer Fan Motor Heating Element Turntable Motor H.V. Diode Magnetron Oven Cavity BLOCK DIAGRAM Input 120Vac 60Hz Conrol Panel (Clock Frequency 4MHz)

Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 41 of 51 APPENDIX C – EUT PHOTOGRAPHS  Front View of EUT Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 42 of 51  Rear View of EUT

Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 35 of 51 APPENDIX A – SAMPLE LABEL The sample label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time of purchase.  FCC ID Location of EUT Labeling Requirements

Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 43 of 51  Door open View of EUT Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 44 of 51  Left View of Inside Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 45 of 51  Right View of Inside Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 46 of 51  Top View of Inside Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 47 of 51  Front View of Magnetron Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 48 of 51  Rear View of Magnetron

Model : KOM-9P0C ■ OPERATION DESCRIPTION After suppling main power to microwave oven, press start button, then low voltage circuit parts supply DC 5V to the micom in control panel. The micom makes main relays keep on-state in sequency, and makes seperated high voltage circuit for magnetron. This high voltage circuit consists of combination of H.V Transformer, H.V Capacitor and H.V Diode, and generats about DC 4kV. This high voltage is supplied to magnetron of top. Microwave generated by magnetrons and guided to the oven cavity. Lamp H.V.H.V. Fan Motor Heating Turntable H.V. Magnetro Oven Cavity BLOCK DIAGRAM Input 120Vac Conrol Panel

Object / Part No MODEL / SPEC. Manufacturer / Trademark Remark 1 MAGNETRON 2M248 Toshiba 2 TRANS H.V. DYAR10A0-9PT S DPC 3 CAPACITOR H.V. 2300VAC, 1.05 ㎌ Elcomtec 4 DIODE H.V. HV03-12 400MA 12000V Several 5 FAN MOTOR 120V 60HZ OEM-15DWX1-B07-R Oh Sung 6 STIRRER MOTOR 120V 60Hz SM16F 20V, 3W Elensys 7 INTERLOCK SWITCH 16 A, 125/250 V ac Several ■ Parts list for the high voltage circuit. : Main electrical Components

3. Wiring Diagram ( SCHEMATICS ) FCC ID: C5F7NF9PMO10ØN

Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 2 of 51 TABLE OF CONTENTS SCOPE INTRODUCTION (Site Description) EUT INFORMATION DESCRIPTION OF TESTS (Radiation Hazard) DESCRIPTION OF TESTS (Input Power Measurement) DESCRIPTION OF TESTS (RF Output Power Measurement) DESCRIPTION OF TESTS (Operating Frequency Measurements) DESCRIPTION OF TESTS (Conducted Emissions) DESCRIPTION OF TESTS (Radiated Emissions) TEST DATA (Radiation Hazard) TEST DATA (Input Power Measurement) TEST DATA (RF Output Power Measurement) TEST DATA (Operating Frequency Measurements) TEST DATA (Conducted Emissions) TEST DATA (Radiated Emissions) PLOT OF EMISSIONS (Operating Frequency Measurements) PLOT OF EMISSIONS (Conducted Emissions Diagram) PLOT OF EMISSIONS (Radiated Emissions Diagram) ACCURACY OF MEASUREMENT LIST OF TEST EQUIPMENT APPENDIX A - SAMPLE LABEL APPENDIX B - PHOTOGRAPHS OF TEST SET-UP APPENDIX C - EUT PHOTOGRAPHS APPENDIX D - SCHEMATIC DIAGRAM APPENDIX E - USER’S MANUAL APPENDIX F - BLOCK DIAGRAM 3 4 5 6 6 6 6 7 8 9 9 9 10 12 13 16 25 27 29 34 35 36 41 49 50 51 Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 3 of 51 SCOPE Measurement and determination of electromagnetic emissions (EME) of radio frequency devices including intentional and/or unintentional radiators for compliance with the technical rules and regulations of the Federal Communications Commission under FCC part 18. Responsible Party : Contact Person : Manufacturer : Factory : Daewoo Electronics Corporation Mr. Kyunghoi Yang Tel No.: + 82 32 510 7910 Daewoo Electronics Corporation 412-2, Cheongcheon2-Dong, Bupyeong-Gu, Incheon, 403-032, Korea Daewoo Microwave Oven Co., Ltd. Development Area, Binhai New Area Tianjin China  FCC ID: C5F7NF9PMO100N  Model: KOM-9P** Note 1) First “*” : 0 ~ 9 or A ~ Z (Enclosure design difference) Note 2) Second “*” : 0 ~ 9 (Mechanical type) or A ~ Z (Electrical type)  Brand Name: DAEWOO  EUT Type: Commercial Microwave Oven  Applied Standard:  Test Procedure(s):  Dates of Test:  Place of Tests:  Test Report No.: FCC Part 18 & Part 2 MP-5:1986 March 05, 2013 to March 12, 2013 Nemko Korea Co., Ltd. EMC Site NK-13-E-186 ※ The model KOM-9P0C was tested and was recorded the data in test report. Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 4 of 51 INTRODUCTION The measurement procedure described in MP5:1986 for Methods of Measurement of radiated, powerline conducted radio noise, frequency and power output was used in determining emissions emanating from Daewoo Electronics Corporation. FCC ID : C5F7NF9PMO100N, Commercial Microwave Oven. These measurement tests were conducted at Nemko Korea Co., Ltd. EMC Laboratory. The site address is 155 & 159, Osan-Ro, Mohyeon-Myeon, Cheoin-Gu, Yongin-Si, Gyeonggi-Do 449-852 KOREA, REPUBLIC OF The area of Nemko Korea Corporation Ltd. EMC Test Site is located in a mountain area at 80 kilometers (48 miles) southeast and Incheon International Airport (Incheon Airport), 30 kilometers (18 miles) south-southeast from central Seoul. It is located in the valley surrounded by mountains in all directions where ambient radio signal conditions are quiet and a favorable area to measure the radio frequency interference on open field test site for the computing and ISM devices manufactures. The detailed description of the measurement facility was found to be in compliance with the requirements of §2.948 according to ANSI C63.4 on 2003. Fig. 1. The map above shows the Seoul in Korea vicinity area. The map also shows Nemko Korea Corporation Ltd. EMC Lab and Incheon Airport. ☜ Nemko Korea Co., Ltd. 155 & 159, Osan-Ro, Mohyeon-Myeon, Cheoin-Gu, Yongin-Si, Gyeonggi-Do 449-852 KOREA, REPUBLIC OF Tel) + 82 31 330 1700 Fax) + 82 31 322 2332 Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 5 of 51 EUT INFORMATION EUT Information Electric Rating : a.c. 120 V, 60 Hz Clock : 4 MHz Magnetron Type : 2M248 (TOSHIBA) Operating Frequency : 2.45 GHz Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 6 of 51 DESCRIPTION OF TESTS Radiation Hazard A 700 ml water load was placed in the center of the oven. The power setting was set to maximum power. While the oven was operating, the Microwave Survey Meter probe was moved slowly around the door seams to check for leakage. Input Power Measurement The EUT was placed on a wooden table 0.8 m at 1 m distance Horn antenna. A 700ml water load was placed in the center of the oven and the oven set to maximum power. A 700 ml water load was chosen for its compatibility. Input power and current were measured using a Power Analyzer. Manufacturers to determine their input ratings commonly use this procedure. Output Power Measurement The Caloric Method was used to determine maximum output power. The initial temperature of a 1000 ml water load was measured. The water load was placed in the center of the oven. The oven was operated at maximum output power for 120 seconds. Then the temperature of the water re-measured. Frequency Measurements Following the above test, after operating the oven long enough to assure that stable operating temperature were obtained, the operating frequency was monitored as the input voltage was varied between 80 to 125 percent of the nominal rating. And the load quantity was reduced by evaporation to approximately 20 % of the original quantity with nominal rating. Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 7 of 51 DESCRIPTION OF TESTS Conducted Emissions The Line conducted emission test facility is located inside a 4 x 7 x 2.5 meter shielded enclosure. It is manufactured by EM engineering. The shielding effectiveness of the shielded room is in accordance with MIL-STD-285 or NSA 65-6. A 1 m X 1.5 m wooden table…

Text truncated - open the document above for the full version.

Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 36 of 51 APPENDIX B – PHOTOGRAPHS OF TEST SET-UP The Conducted Test Picture and Radiated Test Picture and show the worst-case configuration and cable placement. ● Radiation hazard Test Picture  Operating Frequency Test Picture Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 37 of 51  Conducted Test Picture (Front)  Conducted Test Picture (Rear) Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 38 of 51  Radiated Test Picture – 0.15 MHz ~ 30 MHz (Front)  Radiated Test Picture – 0.15 MHz ~ 30 MHz (Rear) Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 39 of 51  Radiated Test Picture – 30 MHz ~ 1 GHz (Front)  Radiated Test Picture – 30 MHz ~ 1 GHz (Rear) Test Report No.: NK-13-E-186 FCC Certification Daewoo Electronics Corporation FCC ID: C5F7NF9PMO100N Page 40 of 51  Radiated Test Picture – 1 GHz ~ 18 GHz (Front)  Radiated Test Picture – 1 GHz ~ 18 GHz (Rear)