OIWMBDASMR025WBi-Directional Booster

Dec, 10,2006 DEKO-1408S Photos • Product Photos Figure 1– Front View Figure 2 – Rear View Figure 3 – Left Side View Figure 4 – Right Side View Figure 5 – Bottom View Figure 6 – Top View Figure 7– Left side view, with side cover removed Figure 8 –Right side view, with side cover removed

Dec, 10,2006 FCC ID for DEKO-1408S • FCC Label Following is the suggested design of the product's label, which includes the FCC ID. The product stamp will be made from metalized (silver) Polyester. The rest of the labels and markings will be printed upon the product's parts. • FCC ID location front view back side view

Dec, 10,2006 DEKO-1408S Tune Up procedure The Micro-Repeater Deko-1408 has a single calibration rotary switch on the left side of the product as presented in fig.30 that enables setting the output power between 4 and 11dBm. Fig.30 – RF power selector rotary switch When taking the product out of its package, the default position of the rotary switch is on maximum output power (11dBm per band). After installing the product, in case of a good coverage, there is a possibility to reduce the output power down to 4dBm in steps of 1dB using the rotary switch. The rotary switch can be freely and easily rotated counter clockwise as well as clockwise. After reducing the output power it is recommended to verify a good reception on your cellular phone at the whole area, which the micro-repeater should cover. This procedure should be performed only once during the product installation.

Prediction of MPE limit at a given distance Equation from page 18 of OET Bulletin 65, Edition 97-01where: S = power density P = power input to the antennaG = power gain of the antenna in the direction of interest relative to an isotropic radiatorR = distance to the center of radiation of the antenna Maximum peak output power at antenna input terminal: 11.00 (dBm) Maximum peak output power at antenna input terminal: 12.58925412 (mW) Antenna gain(typical): 3 (dBi) Maximum antenna gain: 1.995262315 (numeric) Prediction distance: 20 (cm) Prediction frequency: 860 (MHz) MPE limit for uncontrolled exposure at prediction frequency: 0.573333333 (mW/cm^2) Power density at prediction frequency: 0.004997 (mW/cm^2) Maximum allowable antenna gain: 23.59677048 (dBi) Margin of Compliance: 20.59677048 (dB) 2 4 R PG S π =

Prediction of MPE limit at a given distance Equation from page 18 of OET Bulletin 65, Edition 97-01where: S = power density P = power input to the antennaG = power gain of the antenna in the direction of interest relative to an isotropic radiatorR = distance to the center of radiation of the antenna Maximum peak output power at antenna input terminal: 11.00 (dBm) Maximum peak output power at antenna input terminal: 12.58925412 (mW) Antenna gain(typical): 10 (dBi) Maximum antenna gain: 10 (numeric) Prediction distance: 20 (cm) Prediction frequency: 815 (MHz) MPE limit for uncontrolled exposure at prediction frequency: 0.543333333 (mW/cm^2) Power density at prediction frequency: 0.025046 (mW/cm^2) Maximum allowable antenna gain: 23.36336205 (dBi) Margin of Compliance: 13.36336205 (dB) 2 4 R PG S π =

FCC Part 15 Subpart C, 15.247 : February 2005 Test Report: 6W78091 Applicant: Dekolink Wireless Ltd. 16 Bazel St. Qiryat Arieh Petah-Tikva, 49510 Istael Apparatus: MW-MBDA-SMR-025W60-800 DEKO 1408S 800 MHz SMR RF Micro-Repeater FCC ID: OIWMBDASMR025W In Accordance With: FCC Part 90, Boosters Private Land Mobile Radio Services Tested By: Nemko Canada Inc. 303 River Road Ottawa, Ontario K1V 1H2 Authorized By: Xu Jin, Wireless Specialist Date: Total Number of Pages: 24 Nemko Canada Inc. REPORT SUMMARY Report Number: 6W78091 FCC ID: OIWMBDASMR025W Specification: FCC Part 90 Page 2 of 24 Report Summary These tests were conducted on a sample of the equipment for the purpose of demonstrating compliance with Part 90. Conducted measurements were performed in accordance with ANSI TIA-603-B-2002. Radiated tests were conducted is accordance with ANSI C63.4-2003. Radiated emissions are made on an open area test site. A description of the test facility is on file with the FCC. The assessment summary is as follows: Apparatus Assessed: MW-MBDA-SMR-025W60-800 DEKO 1408S 800 MHz SMR RF Micro-Repeater Specification: FCC Part 90 Private Land Mobile Radio Services Compliance Status: Complies Exclusions: None Non-compliances: None Report Release History: Original Release Author: Heng Lin, EMC / Wireless Test Specialist Note that the results contained in this report relate only to the items tested and were obtained in the period between the date of initial receipt of samples and the date of issue of the report. This test report has been completed in accordance with the requirements of ISO/IEC 17025. Nemko Canada Inc. authorizes the applicant to reproduce this report provided it is reproduced in its entirety and for use by the company’s employees only. Any use which a third party makes of this report, or any reliance on or decisions to be made based on it, are the responsibility of such third parties. Nemko Canada Inc. accepts no responsibility for damages, if any, suffered by any third party as a result of decisions made or actions based on this report. Nemko Canada Inc. REPORT SUMMARY Report Number: 6W78091 FCC ID: OIWMBDASMR025W Specification: FCC Part 90 Page 3 of 24 TABLE OF CONTENTS Report Summary......................................................................................................................................... 2 Section 1: Equipment Under Test.............................................................................................................. 4 1.1 Product Identification .................................................................................................................................4 1.2 Samples Submitted for Assessment............................................................................................................4 1.3 Technical Specifications of the EUT ..........................................................................................................5 Section 2: Test Conditions.......................................................................................................................... 6 2.1 Specifications .............................................................................................................................................6 2.2 Deviations From Laboratory Test Procedures ............................................................................................6 2.3 Test Environment .......................................................................................................................................6 2.4 Test Equipment...........................................................................................................................................6 Section 3: Observations .............................................................................................................................. 7 3.1 Modifications Performed During Assessment ............................................................................................7 3.2 Record Of Technical Judgements ...............................................................................................................7 3.3 EUT Parameters Affecting Compliance .....................................................................................................7 3.4 Test Deleted................................................................................................................................................7 3.5 Additional Observations .............................................................................................................................7 Section 4: Results Summary ...................................................................................................................... 8 4.1 FCC Part 90: Test Results ..........................................................................................................................9 Appendix A: Test Results ......................................................................................................................... 10 Appendix B : Setup Photographs ............................................................................................................ 23 Appendix C : Block Diagram of Test Setups .......................................................................................... 24 Nemko Canada Inc. SECTION 1: EQUIPMENT UNDER TEST Report Number: 6W78091 FCC ID: OIWMBDASMR025W Specification: FCC Part 90 Page 4 of 24 Section 1: Equipment Under Test 1.1 Product Identification The Equipment Under Test was identified as follows: MW-MBDA-SMR-025W60-800 DEKO 1408S 800 MHz SMR RF Micro-Repeater 1.2 Samples Submitted for Assessment The following samples of the apparatus have been submitted for type assessment: Sample No. Description Serial No. 1 Micro Mini repeater MN # MW-MBDA-SMR-025W60-800 06110010 2 AC/DC switching adaptor MN # ES25UO7-075 N/A The first samples were received on: Dec. 14, 2006 Nemko Canada Inc. SECTION…

Text truncated - open the document above for the full version.