KRE-E2-TRX500BUHF BASE STATION

Eclipse2 UHF / VHF / 800MHz Base Station Technical Manual Publication Reference – TPR-03XX920015 Issue 1.5 – July 2009. Eclipse2 Technical Manual V1.5 Page 2 of 16 Revisions Version Description Publication Date 1.0 Initial release March 9 2008 1.5 2009 List of Associated Publications Document Number Description TPR-0308920019 IP Commander User Manual TPR-0309920010 Eclipse2 Application Guide Disclaimer Due to our policy of continuous improvement of our products and services, technical specifications and claims that were correct at time going to print maybe subject to variation without notice. RF Technology has endeavoured to ensure that the information in this document is correct, but does not accept liability due to typographical, omissions or other errors or subsequent modifications of the product. Specifications may vary from those given in this document in accordance with the requirements of local regulatory authorities. Copyright All information contained in this manual is the property of RF Technology Pty Ltd. All rights are reserved. This manual may not, in whole or in part, be copied, photocopied, reproduced, translated, stored, or reduced in any manner without prior written permission. All trade names referenced are the trademarks or registered trademarks of the respective manufacturers.  Copyright 2009 RF Technology Pty Ltd. RF Technology Pty Limited Unit 46 / 7 Sefton Road Thornleigh NSW 2120 Sydney Australia Phone +61 2 9484 1022 Fax +61 2 9484 1288 Web www.rftechnology.com.au Eclipse2 Technical Manual V1.5 Page 3 of 16 Contents REVISIONS ........................................................................................................... 2 CONTENTS ........................................................................................................... 3 INTRODUCTION ..................................................................................................... 6 FEATURES ........................................................................................................... 6 SPECIFICATIONS .................................................................................................... 6 Overall .................................................................................................. Error! Bookmark not defined. Receiver ...................................................................................................................................... 7 Exciter ......................................................................................................................................... 7 OPERATING BASICS................................................................................................. 7 Front Panel Controls and Indicators ............................................................................................ 7 Buttons: ............................................................................................................................................ 8 Indicators: ........................................................................................................................................ 8 Connectors: ...................................................................................................................................... 8 Rear Panel Connectors ............................................................................................................... 8 System I/O: ...................................................................................................................................... 8 E/M Line: .......................................................................................................................................... 9 Ethernet: .......................................................................................................................................... 9 RF input: .......................................................................................................................................... 9 RF output: ........................................................................................................................................ 9 RS232 and external reference clock (optional) ............................................................................... 10 Programming and monitoring .............................................................................................................10 Connecting with Ethernet .......................................................................................................... 10 Connecting with USB ................................................................................................................ 10 Connecting with RS232 (optional) ............................................... Error! Bookmark not defined. Circuit Description ..............................................................................................................................11 Processor (Master) board ......................................................................................................... 11 Interface (Main) board ............................................................................................................... 11 Audio signal processing .................................................................................................................. 11 I/O and Controls ............................................................................................................................. 12 Clock generator .............................................................................................................................. 13 Voltage regulators .......................................................................................................................... 13 RF modules ............................................................................................................................... 13 TX module .....................…

Text truncated - open the document above for the full version.

rftechnology Date 1 February 2012 Federal Communications Commission Equipment Authorisation Branch 7435 Oakland Mills Road Columbia , MD 21046 United States of America To whom it may concern Re: E2 TRX 500 B The Eclipse2 UHF Band B Base station/Repeater operates from 450MHz to 480 MHz frequency range, the operating frequency can only be pre-programmed into the unit by the RF Technology's IP commander software,and this software will not be supplied with the Eclipse2 equipment to the end user. We attest that we will apply the Declaration of Conformity procedure to any peripheral portion of any composite filing. We will comply with all requirements of part 90 and part 15 as required Yours Faithfully Frank Romanin CEO ABN 11 131 761 11 Untt 46. Thomleagh Technology Park 7 Sefton Road Thomleagh NSW 2120 RF Technology Pty Ltd T· +61 2 9484 lOll ext 101 F: + 61 2 9484 1822 [email protected] www.rftcehnology.com.a u

____________________________________________________________________________________________________________________________________________________________________________ Page 30 of 36 Test Report No 110132.3a 23 June 2011. This report may not be reproduced except in full. 10. PHOTOGRAPH (S) Base station external view Rack ____________________________________________________________________________________________________________________________________________________________________________ Page 34 of 36 Test Report No 110132.3a 23 June 2011. This report may not be reproduced except in full. Rx module Rx module Tx module Tx module

____________________________________________________________________________________________________________________________________________________________________________ Page 31 of 36 Test Report No 110132.3a 23 June 2011. This report may not be reproduced except in full. Rack Main PCB ____________________________________________________________________________________________________________________________________________________________________________ Page 32 of 36 Test Report No 110132.3a 23 June 2011. This report may not be reproduced except in full. Main PCB Sub board ____________________________________________________________________________________________________________________________________________________________________________ Page 33 of 36 Test Report No 110132.3a 23 June 2011. This report may not be reproduced except in full. Sub board Front panel

Page 1 of 3 RF Exposure Requirements General information: Device category: Fixed as decribed in Part 2.1091/1.1307/1.1310 Environment: Uncontrolled Exposure Fixed devices that operate under Part 90 of this chapter are subject to routine environmental evaluation for RF exposure prior to equipment authorization or use if they operate at frequencies of 1.5 GHz or below and their effective radiated power (ERP) is 1.5 watts or more. Antenna: The manufacturer does not specify an antenna. A typical installation for this type of product is fixed mounted on permanent structures and as such the antenna type is at the discretion of the licensee. We believe a typical gain would be anywhere from 0 to 5 dBi. Configuration Antenna p/n Type Max. Gain (dBi) Fixed mounted Any omni or directional 5 Operating configuration and exposure conditions: The conducted output power is 3 Watts. Although the device is fixed mounted the control of exposure would be in an uncontrolled environment. The duty cycle can go to approximately 100% and is controlled thru the software of the system. - Fixed operation: A typical installation consists of an antenna system with a coaxial cable of the type RG 8U which has a loss of 1dB for a length of 30 feet at UHF. frequencies. MPE Calculation: The minimum separation distance is calculated as follows: The limit for uncontrolled exposure environment above 300 MHz is f/1500 mW/cm 2 . Page 2 of 3 Frequency: 450 MHz The conducted power output is 3 watt. The coax loss was taken as 1 dB (30 ft RG-8 type). Antenna gain was taken as 5 dBi Page 3 of 3 “FCC RF Exposure Requirements: See Users Manual

____________________________________________________________________________________________________________________________________________________________________________ Page: 1 of 30 Test Report No 110132.3b 23 June 2011. This report may not be reproduced except in full. EMC Technologies (NZ) Ltd PO Box 68-307 Newton, Auckland Phone 09 360 0862 Fax 09 360 0861 E-Mail Address: [email protected] Web Site: www.emctech.com.au TEST REPORT Eclipse 2, 500 Series, Band B (450-48 0 MHz) UHF Base St ation tested to the Code of Federal Regulations (CFR) 47 Part 90 –Private Land Mobile Services Part 15 – Radio Frequency Device for RF Technology Pty Ltd This Test Report is issued with the authority of: ________________________________________ Andrew Cutler- General Manager ____________________________________________________________________________________________________________________________________________________________________________ Page: 2 of 30 Test Report No 110132.3b 23 June 2011. This report may not be reproduced except in full. Table of Contents 1. CLIENT INFORMATION 3 2. DESCRIPTION OF TEST SAMPLE 3 3. COMPLIANCE STATEMENT AND RESULT SUMMARY 4 4. TEST SAMPLE DESCRIPTION 5 5. TEST CONDITIONS 6 6. ATTESTATION 7 7. TEST RESULTS 8 8. TEST EQUIPMENT USED 20 9. ACCREDITATIONS 23 10. PHOTOGRAPH (S) 24 ____________________________________________________________________________________________________________________________________________________________________________ Page: 3 of 30 Test Report No 110132.3b 23 June 2011. This report may not be reproduced except in full. 1. CLIENT INFORMATION Company Name RF Technology Pty Ltd Address Unit 46/ 7 Sefton Rd Thornleigh State NSW Country Australia Contact Mr Guang Lou 2. DESCRIPTION OF TEST SAMPLE Brand Name Eclipse 2 Model Number 500 Series, Band B Product Base Station (450-480 MHz) Man ufacturer RF Technologies Manufactured in Australia Serial Number 00307 FCC ID - ____________________________________________________________________________________________________________________________________________________________________________ Page: 4 of 30 Test Report No 110132.3b 23 June 2011. This report may not be reproduced except in full. 3. COMPLIANCE STATEMENT AND RESULT SUMMARY The Eclipse 2, 500 series, Band B (450-480 MHz) UHF Base station complies the limits defined in 47 CFR Part 15, 47 CFR Part 90 and 47 CFR Part 2 when tested in-accordance with the test methods described in 47 CFR Part 2. Clause Description Result 90.203 Certification required Noted 2.1046 90.205 RF power output Power and antenna height limits Noted Complies 2.1047 2.1047(a) 2.1047(b) 90.211(a) Modulation Characteristics Low pass filter response Modulation limiting characteristics Modulation characteristics Noted Noted Noted Complies 2.1049 2.202 22.357 22.359(a) 90.207 90.209 90.210 Occupied bandwidth Bandwidths Emission types Emission masks Types of emissions Bandwidth limitations Emission masks Noted Noted Complies Complies Complies Complies Complies 2.1051 Spurious emissions at antenna terminals Complies 2.1053 Field strength of spurious radiation Complies 2.1055 22.355 90.213 Frequency stability Frequency stability Frequency stability Noted Complies Complies 90.214 Transient frequency behaviour Complies 15.109 15.111 Receiver radiated emissions Receiver local oscillator voltage Complies Complies ____________________________________________________________________________________________________________________________________________________________________________ Page: 5 of 30 Test Report No 110132.3b 23 June 2011. This report may not be reproduced except in full. 4. TEST SAMPLE DESCRIPTION The sample tested has the following specifications: Rated Transmitter Output Power 3.0 Watts (34.7 dBm) Test frequencies Chl Frequency MHz Power Watts Spacing kHz Mode 1 459.075 3.0 12.5 F1E 2 459.075 3.0 12.5 F3E FCC Bands Part 90: 421 - 512 MHz Emission Designators / Modes of operation 8k10F1E – C4FM digital speech 11k2F3E – Analogue speech Power Supply AC voltage supply typically 110.0 V ac ____________________________________________________________________________________________________________________________________________________________________________ Page: 6 of 30 Test Report No 110132.3b 23 June 2011. This report may not be reproduced except in full. 5. TEST CONDITIONS Standard Temperature and Humidity Temperature: +15C to + 30 maintained. Relative Humidity: 20% to 75% observed. Standard Test Power Source Standard Test Voltage: 110.0 V ac. Extreme Temperature High Temperature: + 50C maintained. Low Temperature: - 30 C maintained. Extreme Test Voltages Low Voltage: 93.5 V ac High Voltage: 126.5 V ac ____________________________________________________________________________________________________________________________________________________________________________ Page: 7 of 30 Test Report No 110132.3b 23 June 2011. This report may not be reproduced except in full. 6. ATTESTATION The Eclipse 2, 500 series, Band B (450-480 MHz) UHF Base station complies with the Code of Federal Regulations (CFR) 47 Part 90 –Private Land Mobile Services and 47 Part 15 – Radio Frequency Devices. This report describes the tests and measurements performed for the purpose of determining compliance with the specification with the following conditions: The client selected the test sample. The report relates only to the sample tested. This report does not contain corrections or erasures. This report has been issued in conjunction with report number 110132.3b to show compliance with the FCC narrowband requirements only. Measurement uncertainties with statistical confidence intervals of 95% are shown below test results. Both Class A and Class B uncertainties have been accounted for, as well as influence uncertainties where appropriate. In addition this equipment has been tested in accordance with the requirements contained in the appropriate Commission regulations. To the best…

Text truncated - open the document above for the full version.

____________________________________________________________________________________________________________________________________________________________________________ Page 35 of 36 Test Report No 110132.3a 23 June 2011. This report may not be reproduced except in full. Open air test setup ____________________________________________________________________________________________________________________________________________________________________________ Page 36 of 36 Test Report No 110132.3a 23 June 2011. This report may not be reproduced except in full.