E675JS0123Multi-carrier RF Power Amplifier

Base Station Solutions Powerwave G3L 850-180 MCPA INSTALLATION AND SERVICE MANUAL 044-05454 Rev. A January 2012 © 2011 Powerwave Technologies Incorporated. All rights reserved. Powerwave Technologies, and the Powerwave logo are registered trademarks. This Powerwave product is intended only for installation in a RESTRICTED ACCESS LOCATION and this Powerwave product is designed to operate within the normal operating (typical operating) ranges or conditions specified in this document. Operation of this equipment beyond the specified ranges in this document may cause: 1. Spurious emissions that violate regulatory requirements. 2. The equipment to be automatically removed from service when maximum thresholds are exceeded. 3. The equipment to not perform in accordance with its specifications. It is the operator’s responsibility to ensure this equipment is properly installed and operated within Powerwave specifications to obtain proper performance from the equipment and to comply with regulatory requirements. For PERMANENTLY CONNECTED EQUIPMENT, a readily accessible disconnect device shall be incorporated in the building permanent wiring. FCC CFR 47 Part 15.21: Changes or modifications to this equipment not expressly approved by Powerwave could void the user's authority to operate the equipment. FCC CFR 47 Part 15.105: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Powerwave Technologies Inc., 1801 East St. Andrew Place, CA 92705 Santa Ana, USA. Phone +1 714 466 1000 – Fax +1 714 466 5800 – Internet www.powerwave.com G3L-850-180Warnings, Cautions, and Notes 044-05454 Rev Ai Warnings, Cautions, and Notes Warnings, Cautions, and Notes are found throughout this manual where applicable. The associated icons are used to quickly identify a potential condition that could result in the consequences described below if precautions are not taken. Notes clarify and provide additional information to assist the user. WARNING: This warning symbol means danger. You are in a situation that could cause bodily injury or death. Before working on any equipment, be aware of the hazards involved with electrical and RF circuits and be familiar with standard practices for preventing accidents. CAUTION: The caution symbol means reader be careful. In this situation, the user might do something that could result in equipment damage or loss of data. NOTEThe note symbol means reader take note. Notes contain helpful suggestions or ref- erences to material not covered in this document. Procedures are not contained in not es. G3L-850-180Warnings, Cautions, and Notes 044-05454 Rev Aii Revision Record Revision Letter Date of ChangeReason for Change AJanuary 2012Initial Release G3L-850-180Table of Contents 044-05421 Rev Aiii TABLE OF CONTENTS 1 - Product Description Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-1 Scope of Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-1 Product Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-1 Functional Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-1 Preamplifier . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-3 Main and Error Amplifiers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-3 Feed-forward Loop Control Circuits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-3 Pilot Tone Generator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-4 Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-4 Cooling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-4 Power Distribution . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-4 Derating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-4 2 - Controls and Indicators Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-1 MCPA Controls and Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-1 MCPA Alarms. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-1 MCPA Connectors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-3 3 - Installation Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . …

Text truncated - open the document above for the full version.

1801 E. St. Andrew Place, Santa Ana, CA 92705 USA www.powerwave.com +1.714.466.1000 Fax. +1.714.466.5800 Friday, October 21, 2011 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Re: Request for Confidentiality In reference to the application under FCC ID: E675JS0123, and pursuant to Sections 0.457(d)(1)(ii) and 0.459 of the Commission's Rules, the Applicant hereby requests confidential treatment of the accompanying information as outlined below: Block Diagram, Schematic Diagrams, Operation Description The above materials contain trade secrets and proprietary information not customarily released to the public. The internal circuitry design uses proprietary techniques that are not known by the general public / industry. Powerwave Technologies customers have signed non-disclosure agreements. This product is only serviceable by Powerwave Technologies or a licensee. It is definitely not accessible by the general public in its deployment location(s). The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457(d)(1)(ii), disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Charlotte Yu Reliability Engineer (714) 466-1732 (714) 466-5807 FAX [email protected]

1801 E. St. Andrew Place, Santa Ana, CA 92705 USA www.powerwave.com +1.714.466.1000 Fax. +1.714.466.5800 Friday, October 21, 2011 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Re: Request for Confidentiality In reference to the application under FCC ID: E675JS0123, and pursuant to Sections 0.457(d)(1)(ii) and 0.459 of the Commission's Rules, the Applicant hereby requests confidential treatment of the accompanying information as outlined below: Internal Photographs The above materials contain trade secrets and proprietary information not customarily released to the public. The internal circuitry design uses proprietary techniques that are not known by the general public / industry. Powerwave Technologies customers have signed non-disclosure agreements. This product is only serviceable by Powerwave Technologies or a licensee. It is definitely not accessible by the general public in its deployment location(s). The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The release date is April 1, 2012. The Applicant understands that pursuant to Rule 0.457(d)(1)(ii), disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Charlotte Yu Reliability Engineer (714) 466-1732 (714) 466-5807 FAX [email protected]

Functional DescriptionG3L-850-160 MCPA 1-2044-05236 Rev A • Controller Figure 1-1 MCPA Front and Rear Views Front Rear

Internal Internal Boards Internal PCB RF Filter RF Filter EUT ID Labeling

1801 E. St. Andrew Place, Santa Ana, CA 92705 USA www.powerwave.com +1.714.466.1000 Fax. +1.714.466.5800 Friday, October 21, 2011 To Whom It May Concern: The G3L-850-180 Velocity 850 MCPA product has no tune up procedure. It is controlled at the factory. The product will be completely tuned and tested before it is shipped to customers. Sincerely, Charlotte Yu Sr. Reliability Engineer Powerwave Technologies, Inc. 1801 E. St. Andrew Place Santa Ana, CA92705

This report contains a total of 74 pages and may be reproduced in full only. Partial reproduction may only be done with the written consent of CKC Laboratories, Inc. Powerwave Technologies, Inc. TEST REPORT FOR Multi-carrier RF Power Amplifier, G3L-850-180 Tested To The Following Standards: FCC Part 22 H and RSS-131 Issue 2 Report No.: 92273-8 Date of issue: October 14, 2011 This test report bears the accreditation symbol indicating that the testing performed herein meets the test and reporting requirements of ISO/IEC 17025 under the applicable scope of EMC testing for CKC Laboratories, Inc. We strive to create long-term, trust based relationships by providing sound, adaptive, customer first testing services. We embrace each of our customers’ unique EMC challenges, not as an interruption to set processes, but rather as the reason we are in business. Page 2 of 74 Report No.: 92273-8 TABLE OF CONTENTS Administrative Information .......................................................................................................................... 3 Test Report Information ............................................................................................................................................ 3 Report Authorization ................................................................................................................................................. 3 Test Facility Information ............................................................................................................................................ 4 Site Registration & Accreditation Information .......................................................................................................... 4 Summary of Results ................................................................................................................................................... 5 Conditions During Testing.......................................................................................................................................... 5 Equipment Under Test ............................................................................................................................................... 6 Peripheral Devices ..................................................................................................................................................... 6 FCC Part 22 H ................................................................................................................................................ 7 FCC 2.1033(c)(14)/2.1046/22.913(a) - RF Power Output .......................................................................................... 7 FCC 2.1033(c)(14)/2.1047(a) - Audio Frequency Response ....................................................................................... 8 FCC 2.1033(c)(14)/2.1047(b) - Modulation Limiting Response ................................................................................. 8 FCC 2.1033(c)(14)/2.1049- Occupied Bandwidth ...................................................................................................... 9 FCC 2.1033(c)(14)/2.1051/22.917(a) - Spurious Emissions at Antenna Terminal ................................................... 26 FCC 2.1033(c)(14)/2.1053/22.917(a) - Field Strength of Spurious Radiation .......................................................... 33 FCC 2.1033(c)(14)/2.1055/22.355 - Frequency Stability.......................................................................................... 38 FCC 22.917(b) - Block Edge ...................................................................................................................................... 38 EIA/TIA 603 - Intermodulation ................................................................................................................................. 46 RSS-131 §4.2 - Out of Band Rejection ...................................................................................................................... 57 RSS-131 ....................................................................................................................................................... 59 RSS-131 §4.2/RSP-100 - Passband Gain & Bandwidth ............................................................................................. 59 RSS-131 §4.3.1 - Passband RF Power Output .......................................................................................................... 71 Supplemental Information .......................................................................................................................... 73 Measurement Uncertainty ...................................................................................................................................... 73 Emissions Test Details .............................................................................................................................................. 73 Page 3 of 74 Report No.: 92273-8 ADMINISTRATIVE INFORMATION Test Report Information REPORT PREPARED FOR: REPORT PREPARED BY: Powerwave Technologies, Inc. 1801 E. St. Andrew Place Santa Ana, CA 92705 Joyce Walker CKC Laboratories, Inc. 5046 Sierra Pines Drive Mariposa, CA 95338 REPRESENTATIVE: Charlotte Yu Project Number: 92273 Customer Reference Number: 144808 DATE OF EQUIPMENT RECEIPT: September 23, 2011 DATE(S) OF TESTING: September 23 - October 3, 2011 Report Authorization The test data contained in this report documents the observed testing parameters pertaining to and are relevant for only the sample equipment tested in the agreed upon operational mode(s) and configuration(s) as identified herein. Compliance assessment remains the client’s responsibility. This report may not be used to claim product endorsement by A2LA or any government agencies. This test report has been authorized for release under quality control from CKC Laboratories, Inc. Steve Behm Director of Quality Assurance & Enginee…

Text truncated - open the document above for the full version.