TNE-450LMA1450-470 MHz SUPERHETERODYNE RF RECEIVER MODULE

Font: Arial, Color: White Text Location: X = 280mil, Y = 805 mil

FCC ID: TNE-450LMA1 MODEL: TELERANGE This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. IC ID: 6145A-450LMA1 MAGNETEK

Operational Description The 450 MHz Band Telerange RF module is used in receive mode only. The microprocessor communicates with the CC1020 radio via SPI and UART to receive data communication over the air. Data is FSK-modulated on a carrier frequency from 450 to 470MHz. The CC1020 uses an internal mixing circuit with an IF of 307.2KHz. This module uses a Larsen LM450C-W155 external antenna with a gain of 3.4dBd /5.6dBi.

Retlif Testing Laboratories Test Report Number R-1452P-1, Magnetek FCC ID: TNE-450LMA1, IC: 6145A-450LMA1 Page 1 of 14 Technical Information Applicant Manufacturer Name: Magnetek Name: Magnetek Address: N49 W13650 Campbell Drive Address: N49 W13650 Campbell Drive City, State, Zip: Menomonee Falls, WI 53051 City, State, Zip: Menomonee Falls, WI 53051 Date of Report: December 5, 2009 Test Specifications: FCC Rules and Regulations Part 15, Subpart B, Para. 15.107(a) and 15.109(a) Radio Standards Specification, RSS-210, Issue 7, June, 2007 and RSS-GEN, Issue 2, June 2007 Test Procedure: ANSI C63.4:2003 Test Sample Description TEST SAMPLE: 450 - 470 MHz Receiver BRANDNAME: Enrange MODEL(s): Telerange FCC ID: TNE-450LMA1 IC ID: 6145A-450LMA1 TYPE: Superheterodyne RF Receiver Module POWER REQUIREMENTS: 5 VDC derived from Host FREQUENCY OF OPERATION: 450 - 470 MHz CONFIGURATION: The RF Receiver Module was tested in a test bed which provided DC input voltages and an RF antenna connector. Retlif Testing Laboratories Test Report Number R-1452P-1, Magnetek FCC ID: TNE-450LMA1, IC: 6145A-450LMA1 Page 2 of 14 Tests Performed The test methods performed on the 450 to 470 MHz Band RF Receiver Module are shown below: Testing Dates FCC Part 15, Subpart B Industry Canada RSS-210, Issue 7, June 2007 Industry Canada RSS-GEN Issue 2, June 2008 Test Method December 3, 2009 15.107(a) N/A 7.2.2 Conducted Emissions, Power Leads, 150 kHz to 30 MHz December 2, 2009 15.109(a) 2.6 7.2.3 Receiver Radiated Emissions, 30 MHz to 2 GHz Retlif Testing Laboratories Test Report Number R-1452P-1, Magnetek FCC ID: TNE-450LMA1, IC: 6145A-450LMA1 Page 3 of 14 Requirements and Test Results Requirement: FCC Section 15.107(a) - Conducted Limits For equipment that is designed to be connected to the public utility (AC) power line, the radio frequency voltage that is conducted back only the AC power line on any frequency or frequencies with the band 150 kHz to 30 MHz shall not exceed the limits shown in Table 1, as measured using a 50 μH/50 ohms line impedance stabilization network (LISN). Compliance with the provisions of the paragraph shall be based on the measurement of the radio frequency voltage between each power line and ground at the power terminal. The lower limit applies at the band edges. IC RSS-GEN, Section 7.2.2 - Transmitter and Receiver AC Power Lines Conducted Emissions Limits The purpose of this test is to measure unwanted radio frequency currents induced in any AC conductor external to the equipment which could conduct interference to other equipment via the AC electrical network. Except when the requirements applicable to a given device state otherwise, for any liscense-exempt radio communication device equipped to operate from the public utility AC power supply, either directly or indirectly, the radio frequency voltage that is conducted back onto the AC power lines in the frequency range of 0.15 MHz to 30 MHz shall not exceed the limits shown in Table 1. The tighter limit applies at the frequency range boundaries. The conducted emissions shall be measured with a 50 ohm/50 microhenry line impedance stabilization network. Table 1 - Conducted Emission Limits Conducted Limit (dBμV) Frequency of Emission (MHz) Quasi-Peak Average 0.15 to 0.5 66 to 56* 56 to 46* 0.5 to 5 56 46 5 to 30 60 50 *Decreases due to logarithm of the frequency • Results: The conducted emissions observed did not exceed the limits specified in Table 1. Retlif Testing Laboratories Test Report Number R-1452P-1, Magnetek FCC ID: TNE-450LMA1, IC: 6145A-450LMA1 Page 4 of 14 FCC Section 15.109(a) - Receiver Radiated Emissions Except for Class A digital devices, the field strength of radiated emissions from intentional radiators at a distance of 3 meters shall not exceed the values shown in Table 2. IC RSS-GEN, 7.2.3 - Receiver Spurious Emission Limits Receiver spurious emissions at any discrete frequency shall not exceed 2 nanowatts in the band 30-1000 MHz, or 5 nanowatts above 1 GHz. All spurious emissions shall comply with the limits specified in Table 2. Table 2 - Radiated Emission Limits Frequency of Emission (MHz) Field Strength (microvolts/meter) Measurement Distance (meters) 30 to 88 100 3 88 to 216 150 3 216 to 960 200 3 Above 960 500 3 • Results: The field strength of radiated emissions did not exceed the limits specified in Table 2. Retlif Testing Laboratories Test Report Number R-1452P-1, Magnetek FCC ID: TNE-450LMA1, IC: 6145A-450LMA1 Page 5 of 14 General Notes 1. All readings were taken utilizing a quasi-peak detector and peak detector function at a test distance of 3 meters. 2. All measurements were made with the device powered an input of 120 VAC, 60 Hz. 3. The frequency range was scanned from 30 MHz to 2 GHz. All emissions not reported were more than 20 dB below the specified limit. Modifications No Modifications were made during the course of this testing program in order to demonstrate compliance with the specified requirements. Retlif Testing Laboratories Test Report Number R-1452P-1, Magnetek FCC ID: TNE-450LMA1, IC: 6145A-450LMA1 Page 7 of 14 Equipment List Conducted Emissions, Power Leads, 150 kHz to 30 MHz EN Type Manufacturer Description Model No. Cal Date Due Date 8079 EMI Test Receiver Rohde & Schwarz 0.9-30 MHz ESH3 6/2/2009 6/2/2010 8194 LISN Solar Electronics 10 kHz - 30 MHz 8028-50-TS-24-B 11/17/2007 5/17/2010 8195 LISN Solar Electronics 10 kHz - 30 MHz 8028-50-TS-24-B 11/17/2007 5/17/2010 8355 10.0 dB Attenuator Narda DC - 11 GHz, 20 W 768-10 9/23/2009 9/23/2010 8366A Cable 20' BNC Retlif 10 kHz - 1 GHz n/a 11/5/2009 11/5/2010 Radiated Emissions, 30 MHz to 2 GHz EN Type Manufacturer Description Model No. Cal Date Due Date 8071 Spectrum Analyzer Hewlett Packard 100Hz-2.5 GHz/2-22GH 8566B 8/17/2009 8/17/2010 8072 Spectrum Analyzer Display Hewlett Packard 85662A 8/17/2009 8/17/2010 8080 Receiver Rohde & Schwarz 20-1300 MHz ESVP 5/20/2009 5/20/2010 8300 OATS Site NSA RSI 3/10 Meter Site 9/1/2009 9/1/2010 8300B OATS Cable 10/12/2…

Text truncated - open the document above for the full version.

Retlif Testing Laboratories Test Report Number R-1452P-1, Magnetek FCC ID: TNE-450LMA, IC: 6145A-450LMA1 1 of 4 Test Photographs Magentek FCC ID: TNE-450LMA1 IC: 6145A-450LMA1 Retlif Testing Laboratories Test Report Number R-1452P-1, Magnetek FCC ID: TNE-450LMA, IC: 6145A-450LMA1 2 of 4 Test Photographs Conducted Emissions EUT Configuration Test Setup Retlif Testing Laboratories Test Report Number R-1452P-1, Magnetek FCC ID: TNE-450LMA, IC: 6145A-450LMA1 3 of 4 Test Photographs Radiated Emissions EUT Configuration Horizontal Antenna Polarization Retlif Testing Laboratories Test Report Number R-1452P-1, Magnetek FCC ID: TNE-450LMA, IC: 6145A-450LMA1 4 of 4 Test Photographs Radiated Emissions Vertical Antenna Polarization