Q6DCTX712V2802.11b WLAN miniPCI Card

Creatix WLAN Modem Combo CTX712 V.2 User Manual This handbook is protected by copyright. It must not be copied, reproduced, translated or transmitted in electronic media, in whole or in part. Accuracy of the information is not guaranteed. Any mention in this handbook of products of other manufacturers is for information purposes only and represents no misuse of trademarks. Safety instructions for Data-Fax-Modem This equipment has been designed and tested in accordance with the requirements of Standard IEC 950 „Safety of Information Technology Equipment, Including Electrical Business Equipment“ Extracts from these requirements according Standard IEC 950: • The FAX-Modem was evaluated for use in maximum ambient temperature of 40 °C. • The FAX-Modem may only be used in countries where the modem is certified. • Neither the data transmission cable nor the telephone cable should be connected or disconnected during a thunderstorm. mv205a0.402uk Regulatory Statements FCC Certification The United States Federal Communication Commission and the Canadian Department of Communication have established certain rules governing the use of electronic equipment. Part15, Class B This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device my not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Caution: 1. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. 2. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 3. Changes or modifications made to this equipment not expressly approved by Creatix Polymedia GmbH may void the FCC authorization to operate this equipment Table of Contents Chapter 0 INSTALLATION WLAN Chapter 1 INTRODUCTION ................................ 1-1 What is a Modem? ...................................................................................... 1-1 About this Modem ....................................................................................... 1-1 The 56K Technology.................................................................................... 1-2 General Description .................................................................................... 1-2 Auto-Answering............................................................................................ 1-3 Installation Instructions Windows 95/98 ..............................................1-3 Windows 9x and ME...................................... 1-3 Windows NT 4.0 ............................................ 1-4 Windows 2000/XP ......................................... 1-4 Factory Settings .......................................................................................... 1-4 Chapter 2 AT COMMANDS: DATA MODEM ...... 2-1 Guidelines for Using AT Commands .......................................................... 2-1 AT - Attention Code .................................................................................... 2-3 The ESC Sequence .................................................................................... .2-3 A - Answer Mode ......................................................................................... 2-4 A/ - Repeat Last Command Line ................................................................ 2-4 B - BELL/CCITT .......................................................................................... 2-4 D - Automatic Dialing and Dialing Parameters ........................................... .2-5 E – Echo Function ......................................................................................2-6 H – Switch Hook Check (Replace Handset) – Go "On Hook" .................... 2-6 I – Firmware Information .............................................................................. 2-6 L – Volume Level ........................................................................................ .2-6 M – Switching the Loudspeaker On and ..................................................... 2-6 N – Recognizing Type of Modulation........................................................... 2-7 O – Return to online Operation.................................................................... 2-7 Q – Modem Messages On / Off .................................................................. 2-7 S – Reading and Modifying Registers ........................................................2-7 V – Verbal or Numeric Modem Messages .................................................. 2-7 W – Controlling Connect Messages ........................................................... 2-8 X – Result Code Type/Call Progress .......................................................... 2-9 Y – Long Space Disconnect ...........................................…

Text truncated - open the document above for the full version.

CTX712 V.2 Label Location INFO The label is located on top side: See location as below:

CTX 712_V2 USA SAP: 40004411 Ratings: +3,3V 350mA FCC ID: Q6DCTX712V2 US:CPGM507BCTX712V2

Recognized by the Federal Communications Commission Anechoic chamber registration no: 90462 (FCC) Anechoic chamber registration no: 3436 (IC) TCB ID: DE 0001 Accredited by the German Accreditation Council DAR–Registration Number TTI–P–G 166/98 Independent ETSI compliance test house ETSI Accredited Bluetooth™ Test Facility (BQTF) Test report no.: 2-3360-01-01/03 FCC Part 15.247 / CANADA RSS-210 FCC ID: Q6DCTX712V2 CTX 712 V.2 CETECOM – ICT Services GmbH Untertürkheimerstr. 6-10 D-66117 Saarbrücken, Germany Telephone: + 49 (0) 681 / 598-0 Fax: + 49 (0) 681 / 598-9075 BLUETOOTH is a trademark owned by Bluetooth SIG, Inc. and licensed to Cetecom Testreport for digitally modulated TX CETECOM ICT Services GmbH Saarbruecken, Germany Test report No.: 2-3360-01-01/03 Date: 2003-08-07 Page 2 of 56 Table of contents 1. ADMINISTRATIVE DATA ...................................................................................................................................... 3 1.1. ADMINISTRATIVE DATA OF THE TEST FACILITY..................................................................................................... 3 1.1.1 Identification of the testing laboratory ......................................................................................................... 3 1.1.2 Organizational items..................................................................................................................................... 3 1.1.3 Applicant ́s details ........................................................................................................................................ 4 1.2 ADMINISTRATIVE DATA OF MANUFACTURER / MEMBER........................................................................................ 4 1.3 DESCRIPTION OF THE EQUIPMENT UNDER TEST (EUT) .......................................................................................... 5 1.3.1 EUT: Type, S/N etc. ...................................................................................................................................... 5 1.3.2 If RF component testing only, describtion of additional used HW/SW ......................................................... 5 1.3.3 Additional EUT information................................................................................................................ 5 1.3.4 EUT operating modes ................................................................................................................................... 6 1.3.5 Extreme conditions testing values................................................................................................................. 6 3.1 DESCRIPTION OF TEST SET-UP................................................................................................................................8 3.1.1 Radiated measurements ................................................................................................................................ 8 3.1.2 Conducted measurements ............................................................................................................................. 8 3.3 ADDITIONAL COMMENTS....................................................................................................................................... 9 3.4 ANTENNA GAIN..................................................................................................................................................... 9 3.5 PEAK POWER SPECTRAL DENSITY (DIGITALLY MODULATED SYSTEMS)§15.247(D) ............................................. 10 3.9 SPECTRUM BANDWIDTH OF A DSSS SYSTEM / 6 DB BANDWITH §15.247(A2).................................................... 13 3.7 MAXIMUM OUTPUT POWER (CONDUCTED) § 15.247 (B) (1) ................................................................................ 17 3.8 MAX. PEAK OUTPUT POWER (RADIATED) § 15.247 (B) (1)................................................................................... 19 3.12 CONDUCTED EMISSIONS §15.247 (C) ................................................................................................................... 20 3.10 BAND-EDGE COMPLIANCE OF RADIATED EMISSIONS §15.205 .............................................................................. 26 3.11 SPURIOUS EMISSIONS - CONDUCTED (TRANSMITTER) § 15.247 (C)..................................................................... 30 3.12 SPURIOUS EMISSIONS - RADIATED (TRANSMITTER) § 15.209 .............................................................................. 31 3.13 SPURIOUS EMISSIONS - RADIATED (RECEIVER) § 15. 209.................................................................................... 39 3.14 SPURIOUS EMISSIONS - RADIATED <30 MHZ § 15.209 ........................................................................................ 43 3.15 CONDUCTED EMISSIONS <30 MHZ § 15.207 ....................................................................................................... 44 4 PHOTOGRAPHS ..................................................................................................................................................... 49 4.1 TEST SETUP PHOTOS .......................................................................................................................................... 49 4.2 E XTERNAL PHOTOS INCL. ACCESSORIES.............................................................................................................. 51 4.3 I NTERNAL PHOTOS ............................................................................................................................................. 55 ANNEX 1: TECHNICAL PRODUCT DESCRIPTION WLAN mini-PCI card (DSSS) with analog modem interface (not part of this test) for use in PC`s. For radiated tests we used a special prepared PC with extender board and a wide spread antenna set from HITACHI, for conducted measurements we used a laptop . We used a special testing software to set the product in the test setup. Wit…

Text truncated - open the document above for the full version.

Testreport for digitally modulated TX CETECOM ICT Services GmbH Saarbruecken, Germany Test report No.: 2-3360-01-01/03 Date: 2003-08-07 Page 49 of 56 4 Photographs 4.1 TEST SETUP PHOTOS Testreport for digitally modulated TX CETECOM ICT Services GmbH Saarbruecken, Germany Test report No.: 2-3360-01-01/03 Date: 2003-08-07 Page 50 of 56 WLAN card on extender board and antenna set Testreport for digitally modulated TX CETECOM ICT Services GmbH Saarbruecken, Germany Test report No.: 2-3360-01-01/03 Date: 2003-08-07 Page 51 of 56 Testreport for digitally modulated TX CETECOM ICT Services GmbH Saarbruecken, Germany Test report No.: 2-3360-01-01/03 Date: 2003-08-07 Page 52 of 56 AC-conducted: made with a laptop with build-in testsample.