N5OD3DRCMP2.4 GHz Transceiver

Scanreco AB Stensätravägen 13, SE-127 39 Skärholmen Box 90304, SE-120 25 Stockholm, Sweden Tel +46 8 556 32 800 www.scanreco.com Portable control unit (transmitter) D3 DRC-MP D3 DRC-MP: 2.4 GHz transmitter Scanreco AB Stensätravägen 13, SE-127 39 Skärholmen Box 90304, SE-120 25 Stockholm, Sweden Tel +46 8 556 32 800 www.scanreco.com This product is intended to be installed in a Control unit system as a transmitter by Scanreco AB and it is designed preferably for wireless control of crane installations, travelling hoist units, chain and rope hoists, transfer carriages and similar applications. Terminal diagrams: Scanreco AB Stensätravägen 13, SE-127 39 Skärholmen Box 90304, SE-120 25 Stockholm, Sweden Tel +46 8 556 32 800 www.scanreco.com Radio part diagram: Radio specification: Attribute Information Frequency 2.405 – 2.480 GHz Channels 16 Channels management FHSS Channel bandwidth 2.7 MHz RF Power +18 dBm typical Modulation GFSK Range 100 meter Antenna specification: N Antenna type Details Manufacture Part number Connector Gain 1 Dipole antenna Total length 82 mm, Ø17mm Scanreco 50250 TNC 2 dBi 2 Striaght antenna 185 mm length, Ø13mm Nearson 102784 TNC/SMA 5 dBi Scanreco AB Stensätravägen 13, SE-127 39 Skärholmen Box 90304, SE-120 25 Stockholm, Sweden Tel +46 8 556 32 800 www.scanreco.com Installation description: Figure 1 Figure 2 1- Assemble D3 DRC-MP to box with screws. Torque =0.7Nm. 2- Screw antenna connector to PCBA. Torque = 0.56Nm 3- Assemble transparent plastic cover. Tightening torque = 0.7Nm, see Figure 2. Scanreco AB Stensätravägen 13, SE-127 39 Skärholmen Box 90304, SE-120 25 Stockholm, Sweden Tel +46 8 556 32 800 www.scanreco.com FCC information This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesirable operation. Warning Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Industry Canada information This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. CAN ICES-3 (A)/NMB-3(A)

Page 1 of 1 EUT is PCB, no enclosure. External photos are the same internal photos, internal photographs are confidential.

D3 DRC-MP label format and location On the host product shall be noted:

Reference number: 295560-1-3 Page 1 of 46 These test results are valid for the tested unit only. This report shall not be reproduced, except in full, without a written permission of SGS Fimko. Test Report INTENTIONAL RADIATOR TESTS ACCORDING TO FCC PART 15 C AND ISED CANADA REQUIREMENTS Equipment Under Test: 2.4GHz radio module Model: D3 DRC-MP Manufacturer: Scanreco AB Stensätravägen 13 SE-127 39 Skärholmen, Sweden Customer: Scanreco AB Stensätravägen 13 SE-127 39 Skärholmen, Sweden FCC Rule Part: 15.247: 2017 IC Rule Part: RSS-247, Issue 2, 2017 RSS-GEN Issue 5 Amendment 1, 2019 KDB: 558074 D01 15.247 Meas Guidance v05r02 Guidance for Compliance Measurements on Digital Transmission Systems, Frequency Hopping Spread Spectrum System, and Hybrid System Devices Operating Under §15.247 of the FCC rules (April 2, 2019) Date: 12 August 2019 Date: 12 August 2019 Issued by: Checked by: Pekka Kälviäinen Rauno Repo Testing Engineer Senior EMC/RF Specialist Reference number: 295560-1-3 Page 2 of 46 Table of Contents GENERAL REMARKS .......................................................................................................................................... 3 Disclaimer ........................................................................................................................................................ 3 RELEASE HISTORY ............................................................................................................................................ 4 Page 11: measuring distance was added (3m) ............................................................................................... 4 Page 45: Calibration date of SMBV100A updated .......................................................................................... 4 PRODUCT DESCRIPTION .................................................................................................................................. 5 Equipment Under Test .................................................................................................................................... 5 General Description ......................................................................................................................................... 5 Ratings and declarations ................................................................................................................................. 5 Power Supply .................................................................................................................................................. 5 Mechanical Size of the EUT ............................................................................................................................ 5 SUMMARY OF TESTING ..................................................................................................................................... 6 EUT Test Conditions during Testing ............................................................................................................... 6 TEST RESULTS ................................................................................................................................................... 8 Antenna requirement ....................................................................................................................................... 8 Maximum Peak Conducted Output Power ...................................................................................................... 9 Transmitter Radiated Spurious Emissions 9 kHz – 26.5 GHz ........................................................................ 12 Transmitter Band Edge Measurement and Conducted Spurious Emissions .................................................. 20 20 dB Bandwidth of the Hopping Channel ...................................................................................................... 28 Hopping Channel Carrier Frequencies Separation ......................................................................................... 31 Number of Hopping Channels ......................................................................................................................... 34 Average Time of Occupancy of Hopping Frequency ...................................................................................... 36 6 dB Bandwidth of the Channel ....................................................................................................................... 39 99% Occupied Bandwidth ............................................................................................................................... 42 Duty cycle correction factor, Transmit time in 100 ms .................................................................................... 45 TEST EQUIPMENT .............................................................................................................................................. 46 Reference number: 295560-1-3 Page 3 of 46 General Remarks GENERAL REMARKS Disclaimer This document is issued by the Company under its General Conditions of service accessible at http://www.sgs.com/terms_and_conditions.htm. attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company's findings at the time of its intervention only and within the limits of Client's instructions, if any. The Company's sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. This document cannot …

Text truncated - open the document above for the full version.

P26,40dBm Tune-up tolerance 0,50dB Duty Cycle8,52% P average41,73mW d200mm f2480MHz x7,5for 1-g SAR SAR exclusion0,33<7.5 Limit7,5 Pmax953mW * calculated using 447498 D01 General RF Exposure Guidance v05r02 section 4.3.1 1) [(max. power of channel, including tune-up tolerance, mW)/(min. test separation distance, mm)] ·[√f(GHz)

Test Setup Photographs 295560-1-3 Scanreco DRC-MP D3 Photograph 1. Radiated Spurious Emissions 9 kHz – 30 MHz Photograph 2. Radiated Spurious Emissions 30 MHz – 1000 MHz Test Setup Photographs 295560-1-3 Scanreco DRC-MP D3 2/3 Photograph 3. Radiated Spurious Emissions 1 GHz – 18 GHz Photograph 4. Radiated Spurious Emissions 18 GHz – 26.5 GHz Test Setup Photographs 295560-1-3 Scanreco DRC-MP D3 3/3 Photograph 5. EUT position during radiated tests Photograph 6. FCC Conducted measurement