QPU8000Wi-Fi Network Controller Module

SN8000 and SN8000UFL Module Regulatory Certification User’s Manual Version: 1.0 July 26, 2013 Revision History Revision Date Author Change Description 1.0 07/26/2013 R. Willett Initial version Page 2 of 7 SN8200 and 8200 UFL Regulatory Certification v1.0 Table of Contents 1 REGULATORY CERTIFICATION ...................................................................................................................... 4 1.1 REGULATORY INFORMATION .................................................................................................................................. 4 1.1.1 FEDERAL COMMUNICATIONS COMMISSION ....................................................................................... 4 1.1.2 INDUSTRY CANADA ................................................................................................................................... 5 1.1.3 OEM RESPONSIBILITY FOR FCC AND IC COMPLIANCE ..................................................................... 6 1.1.4 OEM PRODUCT LABELING REQUIREMENTS ........................................................................................ 7 Page 3 of 7 SN8200 and 8200 UFL Regulatory Certification v1.0 1 Regulatory Certification FCC ID: QPU8000 IC ID: 4523A-SN8000 ETSI: Compliant to standards EN 300 328 and EN 301 489 1.1 Regulatory Information 1.1.1 FEDERAL COMMUNICATIONS COMMISSION FCC Modular Approval (MA) has been granted for the SN8000 and SN8000UFL modules. For the SN8000 module, the on-board antenna has been qualified and approved for use under the MA certification. The SN8000UFL module has also been qualified and approved WITH THE STATED ANTENNA ONLY (see Industry Canada section for the specific antenna). NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can re-radiate radio frequency energy and, if not installed and used in accordance with these instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/ TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT Page 4 of 7 SN8200 and 8200 UFL Regulatory Certification v1.0 1.1.2 INDUSTRY CANADA This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. L’opération est soumise aux deux conditions suivantes : (1) cet appareil ne peut pas provoquer d’interférences et (2) cet appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement de l’appareil. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the Equivalent Isotropically Radiated Power (E.I.R.P.) is not more than that permitted for successful communication. Pour réduire le risque d'interférence avec d'autres utilisateurs, le type d'antenne et son gain doivent être choisis afin que la puissance isotrope rayonnée équivalente (PIRE) ne soit pas supérieure à celle permise pour une communication réussie. The SN8000UFL device has been designed and certified to operate with the antenna listed below, having a maximum gain of 5 dBi. Antennas not included in this list or having a gain greater than 5 dBi are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. Le dispositif SN8000UFL a été conçu et certifié pour fonctionner avec l'antenne énumérés ci- dessous, avec un gain maximum de 5 dBi. Antennes pas inclus dans cette liste ou présentant un gain de plus de 5 dBi sont strictement interdits pour une utilisation avec cet appareil. L'antenne requise impédance est de 50 ohms. Antenna: 5 dBi antenna from Microchip Technology, part number TRF1002 Page 5 of 7 SN8200 and 8200 UFL Regulatory Certification v1.0 1.1.3 OEM RESPONSIBILITY FOR FCC AND IC COMPLIANCE For OEM products that incorporate this device, the manufacturer must include certain text in their product user’s guide along with other applicable regulatory information. For an intentional or unintentional radiator, the OEM product guide should caution that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The OEM should not provide information to the end user that allows modification or change of RF characteristics of the end product. Also, the following conditions apply: 1. This device is granted for use in mobile only configurations in which the antennas used for this transmitter must be installed to provide a) a separation distance of at least 20 cm from all persons and b) not be co-located with any other tra…

Text truncated - open the document above for the full version.

Prediction of MPE limit at a given distance Equation from page 18 of OET Bulletin 65, Edition 97-01 where:S = power density P = power input to the antenna G = power gain of the antenna in the direction of interest relative to an isotropic radiator R = distance to the center of radiation of the antenna Maximum peak output power at antenna input terminal:22.9(dBm)* Maximum peak output power at antenna input terminal:195.0(mW) Antenna gain(maximum):0.8(dBi)* Maximum antenna gain:1.20(numeric) Time Averaging:100(%)* Prediction distance:20(cm)* Prediction frequency:2412(MHz)* MPE limit for uncontrolled exposure at prediction frequency:1.000(mW/cm^2) Power density at prediction frequency:0.047 (mW/cm^2) This equates to:0.466 W/m^2 2 4R PG S  

Nemko Test Report: 10238007RUS1rev2 Applicant: SyChip, LLC 4441 Sigma Road Dallas, TX 75244 USA Equipment Under Test: WiFi SN8000 and SN8000UFL (E.U.T.) FCC Identifier: QPU8000 Industry Canada Identifier: 4523A-SN8000 In Accordance With: FCC Part 15, Subpart C, 15.247 and Industry Canada RSS-210, Issue 8 Digital Transmission Systems Tested By: Nemko USA, Inc. 802 N. Kealy Lewisville, Texas 75057-3136 TESTED BY: DATE: 08 May 2013 David Light, Senior Wireless Engineer APPROVED BY: DATE: 06 June 2013 Michael Cantwell, Reviewer Number of Pages: 67 Nemko USA, Inc. FCC PART 15, SUBPART C and Industry Canada RSS-210 Digital Transmission Systems EQUIPMENT: WiFi SN8000 and SN8000UFL Test Report No.:10238007RUS1rev2 Page 2 of 67 Table of Contents SECTION 1. SUMMARY OF TEST RESULTS 3 SECTION 2. EQUIPMENT UNDER TEST (E.U.T.) 5 SECTION 3. OCCUPIED BANDWIDTH 6 SECTION 4. MAXIMUM PEAK OUTPUT POWER 19 SECTION 5 SPURIOUS EMISSIONS AT ANTENNA TERMINALS 29 SECTION 6. RADIATED EMISSIONS 42 SECTION 7. PEAK POWER SPECTRAL DENSITY 44 SECTION 8. POWERLINE CONDUCTED EMISSIONS 54 SECTION 9. TEST EQUIPMENT LIST 57 ANNEX A - TEST DETAILS 58 ANNEX B - TEST DIAGRAMS 65 Nemko USA, Inc. FCC PART 15, SUBPART C and Industry Canada RSS-210 Digital Transmission Systems EQUIPMENT: WiFi SN8000 and SN8000UFL Test Report No.:10238007RUS1rev2 Page 3 of 67 Section 1. Summary of Test Results Manufacturer: SyChip, LLC Model No.: SN8000 and SN8000UFL* Serial No.: None *Note: Model SN8000 uses chip antenna and model SN8000UFL uses external 5 dBi dipole antenna. General: All measurements are traceable to national standards. These tests were conducted on a sample of the equipment for the purpose of demonstrating compliance with Part 15, Subpart C, Paragraph 15.247 and Industry Canada RSS-210, Issue 8 for Digital Transmission Systems. Radiated tests were conducted is accordance with ANSI C63.4-2003. Radiated emissions are made on an open area test site. A description of the test facility is on file with the FCC and Industry Canada. New Submission Production Unit Class II Permissive Change Pre-Production Unit THIS TEST REPORT RELATES ONLY TO THE ITEM(S) TESTED. THE FOLLOWING DEVIATIONS FROM, ADDITIONS TO, OR EXCLUSIONS FROM THE TEST SPECIFICATIONS HAVE BEEN MADE. See “ Summary of Test Data”. This report must not be used to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the Federal Government. Nemko USA, Inc. is a NVLAP accredited laboratory. Nemko USA Inc. authorizes the above named company to reproduce this report provided it is reproduced in its entirety and for use by the company’s employees only. Any use which a third party makes of this report, or any reliance on or decisions to be made based on it, are the responsibility of such third parties. Nemko USA Inc. accepts no responsibility for damages, if any, suffered by any third party as a result of decisions made or actions based on this report. This report applies only to the items tested. Nemko USA, Inc. FCC PART 15, SUBPART C and Industry Canada RSS-210 Digital Transmission Systems EQUIPMENT: WiFi SN8000 and SN8000UFL Test Report No.:10238007RUS1rev2 Page 4 of 67 Summary Of Test Data NAME OF TEST PARA. NO. RESULT Powerline Conducted Emissions 15.207(a) / RSS-Gen 7.2.4 Complies Minimum 6 dB Bandwidth 15.247(a)(2) / RSS-210 A8.2(a) Complies Maximum Peak Power Output 15.247(b)(3) / RSS-210 A8.4(4) Complies Spurious Emissions (Antenna Conducted) 15.247(d) / RSS-210 A8.5 Complies Spurious Emissions (Restricted Bands) 15.247(d)/15.209(a) / RSS-Gen 7.2.2 Complies Peak Power Spectral Density 15.247(e) / RSS-210 A8.2(b) Complies Footnotes: Revisions: Rev1 Corrected typographical error on model number. Rev2 Corrected antenna type and customer address. Nemko USA, Inc. FCC PART 15, SUBPART C and Industry Canada RSS-210 Digital Transmission Systems EQUIPMENT: WiFi SN8000 and SN8000UFL Test Report No.:10238007RUS1rev2 Page 5 of 67 Section 2. Equipment Under Test (E.U.T.) General Equipment Information Frequency Band (MHz): 902-928 2400-2483.5 5725-5850 Operating Frequency of Test Sample: 2412 to 2462 MHz Channel Spacing: 5 MHz User Frequency Adjustment: Software controlled Nemko USA, Inc. FCC PART 15, SUBPART C and Industry Canada RSS-210 Digital Transmission Systems EQUIPMENT: WiFi SN8000 and SN8000UFL Test Report No.:10238007RUS1rev2 Page 6 of 67 Section 3. Occupied Bandwidth NAME OF TEST: Occupied Bandwidth PARA. NO.: FCC 15.247(a)(2) RSS-210 A8.2(a) TESTED BY: David Light DATE: 29 April 2013 Test Results: Complies. Measurement Data: See 6 dB BW plot(s) Measured 6 dB bandwidth: 10 MHz 802.11b 16 MHz 802.11g 17 MHz 802.11n Test Conditions: 47 %RH 25 °C Measurement Uncertainty: +/-1x10 -7 ppm Test Equipment Used: 1036-1082-1472 Nemko USA, Inc. FCC PART 15, SUBPART C and Industry Canada RSS-210 Digital Transmission Systems EQUIPMENT: WiFi SN8000 and SN8000UFL Test Report No.:10238007RUS1rev2 Page 7 of 67 Test Data – Occupied Bandwidth 6 dB Bandwidth 802.11b Low Channel Nemko USA, Inc. FCC PART 15, SUBPART C and Industry Canada RSS-210 Digital Transmission Systems EQUIPMENT: WiFi SN8000 and SN8000UFL Test Report No.:10238007RUS1rev2 Page 8 of 67 Test Data – Occupied Bandwidth 6 dB Bandwidth 802.11b Mid Channel Nemko USA, Inc. FCC PART 15, SUBPART C and Industry Canada RSS-210 Digital Transmission Systems EQUIPMENT: WiFi SN8000 and SN8000UFL Test Report No.:10238007RUS1rev2 Page 9 of 67 Test Data – Occupied Bandwidth 6 dB Bandwidth 802.11b High Channel Nemko USA, Inc. FCC PART 15, SUBPART C and Industry Canada RSS-210 Digital Transmission Systems EQUIPMENT: WiFi SN8000 and SN8000UFL Test Report No.:10238007RUS1rev2 Page 10 of 67 Test Data – Occupied Bandwidth 6 dB Bandwidth 802.11g Low Channel Nemko USA, Inc. FCC PART 15, SUBPART C and Industry Canada RSS-210 Digital Transmission Systems EQUIPMENT: WiFi SN8000 and SN8000UFL Test Report No.:10238007RUS1rev2 Page 11 of 67 Test Data – Occupied Bandwidth 6 dB Bandwidth 802.11g Mid Channel Nemko USA, Inc. FCC PA…

Text truncated - open the document above for the full version.