Q2V5D2007083MWWII WIRELESS CONTROLLER

WIRELESS CONTROLLER INSTRUCTION MANUAL(ENGLISH) Safety Information: 1. The protective silicon skin and wrist-strap must be used at all times to avoid accidental damage or injury. 2. Always make sure there is sufficient room in which to play. Installing Batteries: 1. Wireless Controller requires 2 x AA batteries (not included). 2. Remove battery cover and insert batteries – please note correct polarities. 3. Then replace battery cover. 4. Please note safety information on the packaging of the batteries used. Controller Set-Up: 1. Turn on your Wii™ console. 2. Remove the battery cover from Wireless Controller and press the “SYNC” button. The player LEDs will flash. 3. Open SD card slot cover on the front of your Wii™ console, then press and release the “SYNC” button on inside of compartment. When the player LEDs stop flashing set-up is complete. 4. The LED that is illuminated donates your player number. Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

MAXWISE Production Enterprise Ltd Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of FCC ID: Q2V5D2007083MW. Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, we hereby request confidential treatment of information accompanying this application as outlined below: Exhibit Type File Name Block Diagram Block Diagram.pdf Schematics Schematics.pdf Operational Description Operational Description.pdf Part List Part List BOM).pdf The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, -------------------------------------- Rui Yang Lin / Managing Director Company Name: Koome Crafts & Toys Co., Ltd. Tel: (+86)0760- 28181218

SGS-CSTC Standards Technical Services Co., Ltd. Test Lab Attestation Letter This attestation is to confirm that the below listed device was tested at our Test Facilities located at: Test Lab Name: SGS-CSTC Standards Technical Services Co., Ltd. Test Lab Address: 198 Kezhu Road, Scientech Park, Guangzhou Economic & Technology Development District, Guangzhou, China 510663 Test Lab Registration Number: 282399 Date of Test: 2012-04-23 to 2012-06-15 Test Report Number: GZEM120400124801 Applicant Name: MAXWISE Production Enterprise Ltd. FCC ID: Q2V5D2007083MW Name of Engineer(s) Performing Test: Danviel He Company Name of Engineer(s) Performing Test: SGS-CSTC Standards Technical Services Co., Ltd. TEST LABORATORY: Signature of Authorized Representative of the Test Laboratory: Full Contact Name: Strong Yao Position/Title: Lab Manager SGS-CSTC Standards Technical Services Co., Ltd. Photos:

External Photos

Label & Location FCC ID: Q2V5D2007083MW Size: 30mmX5mm

Internal Photos

SGS-CSTC Standards Technical Services Co., Ltd. Application No..: GZEM1204001248RF Page: 1 of 1 FCC ID: Q2V5D2007083MW This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. RF Exposure Compliance Requirement The product belongs to the Portable device base the FCC rule part 2.1091&2.1093. The Max Conducted Peak Output Power is -0.15dBm (0.97mW) in channel 39; the antenna is generally less than 0dBi PCB integrated in the actual use. 3dB logarithmic terms convert to numeric result is nearly 1; According to the formula, calculate the EIRP test result: 1) EIRP= P x G = mW x 1 =0.97mW; The portable device SAR low threshold is 60/f(GHz); 2) S= 60 / f(GHz) = 60/2.4 = 25mW; According to TCB Exclusion List (17 July 2002), the SAR report is not required.

SGS-CSTC Standards Technical Services Co., Ltd. 198 Kezhu Road, Scientech Park, Guangzhou Economic & Technology Development District, Guangzhou, China 510663 Tel: +86 20 82155555 Fax: +86 20 82075059 Email: [email protected] FEDERAL COMMUNICATIONS COMMISSION Registration number: 282399 Report No.: GZEM120400124801 Page: 1 of 57 FCC ID: Q2V5D2007083MW Authorized Signature: Strong Yao Manager The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the federal government. All test results in this report can be traceable to National or International Standards. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only 1 Cover Page TEST REPORT Application No.: GZEM1204001248RF Applicant: MAXWISE Production Enterprise Ltd. FCC ID: Q2V5D2007083MW Product Name: Wii Wireless Controller Product Description: Wii Wireless Controller Model No.: 5D20070MW, 5D20076MW, 5D20072MW, 5D20078MW, 5D20068MW, 5D20069MW, 5D20082MW, 5D20074MW, 5D20075MW, 5D20083MW, 5D20067MW, 5D20073MW ♣ ♣ Please refer to section 3 of this report for details Standards: FCC PART 15 Subpart C: 2011 section 15.247 Date of Receipt: 2012-04-23 Date of Test: 2012-04-23 to 2012-06-15 Date of Issue: 2012-06-20 Test Result : Pass* * In the configuration tested, the EUT detailed in this report complied with the standards specified above. Please refer to section 3 of this report for further detail. SGS-CSTC Standards Technical Services Co., Ltd. Report No.: GZEM120400124801 Page: 2 of 57 FCC ID: Q2V5D2007083MW This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. 2 Version Revision Record Version Chapter Date Modifier Remark 00 2012-06-20 Original Authorized for issue by: Tested By 2012-04-23 to 2012-06-15 (Daniel He) /Signature Date Prepared By 2012-06-18 (Daniel He) /Signature Date Checked By 2012-06-20 (Strong Yao) /Reviewer Date SGS-CSTC Standards Technical Services Co., Ltd. Report No.: GZEM120400124801 Page: 3 of 57 FCC ID: Q2V5D2007083MW This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. 3 Test Summary TEST TEST REQUIREMENT TEST METHOD RESULT Antenna Requirement FCC PA…

Text truncated - open the document above for the full version.

Test Setup Photos Radiated Spurious Emission Test Setup Below 30 MHz: 30MHz to 1GHz: Above 1GHz: (full anechoic chamber)