PKW-WETAP11Wireless AP/ Ethernet to Wireless Adapter

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. FCC RF Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

Report No.: 01BH017FI Page: 1 of 12 Version:1.0 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (Mode 1) (2) EUT Photo (Mode 1) Report No.: 01BH017FI Page: 2 of 12 Version:1.0 (3) EUT Photo (Mode 2) (4) EUT Photo (Mode 2)

BroMax FCC ID.: PKW-WETAP11 1F, No. 21, R&D Road II, Science-based Industrial Park, Hsinchu, Taiwan, R.O.C. Tel: 886 3 578-9090 Fax: 886 3 578-9520 FCC ID The FCC ID Label will be placed on the equipment as shown in the photograph below. Wireless AP/Ethernet to Wireless Adapter Model No.: WAP11C/WET11 F F C C C C I I D D : : P P K K W W - - W W E E T T A A P P 1 1 1 1 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. S/N: Made in Taiwan

Report No.: 01BH017FI Page: 3 of 12 Version:1.0 (5) EUT Photo (6) EUT Photo Report No.: 01BH017FI Page: 4 of 12 Version:1.0 (7) EUT Photo (8) EUT Photo Report No.: 01BH017FI Page: 5 of 12 Version:1.0 (9) EUT Photo (10) EUT Photo Report No.: 01BH017FI Page: 6 of 12 Version:1.0 (11) EUT Photo (12) EUT Photo Report No.: 01BH017FI Page: 7 of 12 Version:1.0 (13) EUT Photo (14) EUT Photo Report No.: 01BH017FI Page: 8 of 12 Version:1.0 (15) EUT Photo (16) EUT Photo Report No.: 01BH017FI Page: 9 of 12 Version:1.0 (17) EUT Photo (Mode 1) (18) EUT Photo (Mode 1) Report No.: 01BH017FI Page: 10 of 12 Version:1.0 (19) EUT Photo (Mode 1) (20) EUT Photo (Mode 1) Report No.: 01BH017FI Page: 11 of 12 Version:1.0 (21) EUT Photo (Mode 2) (22) EUT Photo (Mode 2) Report No.: 01BH017FI Page: 12 of 12 Version:1.0 (23) EUT Photo (Mode 2) (24) EUT Photo (Mode 2)

1.2 . Operational Description EUT is a Wireless AP/Ethernet to Wireless Adapter with 11 channels. This device provided four kind of transmitting speed 1,2,5.5 and 11Mbps. The device of RF carrier is DQPSK, DB PSK and CCK. The device adapts direct sequence spread spectrum modulation. The connector antenna provides diversity function to improve the receiving function. Data can be transmitted by the radio signal connect to the Internet or Local network.

1.2 . Operational Description EUT is a Wireless AP/Ethernet to Wireless Adapter with 11 channels. This device provided four kind of transmitting speed 1,2,5.5 and 11Mbps. The device of RF carrier is DQPSK, DB PSK and CCK. The device adapts direct sequence spread spectrum modulation. The connector antenna provides diversity function to improve the receiving function. Data can be transmitted by the radio signal connect to the Internet or Local network.

Report No. 01BH017FI Page: 3 of 64 Version:1.0 TABLE OF CONTENTS Description Page 1. GENERAL INFORMATION.............................................................................................5 1.1. EUT Description.................................................................................................................5 1.2. Operational Description.......................................................................................................5 1.3. Tested System Details..........................................................................................................6 1.4. Configuration of tested System.............................................................................................6 1.5. EUT Exercise Software........................................................................................................6 1.6. Test Facility........................................................................................................................7 2. Conducted Emission..........................................................................................................8 2.1. Test Equipment List.............................................................................................................8 2.2. Test Setup...........................................................................................................................8 2.3. Limits.................................................................................................................................8 2.4. Test Procedure.....................................................................................................................9 2.5. Test Result of Conducted Emission.....................................................................................10 3. Peak Power Output..........................................................................................................12 3.1. Test Equipment..................................................................................................................12 3.2. Test Setup.........................................................................................................................12 3.3. Test Condition...................................................................................................................12 3.4. Minimum Standard............................................................................................................12 3.5. Test Result of Peak Power Output.......................................................................................13 4. RF Exposure Evaluation..................................................................................................14 4.1. Friis Formula.....................................................................................................................14 4.2. EUT Operation condition...................................................................................................14 4.3. Test Result of RF Exposure Evaluation...............................................................................15 5. Radiated Emission...........................................................................................................16 5.1. Test Equipment..................................................................................................................16 5.2. Test Setup.........................................................................................................................16 5.3. Test Condition...................................................................................................................17 5.4. Limits...............................................................................................................................17 5.5. Test Procedure...................................................................................................................18 5.6. Test Result of Radiated Emission........................................................................................19 6. Band Edge.......................................................................................................................37 6.1. Test Equipment..................................................................................................................37 6.2. Test Setup.........................................................................................................................37 6.3. Test Condition...................................................................................................................38 6.4. Standard Reqirement..........................................................................................................38 6.5. Test Result of Band Edge...................................................................................................39 7. Occupied Bandwidth.......................................................................................................43 7.1. Test Equipment..................................................................................................................43 7.2. Test Setup.........................................................................................................................43 7.3. Test Condition...................................................................................................................43 7.4. Standard Reqirement..........................................................................................................43 7.5. Test Result of Occupied Bandwidth....................................................................................44 Report No. 01BH017FI Page: 4 of 64 Version:1.0 8. Processing Gain...............................................................................................................47 8.1. Test Condition...................................................................................................................4…

Text truncated - open the document above for the full version.

Report No.: 01BH017FI Page: 1 of 6 Version:1.0 Attachment 1: EUT Test Setup Photographs Front View of Conducted Test (Mode 1) Back View of Conducted Test (Mode 1) Report No.: 01BH017FI Page: 2 of 6 Version:1.0 Front View of Conducted Test (Mode 2) Back View of Conducted Test (Mode 2) Report No.: 01BH017FI Page: 3 of 6 Version:1.0 Front View of Radiated Test (Mode 1) Back View of Radiated Test (Mode 1) Report No.: 01BH017FI Page: 4 of 6 Version:1.0 Front View of Radiated Test (Mode 2) Back View of Radiated Test (Mode 2) Report No.: 01BH017FI Page: 5 of 6 Version:1.0 Front View of Radiated Test-Horn (Mode 1) Back View of Radiated Test-Horn (Mode 1) Report No.: 01BH017FI Page: 6 of 6 Version:1.0 Front View of Radiated Test-Horn (Mode 2) Back View of Radiated Test-Horn (Mode 2)