NJQ372HAF372.5MHz Wireless Remote Controller Transceiver

L-372HAF USER’S MANUAL The remote is a dummy device used to display RCSM states. Is transmits data using Astroflex proprietary modulation, it behave similarly to Astroflex remote family by playing music tones , transmitting 3 data frames and supporting two cars mode. Function no Remote function Icons Hex value 1 Start 0D 2 Stop + 02 3 Valet ON/OFF toggle + 1A 4 Sentinel mode + 0C 5 Lock 0A 6 Unlock 0B 7 Remote buzzer mute toggle hold 5 seconds 0B 8 Trunk + 0E 9 Aux out + 06 10 Car finder + 03 11 Panic hold 5 seconds 01 12 Status 17 13 Keyboard lock/unlock toggle hold 5 seconds 1B 14 More than 2 buttons 00 ''This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.'' This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Page 1 CONSTRUCTION PHOTOS OF EUT Page 2

FCCID-1 (298x204x16M jpeg)

2WAY (600x450x16M jpeg)

Page 1 Page 2 Page 3 Page 4 Page 5

FCC ID: NJQ372HAF Report No.: RF95803L12A Reference No.: 950803L19 Operational Description The transmitter of the EUT (372.5MHz Wireless Remote Controller Transceiver) is powered by a 1.5Vdc from battery. The transmitter uses Wire antenna and designed to operate on a fixed frequency at 372.5MHz. This 372.5MHz transmitter device is operated by manual and activate time is less than 5 second after being released.

Report No.: RF950803L12A1Report Format Version 2.0.4 Reference No.: 950803L19 FCC TEST REPORT REPORT NO.: RF950803L12A MODEL NO.: L-372HAF RECEIVED: Aug. 03, 2006 TESTED: Aug. 04 ~ Aug. 21, 2006 ISSUED: Aug. 22, 2006 APPLICANT: Wintecronics Ltd. ADDRESS: No. 716, 11F-3, Jung Jeng Rd., Chung Ho City 235, Taipei Hsien, Taiwan, R.O.C. ISSUED BY:Advance Data Technology Corporation LAB ADDRESS:No. 47, 14 th Ling, Chia Pau Tsuen, Lin Kou Hsiang 244, Taipei Hsien, Taiwan, R.O.C. TEST LOCATION:No. 19, Hwa Ya 2 nd Rd., Wen Hwa Tsuen, Kwei Shan Hsiang, Taoyuan Hsien 333, Taiwan, R.O.C. This test report consists of 25 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by CNLA, A2LA or any government agencies. The test results in the report only apply to the tested sample. No. 2177-01 Report No.: RF950803L12A2Report Format Version 2.0.4 Reference No.: 950803L19 Table of Contents 1CERTIFICATION ....................................................................................................................... 3 2SUMMARY OF TEST RESULTS............................................................................................... 4 2.1MEASUREMENT UNCERTAINTY ............................................................................................ 4 3GENERAL INFORMATION ....................................................................................................... 5 3.1GENERAL DESCRIPTION OF EUT ......................................................................................... 5 3.2DESCRIPTION OF TEST MODES ........................................................................................... 6 3.2.1CONFIGURATION OF SYSTEM UNDER TEST ...................................................................... 6 3.2.2TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL ........................................... 7 3.3GENERAL DESCRIPTION OF APPLIED STANDARDS .......................................................... 8 3.4DESCRIPTION OF SUPPORT UNITS ..................................................................................... 8 4TEST PROCEDURE AND RESULT.......................................................................................... 9 4.1CONDUCTED EMISSION MEASUREMENT ........................................................................... 9 4.2RADIATED EMISSION MEASUREMENT................................................................................. 9 4.2.1LIMITS OF RADIATED EMISSION MEASUREMENT .............................................................. 9 4.2.2TEST INSTRUMENT................................................................................................................11 4.2.3TEST PROCEDURE ............................................................................................................... 12 4.2.4TEST SETUP .......................................................................................................................... 13 4.2.5EUT OPERATING CONDITION .............................................................................................. 13 4.2.6TEST RESULTS ...................................................................................................................... 14 4.3EMISSION BANDWIDTH MEASUREMENT........................................................................... 18 4.3.1LIMITS OF BAND EDGES MEASUREMENT ......................................................................... 18 4.3.2TEST INSTRUMENT............................................................................................................... 18 4.3.3TEST PROCEDURE ............................................................................................................... 18 4.3.4DEVIATION FROM TEST STANDARD................................................................................... 19 4.3.5TEST SETUP .......................................................................................................................... 19 4.3.6TEST RESULTS ...................................................................................................................... 19 4.4DEACTIVATION TIME............................................................................................................. 21 4.4.1LIMITS OF DEACTIVATION TIME MEASUREMENT ............................................................. 21 4.4.2TEST INSTRUMENTS ............................................................................................................ 21 4.4.3TEST PROCEDURES............................................................................................................. 21 4.4.4DEVIATION FROM TEST STANDARD................................................................................... 21 4.4.5TEST SETUP .......................................................................................................................... 22 4.4.6TEST RESULTS ...................................................................................................................... 22 5INFORMATION ON THE TESTING LABORATORIES ........................................................... 24 APPENDIX-A..................................................................................................................A-1 Report No.: RF950803L12A3Report Format Version 2.0.4 Reference No.: 950803L19 1 CERTIFICATION PRODUCT:372.5MHz Wireless Remote Controller Transceiver BRAND NAME:Wintec MODEL NO:L-372HAF TEST SAMPLE:MASS-PRODUCTION TESTED:Aug. 04 ~ Aug. 21, 2006 APPLICANT:Wintecronics Ltd. STANDARDS: FCC Part 15, Subpart C (Section 15.231) ANSI C63.4-2003 The above equipment (model: L-372HAF) has been tested by Advance Data Technology Corporation, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under T…

Text truncated - open the document above for the full version.

1 PHOTOGRAPHS OF THE TEST CONFIGURATION RADIATED EMISSION TEST