VTV-RFWKDWIFI Module

USER’S MANUAL RF-WKD Wi-Fi module Copyright Information ©2014 TSC Auto ID Technology Co., Ltd, The copyright in this manual, the software and firmware in the printer described therein are owned by TSC Auto ID Technology Co., Ltd, All rights reserved. Information in this document is subject to change without notice and does not represent a commitment on the part of TSC Auto ID Technology Co. No part of this manual may be reproduced or transmitted in any form or by any means, for any purpose other than the purchaser’s personal use, without the expressed written permission of TSC Auto ID Technology Co. Agency Compliance and Approvals FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/ TV technician for help. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF exposure warning This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: "Contains FCC ID: VTV-RF- WKD ” and "Contains IC: 10524A-RF-WKD “ Information for the OEMs and Integrators The following statement must be included with all versions of this document supplied to an OEM or integrator, but should not be distributed to the end user. 1) This device is intended for OEM integrators only. 2) Please see the full Grant of Equipment document for other restrictions. This radio transmitter FCC ID: VTV-RF-WKD has been approved by FCC to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Antenna List No. Manufacturer Part No. Antenna Type Peak Gain 1 ARISTOTLE ENTERPRISES INC. RFA-25-P393B-70-85-L FPC 3.2 dBi for 2.4 GHz 3.1 dBi for 5 GHz 2 ARISTOTLE ENTERPRISES INC. RFA-25-P393B-70B140R FPC 0.9 dBi for 2.4 GHz 3.2 dBi for 5 GHz Note: The antenna connector is I-PEX type. Canada, Industry Canada (IC) Notices This device complies with Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Canada, avis d'Industry Canada (IC) Cet appareil est conforme avec Industrie Canada exemptes de licence RSS standard(s). Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer d'interférence et (2) cet appareil doit accepter toute interférence, notamment les interférences qui peuvent affecter son fonctionnement. This device is slave equipment, the device is not radar detection and not ad-hoc operation in the DFS band. Radio Frequency (RF) Exposure Information The radiated output power of the Wireless Device is below the Industry Canada (IC) radio frequency exposure limits. The Wireless Device should be used in such a manner such that the potential for human contact during normal operation is minimized. This device has also been evaluated and shown compliant with the IC RF Exposure limits under mobile exposure conditions. (antennas are greater than 20cm from a person's body). Informations concernant l'exposition aux fréquences radio (RF) La puissance de sortie émise par l’appareil de sans fil est inférieure à la limite d'exposition aux fréquences radio d'Industry Canada (IC). Utilisez l’appareil de sans fil de façon à minimiser les contacts humains lors du fonctionnement normal. Ce périphérique a également été évalué et démontré conforme aux limites d'exposition aux RF d'IC dans des conditions d'exposition à des appareils mobiles (antennes sont supérieures à 20 cm à partir du corps d'une personne). This radio transmitter IC: 10524A-RF-WKD has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. An…

Text truncated - open the document above for the full version.

Report No.: 14C0347R-RFUSP37V00 Page : 1 of 5 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (2) EUT Photo

TSC Auto ID Technology Co., Ltd. FCC ID.: VTV-RFWKD 9F., No. 95, Minquan Rd. Xindian Dist.Line two:New Taipei City 23141, Taiwan Tel : 886-2-2218-6789 FCC ID Label

TSC Auto ID Technology Co., Ltd. FCC ID.: VTV-RFWKD 9F., No. 95, Minquan Rd. Xindian Dist.Line two:New Taipei City 23141, Taiwan Tel : 886-2-2218-6789 The FCC ID Label will be placed on the equipment as shown in the photograph below.

Report No.: 14C0347R-RFUSP37V00 Page : 2 of 5 (3) EUT Photo (4) EUT Photo Report No.: 14C0347R-RFUSP37V00 Page : 3 of 5 (5) EUT Photo (6) EUT Photo Report No.: 14C0347R-RFUSP37V00 Page : 4 of 5 (7) EUT Photo (8) EUT Photo Report No.: 14C0347R-RFUSP37V00 Page : 5 of 5 (9) EUT Photo

Report No. 14C0347R-RFUSP26V00 Page: 1 of 3 RF Exposure Evaluation declaration Product Name WIFI Module Model No. RF-WKD FCC ID VTV-RFWKD Applicant TSC Auto ID Technology Co., Ltd. Address 9F., No. 95, Minquan Rd. Xindian Dist. New Taipei City 23141, Taiwan Date of Receipt Oct. 09, 2014 Date of Declaration Nov. 21, 2014 Report No. 14C0347R-RFUSP26V00 The test results relate only to the samples tested. The test results shown in the test report are traceable to the national/international standard through the calibration report of the equipment and evaluated measurement uncertainty herein. This report must not be used to claim product endorsement by TAF or any agency of the government. The test report shall not be reproduced without the written approval of QuieTek Corporation. Report No. 14C0347R-RFUSP26V00 Page: 2 of 3 1. RF Exposure Evaluation 1.1. Limits According to FCC 1.1310: The criteria listed in the following table shall be used to evaluate the environment impact of human exposure to radio frequency (RF) radiation as specified in 1.1307(b) LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) Frequency Range (MHz) Electric Field Strength (V/m) Magnetic Field Strength (A/m) Power Density (mW/cm 2 ) Average Time (Minutes) (A) Limits for Occupational/ Control Exposures 300-1500 -- -- F/300 6 1500-100,000 -- -- 5 6 (B) Limits for General Population/ Uncontrolled Exposures 300-1500 -- -- F/1500 6 1500-100,000 -- -- 1 30 F= Frequency in MHz Friis Formula Friis transmission formula: Pd = (Pout*G)/(4*pi*r 2 ) Where Pd = power density in mW/cm 2 Pout = output power to antenna in mW G = gain of antenna in linear scale Pi = 3.1416 R = distance between observation point and center of the radiator in cm Pd id the limit of MPE, 1 mW/cm 2 . If we know the maximum gain of the antenna and the total power input to the antenna, through the calculation, we will know the distance r where the MPE limit is reached. 1.2. Test Procedure Software provided by client enabled the EUT to transmit and receive data at lowest, middle and highest channel individually. The temperature and related humidity: 18°Cand 78％ RH. Report No. 14C0347R-RFUSP26V00 Page: 3 of 3 1.3. Test Result of RF Exposure Evaluation Product : WIFI Module Test Item : RF Exposure Evaluation Test Site : No.3 OATS Operation Frequency 2412-2462MHz, 2422-2452MHz, 5745-5825MHz, 5755-5795MHz, 5180-5240MHz, 5260-5320MHz, 5500-5700MHz, 5190-5230MHz, 5270-5310MHz, 5510-5670MHz Maximum Conducted output power 23.49 dBm Antenna gain 3.2 dBi Output Power Into Antenna & RF Exposure Evaluation Distance: Output Power to Antenna (mW) Power Density at R = 20 cm (mW/cm2) 223.3572 0.092839 Power density is lower than the limit (1 mW/cm2).

Report No.: 14C0347R-RFUSP37V00 Page: 1 of 99 FCC Test Report Product Name WIFI Module Model No RF-WKD FCC ID. VTV-RFWKD Applicant TSC Auto ID Technology Co., Ltd. Address 9F., No. 95, Minquan Rd. Xindian Dist. New Taipei City 23141, Taiwan Date of Receipt Dec. 11, 2014 Issue Date Jan. 15, 2015 Report No. 14C0347R-RFUSP37V00 Report Version V1.0 The test results relate only to the samples tested. The test results shown in the test report are traceable to the national/international standard through the calibration report of the equipment and evaluated measurement uncertainty herein. This report must not be used to claim product endorsement by TAF or any agency of the government. The test report shall not be reproduced without the written approval of QuieTek Corporation. Report No.: 14C0347R-RFUSP37V00 Page: 2 of 99 Test Report Issue Date: Jan. 15, 2015 Report No.: 14C0347R-RFUSP37V00 Product Name WIFI Module Applicant TSC Auto ID Technology Co., Ltd. Address 9F., No. 95, Minquan Rd. Xindian Dist. New Taipei City 23141, Taiwan Manufacturer TSC Auto ID Technology Co., Ltd. Model No. RF-WKD EUT Rated Voltage DC 3.3V EUT Test Voltage AC 120V/60Hz Trade Name TSC Applicable Standard FCC CFR Title 47 Part 15 Subpart C: 2014 ANSI C63.10: 2009 KDB 558074 D01 DTS Meas Guidance v03r02 Test Result Complied Documented By: ( Senior Adm. Specialist / Jinn Chen ) Tested By : ( Assistant Engineer / Nova Chu ) Approved By : ( Director / Vincent Lin ) Report No.: 14C0347R-RFUSP37V00 Page: 3 of 99 TABLE OF CONTENTS Description Page 1. GENERAL INFORMATION ..................................................................................................... 5 1.1. EUT Description ............................................................................................................................ 5 1.2. Operational Description ................................................................................................................ 7 1.3. Tested System Details.................................................................................................................... 8 1.4. Configuration of Tested System .................................................................................................... 8 1.5. EUT Exercise Software ................................................................................................................. 8 1.6. Test Facility ................................................................................................................................... 9 2. Conducted Emission .................................................................................................................. 10 2.1. Test Equipment ............................................................................................................................ 10 2.2. Test Setup .................................................................................................................................... 10 2.3. Limits .......................................................................................................................................... 11 2.4. Test Procedure ............................................................................................................................. 11 2.5. Uncertainty .................................................................................................................................. 11 2.6. Test Result of Conducted Emission ............................................................................................. 12 3. Maximum Conducted Power .................................................................................................... 14 3.1. Test Equipment ............................................................................................................................ 14 3.2. Test Setup .................................................................................................................................... 14 3.3. Limits .......................................................................................................................................... 14 3.4. Test Procedure ............................................................................................................................. 14 3.5. Uncertainty .................................................................................................................................. 14 3.6. Test Result of Maximum Conducted Power ................................................................................ 15 4. Radiated Emission ..................................................................................................................... 19 4.1. Test Equipment ............................................................................................................................ 19 4.2. Test Setup .................................................................................................................................... 19 4.3. Limits .......................................................................................................................................... 20 4.4. Test Procedure ............................................................................................................................. 21 4.5. Uncertainty .................................................................................................................................. 21 4.6. Test Result of Radiated Emission ................................................................................................ 22 5. RF Antenna conducted test ....................................................................................................... 38 5.1. Test Equipment ............................................................................................................................ 38 5.2. Test Setup ........................................................................................…

Text truncated - open the document above for the full version.

Report No.: 14C0347R-RFUSP37V00 Page : 1 of 4 Attachment 1: EUT Test Setup Photographs Front View of Conducted Test Back View of Conducted Test Report No.: 14C0347R-RFUSP37V00 Page : 2 of 4 Front View of Radiated Test Back View of Radiated Test Report No.: 14C0347R-RFUSP37V00 Page : 3 of 4 Front View of Radiated Test Back View of Radiated Test Report No.: 14C0347R-RFUSP37V00 Page : 4 of 4 Front View of Radiated Test (Horn) Back View of Radiated Test (Horn)