MESIDBCT40Smart Card Reader

FCC ID: MESIDBCT40 Page 1/3 USER MANUAL User manual is printing on the box with FCC statement document in: FCC ID: MESIDBCT40 Page 2/3 FCC ID: MESIDBCT40 Page 3/3 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Regulatory Information Notice for the USA: FCC Statement Federal Communications Commission (FCC) Radio Frequency Interference Statement (USA Only) This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protections against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try one of more of the following measures:
Relocate the radio or television antenna.
Plug the equipment away from the radio or television.
Plug the equipment into a different electrical outlet, so that the equipment and the radio or television are on separate electrical circuits.
Make sure that all your peripheral devices are also FCC Class B certified.
Make sure you use only shielded cables to connect peripheral devices to your equipment.
Consult your equipment dealer, or an experienced radio / television technician for help. WARNING: The system verification tests were conducted with GEMALTO supported peripheral devices. Cables used with this equipment must be properly shielded to comply with the requirements of the FCC. Changes or modifications not expressly approved by GEMALTO could void the user's authority to operate the equipment. Don’t use USB or SERIAL extension cable with this product. "Accessories for use with UL Listed Computers having limited power or Class 2 output"

June 18 th , 2012 CONFIDENTIALITY REQUEST Curtis-Straus LLC One Distribution Center Circle #1 Littleton, MA 01460 USA Re: Confidentiality request for a Digital Device FCC ID: MESIDBCT40 Gentlemen, GEMALTO requests, pursuant to 47CFR 0.459, post grant confidentiality for portions of the material contained in this application. The following document regarding this submission for FCC ID: MESIDBCT40 shall be kept confidential: 1. Block Diagram description of the IDBRIDGE CT40 (file: Block Diagram- MESIDBCT40.pdf) Specifically, these exhibits contain information relating to circuit function and complexity that could be of benefit to competitors. The material contains trade secrets and confidential information that GEMALTO does not customarily release to the public and which is otherwise not generally available to the public. Regards, Pierre André COLLET GEMALTO

FCC ID: MESIDBCT40 EXTERNAL PHOTOS OF TESTED EUT FCC ID: MESIDBCT40 FCC ID: MESIDBCT40 FCC ID: MESIDBCT40

FCC ID: MESIDBCT40 Page 1/2 PRODUCT LABELING FCC ID: MESIDBCT40 Page 2/2

FCC ID: MESIDBCT40 Page 1/2 INTERNAL PHOTOS OF TESTED EUT FCC ID: MESIDBCT40 Page 2/2

FCC ID: MESIDBCT40 Page 1/3 OPERATIONAL DESCRIPTION 1.1. Equipment description FCC ID: MESIDBCT40 Page 2/3 FCC ID: MESIDBCT40 Page 3/3 1.2. Related Submittal(s) / Grant(s) All host equipment used in the test configuration are FCC granted, when relevant. 1.3. Tested System Details The FCC IDs for all equipment, plus description of all cables used in the tested system are: • Inputs/outputs: - USB cable • Cables: - USB cable, shielded, length: 1.5m • Auxiliaries equipment used during test: - 1 x Laptop TOSHIBA SATELITE S1410-704 (PS141E-04YCM-3V), Sn: 13594938G The EUT exercise program (Apitest) used during radiated and conducted testing in loop was designed to exercise the EUT in a manner similar to a typical use: - Smart card: Reading – comparison - Answer To Reset (ATR) 1.4. Test Methodology Both conducted and radiated testing were performed according to the procedures in ANSI C63.4-2003, FCC Part 15 Subpart B. Radiated testing was performed at an antenna to EUT distance of 10 meters. During testing, all equipment’s and cables were moved relative to each other in order to identify the worst case set-up. 1.5. Test facility Tests have been performed on June 18 th , 2012. This test facility has been fully described in a report and accepted by FCC as compliant with the radiated and AC line conducted test site criteria in ANSI C63.4-2003 in a letter dated March 25 th , 2008 (registration number 94821). This test facility has also been accredited by COFRAC (French accreditation authority for European Union test lab accreditation organization) according to NF EN ISO/IEC 17025, accreditation number 1-1633 as compliant with test site criteria and competence in 47 CFR Part 15/ANSI C63.4 and EN55022/CISPR22 norms for 89/336/EEC European EMC Directive application. All pertinent data for this test facility remains unchanged.

Rapport d’essai / Test report JDE : 114913 N° 441427-R1-E DELIVRE A / ISSUED TO : GEMALTO Avenue du Pic de Bertagne BP 100 13881 GEMENOS – France Objet / Subject : Essais de compatibilité électromagnétique conformément aux normes : Electromagnetic compatibility tests according to the standards: FCC CFR 47 Part 15, Subpart B. ANSI C63.4 (2003) Matériel testé / Apparatus under test : • Produit / Product : Lecteur de carte / Card reader • Marque / Trade mark : GEMALTO • Constructeur / Manufacturer : GEMALTO • Type / Model : IDBRIDGE CT40 • N° de série / serial number : R12425324800040 • FCCID : MESIDBCT40 Date des essais / Test date : Le 18 Juin 2012 / June 18 th , 2012 Lieu d’essai / Test location : LCIE SUD-EST ZI Centr’Alp – 170 rue de Chatagnon 38430 MOIRANS - FRANCE Test réalisé par / Test performed by : Anthony MERLIN document comporte / Composition of document: 15 pages M OIRANS, LE 4 JUILLET 2012 / JULY 4TH, 2012 Ecrit par / Written by Approuvé par / Approved by, Anthony MERLIN Jacques LORQUIN La reproduction de ce document n'est autorisée que sous sa forme intégrale. Toute reproduction partielle ou toute insertion de résultats dans un texte d'accompagnement en vue de leur diffusion doit recevoir un accord préalable et formel du LCIE. Ce document résulte d’essais effectués sur un spécimen, un échantillon ou une éprouvette. Il ne préjuge pas de la conformité de l’ensemble des produits fabriqués à l’objet essayé. Sauf indication contraire, la décision de conformité prend en compte l’incertitude de mesures. Il ne préjuge en aucun cas d’une décision de certification. This document shall not be reproduced, except in full, without the written approval of the LCIE. This document contains results related only to the item tested. It does not imply the conformity of the whole production to the item tested .Unless otherwise specified; the decision of conformity takes into account the uncertainty of measures. This document does not anticipate any certification decision. RAPPORT D'ESSAI / TEST REPORT N° 441427-R1-E Page : 2 / 15 SUMMARY 1. TEST PROGRAM ................................................................................................................................... 3 2. APPARATUS UNDER TEST: CONFIGURATION ................................................................................... 4 3. MEASUREMENT OF CONDUCTED EMISSION (150KHZ-30MHZ) ....................................................... 5 4. MEASUREMENT OF RADIATED EMISSION (30MHZ-1GHZ) ................................................................ 7 5. UNCERTAINTIES CHART .................................................................................................................... 11 6. ANNEX 1 (GRAPHS) ............................................................................................................................ 12 RAPPORT D'ESSAI / TEST REPORT N° 441427-R1-E Page : 3 / 15 1. TEST PROGRAM Standard: - FCC Part 15, Subpart B (Digital Devices) - ANSI C63.4 (2003) EMISSION TEST LIMITS RESULTS (Comments) Limits for conducted disturbance at mains ports 150kHz-30MHz Frequency Quasi-peak value (dBμV) Average value (dBμV) PASS 150-500kHz 66 to 56 56 to 46 0.5-5MHz 56 46 5-30MHz 60 50 Radiated emissions 30MHz-1GHz* Highest frequency < 104MHz (Declaration of provider) Measure at 3m 30MHz-88MHz : 40 dBμV/m 88MHz-216MHz : 43.5 dBμV/m 216MHz-960MHz : 46.0 dBμV/m Above 960MHz : 54.0 dBμV/m PASS *§15.33: The highest internal source of a testing device is defined like more the highest frequency generated or used in the testing device or on which the testing device works or agrees. - If the highest frequency of the internal sources of the testing device is lower than 108 MHz, measurement must be only performed until 1GHz. - If the highest frequency of the internal sources of the testing device ranges between 108 MHz and 500 MHz, measurement must be only performed until 2GHz. - If the highest frequency of the internal sources of the testing device ranges between 500 MHz and 1 GHz, measurement must be only performed until 5GHz. If the highest frequency of the internal sources of the testing device is above 1 GHz, measurement must be only performed until 5 times the highest frequency or 40 GHz, while taking smallest of both. RAPPORT D'ESSAI / TEST REPORT N° 441427-R1-E Page : 4 / 15 2. APPARATUS UNDER TEST: CONFIGURATION 2.1. HARDWARE IDENTIFICATION (EUT AND AUXILIARIES): • Equipment under test (EUT): IDBRIDGE CT40 Serial Number: R12425324800040 • Inputs/outputs: - USB cable • Cables: - USB cable, shielded, length: 1.5m • Auxiliaries equipment used during test: - 1 x Laptop TOSHIBA SATELITE S1410-704 (PS141E-04YCM-3V), Sn: 13594938G 2.2. RUNNING MODE The EUT exercise program (Apitest) used during radiated and conducted testing in loop was designed to exercise the EUT in a manner similar to a typical use: - Smart card: Reading – comparison - Answer To Reset (ATR) 2.3. EQUIPMENT MODIFICATIONS None 2.4. SPECIAL ACCESSORIES None RAPPORT D'ESSAI / TEST REPORT N° 441427-R1-E Page : 5 / 15 3. MEASUREMENT OF CONDUCTED EMISSION (150KHZ-30MHZ) 3.1. TEST CONDITIONS Date of test : June 18 th , 2012 Test performed by : A.MERLIN Atmospheric pressure : 994hPa Relative humidity : 42% Ambient temperature : 23°C 3.2. SETUP FOR CONDUCTED EMISSIONS MEASUREMENT The product has been tested according to ANSI C63.4-(2003) and FCC Part 15 subpart B. The product has been tested with 110V/60Hz power line voltage and compared to the FCC Part 15 subpart B §15.107 limits. Measurement bandwidth was 9kHz from 150kHz to 30MHz. The EUT with its auxiliaries are set on a non-conducting table 80cm above the ground reference plane. The distance between the EUT and the LISN is 80cm. The EUT is 40cm away for the vertical ground plane. The EUT is powered through a LISN (measure). Auxiliaries are powered by another LISN. Measurement is made with a Rohde & Schwarz ESU8 receiver in peak mode. This was followed by a Quasi-Peak, i.e. CISPR measurement for any str…

Text truncated - open the document above for the full version.

FCC ID: MESIDBCT40 Page 1/2 1 CONDUCTED AND RADIATED MEASUREMENT PHOTO 1.1 Conducted emission FCC ID: MESIDBCT40 Page 2/2 1.2 Radiated emission