TYLLS30Base Unit

L L i i f f e e S S O O S S THE HOME SECURITY & AUTOMATION SYSTEM FOR YOUR FUTURE NEEDS Model LS-30 OPERATION MANUAL NOTE: The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The comply with the FCC RF exposure compliance requirements, this device and its antenna must not be co-located or operating to conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Table of Contents Page INTRODUCTION & INSTALLATION --------------------------------------------------------- 1 BASE UNIT -------------------------------------------------------------------------------------- 3 STATUS INDICATORS ------------------------------------------------------------------------ 4 ELECTRICAL INSTALLATION ------------------------------------------------------------- 5 MECHANICAL INSTALLATION --------------------------------------------------------- 6 USER OPERATION -------------------------------------------------------------------------------- 7 INITIAL STATE ------------------------------------------------------------------------------- 9 (2) System Check ------------------------------------------------------------------------------ 10 (2-1) Telephone Number Check ---------------------------------------------------------- 11 (2-2) Voice Check -------------------------------------------------------------------------- 12 (2-3) Device Check ------------------------------------------------------------------------ 12 (3) Master Mode -------------------------------------------------------------------------------- 13 OPERATION MODES OF LS-30 ----------------------------------------------------------- 15 REACTION OF LS-30 TO DIFFERENT ALARMS ------------------------------------- 16 ANSWERING THE CALL FROM LS-30 ------------------------------------------------- 17 DIAL-IN CONTROL ------------------------------------------------------------------------- 18 INSTALLER & CMS SETTINGS ----------------------------------------------------------------- 19 (4) Installer Mode ------------------------------------------------------------------------------ 20 (4-1) Set Timer --------------------------------------------------------------------------- 20 (4-2) Set Telephone ---------------------------------------------------------------------- 22 (4-2-1) Set Telephone Number -------------------------------------------------- 24 (4-3) Set Sound --------------------------------------------------------------------------- 26 (4-4) Set Device -------------------------------------------------------------------------- 28 (4-4-1) Change Device Setting ------------------------------------------------- 29 (4-5) Set Siren ---------------------------------------------------------------------------- 31 (4-6) Set Misc. --------------------------------------------------------------------------- 32 (4-7) Set GSM ---------------------------------------------------------------------------- 33 (5) CMS Mode --------------------------------------------------------------------------------- 34 SPECIFICATIONS--------------------------------------------------------------------------------- 35 APPENDIX ------------------------------------------------------------------------------------------- 36 A-1, Remote Message Display. A-2, Connection Diagram for RS-232 Computer Interface A-3, Connection Diagram for Ethernet Adaptor and Internet Remote Access A-4, Connection Diagram for X-10 Power Line Interface A-5, Terminal Board Connection A-6, Connection Diagram for GSM Module A-7, Using the Same Telephone Line to Connect LS-30, Fax Machine and Telephone Answering Machine A-8, Partial Arm for Group Numbers “91” to “99” ACCESSORIES -------------------------------------------------------------------------------------- 39 Remote Controller ------------------------------------------------------------------------------ 40 Magnetic Contact Transmitter ---------------------------------------------------------------- 41 PIR Motion Detector --------------------------------------------------------------------------- 44 Glass Break Detector -------------------------------------------------------------------------- 48 Smoke Detector --------------------------------------------------------------------------------- 50 Outdoor Wireless Siren With Light ----------------------------------------------------------- 52 INTRODUCTION & INSTALLATION 1 Thank you for purchasing the LS-30 IP Based Wireless Home Security & Control System. By adopting modern microprocessor control and communication technologies, the LS-30 is designed to provide all the most advanced features that you need to protect your home and business. Moreover, you can operate the system and read its status by using the proprietary GUI (Graphic User Interface) HyperSecureLink through the Internet, from all over the world*. The LS-30 is not only a security system but also a home automation controller that allows you to set as many as 16 programmable switches to execute daily commands throughout a whole week. With optional temperature, humidity and other sensors, the LS-30 also operates as an environmental monitoring center to report and prevent floods, gas leaks and other hazards. Although the LS-30 is a very powerful device, thanks to the interactive HMI (Human Machine Interface) programming technology, its operation is simple. Just follow the instructions shown on the LCD display by answering the questions with YES/NO buttons or pressing the correct keys, and the settings are done. You can also set up the system on your laptop or PC using the optional RS-232 adapter and HyperSecureLink software. The set up is simple, switch on back up battery, connect the Base Uni…

Text truncated - open the document above for the full version.

FCC ID: TYLLS30 Device Name: Base Unit Model No.: LS-30 Date: 2005/12/12 Compliance Certification Services Certification Division 561F Monterey Road Morgan Hill, CA 95037 To whom it may concern: We, the undersigned, hereby authorize ELECTRONICS TESTING CENTER, TAIWAN, to act on our behalf in all manners relating to application for equipment authorization, including signing of all documents relating to these matters. Any and all acts carried out by ELECTRONICS TESTING CENTER, TAIWAN on our behalf shall have the same effect as acts of our own. In authorizing ELECTRONICS TESTING CENTER, TAIWAN as our agent, we still recognize that we are responsible to: a)comply with the relevant provisions of the certification program; b)make all necessary arrangements for the conduct of the evaluation, including provision for examining documentation and access to all areas, records (including internal audit reports) and personnel for the purposes of evaluation (e.g. testing, inspection, assessment, surveillance, reassessment) and resolution of complaints; c)make claims regarding certification only in respect of the scope for which certification has been granted; d)do not use our product certification in such a manner as to bring the Certification Division into disrepute and not make any statement regarding our product certification which the Certification Division may consider misleading or unauthorized; e)upon suspension or cancellation of certification, discontinue use of all advertising matter that contains any reference thereto and return any certification documents as required by the Certification Division; f)use certification only to indicate the products are certified as being in conformity with specified standards; g)endeavor to ensure that no certificate or report nor any part thereof is used in a misleading manner; h) ensure that any reference to our product certification in communication media such as documents, brochures or advertising, complies with the requirements of the Certification Division; i) keep a record of all complaints made known to the us relating to the product compliance with requirements of the relevant standard and to make these records available to the Certification Division when requested; j) take appropriate action with respect to such complaints and any deficiencies found in products or services that affect compliance with the requirements for certification; k) document the actions taken. This authorization is valid until further written notice from the applicant. Sincerely Yours, By:By: Kevin Wang (Signature)(Printed) Title:Marketing Manager Applicant:Scientech Electronics Co., Ltd. Address:4F, No. 501-17. Chung-Cheng Rd., Hsin-Tien City, Taipei 231, Taiwan, R.O.C. Tel:886-2-22183085 Fax:886-2-22187380

FCC ID: TYLLS30 Federal Communications Commission Dear Sir: Pursuant to Section 0.457 and 0.459 of the Commission’s Rules, the Applicant hereby requests confidential treatment of information accompanying this Application as outlined below: Schematics Block Diagram Operational Descriptions The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457, disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application. By:By: Kevin Wang (Signature)(Printed) Title:Marketing Manager Applicant: Scientech Electronics Co., Ltd. Address:4F, No. 501-17. Chung-Cheng Rd., Hsin-Tien City, Taipei 231, Taiwan, R.O.C. Tel:886-2-22183085 Fax:886-2-22187380

ETC Report No.: ET94S-09-165-09 Page A1 of A1 FCC ID.:TYLLS30 ANNEX A: EXTERNAL CONSTRUCTION PHOTOS OF EUT 1. Outside view 1 of EUT 2. Outside view 2 of EUT

LS-30 Model: LS-30 FCC ID: TYL LS30 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. S/N: XXXXXXXX 60mm 37mm

ETC Report No.: ET94S-09-165-09 Page B1 of B9 FCC ID.: TYLLS30 ANNEX B: INTERNAL CONSTRUCTION PHOTOS OF EUT 1. Inside View 1 of EUT 2. Inside View 2 of EUT ETC Report No.: ET94S-09-165-09 Page B2 of B9 FCC ID.: TYLLS30 3. adaptor 4. adaptor ETC Report No.: ET94S-09-165-09 Page B3 of B9 FCC ID.: TYLLS30 5. adaptor 6. battery ETC Report No.: ET94S-09-165-09 Page B4 of B9 FCC ID.: TYLLS30 7. battery 8. Front view of PCB1 ETC Report No.: ET94S-09-165-09 Page B5 of B9 FCC ID.: TYLLS30 9. Rear view of PCB1 10. Front view of PCB2 ETC Report No.: ET94S-09-165-09 Page B6 of B9 FCC ID.: TYLLS30 11. Rear view of PCB2 12. Front view of PCB3 ETC Report No.: ET94S-09-165-09 Page B7 of B9 FCC ID.: TYLLS30 13. Rear view of PCB3 14. Front view of PCB4 ETC Report No.: ET94S-09-165-09 Page B8 of B9 FCC ID.: TYLLS30 15. Rear view of PCB4 16. Front view of PCB5 ETC Report No.: ET94S-09-165-09 Page B9 of B9 FCC ID.: TYLLS30 17. Rear view of PCB5

ETC Report No. : ET94S-09-165-09 Sheet 1 of 29 Sheets FCC ID.: TYLLS30 Rev. No 1.0 CONFORMANCE TEST REPORT FOR FCC 47 CFR, Part 15 Subpart C Report No.: ET94S-09-165-09 Client: Scientech Electronics Co., Ltd. Product: Alarm Base Unit Model: LS-30 FCC ID: TYLLS30 Manufacturer/supplier: Scientech Electronics Co., Ltd. Date test item received: 2005/09/20 Date test campaign completed: 2005/10/31 Date of issue: 2005/11/22 The test result only corresponds to the tested sample. It is not permitted to copy this report, in part or in full, without the permission of the test laboratory. Total number of pages of this test report: 29 pages Total number of pages of photos: External photos 1 pages Internal photos 9 pages Setup photos 2 pages Test Engineer Checked By Approved By James Mark Joe Hsieh ELECTRONICS TESTING CENTER, TAIWAN NO.8, LANE 29, WENMING RD., LESHAN TSUEN, GUISHAN SHIANG, TAOYUAN COUNTY, TAIWAN 33383, R.O.C. TEL: (03) 3276170~4 INT: +886-3-3276170~4 FAX: (03) 3276188 INT: +886-3-3276188 ETC Report No. : ET94S-09-165-09 Sheet 2 of 29 Sheets FCC ID.: TYLLS30 Rev. No 1.0 Client : Scientech Electronics Co., Ltd. Address : 4F, No. 501-17, Chung-Cheng Rd., Hsin-Tien City, Taipei 231, Taiwan, R.O.C. Manufacturer : Scientech Electronics Co., Ltd. Address : 4F, No. 501-17, Chung-Cheng Rd., Hsin-Tien City, Taipei 231, Taiwan, R.O.C. EUT : Alarm Base Unit Trade name : LifeSOS Model No. : LS-30 Power Source : AC 110V, 60Hz Regulations applied : FCC 47 CFR, Part 15 Subpart C (2005) The testing described in this report has been carried out to the best of our knowledge and ability, and our responsibility is limited to the exercise of reasonable care. This certification is not intended to believe the sellers from their legal and/or contractual obligations. The compliance test is only certified for the test equipment and the results of the testing report relate only to the item tested. The compliance test of this report was conducted in accordance with the appropriate standards. It’s not intention to assure the quality and performance of the product. This report shall not be reproduced except in full, without the approval of ETC. This report must not be used by the client to claim product endorsement by NVLAP or any agency of the U.S. Government. Laboratory Introduction: Electronics Testing Center, Taiwan is recognized, filed and mutual recognition arrangement as following: 1 ISO9001: TüV Product Service 2 ISO/IEC 17025: BSMI, CNLA, DGT, NVLAP, CCIBLAC, UL, Compliance 3 Filing: FCC, Industry Canada, VCCI 4 MRA: Australia, Hong Kong, New Zealand, Singapore, USA, Japan, Korea, China, APLAC through CNLA 5 FCC Registration Number: 90588, 91094, 91095 NVLAP Lab Code 200133-0 ETC Report No. : ET94S-09-165-09 Sheet 3 of 29 Sheets FCC ID.: TYLLS30 Rev. No 1.0 Table of Contents Page 1. GENERAL INFORMATION ......................................................................................................................................4 1.1 PRODUCT DESCRIPTION.................................................................................................................................................4 1.2 CHARACTERISTICS OF DEVICE:......................................................................................................................................4 1.3 TEST METHODOLOGY....................................................................................................................................................4 1.4 TEST FACILITY...............................................................................................................................................................4 2. DEFINITION AND LIMITS........................................................................................................................................5 2.1 DEFINITION....................................................................................................................................................................5 2.2 RESTRICTED BANDS OF OPERATION...............................................................................................................................5 2.3 LIMITATION....................................................................................................................................................................6 2.4 LABELING REQUIREMENT..............................................................................................................................................7 2.5 USER INFORMATION.......................................................................................................................................................7 3. RADIATED EMISSION MEASUREMENT..............................................................................................................8 3.1 APPLICABLE STANDARD.................................................................................................................................................8 3.2 MEASUREMENT PROCEDURE.........................................................................................................................................8 3.3 TEST DATA..................................................................................................................................................................10 3.4 FIELD STRENGTH CALCULATION..................................................................................................................................13 3.5 RADIATED TEST EQUIPMENT.......................................................................................................................................13 3.6 MEASURING INSTRUMENT SETUP.................................................................................................................................16 3.6 MEASURING INSTRUMENT SETUP.................................................................................................................................17 4. BANDWIDTH…

Text truncated - open the document above for the full version.

ETC Report No. : ET94S-09-165-09 Sheet 1 of 2 Sheets FCC ID. : TYLLS30 Photos of Radiation Measuring Setup ETC Report No. : ET94S-09-165-09 Sheet 2 of 2 Sheets FCC ID. : TYLLS30 Photos of Conduction Measuring Setup