SBC-ADB100Bluetooth Cradle

http://www.cino.com.tw MBC-6890 Cordless Scanning Family Quick Reference International Edition, Rev. FSQR-A31204 -i- Table of Content 1. Getting Started............................................................................................1 1.1 FuzzyScan MBC-6890 .........................................................................2 2. Using Your MBC6890..................................................................................5 1.2 Install Your MBC6890...........................................................................6 1.3 LED Display and Beeping Reference Table............................................8 1.4 Uninstall / Pairing Command.................................................................9 1.5 Paging Command.................................................................................11 1.6 Interface Cable Setting..........................................................................12 3. Trouble Shooting.......................................................................................15 4. Safety Precautions for Batteries................................................................15 5. Appendix...................................................................................................16 Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment of f and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit di fferent from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. Regulatory information / Disclaimers Install and use of this Fuzzy Scan device must be in strict accordance with the instructions included in the user documentation provided with the product. Any changes or modifications (including the antennas) made to his device that are not expressly approved by the manufacturer may void the User ’ authority to operate the equipment, The manufacturer is not responsible for any radio or television interference caused by unauthorized modification Of this device, or the substitution of the connecting cable and equipment other than manufacturer specified. It is the responsibility of the user to correct any interference caused by such unauthorized modification, substitution or attachment. Manufacture and its authorized resellers or distributors will assume no liability for any damage or violation of government regulation aris ing from failing to comply with there guidelines. FCC RF Radiation Exposure Statement: 1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment shou ld be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. (for FCC ID: SBC-ADB100) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, incl uding interference that may cause undesired operation. -1- Getting Started Welcome to the FuzzyScan world Cordless Scanning Family, the most professional high quality cordless bar code liner imagers available in the market. In order to work with various needs, the Long Distance and Short Distance Bluetooth connections are available for both Long Range and High Density bar code linear imagers. The FuzzyScan Cordless family is designed to read various poor-printing bar codes with superior tolerance. Aside from the outstanding reading performance, the MBC6890 cordless linear imager is implemented with the latest Bluetooth technology for the reliable as well as cost-effective cordless solution. -2- FuzzyScan MBC-6890 The long distance/short distance, long-range/high-density bar code linear imager for mobile reading or cable replacement The Cordless Communication MBC6890 achieves the real-time cordless data transmission to the host through the most contemporary Bluetooth module. The Maximized Freedom of Scanning MBC6890 can free the operators from standing behind the desk, so they can move around and scan the bar code labels on bulky items without any difficulty. The Reliable Plug & Play Solution In order to guarantee the accuracy of data transmission, the auto acknowledgement will feedback from the Smart Cradle to scanner. Therefore, the bar code scanning can be processed more freely, efficiently and correctly. The Embedded “FuzzyScan” Scan Engine Applied to the latest innovative linear imaging technology, the FuzzyScan MBC-6890 linear imager is designed to capture bar code image up to 12” in snapshot (300 scans per second). Thanks to the ergonomic gun-shape and no moving part designs, this reader is the best choice to replace traditional laser scanner with lower cost. Both “Long-range” and “High-density” models are provided for reading alternatives of different resolution bar codes. Usually, the long-range model can read most popular bar codes up to 4-mil (0.01mm) resolution. Once the very fine resolution bar code capture is needed, y…

Text truncated - open the document above for the full version.

Power of Attorney Date: August 30, 2004 We, the undersigned, hereby authorize Compliance Certification Services Inc. to act on our behalf in all matters relating to all processes related to F C C applications and communications issue. Any and all acts carried out by Compliance Certification Services Inc. on our behalf shall have the same effects as acts of our own. If you have any questions regarding this authorization, please don’t hesitate to contact us. Thank you. Sincerely yours, ------------------------------------------------------------ Mr. Johnson Yu / Technical Director PC Worth Int’l Co., Ltd.

Confidentiality Request PC Worth Int’l Co., Ltd. Mr. Johnson Yu / Technical Director FCC ID: SBC-ADB100 Authorization and Evaluation Division Federal Communications Commission August 30, 2004 ----------------------------------------------- Sincerely, The Applicant understands that pursuant to Rule 0.457, disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application. The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. 3. Block diagram 2. Operational description 1. Schematics Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, the Applicant hereby requests confidential treatment of information accompanying this Application as outlined below:

Mike Kuo From: [email protected] Sent: October11 2004 Monday 6:32 PM To: Mike Kuo Cc: [email protected]; [email protected] Subject: RE: PC WORTH INTERNATIONAL CO., LTD. , FCC ID: SBC-ADB100, Asses sment NO.: AN04T4223, Notice#1 10/11/2004 Hi Lucy : Reply to Question #2 still post a question in mind. In the revised test report, all RF conducted portion of test data are identical to AN04T4090. Is the radio portion of device identical to the one in AN04T4090 ? Best Regards Mike Kuo -----Original Message----- From: [email protected] [mailto:[email protected]] Sent: Friday, October 08, 2004 7:41 PM To: Mike Kuo Cc: [email protected]; [email protected] Subject: PC WORTH INTERNATIONAL CO., LTD. , FCC ID: SBC-ADB100, Asses sment NO.: AN04T4223, Notice#1 Hi Mike, Mike Kuo <[email protected]> 2004/10/12 08:51 AM "'[email protected]'" <[email protected]> [email protected], [email protected] Please refer to the below for the reply for PC Worth. Question #1: The FCC ID number listed on the TCB application form is SBCADB100 which does not agree with the FCC ID number listed on FCC ID label format and test report ( SBC-ADB100). Please inform which FCC ID number is correct. Ans: Typing Error. the correct fcc id is SBC-ADB100 Question #2: All test data contains in this test report are identical to the one under assessment no:AN04T4090. Such misrepresenting test data on two different device is not acceptable. It is position of CCS-TCB to dismiss this application due to misrepresentation. Any test report submitted under above FCC ID number will be subject to TCB sample request tests. Ans:We have redo the test and attached are the test report for your reference. (See attached file: 40813202-RP Revised 1007.pdf)(See attached file: 40813202-Photo.pdf) Best Regards, Lucy ________________________________________________________________________ This e-mail transmission is confidential and intended solely for being reviewed by the recipient(s) identified above. If you are not an identified recipient, please ensure that this communication remains confidential and promptly return it to the sender. Please contact immediately by phone (Tel: 886-2-2299-9720) for any problem with this transmission, Thank you for your attention. ---------------------------------------------------------------------------- -------------------------------------- This e-mail transmission is confidential and intended solely for being reviewed by the recipient(s) identified above. If you are not an identified recipient, please ensure that this communication remains confidential and promptly return it to the sender. For any problem with this transmission, please immediately contact by phone (Tel: 886-2-2299-9720). Thank you for your attention. 10/11/2004

Compliance Certification Services Inc. Report No: 40813202 Date of Issue: September 15, 2004 Page 1 of 8 EXTERNAL PHOTOGRAPHS OF EUT Compliance Certification Services Inc. Report No: 40813202 Date of Issue: September 15, 2004 Page 2 Compliance Certification Services Inc. Report No: 40813202 Date of Issue: September 15, 2004 Page 3 Compliance Certification Services Inc. Report No: 40813202 Date of Issue: September 15, 2004 Page 4

Compliance Certification Services Inc. Report No: 40813202 Date of Issue: September 15, 2004 Page 5 INTERNAL PHOTOGRAPHS OF EUT Compliance Certification Services Inc. Report No: 40813202 Date of Issue: September 15, 2004 Page 6 Compliance Certification Services Inc. Report No: 40813202 Date of Issue: September 15, 2004 Page 7 Compliance Certification Services Inc. Report No: 40813202 Date of Issue: September 15, 2004 Page 8

Compliance Certification Services Inc. Report No: 40813202-RP FCC ID: SBC-ADB100 Date of Issue: September 15, 2004 Note: This report shall not be reproduced except in full, without the written approval of Compliance Certification Services Inc. This document may be altered or revised by Compliance Certification Services Inc. personnel only, and shall be noted in the revision section of the document Page 1 of 54 FCC 47 CFR PART 15 SUBPART C TEST REPORT For PC WORTH INTERNATIONAL CO., LTD. Bluetooth Cradle Model: DB-100 Trade Name: Cino Prepared for PC WORTH INTERNATIONAL CO., LTD. 18F, No. 100, Hsin-Tai-Wu Rd., Sec. 1, Hsi-Chih, Taipei, Taiwan, 22102, R.O.C. Prepared by Compliance Certification Services Inc. No. 81-1, Lane 210, Bade Rd. 2, Luchu Hsiang, Taoyuan Hsien, (338) Taiwan, R.O.C. TEL: 886-3-324-0332 FAX: 886-3-324-5235 Compliance Certification Services Inc. Report No: 40813202-RP FCC ID: SBC-ADB100 Date of Issue: September 15, 2004 Page 2 TABLE OF CONTENTS 1. TEST RESULT CERTIFICATION............................................................................................. 3 2. EUT DESCRIPTION .................................................................................................................... 4 3. TEST METHODOLOGY ............................................................................................................. 5 3.1 EUT CONFIGURATION.............................................................................................................. 5 3.2 EUT EXERCISE......................................................................................................................... 5 3.3 GENERAL TEST PROCEDURES.................................................................................................. 5 3.4 FCC PART 15.205 RESTRICTED BANDS OF OPERATIONS ............................................. 6 3.5 DESCRIPTION OF TEST MODES................................................................................................. 6 4. INSTRUMENT CALIBRATION................................................................................................. 7 5. FACILITIES AND ACCREDITATIONS ................................................................................... 8 5.1 FACILITIES.............................................................................................................................. 8 5.2 EQUIPMENT............................................................................................................................. 8 5.3 LABORATORY ACCREDITATIONS AND LISTING....................................................................... 8 5.4 TABLE OF ACCREDITATIONS AND LISTINGS............................................................................ 9 6. SETUP OF EQUIPMENT UNDER TEST ................................................................................ 10 6.1 SETUP CONFIGURATION OF EUT............................................................................................ 10 6.2 SUPPORT EQUIPMENT .................................................................................................... 10 7. FCC PART 15.247 REQUIREMENTS...................................................................................... 11 7.1 PEAK POWER......................................................................................................................... 11 7.2 PEAK POWER SPECTRAL DENSITY......................................................................................... 12 7.3 BAND EDGES MEASUREMENT ..................................................................................... 17 7.4 FREQUENCY SEPARATION ............................................................................................ 22 7.5 NUMBER OF HOPPING FREQUENCY............................................................................ 24 7.6 TIME OF OCCUPANCY (DWELL TIME) ........................................................................ 26 7.7 RADIO FREQUENCY EXPOSURE............................................................................................. 34 7.8 SPURIOUS EMISSIONS..................................................................................................... 37 7.9 POWERLINE CONDUCTED EMISSIONS.................................................................................... 50 APPENDIX 1 PHOTOGRPHS OF TEST SETUP.......................................................................... 53 Compliance Certification Services Inc. Report No: 40813202-RP FCC ID: SBC-ADB100 Date of Issue: September 15, 2004 Page 3 1. TEST RESULT CERTIFICATION Applicant: PC WORTH INTERNATIONAL CO., LTD. 18F, No. 100, Hsin-Tai-Wu Rd., Sec. 1, Hsi-Chih, Taipei, Taiwan, 22102, R.O.C. Equipment Under Test: Bluetooth Cradle Trade Name: Cino Model: DB-100 Date of Test: June 10 ~ October 6, 2004 APPLICABLE STANDARDS STANDARD TEST RESULT FCC Part 15 Subpart C No non-compliance noted We hereby certify that: The above equipment was tested by Compliance Certification Services Inc. The test data, data evaluation, test procedures, and equipment configurations shown in this report were made in accordance with the procedures given in ANSI C63.4-2001 and the energy emitted by the sample EUT tested as described in this report is in compliance with conducted and radiated emission limits of FCC Rules Part 15.207, 15.209 and 15.247. The test results of this report relate only to the tested sample EUT identified in this report. Approved by: Reviewed by: Harris W. Lai Devin Chang Executive Vice President Section Manager Compliance Certification Services Inc. Compliance Certification Services Inc. Compliance Certification Services Inc. Report No: 40813202-RP FCC ID: SBC-ADB100 Date of Issue: September 15, 2004 Page 4 2. EUT DESCRIPTION Product Bluetooth Cradle Trade Name Cino Model Number DB-100 Model Discrepancy N/A Power Supply HRZ-10-0502000 I/P: AC 100-240V, 50/60Hz, 0.25A O/P: DC 5.0V, 2000mA Frequency Range 2402 ~ 2480 MHz Transmit Power…

Text truncated - open the document above for the full version.

Compliance Certification Services Inc. Report No: 40813202-RP FCC ID: SBC-ADB100 Date of Issue: September 15, 2004 Page 53 APPENDIX 1 PHOTOGRPHS OF TEST SETUP Radiated Emission Set up Photos Compliance Certification Services Inc. Report No: 40813202-RP FCC ID: SBC-ADB100 Date of Issue: September 15, 2004 Page 54 Conducted Emission Set Up Photos