OIWCSR80050W90DBi-Directional Booster

Nemko Canada Inc. I would like to confirm that I have a copy of section 90.219 & 22.383 for in-building/booster operation and our boosters comply with these rules. Best Regards, David Levy, Technical Support Manager Dekolink Wireless Ltd. 16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510 Tel- 972-3-9180179 Fax-972-3-9180190

14 . 11 .06 Part List For: 300NC10000 - DEKO-4008 FOR CELLULAR 800MHZ Line Part No. Part Des. Qty. Unit Sup/Mnf P/N 1. 300NC15000 CHANN 3X08-25-1.5 D/L 1.00 EA 300NC15000 2. 1510992867 AMP 800-900MHz 46dB 16W REMOTE+ISOLATOR 1.00 EA CD16W0900-EX 3. 1510992641 AMP RF 870-900MHZ 50W 1.00 EA 7040-PCM3Q4AHL 4. 300NC16000 CHANN 3X08-25-1.5 U/L 1.00 EA 300NC16000 5. 1544003181 AC/DC POWER SUPPLY Vo-9.1V&28V 650W VEGA 1.00 EA V605T5X 6. 300NC14000 MONITOR ASSY 1.00 EA 300NC14000 7. 1513000641 DUPLEX RX-824 TX-869MHz BW-25M 20W (SGC) 1.00 EA SGC-D881.5-25NS-ISR 8. 1513000698 DUPLEX RX-824M TX-869M BW-25M 100W 1.00 EA SGC-D881.5-25SS-FRR 9. CC050B0B20 CABLE ASSY SMA-SMA MALE SEMI 0.141 20CM 2.00 EA SM141-11SMA(X2)-20cm 10. CC050B0B18 CABLE ASSY SMA-SMA MALE STR 0.141 18CM 1.00 EA SM141-11SMA(X2)-18CM 11. CC050B0B24 CABLE ASSY SMA-SMA MALE SEMI 0.141 24CM 2.00 EA SM141-11SMA(X2)-24cm 12. CC050B0B22 CABLE ASSY SMA-SMA MALE SEMI 0.141 22CM 1.00 EA SM141-11SMA(X2)-22cm 13. CC050B0B12 CABLE ASSY SMA-SMA MALE SEMI 0.141 12CM 1.00 EA SM141-11SMA(X2)-12CM 14. CC040B0B0B CABLE ASSY SMA-SMA STR MALE 2M RG316 1.00 EA RG316-11SMA(X2)-2m 15. 30WGC30100 MAIN CABLE ASSY 1.00 EA 30WGC30100

1 Nov. 24.2006 Tune up procedure for DEKO 4008 1. General 1.1. This Procedure is conducted by the customer using RMS SW, on “Parameters and Control “ screen. 2. Procedure 2.1. Connect to unit using RMS (see Manual). 2.2. Chose “Parameters and Control “ screen (see figure 1). 2.3. Set Max Power to the required output power using the combo choice list. 2.4. Set Max Gain to maximum value. 2.5. Set SALC check box on. 2.6. Set Power check box on for Downlink and uplink. 3. Result: 3.1. The unit is set to the required power, the SALC control the Gain so that the output power will not exceed the maximum output power. 2
Switch to the Parameters and Control tab as shown on the figure below and follow the instructions.
Figure 1: RMS Software – Controls and Parameters Screen Heat sink Temp Pout Main DC Readout Max Gain Amp DL Power Amp On/Off Smart ALC On/Off Channel Selection

Prediction of MPE limit at a given distance Equation from page 18 of OET Bulletin 65, Edition 97-01where: S = power density P = power input to the antennaG = power gain of the antenna in the direction of interest relative to an isotropic radiatorR = distance to the center of radiation of the antenna Maximum peak output power at antenna input terminal: 31.55 (dBm) Maximum peak output power at antenna input terminal: 1428.893959 (mW) Antenna gain(typical): 2 (dBi) Maximum antenna gain: 1.584893192 (numeric) Prediction distance: 20 (cm) Prediction frequency: 869 (MHz) MPE limit for uncontrolled exposure at prediction frequency: 0.579333333 (mW/cm^2) Power density at prediction frequency: 0.450537 (mW/cm^2) Maximum allowable antenna gain: 3.091983727 (dBi) Margin of Compliance: 1.091983727 2 4 R PG S π =

Prediction of MPE limit at a given distance Equation from page 18 of OET Bulletin 65, Edition 97-01where: S = power density P = power input to the antennaG = power gain of the antenna in the direction of interest relative to an isotropic radiatorR = distance to the center of radiation of the antenna Maximum peak output power at antenna input terminal: 40.00 (dBm) Maximum peak output power at antenna input terminal: 10000 (mW) Antenna gain(typical): 8 (dBi) Maximum antenna gain: 6.309573445 (numeric) Prediction distance: 100 (cm) Prediction frequency: 869 (MHz) MPE limit for uncontrolled exposure at prediction frequency: 0.579333333 (mW/cm^2) Power density at prediction frequency: 0.502100 (mW/cm^2) Maximum allowable antenna gain: 8.621383814 (dBi) Margin of Compliance: 0.621383814 2 4 R PG S π =

FCC Part 22 Boosters : October 2006 Test Report: 6W76966 Applicant: Dekolink Wireless Ltd. 16 Bazel St, Qiryat-Arieh, Petah-Tikva 49510 Israel Apparatus: DEKO-4008 Cellular Repeater 800MHz (M/N: MW-CSR-800-50W90-XX-YY) FCC ID: OIWCSR80050W90D In Accordance With: FCC Part 22, Boosters Public Mobile Services Tested By: Nemko Canada Inc. 303 River Road Ottawa, Ontario K1V 1H2 Authorized By: Jin Xu, Wireless Specialist Date: December 13, 2006 Total Number of Pages: 26 Nemko Canada Inc. REPORT SUMMARY Report Number: 6W76966 FCC ID: OIWCSR80050W90D Specification: FCC Part 22 Page 2 of 26 Report Summary These tests were conducted on a sample of the equipment for the purpose of demonstrating compliance with Part 22. Conducted measurements were performed in accordance with ANSI TIA-603-B-2002. Radiated tests were conducted is accordance with ANSI C63.4-2003. Radiated emissions are made on an open area test site. A description of the test facility is on file with the FCC. The assessment summary is as follows: Apparatus Assessed: DEKO-4008 Cellular Repeater 800MHz (M/N: MW-CSR-800-50W90-XX-YY) Specification: FCC Part 22 Public Mobile Services Compliance Status: Complies Exclusions: None Non-compliances: None Report Release History: Original Release Author: Jason Nixon, Telecom Specialist Note that the results contained in this report relate only to the items tested and were obtained in the period between the date of initial receipt of samples and the date of issue of the report. This test report has been completed in accordance with the requirements of ISO/IEC 17025. Nemko Canada Inc. authorizes the applicant to reproduce this report provided it is reproduced in its entirety and for use by the company’s employees only. Any use which a third party makes of this report, or any reliance on or decisions to be made based on it, are the responsibility of such third parties. Nemko Canada Inc. accepts no responsibility for damages, if any, suffered by any third party as a result of decisions made or actions based on this report. Nemko Canada Inc. REPORT SUMMARY Report Number: 6W76966 FCC ID: OIWCSR80050W90D Specification: FCC Part 22 Page 3 of 26 TABLE OF CONTENTS Report Summary......................................................................................................................................... 2 Section 1 : Equipment Under Test............................................................................................................. 4 1.1 Product Identification .................................................................................................................................4 1.2 Samples Submitted for Assessment............................................................................................................4 1.3 Theory of Operation ...................................................................................................................................4 1.4 Technical Specifications of the EUT ..........................................................................................................5 1.5 Block Diagram of the EUT.........................................................................................................................5 Section 2 : Test Conditions......................................................................................................................... 6 2.1 Specifications .............................................................................................................................................6 2.2 Deviations From Laboratory Test Procedures ............................................................................................6 2.3 Test Environment .......................................................................................................................................6 2.4 Test Equipment...........................................................................................................................................6 Section 3 : Observations ............................................................................................................................. 7 3.1 Modifications Performed During Assessment ............................................................................................7 3.2 Record Of Technical Judgements ...............................................................................................................7 3.3 EUT Parameters Affecting Compliance .....................................................................................................7 3.4 Test Deleted................................................................................................................................................7 3.5 Additional Observations .............................................................................................................................7 Section 4 : Results Summary ..................................................................................................................... 8 4.1 FCC Part 22 : Test Results .........................................................................................................................9 Appendix A : Test Results ........................................................................................................................ 10 Clause 22.355 Frequency Stability ......................................................................................................................10 Clause 22.913 Output Power ...............................................................................................................................11 Clause 22.917 Conducted Spurious Emissions....................................................................................................12 Clause 22.917 Radiated Spurious Emissions.......................................................................................................17 Clause 2-11-04/EAB/RF Occupied…

Text truncated - open the document above for the full version.

Radiated Spurious Emissions Setup: