R932036-010Hand Held Transmitter

Transmitter Instructions Before you can operate the device the transmitter must be learned to the receiver. This is very easy turn on your transmitter you will see the LED blink two times. Press one of the activation buttons and hold it down. Apply power to the receiver device while continuing to press the transmitter activation button and you will hear the relay click. Be Careful the device may start operation. If you experience problems repeat the process again. After the transmitter is learned you should not have to repeat this process again Place the transmitter in the palm of your hand . You will see three buttons. The button to the lower left turns the transmitter on and off after use. Press this button a red LED will blink twice and go out letting the operator know the unit is activated and ready for operation. Press the button again the LED will blink once shutting the unit down. The unit will shut down automatically if you fail to turn it off or there is no activity on the activation buttons for a period of five minutes. The activation buttons are located above the power button and have raised surfaces. The two buttons are used to activate the device after the transmitter is turned on. . This Device complies With The FCC Part15. Operation is subject to the following two conditions. (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Section 15.105 Information to the user Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: __Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. -- Caution any changes or modifications not approved by Delta Systems Inc voids user’s authority to operate this equipment .

Cover Letter To: Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046-1609 Delta Systems Inc 1734 Frost Road Streetsboro, Ohio 44241 Gentleman: Enclosed is a submittal for a 433.92Mhz hand held transmitter from Delta Systems Inc FRN# 0011099124 and grantee code R93. Testing was complete Nov 6 2005 at a facility ( FCC:91010) owned by The Genie Company where I do consulting work. I have done several submittals in the past but this is my first using the web. If you have any questions or problems please Email me at [email protected] or call me at 330-422- 5142. I believe I have included all necessary items. Thanks and have a great day! L.Chop Kramer

To: Linda Elliott Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046-1609 L.Chop Kramer Delta Systems Inc 1734 Frost Road Streetsboro, Ohio 44241 Linda: The FCC ID (R93OHIO) is an error on the Form731 (EA406832). Please Change it to (R932036-010) to reflect the identification label. This is an error on my part and I sincerely apologize. Thank You! L.Chop Kramer

To: Linda Elliott Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046-1609 L.Chop Kramer Delta Systems Inc 1734 Frost Road Streetsboro, Ohio 44241 Linda: The FCC ID (R93OHIO) is an error on the Form731 (EA406832). Please Change it to (R932036-010) to reflect the identification label. This is an error on my part and I sincerely apologize. Thank You! L.Chop Kramer