IMA-T1087NON-BROADCAST UHF RADIO TRANSMITTER

MULTIBAND P25 AIRBORNE TRANSCEIVER MODEL TDFM-600/6000 Installation and Operating Instructions Til Document No. 01RE293 Rev. F Issue 2 December 2004 Technisonic Industries Limited 240 Traders Blvd, Mississauga, Ontario L4Z 1W7 Tel:(905)890-2113 Fax:(905)890-5338 www.til.ca CAUTION This unit contains static sensitive devices. Wear a grounded wrist strap and/or conductive gloves when handling printed circuit boards. WARNING: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Warning: Changes or modifications not expressly approved by Technisonic Industries could void the users authority to operate the equipment. WARRANTY INFORMATION The Model TDFM-600/6000 Transceiver is under warranty for one year from date of purchase. Failed units caused by defective parts, or workmanship should be returned to: Technisonic Industries Limited Technisonic Industries Limited 240 Traders Boulevard 3840 E. Robinson Road, Suite 214 Mississauga, Amherst, Ontario L4Z 1W7 New York 14228 Tel: (905) 890-2113 Fax: (905) 890-5338 Tel: (716) 691-0669 WARNING For compliance with FCC RF Exposure Requirements, the mobile transmitter antenna installation shall comply with the following two conditions: 1. The transmitter antenna gain shall not exceed 3 dBi 2. The transmitter antenna is required to be located outside of a vehicle and kept at a separation distance of 70 cm or more between the transmitter antenna of this device and persons during operation. Summary of DO-160C Environmental Testing for Technisonic Model TDFM-600 and 6000 Transceiver. Conditions Section Description of Conducted Tests Temperature and Altitude 4.0 Equipment tested to categories C4 and D1. Vibration 8.0 Equipment is tested without shock mounts to categories B, M and N. Magnetic Effect 15.0 Equipment is class Z. Power Input 16.0 Equipment tested to category B. Voltage Spike 17.0 Equipment tested to category B. RF Emission 21.0 Equipment tested to category Z. Installation Approval Note Presently no TSO standard exists for airborne FM transceivers. To make it easier for installation agencies to provide their customers with an approved installation supported by an effective Airworthiness Approval, Technisonic has secured Supplemental Type Certificate (STC) Approvals (both US and Canadian) on its Airborne FM products for many helicopters currently being delivered in the US and Canada as well as a number of single engine fixed wing aircraft. The above referenced DO-160C test data is also on file and available from Technisonic to support approval requirements in airframes for which Technisonic does not possess an STC. Approved aircraft types are listed in the attachments to the formal STC documents. These STC's are the exclusive property of Technisonic and require the written authority of Technisonic for their use. To assist Factory Authorized Technisonic Dealers in the certification process, we have placed copies of our Canadian and US STC's on our web site along with a letter of authorization for their use. These documents may be downloaded and used as support for the technical submission to FAA or Transport Canada. Only factory authorized dealers/installers are permitted to download and make use of these documents on behalf of their customers (end users) in support of regulatory agency approval. Please refer to the Technisonic web site www.til.ca for the latest issue of available STC=s and letter of authorization for use. TABLE OF CONTENTS Paragraph Title Page SECTION 1 GENERAL DESCRIPTION 1.1 Introduction...............................................................................................1-1 1.2 Description................................................................................................1-1 1.3 Model Variation..........................................................................................1-1 1.4 Technical Summary.....................................................................................1-3 SECTION 2 OPERATING INSTRUCTIONS 2.1 General.....................................................................................................2-1 2.2 Front Panel................................................................................................2-1 2.3 Power Switch............................................................................................2-2 2.4 Knob.........................................................................................................2-2 2.5 Soft Keys and HOME..................................................................................2-3 2.6 Function Keys............................................................................................2-3 2.7 MUP and MDN Keys...................................................................................2-5 2.8 Up and Down Arrow Keys...........................................................................2-5 2.9 Left and Right Arrow Keys...........................................................................2-5 2.10 ESW Key...................................................................................................2-5 2.11 TSW Key..…

Text truncated - open the document above for the full version.

Technisonic Industries Limited 240 Traders Blvd, Mississauga, Ontario L4Z 1W7 Tel:(905)890-2113 Fax:(905)890-5338 www.til.ca 14 December 2004 FEDERAL COMMUNICATIONS COMMISSION 7435 Oakland Mills Road Columbia, MD 21046 U.S.A. Subject: Request for withholding from public disclosure the schematic diagrams and system block diagrams pursuant to an application for certification. Applicant: Technisonic Industries Limited Product: UHF RF Module (high split) Model: T1087 FCC ID: IMA-T1087 Dear Sir/Madam, We, Technisonic Industries Limited, would like to request that the schematic diagrams, system block diagrams, parts lists, tuning procedures and Operational description submitted with the application for certification be withheld from public disclosure as per Section 0.459 of FCC Rules. This request is made under the provisions of Section 0.457(d) of the Commission’s Rules, and Section 552(b)(4) of the Freedom of Information Act. These sections authorize as a withholding from public inspection materials which would be privileged as a matter of law if retained by the person submitting them, and materials which would not customarily be released to the public by that person. If you have any queries, please do not hesitate to contact us: OUR TELEPHONE NO.: (905) 890-2113 Yours truly, Steve McIntosh Engineering Manager

Annex 2 – External Photographs of EUT Photo #1 UHF HI RF Module, Model No.: T1087 FCC: IMA-T1087, IC: 120A-T1087 Annex 2 – External Photographs of EUT Photo #2 UHF HI RF Module, Model No.: T1087 FCC: IMA-T1087, IC: 120A-T1087

Applicant: Technisonic Industries Ltd. FCC ID: IMA-T1087, IC: 120A-T1087 INTERNAL PHOTOGRAPHS The following photographs are attached. 1.RF board with Shields (Top). 2. RF board without Shields (Top). 3. RF board with Shields (Bottom). 4. RF board without Shields (Bottom). 5. Vocon board with Shields (Top). 6. Vocon board without Shields (Top). 7. Vocon board (Bottom). Applicant: Technisonic Industries Ltd. FCC ID: IMA-T1087, IC: 120A-T1087 RF board with Shields (Top) Applicant: Technisonic Industries Ltd. FCC ID: IMA-T1087, IC: 120A-T1087 RF board without Shields (Top) Applicant: Technisonic Industries Ltd. FCC ID: IMA-T1087, IC: 120A-T1087 RF board with Shields (Bottom) Applicant: Technisonic Industries Ltd. FCC ID: IMA-T1087, IC: 120A-T1087 RF board without Shields (Bottom) Applicant: Technisonic Industries Ltd. FCC ID: IMA-T1087, IC: 120A-T1087 Vocon board with Shields (Top) Applicant: Technisonic Industries Ltd. FCC ID: IMA-T1087, IC: 120A-T1087 Vocon board without Shields (Top) Applicant: Technisonic Industries Ltd. FCC ID: IMA-T1087, IC: 120A-T1087 Vocon board (Bottom)

CAUTION This unit contains static sensitive devices. Wear a grounded wrist strap and/or conductive gloves when handling printed circuit boards. WARNING: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Warning: Changes or modifications not expressly approved by Technisonic Industries could void the users authority to operate the equipment. WARRANTY INFORMATION The Model TDFM-600/6000 Transceiver is under warranty for one year from date of purchase. Failed units caused by defective parts, or workmanship should be returned to: Technisonic Industries Limited Technisonic Industries Limited 240 Traders Boulevard 3840 E. Robinson Road, Suite 214 Mississauga, Amherst, Ontario L4Z 1W7 New York 14228 Tel: (905) 890-2113 Fax: (905) 890-5338 Tel: (716) 691-0669 WARNING For compliance with FCC RF Exposure Requirements, the mobile transmitter antenna installation shall comply with the following two conditions: 1. The transmitter antenna gain shall not exceed 3 dBi 2. The transmitter antenna is required to be located outside of a vehicle and kept at a separation distance of 70 cm or more between the transmitter antenna of this device and persons during operation.

UHF-HI RF MODULE Model No.: T1087 FCC ID: IMA-T1087 Applicant: Technisonic Industries Ltd. 240 Traders Blvd E, Mississauga, Ontario Canada, L4Z 1W7 Tested in Accordance With Federal Communications Commission (FCC) CFR 47, PARTS 2 and 90 (Subpart I) UltraTech's File No.: TIL-48FCC90 This Test report is Issued under the Authority of Tri M. Luu, Professional Engineer, Vice President of Engineering UltraTech Group of Labs Date: December 24, 2004 Report Prepared by: Dharmajit Solanki, RFI Engineer Tested by: Hung Trinh, EMI/RFI Technician Issued Date: December 24, 2004 Test Dates: December 20 – 24, 2004 The results in this Test Report apply only to the sample(s) tested, and the sample tested is randomly selected. UltraTech 3000 Bristol Circle, Oakville, Ontario, Canada, L6H 6G4 Tel.: (905) 829-1570 Fax.: (905) 829-8050 Website: www.ultratech-labs.com Email: [email protected], Email: [email protected] 2 31040/SIT C-1376 46390-2049 200093-0 SL2-IN-E-1119R 00-034 FCC PARTS 2 & 90, SUBPART I, NON-BROADCAST RADIO TRANSCEIVERS Page 1 UHF-HI RF MODULE, Model: T1087 FCC ID: IMA-T1087 ULTRATECH GROUP OF LABS File #: TIL-48FCC90 3000 Bristol Circle, Oakville, Ontario, Canada L6H 6G4 December 24, 2004 Tel. #: 905-829-1570, Fax. #: 905-829-8050, Email: [email protected] , Website: http://www.ultratech-labs.com All test results contained in this engineering test report are traceable to National Institute of Standards and Technology (NIST) TABLE OF CONTENTS EXHIBIT 1. SUBMITTAL CHECK LIST........................................................................................................................ 3 EXHIBIT 2. INTRODUCTION ......................................................................................................................................... 4 2.1. SCOPE......................................................................................................................................................................... 4 2.2. RELATED SUBMITAL(S)/GRANT(S) ..................................................................................................................... 4 2.3. NORMATIVE REFERENCES ................................................................................................................................... 4 EXHIBIT 3. PERFORMANCE ASSESSMENT .............................................................................................................. 5 3.1. CLIENT INFORMATION .......................................................................................................................................... 5 3.2. EQUIPMENT UNDER TEST (EUT) INFORMATION............................................................................................. 5 3.3. EUT’S TECHNICAL SPECIFICATIONS.................................................................................................................. 6 3.4. LIST OF EUT’S PORTS ............................................................................................................................................. 7 3.5. ANCILLARY EQUIPMENT ...................................................................................................................................... 7 3.6. BLOCK DIAGRAM OF TEST SETUP...................................................................................................................... 8 EXHIBIT 4. EUT OPERATING CONDITIONS AND CONFIGURATIONS DURING TESTS ............................... 9 4.1. CLIMATE TEST CONDITIONS................................................................................................................................ 9 4.2. OPERATIONAL TEST CONDITIONS & ARRANGEMENT FOR TEST SIGNALS............................................. 9 EXHIBIT 5. SUMMARY OF TEST RESULTS ............................................................................................................. 10 5.1. LOCATION OF TESTS ............................................................................................................................................ 10 5.2. APPLICABILITY & SUMMARY OF EMISSION TEST RESULTS ..................................................................... 10 5.3. MODIFICATIONS INCORPORATED IN THE EUT FOR COMPLIANCE PURPOSES ..................................... 11 5.4. DEVIATION OF STANDARD TEST PROCEDURES ...........................................................................................11 EXHIBIT 6. MEASUREMENTS, EXAMINATIONS & TEST DATA FOR EMC EMISSIONS............................. 12 6.1. TEST PROCEDURES............................................................................................................................................... 12 6.2. MEASUREMENT UNCERTAINTIES .................................................................................................................... 12 6.3. MEASUREMENT EQUIPMENT USED: ................................................................................................................ 12 6.4. ESSENTIAL/PRIMARY FUNCTIONS AS DECLARED BY THE MANUFACTURER:..................................... 12 6.5. RF POWER OUTPUT @ FCC 2.1046 & 90.205 ..................................................................................................... 13 6.6. RF EXPOSURE REQUIRMENTS @ 1.1310 & 2.1091........................................................................................... 14 6.7. FREQUENCY STABILITY @ FCC 2.1055 & 90.213 ............................................................................................ 17 6.8. AUDIO FREQUENCY RESPONSE @ FCC 2.1047(A) & 90.242(B)(8)................................................................ 19 6.9. MODULATION LIMITING @ FCC 2.1047(B) & 90.210 ...................................................................................... 24 6.10. EMISSION MASK @ FCC 2.1049, 90.208 & 90.210 ............................................................................................. 30 6.11. TRANSMITTER ANTENNA POWER SPURIOUS/H…

Text truncated - open the document above for the full version.