J3OWM3A5000Mini PCI Card

Intel® PRO/Wireless 5000 Type 3 Mini-PCI Adapter User’s Guide 2 Copyright and Legal Disclaimers Copyright © 2002 Intel Corporation. All rights reserved. Intel Corporation, 5200 N.E. Elam Young Parkway, Hillsboro, OR 97124-6497 Intel Corporation assumes no responsibility for errors or omissions in this document. Nor does Intel make any commitment to update the information contained herein. Intel, Itanium, and Pentium are trademarks or registered trademarks of Intel Corporation or its subsidiaries in the United States and other countries. *Other names and brands may be claimed as the property of others. 3 Overview .......................................................................................................................................... 5 Introduction to Wireless Networking ................................................................................................ 5 Infrastructure Mode: A WLAN with Access Points ...................................................................... 5 Peer-to-Peer Mode: A WLAN without Access Points .................................................................. 5 Identifying a WLAN ...................................................................................................................... 5 Wireless Security ......................................................................................................................... 5 64-bit or 128-bit security.......................................................................................................... 6 Installation ........................................................................................................................................ 6 Intel® PRO/Wireless 5000 LAN Adapter Features...................................................................... 6 Hardware Installation ................................................................................................................... 7 Install Drivers Under Windows .................................................................................................... 7 START HERE to install Mini-PCI Adapter............................................................................... 7 Install Windows Drivers and Utilities ....................................................................................... 7 Windows XP ............................................................................................................................ 8 Windows 2000......................................................................................................................... 9 Windows Me (Millennium Edition) ......................................................................................... 10 Windows 98SE ...................................................................................................................... 11 PROSet II Software ................................................................................................................... 12 Uninstalling Adapter and Utility Software .................................................................................. 12 How to Uninstall Mini-PCI Adapter Drivers Using Device Manager...................................... 12 How to Uninstall PROSet II Utility Software Using Add/Remove Programs ......................... 13 How to Uninstall Wired Drivers and PROSet II Software Using the Intel® PRO Intelligent Installer .................................................................................................................................. 13 Reinstalling Adapter and Utility Software .................................................................................. 13 Configuring with Intel® PROSet II ................................................................................................. 14 Viewing and Changing Network Settings .............................................................................. 14 Connecting to the Network Using an Access Point............................................................... 14 Connecting to a Peer-to-Peer Network ................................................................................. 15 Protecting Your Network with WEP Encryption .................................................................... 15 Using Wireless Profiles ......................................................................................................... 16 Switching Between Wired and Wireless Adapters ................................................................ 16 Setting the Adapter's Power Consumption ........................................................................... 17 Managing the Adapter from the Control Panel .......................................................................... 17 Updating the Driver and Firmware Version ............................................................................... 17 Verifying the Driver and Firmware Versions.......................................................................... 17 Troubleshooting ............................................................................................................................. 18 Windows 98SE and Me Troubleshooting Tips ...................................................................... 18 Windows 2000 and XP Troubleshooting Tips ....................................................................... 19 Wireless Configuration Feature (Microsoft Windows XP only) ............................................. 19 General Troubleshooting Guidelines..................................................................................... 19 Use the Latest Release of Your Intel Installation CD-ROM .................................................. 19 Use the Latest Version of PROSet II..................................................................................... 19 Additional Sources of Information ..................................................................................…

Text truncated - open the document above for the full version.

June 8, 2002 ATCB 6731 Whittier Ave Suite C110 McLean, Va. 22101 Dear Application Examiner: Limited Modular approval for the device is being requested. The device does not meet two out of the eight requirements outlined in FCC Public Notice DA 00-1407 Released: June 26, 2000. The reason for the request is that, although it has it’s own RF shielding, the MINI PCI card depends on the Laptop host to provided additional shielding to be in compliance. The MINI PCI will be sold to specific Laptop vendors, only. It will not be sold to the general public. This will allow Intel to have full control of the compliance of the MINI PCI card when it is installed on a different Laptop. Proper installation instructions are provided to the Laptop vendor, so that they are fully aware that additional testing must be performed before selling the Laptop, with the MINI PCI card, to the general public. The Laptop vendor will be provided with specific instructions about the RF exposure, such as not using a different antenna and unauthorized changes to the MINI PCI card is not allowed, and that additional compliance for the radiated emission must be performed. If there are any questions or if further information is needed, please contact Elliott Laboratories for assistance. Sincerely, Juan Martinez Senior EMC Engineer JM/dmg

EXTERNAL PHOTO

ART# 832-2494-001A FAB# 830-1760-002 ECN23971 Use only with the Intel supplied antennas designated for this product 830-1760-002A 01WYBA1009 D02-0016JP FOR HOME OR OFFICE USE Tested to Comply with FCC Standards FCC ID: J3OWM3A5000 CANADA ICES/NMB-003 Class/Classe (B) CANADA: XXXXX XXXXX Product of Malaysia SCT xxxxxxxx-xxx E178682E178682 CUS Intel ® PRO/Wireless 5000 LAN 3A Mini PCI Adapter Model WM3A5000 CNC xx-xxxx 049700-AQV1137 90LP0011 X-XXX-XX-XXXX Approved by IDA for use in Singapore. DB02941

FCC ID Label Location

INTERNAL PHOTOS MINI PCI Front Side MINI PCI Back Side

MPE Calculations FCC part 1.1310, Table 1 limits the power density for uncontrolled exposure to 1mW/ cm 2 for systems operating in the UNII bands. The distance, d(cm) from the antenna at which the power density, P d (mW/cm 2 ) is below this limit is calculated from the maximum EIRP, P t (mW) using the equation: P d = P t #q 2 ) Re-arranging for the distance at which the power density is 1mW/cm2 gives: d = √ (P t # The device under test is designed to use an integral antenna with a gain of 2 dBi. The maximum output power for the two modes and all channels is 19.6 dBm. The maximum EIRP is, therefore, 19.6 dBm + 2 dBi = 21.6 dBm (144.54 mW): d = √ (144.54 #23.39 cm The distance from the antenna that the power density is 1mW/ cm 2 is, therefore, 3.39 cm. The users guide instructs the user to install the device such that it has a separation of at least 20cm from persons (see text below) to comply with the FCC’s requirements. This separation of 20cm more than meets the FCC’s and Industry Canada RF exposure requirements. Mode EIRP Pd at 20cm Calculated distance (in cm) where Pd < 1mW/ cm 2 Normal 19.6 dBm (144.54 mW) 0.0287 mW/ cm 2 3.39 Extract From User’s Manual

File: R46225 February 11, 2002 ATCB 6731 Whittier Ave Suite C110 McLean, Va. 22101 Gentlemen: The enclosed documents constitute a formal submittal and application for a Grant of Equipment Authorization pursuant to Subpart E of Part 15 of FCC Rules (CFR 47) regarding intentional radiators. Data within this report demonstrates that the equipment tested complies with the FCC limits for intentional radiators. Elliott Laboratories, as duly authorized agent prepared this submittal. A copy of the letter of our appointment as agent is enclosed. If there are any questions or if further information is needed, please contact Elliott Laboratories for assistance. Sincerely, Juan Martinez Senior EMC Engineer JM/ Enclosures: Agent Authorization Letter Emissions Test Report with Exhibits File: R46225 Page 1 of 18 Electromagnetic Emissions Test Report and Application for Grant of Equipment Authorization pursuant to FCC Part 15, Subpart E (UNII Devices) and Industry Canada RSS 210 Issue 4 (LELEAN Devices) on the Intel Corporation Model: WM3A5000 Mini PCI Card FCC ID: J3OWM3A5000 GRANTEE: Intel Corporation 2300 Corporate Center Drive Thousand Oaks, CA. 91320 TEST SITE: Elliott Laboratories, Inc. 684 W. Maude Avenue Sunnyvale, CA 94086 REPORT DATE: February 11, 2002 FINAL TEST DATE: January 4 and January 5, 2002 AUTHORIZED SIGNATORY: ______________________________ Juan Martinez Senior EMC Engineer This report shall not be reproduced, except in its entirety, without the written approval of Elliott Laboratories, Inc. Elliott Laboratories, Inc. -- EMC Department Test Report Report Date: February 11, 2002 File: R46225 Page 2 of 18 Pages DECLARATIONS OF COMPLIANCE Equipment Name and Model: WM3A5000 Mini PCI Card Manufacturer: Intel Corporation 2300 Corporate Center Drive Thousand Oaks, CA. 91320 Tested to applicable standards: RSS-210, Issue 4, December 2000 (Low Power License-Exempt Radiocommunication Devices) FCC Part 15 Subpart E (UNII Devices) Measurement Facility Description Filed With Department of Industry: Departmental Acknowledgement Number: IC2845 SV1 Dated July 30, 2001 Departmental Acknowledgement Number: IC2845 SV4 Dated July 19, 2001 I declare that the testing was performed or supervised by me; that the test measurements were made in accordance with the above mentioned departmental standards (through the use of ANSI C63.4 as detailed in section 5.3 of RSS-210, Issue 4); and that the equipment performed in accordance with the data submitted in this report. Signature ______________________________ Name Juan Martinez Title Senior EMC Engineer Company Elliott Laboratories Inc. Address 684 W. Maude Ave Sunnyvale, CA 94086 USA Date: February 11, 2002 Maintenance of compliance with the above standards is the responsibility of the manufacturer. Any modification of the product which may result in increased emissions should be checked to ensure compliance has been maintained (i.e., printed circuit board layout changes, different line filter, different power supply, harnessing or I/O cable changes, etc.). Elliott Laboratories, Inc. -- EMC Department Test Report Report Date: February 11, 2002 File: R46225 Page 3 of 18 Pages TABLE OF CONTENTS COVER PAGE .............................................................................................................................................................1 DECLARATIONS OF COMPLIANCE ................................................................................................................. 2 TABLE OF CONTENTS.......................................................................................................................................... 3 SCOPE ....................................................................................................................................................................... 4 OBJECTIVE ............................................................................................................................................................. 4 SUMMARY OF RESULTS ..................................................................................................................................... 5 MEASUREMENT UNCERTAINTIES ................................................................................................................. 6 EQUIPMENT UNDER TEST (EUT) DETAILS.................................................................................................... 7 GENERAL ............................................................................................................................................................. 7 ENCLOSURE ........................................................................................................................................................ 7 MODIFICATIONS ................................................................................................................................................ 7 SUPPORT EQUIPMENT ...................................................................................................................................... 7 EUT INTERFACE PORTS.................................................................................................................................... 7 EUT OPERATION DURING TESTING .............................................................................................................. 8 ANTENNA REQUIREMENTS............................................................................................................................. 8 TEST SITE ................................................................................................................................................................ 9 GENERAL INFORMATION ................................................................................................................................ 9 CONDUCTED EMISSIONS CONSIDERATIONS..............................................................................................9 RADIATED EMISSIONS CONSID…

Text truncated - open the document above for the full version.