W8F813207300DATAPASS

FCC Compliance Statement for DataPass/μDataPass 1 DataPass & μDataPass P/N 817407400 Rev A2 1. SCOPE This document provides a general and functional description of the DataPass and μDataPass units. 2. DATAPASS & μDATAPASS DESCRIPTION DataPass and μDataPass are miniature units that connect to the vehicle bus and capture data from the vehicle CPU/BUS. They then transmit this data to the nearest Wireless Gateway in the forecourt. Two unit types are available for the installer (see Figure 1 and Figure 2): μDataPass (CAN) for CAN Bus Protocol μDataPass (k-line) for K-line Protocol Figure 1. μDataPass DataPass for Light Vehicles (OBD-II) DataPass AVL for Heavy Vehicles Figure 2. DataPass FCC Compliance Statement for DataPass/μDataPass 2 μDataPass – a connector shaped unit that plugs into the vehicle On Board Diagnostics connector (OBD II) and intended for light and commercial vehicles which has OBD II connector. The following μDataPass types are available:  μDataPass CAN, P/N 800907435  μDataPass K-Line, P/N 800907436  μDataPass Plus CAN, P/N 800907430  μDataPass Plus K-Line, P/N 800907431 DataPass - connected directly to the vehicle bus harness, used in heavy and light vehicles and supports most common bus protocols. The following DataPass types are available:  DataPass Heavy, P/N 800907340  DataPass Light, P/N 800907330  DataPass Plus Heavy, P/N 800907310  DataPass Plus Light, P/N 800907300  DataPass AVL Heavy, P/N 800907540  DataPass AVL Light, P/N 800907541 N N O O T T E E Please check the manufacturer specifications for the proper protocol supported by the Vehicles in your fleet! The DataPass is installed using the provided DataPass harness. The harness is installed inside the driver cabin, behind the dashboard and connects to the vehicle's diagnostics connector in light vehicles, or to the diagnostics plug rear wiring in heavy vehicles. 3. DATAPASS – TECHNICAL SPECIFICATION Table 1 lists the specifications for the DataPass units. Table 1. DataPass Specifications Parameter Value Physical HxWxD 15x70x21 mm Weight 45g Connectors 562810 Molex Electrical Supply voltage Normal operation: 12VDC (Nominal) Minimum: 10 VDC FCC Compliance Statement for DataPass/μDataPass 3 Parameter Value Maximum: 32 VDC Current consumption (typical) KLINE Mode: Sleep mode: 5mA Active mode: 35mA CAN Mode: Sleep mode: 5mA Active mode: 25mA J1708 Mode: Sleep mode: 5mA Active mode: 25mA Environmental Conditions Temperature Range Operating: -40 to +70 ºC Storage: -40 to +85 ºC Humidity 95% non-condensing Communication Wireless Interfaces Single IEEE802.15.4 wireless channel Operating Frequency: ISM 2.405 to 2.480 GHz (Global license free band) Implements proprietary mesh network IEEE802.15.4 Modem DSSS/FA – Direct Sequence Spread Spectrum with Frequency Agility Supported network topologies: Propriety mesh network Channel capacity: 16 frequency channels / 5MHz channel spacing Transmit power output: 2mW (3dbm) Receive sensitivity: -101dbm Wireless Antenna Built in PCB Antenna Wired Interfaces OBDII – J2284/ISO15765 (CAN BUS) Data rate: 250Kbps / 500Kbps OBDII – ISO14230/ISO9141 (KLINE) Data rate: 10400bps J1708/J1587 Data rate: 9600bps Table 2 lists the specifications for the μDataPass units. FCC Compliance Statement for DataPass/μDataPass 4 Table 2.μDataPass Specifications Parameter Value Physical HxWxD 22x70x17 mm Weight 10g Connectors OBDII compatible (male) Electrical Supply voltage Normal operation: 12VDC (Nominal) Minimum: 10 VDC Maximum: 32 VDC Current consumption (typical) KLINE Interface: Sleep mode: 4mA Active mode: 35mA CAN Interface: Sleep mode: 4mA Active mode: 25mA Environmental Conditions Temperature Range Operating: -40 to +70 ºC Storage: -40 to +85 ºC Communication Wireless Interfaces Single IEEE802.15.4 wireless channel Operating Frequency: ISM 2.405 to 2.480 GHz (Global license free band) Implements proprietary Mesh network IEEE802.15.4 Modem DSSS/FA – Direct Sequence Spread Spectrum with Frequency Agility Supported network topologies: Propriety Mesh network Channel capacity: 16 frequency channels / 5MHz channel spacing Transmit power output: 2mW (3dbm) Receive sensitivity: -101dbm Wireless Antenna Built in PCB Antenna Wired Interfaces OBDII – J2284/ISO15765 (CAN BUS) Data rate: 250Kbps / 500Kbps OBDII – ISO14230/ISO9141 (KLINE) Data rate: 10400bps FCC Compliance Statement for DataPass/μDataPass 5 FCC COMPLIANCE STATEMENT IN USER'S MANUAL This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. For a Class A or Class B digital device or peripheral, the instructions GIVEN to the user shall include the following, or a similar statement should be placed in a prominent location in the text of the manual (Section 15.105). The User’s Manual or Instruction Manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. (from FCC rules 15.21): Sample user information for a Class A digital device: THE FCC WANTS YOU TO KNOW: This equipment has been tested and found to comply with the limits or a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. his equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, ay cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Warning Modifications not expressly approved by the ma…

Text truncated - open the document above for the full version.

REPLACE WITH OFFICIAL COMPANY LOGO / LETTERHEAD Date: 03 October 2012 Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of FCC ID: W8F813207300 Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, we hereby request confidential treatment of information accompanying this application as outlined below: CONF APPENDIX DataPass BlkDia.pdf CONF APPENDIX DataPass PartsLst.pdf CONF APPENDIX DataPass Schem.pdf The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Thank you, Signature: ______________ Printed Name: Gidi Segal Quality Assurance Director Orpak Systems Ltd.

Date: 03 October 2012 To: Timco Engineering Inc. To Whom It May Concern We hereby authorize Mr. Shaike Raz of I.T.L. (Product Testing) Ltd (ITL) to sign FORM 731 on our behalf for the following application: FCC ID: W8F813207300 Thank you, Gidi Segal Quality Assurance Director Orpak Systems Ltd. Tel: +972-3- 577-6866 Fax: +972-3- 579-6310 E-mail: [email protected] Website: www.orpak.com Fueling your business for success  Consider the environment - do you really need to print this email? CONFIDENTIAL!

REPLACE WITH OFFICIAL COMPANY LOGO / LETTERHEAD Date: 03 October 2012 attn: Reviewing Engineer Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 To Whom It May Concern: The DataPass, FCC ID: W8F813207300 and label is so small that it cannot include the statement specified in FCC Part 15 Sub-part A, Section 15.19 (a) (3) “This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation." Due to this reason, we are using the provisions of Part 15 Sub-part A, Section 15.19 (a) (5) and this statement appears in a prominent location in the user manual. Please contact me if there is any information you may need. Thank you, Signature: ______________ Printed Name: Gidi Segal Quality Assurance Director Orpak Systems Ltd.

REPLACE WITH OFFICIAL COMPANY LOGO / LETTERHEAD Date: 03 October 2012 To Whom It May Concern We hereby authorize I.T.L. (Product Testing) Ltd (ITL) to act on our behalf regarding the FCC ID Change Process for the following application: FCC ID: W8F813207300 Thank you, Signature: ______________ Printed Name: Gidi Segal Quality Assurance Director Orpak Systems Ltd.

DataPass is a miniature unit that connects to the vehicle bus and captures data from the vehicle CPU/BUS. It then transmits this data to the nearest Wireless Gateway Terminal (WGT) and RS-232. DataPass ‐ connected directly to the vehicle bus harness and is used in heavy vehicles and trucks and supports most bus protocols common to those vehicles. DataPass unit supports the following vehicle protocols: J1708/J1587, FMS/J1939/CAN Bus, Odometer pulses, OBD II.

Date: 03 October 2012 To Whom It May Concern I hereby declare that there is no tune-up procedure for: FCC ID: W8F813207300 Thank you, Gidi Segal Quality Assurance Director Orpak Systems Ltd. Tel: +972-3- 577-6866 Fax: +972-3- 579-6310 E-mail: [email protected] Website: www.orpak.com Fueling your business for success  Consider the environment - do you really need to print this email? CONFIDENTIAL!