VVJ-T306R434Transmitter

HAND HELD DIGITAL TRANSMITTER 1 Description The T306 Series Transmitter is ideal for the opening, closing the garage door and control the winch of hoist machine. The Transmitter is available in hand-held and transmits a unique code each time the switch is closed to provide a secure control. The transmitter is powered by a 12-volt battery and a blue indicator light when the transmitter is activated. 2 Specifications DESCRIPTION SPECIFICATION FREQUENCY 434MHz EMITTED RADIO POWER <5dBm POWER CONSUMPTION Max 9mA OPERATING TEMPERATURE -10 ̊C~+55 ̊C DIMENSIONS 75mmx38mmx13mm CERTIFICATION FCC 3 Battery Replacement 1.Remove screw from back of transmitter. 2.Separate housing and install a fresh 12-Volt/23A ALKALINE battery making sure to observe properly polarity. 3.Reassemble housing and replace screw. CANSEC T306 / T306-2 TRANSMITTERS RF MODULE & SECURIT Y PRODUCTS USER’S GUIDE T306 T306-2 T306 T306-2 1 4 FCC Compliance 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. 5 Company Contact Beijing Jia An Electronic Technology Co,.Ltd. Add: No.19 Gu Cheng west street, Shi Jing Shan District, Beijing 100043, CHINA TEL: +86-10-6888 9971 / 6888 9972 / 6888 9973 FAX: +86-10-6888 9905

SCS-F19: Confidentiality Request Letter Page 1 of 2 Rev 4.0 775 Montague Expressway Milpitas, CA 95035 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Confidentiality Request Letter Reason for Amendment (current / obsolete) Revision History Approved Date From To Initial Release (obsolete) 1.0 1.0 Nov-14-2006 Adding CFR 2.459 (obsolete) 1.0 2.0 August – 11 - 2008 Updated company template & Added text box (obsolete) 2.0 3.0 Jan-31-2012 Added IC confidentiality letter form (current) 3.0 4.0 March-26-2015 SCS-F19: Confidentiality Request Letter Page 2 of 2 Rev 4.0 Beijing Jia An Electronic Technology Co,.Ltd. ______________________________________________________________________________ 2015.08.27 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Subject: Permanent Confidentiality Request for FCC ID: VVJ-T306R434 We hereby request confidential treatment of information accompanying this application as outlined below: - Block Diagram - Schematics - Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Client’s signature: Client’s name / title : Helen BAN /General Manager Contact information / address : Beijing Jia An Electronic Technology Co,.Ltd. No.19 GuCheng West Street,Shi Jing Shan District,Beijing 100043, China

Beijing Jia An Electronics Technology Co,.Ltd. Add:No.19 Gu Cheng west street,Shi Jing Shan District,Beijing 100043,CHINA Tel:+86-10-6888 9971 Fax:+86-10-6888 9950 Declaration on model difference We the undersigned hereby confirm that any of our production units bearing the following model numbers for the Transmitters are identical in circuitry, PCB Layout, components, material manufacture of PCB, mechanical, and physical construction; the only differences between model No. T306 and T306-2 are the number of activation buttons. The T306-2 is a two button device,the T306 is a three button device.  In fact they are 1 model, but have two names, so named with 2 model numbers. Production name Trade name Model no. Transmitter T306 T306-2  Please provide at least 1 sample with difference except specified as above for further evaluation. Production name Trade name Model no. Description Confirmed by Beijing Jia An Electronics Technology Co,.Ltd. Authorized Signature: Date: 2015.8.24

Test Report No. 15020860-FCC-R1 Page 21 of 30 Annex B. EUT And Test Setup Photographs Annex B.i. Photograph: EUT External Photo Front View of EUT Rear View of EUT Test Report No. 15020860-FCC-R1 Page 22 of 30 Top View of EUT Bottom View of EUT Test Report No. 15020860-FCC-R1 Page 23 of 30 Left View of EUT Right View of EUT

T306 FCC LABEL: FCC ID: VVJ-T306R434 21mm 7mm

Label location

Test Report No. 15020860-FCC-R1 Page 24 of 30 Annex B.ii. Photograph EUT Internal Photo Uncover - Front View EUT PCBA – Front View Antenna Test Report No. 15020860-FCC-R1 Page 25 of 30 EUT PCBA – Rear View

RF TEST REPORT Report No.: 15020860-FCC-R1 Supersede Report No.: N/A Applicant Beijing Jia An Electronic Technology Co,.Ltd. Product Name Transmitter Main Model T306 Serial Model T306-2 Test Standard FCC Part 15.231: 2014, ANSI C63.10: 2013 Test Date August 21, 2015 Issue Date August 25, 2015 Test Result Pass Fail Equipment complied with the specification Equipment did not comply with the specification Amos Xia Test Engineer Herve Idoko Checked By This test report may be reproduced in full only Test result presented in this test report is applicable to the tested sample only Issued by: SIEMIC (Nanjing-China) Laboratories 2-1 Longcang Avenue Yuhua Economic and Technology Development Park, Nanjing, China Tel:+86(25)86730128/86730129 Fax:+86(25)86730127 Email: [email protected] Test Report No. 15020860-FCC-R1 Page 2 of 30 Laboratories Introduction SIEMIC, headquartered in the heart of Silicon Valley, with superior facilities in US and Asia, is one of the leading independent testing and certification facilities providing customers with one-stop shop services for Compliance Testing and Global Certifications. In addition to testing and certification, SIEMIC provides initial design reviews and compliance management throughout a project. Our extensive experience with China, Asia Pacific, North America, European, and International compliance requirements, assures the fastest, most cost effective way to attain regulatory compliance for the global markets. Accreditations for Conformity Assessment Country/Region Scope USA EMC , RF/Wireless , Telecom Canada EMC, RF/Wireless , Telecom Taiwan EMC, RF, Telecom , Safety Hong Kong RF/Wireless ,Telecom Australia EMC, RF, Telecom , Safety Korea EMI, EMS, RF , Telecom, Safety Japan EMI, RF/Wireless, Telecom Singapore EMC , RF , Telecom Europe EMC, RF, Telecom , Safety Test Report No. 15020860-FCC-R1 Page 3 of 30 This page has been left blank intentionally. Test Report No. 15020860-FCC-R1 Page 4 of 30 CONTENTS 1. REPORT REVISION HISTORY ....................................................................................................................................... 5 2. CUSTOMER INFORMATION ......................................................................................................................................... 5 3. TEST SITE INFORMATION ............................................................................................................................................ 5 4. EQUIPMENT UNDER TEST (EUT) INFORMATION ......................................................................................................... 6 5. TEST SUMMARY .......................................................................................................................................................... 7 6. MEASUREMENTS, EXAMINATION AND DERIVED RESULTS ........................................................................................ 8 6.1 ANTENNA REQUIREMENT .............................................................................................................................................. 8 6.2 AC CONDUCTED EMISSIONS VOLTAGE ......................................................................................................................... 9 6.3 20DB OCCUPIED BANDWIDTH ...................................................................................................................................... 11 6.4 RADIATED FUNDAMENTAL AND SPURIOUS EMISSION ................................................................................................ 13 6.5 DEACTIVATION ............................................................................................................................................................. 18 ANNEX A. TEST INSTRUMENT ........................................................................................................................................... 20 ANNEX B. EUT AND TEST SETUP PHOTOGRAPHS ........................................................................................................... 21 ANNEX C. TEST SETUP AND SUPPORTING EQUIPMENT ................................................................................................... 27 ANNEX D. USER MANUAL / BLOCK DIAGRAM / SCHEMATICS / PARTLIST ........................................................................ 29 ANNEX E. DECLARATION OF SIMILARITY ......................................................................................................................... 30 Test Report No. 15020860-FCC-R1 Page 5 of 30 1. Report Revision History Report No. Report Version Description Issue Date 15020860-FCC-R1 NONE Original August 25, 2015 2. Customer information Applicant Name Beijing Jia An Electronic Technology Co,.Ltd. Applicant Address No.19 GuCheng West Street,Shi Jing Shan District,Beijing 100043, China Manufacturer Name Beijing Jia An Electronic Technology Co,.Ltd. Manufacturer Address No.19 GuCheng West Street,Shi Jing Shan District,Beijing 100043, China 3. Test site information Lab performing tests SIEMIC (Nanjing-China) Laboratories Lab Address 2-1 Longcang Avenue Yuhua Economic and Technology Development Park, Nanjing, China FCC Test Site No. 986914 IC Test Site No. 4842B-1 Test Software Labview of SIEMIC version 1.0 Test Report No. 15020860-FCC-R1 Page 6 of 30 4. Equipment Under Test (EUT) Information Description of EUT: Transmitter Main Model: T306 Serial Model: T306-2 Date EUT received: August 17, 20145 Test Date(s): August 21, 2015 Antenna Gain: 3 dBi Type of Modulation: ASK RF Operating Frequency (ies): Tx:433.97MHz Number of Channels: 1 CH Port: N/A Input Power: DC: 12V Trade Name : N/A FCC ID: VVJ-T306R434 Test Report No. 15020860-FCC-R1 Page 7 of 30 5. Test Summary The product was tested in accordance with the following specifications. All testing has been performed according to below product classification: FCC Rules Description of Test Result §15.203 Antenna Requirement Compliance §15.207 Conducted Emissions…

Text truncated - open the document above for the full version.

Test Report No. 15020860-FCC-R1 Page 26 of 30 Annex B.iii. Photograph: Test Setup Photo Radiated Spurious Emissions Test Setup Below 1GHz Radiated Spurious Emissions Test Setup Above 1GHz