OS3IPC05Wireless IP camera

Wireless IP Camera User Manual Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: z Reorient or relocate the receiving antenna. z Increase the separation between the equipment and receiver. z Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. z Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co ‐ located or operating in conjunction with any other antenna or transmitter. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Country Code selection feature to be disabled for products marketed to the US/CANADA NCC statement 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信 ，指依電信法規定作業之無線電通信。低功率射頻電 機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

Declaration for no non‐US channel operation 2014/6/26 We, Zhuhai FTZ Oplink Communications, Inc. declare that the device does not support channel 12 ~ 13 in 2.4GHz band and any non-US channels in all the operational mode(s) for the following product. FCC ID: OS3IPC05 If you should have any question(s) regarding this declaration, please don’t hesitate to contact us. Thank you! ----------------------------------- Name: / Title: Lizhi Li/Engineer Zhuhai FTZ Oplink Communications, Inc. Tel: 86-0756-8819682 Fax: 86-0756-8686790 E-mail: [email protected] 2014/6/26

Report No.: 130925E07C Page 1 Reference No.: 140430E04 CONSTRUCTION PHOTOS OF EUT Report No.: 130925E07C Page 2 Reference No.: 140430E04 Report No.: 130925E07C Page 3 Reference No.: 140430E04 Adapter 1: Model No.: AMS9-1201000FU2 Report No.: 130925E07C Page 4 Reference No.: 140430E04 Report No.: 130925E07C Page 5 Reference No.: 140430E04 Adapter 1: Model No.: AMS9-1201000FU2 Report No.: 130925E07C Page 6 Reference No.: 140430E04 Report No.: 130925E07C Page 7 Reference No.: 140430E04 Adapter 2: Model No.: CAP012121 US Report No.: 130925E07C Page 8 Reference No.: 140430E04 Report No.: 130925E07C Page 9 Reference No.: 140430E04 Adapter 2: Model No.: CAP012121 US Report No.: 130925E07C Page 10 Reference No.: 140430E04

FCC ID： OS3IPC05 LABEL LOCATION The label will be permanently affixed at a conspicuous location on the device. Lebel Here

Report No.: 130925E07C Page 1 Reference No.: 140430E04 CONSTRUCTION PHOTOS OF EUT Report No.: 130925E07C Page 2 Reference No.: 140430E04 Report No.: 130925E07C Page 3 Reference No.: 140430E04 Report No.: 130925E07C Page 4 Reference No.: 140430E04 Report No.: 130925E07C Page 5 Reference No.: 140430E04 Report No.: 130925E07C Page 6 Reference No.: 140430E04 Report No.: 130925E07C Page 7 Reference No.: 140430E04 Report No.: 130925E07C Page 8 Reference No.: 140430E04

Report No.: SA130925E07C 1 of 6 Report Format Version 5.0.0 Reference No.: 140430E04 RF EXPOSURE REPORT REPORT NO.: SA130925E07C MODEL NO.: IPC1205 FCC ID: OS3IPC05 RECEIVED: Sep. 17, 2013 TESTED: Sep. 27, 2013 ISSUED: Aug. 05, 2014 APPLICANT: Zhuhai FTZ Oplink Communications, Inc. ADDRESS: #29, #30 Lianfeng Avenue, Free Trade Zone, Zhuhai City, Guangdong Province,, 519030 China ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch Hsin Chu Laboratory LAB ADDRESS: No. 81-1, Lu Liao Keng, 9th Ling,Wu Lung Tsuen, Chiung Lin Hsiang, Hsin Chu Hsien 307, Taiwan, R.O.C. This report should not be used by the client to claim product certification, approval, or endorsement by any government agencies. This report is for your exclusive use. Any copying or replication of this report to or for any other person or entity, or use of our name or trademark, is permitted only with our prior written permission. This report sets forth our findings solely with respect to the test samples identified herein. The results set forth in this report are not indicative or representative of the quality or characteristics of the lot from which a test sample was taken or any similar or identical product unless specifically and expressly noted. Our report includes all of the tests requested by you and the results thereof based upon the information that you provided to us. You have 60 days from date of issuance of this report to notify us of any material error or omission caused by our negligence, provided, however, that such notice shall be in writing and shall specifically address the issue you wish to raise. A failure to raise such issue within the prescribed time shall constitute your unqualified acceptance of the completeness of this report, the tests conducted and the correctness of the report contents. Unless specific mention, the uncertainty of measurement has been explicitly taken into account to declare the compliance or non-compliance to the specification Report No.: SA130925E07C 2 of 6 Report Format Version 5.0.0 Reference No.: 140430E04 TABLE OF CONTENTS RELEASE CONTROL RECORD ..................................................................................... 3 1. CERTIFICATION ...................................................................................................... 4 2. RF EXPOSURE LIMIT .............................................................................................. 5 3. MPE CALCULATION FORMULA ............................................................................. 5 4. CLASSIFICATION .................................................................................................... 5 5. CALCULATION RESULT OF MAXIMUM CONDUCTED POWER ........................... 6 Report No.: SA130925E07C 3 of 6 Report Format Version 5.0.0 Reference No.: 140430E04 RELEASE CONTROL RECORD ISSUE NO. REASON FOR CHANGE DATE ISSUED SA130925E07C Original release Aug. 05, 2014 Report No.: SA130925E07C 5 of 6 Report Format Version 5.0.0 Reference No.: 140430E04 2. RF EXPOSURE LIMIT LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) FREQUENCY RANGE (MHz) ELECTRIC FIELD STRENGTH (V/m) MAGNETIC FIELD STRENGTH (A/m) POWER DENSITY (mW/cm 2 ) AVERAGE TIME (minutes) LIMITS FOR GENERAL POPULATION / UNCONTROLLED EXPOSURE 300-1500 ... ... F/1500 30 1500-100,000 ... ... 1.0 30 F = Frequency in MHz 3. MPE CALCULATION FORMULA Pd = (Pout*G) / (4*pi*r 2 ) where Pd = power density in mW/cm2 Pout = output power to antenna in mW G = gain of antenna in linear scale pi = 3.1416 r = distance between observation point and center of the radiator in cm 4. CLASSIFICATION The antenna of this product, under normal use condition, is at least 20cm away from the body of the user. So, this device is classified as Mobile Device. Report No.: SA130925E07C 6 of 6 Report Format Version 5.0.0 Reference No.: 140430E04 5. CALCULATION RESULT OF MAXIMUM CONDUCTED POWER FREQUENCY BAND (MHz) CONDUCTED POWER (mW) ANTENNA GAIN (dBi) DISTANCE (cm) POWER DENSITY (mW/cm 2 ) LIMIT (mW/cm 2 ) 2412 - 2462 410.204 2.23 20 0.13637 1.00 --- END ---

Report No.: RF130925E07C 1 of 57 Report Format Version 5.2.1 Reference No.: 140430E04 FCC TEST REPORT REPORT NO.: RF130925E07C MODEL NO.: IPC1205 FCC ID: OS3IPC05 RECEIVED: Sep. 17, 2013 TESTED: Sep. 17 to 30, 2013 ISSUED: Aug. 05, 2014 APPLICANT: Zhuhai FTZ Oplink Communications, Inc. ADDRESS: #29, #30 Lianfeng Avenue, Free Trade Zone, Zhuhai City, Guangdong Province,, 519030 China ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch Hsin Chu Laboratory LAB ADDRESS : No. 81-1, Lu Liao Keng, 9th Ling, Wu Lung Tsuen, Chiung Lin Hsiang, Hsin Chu Hsien 307, Taiwan, R.O.C. TEST LOCATION (1): No. 81-1, Lu Liao Keng, 9th Ling, Wu Lung Tsuen, Chiung Lin Hsiang, Hsin Chu Hsien 307, Taiwan, R.O.C. TEST LOCATION (2): No. 49, Ln. 206, Wende Rd., Shangshan Tsuen, Chiung Lin Hsiang, Hsin Chu Hsien 307, Taiwan, R.O.C. This report should not be used by the client to claim product certification, approval, or endorsement by TAF or any government agencies. This report is for your exclusive use. Any copying or replication of this report to or for any other person or entity, or use of our name or trademark, is permitted only with our prior written permission. This report sets forth our findings solely with respect to the test samples identified herein. The results set forth in this report are not indicative or representative of the quality or characteristics of the lot from which a test sample was taken or any similar or identical product unless specifically and expressly noted. Our report includes all of the tests requested by you and the results thereof based upon the information that you provided to us. You have 60 days from date of issuance of this report to notify us of any material error or omission caused by our negligence, provided, however, that such notice shall be in writing and shall specifically address the issue you wish to raise. A failure to raise such issue within the prescribed time shall constitute your unqualified acceptance of the completeness of this report, the tests conducted and the correctness of the report contents. Unless specific mention, the uncertainty of measurement has been explicitly taken into account to declare the compliance or non-compliance to the specification Report No.: RF130925E07C 2 of 57 Report Format Version 5.2.1 Reference No.: 140430E04 Table of Contents RELEASE CONTROL RECORD ........................................................................................ 4 1. CERTIFICATION .................................................................................................... 5 2. SUMMARY OF TEST RESULTS ............................................................................ 6 2.1 MEASUREMENT UNCERTAINTY .......................................................................... 7 3. GENERAL INFORMATION ..................................................................................... 8 3.1 GENERAL DESCRIPTION OF EUT ....................................................................... 8 3.2 DESCRIPTION OF TEST MODES ....................................................................... 10 3.2.1 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL ........................ 11 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS ....................................... 14 3.4 DUTY CYCLE OF TEST SIGNAL ......................................................................... 15 3.5 DESCRIPTION OF SUPPORT UNITS .................................................................. 16 3.6 CONFIGURATION OF SYSTEM UNDER TEST ................................................... 16 4. TEST TYPES AND RESULTS .............................................................................. 17 4.1 CONDUCTED EMISSION MEASUREMENT ........................................................ 17 4.1.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT ...................................... 17 4.1.2 TEST INSTRUMENTS .......................................................................................... 17 4.1.3 TEST PROCEDURES .......................................................................................... 18 4.1.4 DEVIATION FROM TEST STANDARD ................................................................. 18 4.1.5 TEST SETUP ....................................................................................................... 18 4.1.6 EUT OPERATING CONDITIONS ......................................................................... 19 4.1.7 TEST RESULTS (MODE 1) .................................................................................. 20 4.1.8 TEST RESULTS (MODE 2) .................................................................................. 22 4.2 RADIATED EMISSION AND BANDEDGE MEASUREMENT ................................ 24 4.2.1 LIMITS OF RADIATED EMISSION AND BANDEDGE MEASUREMENT .............. 24 4.2.2 TEST INSTRUMENTS .......................................................................................... 25 4.2.3 TEST PROCEDURES .......................................................................................... 27 4.2.4 DEVIATION FROM TEST STANDARD ................................................................. 27 4.2.5 TEST SETUP ....................................................................................................... 28 4.2.6 EUT OPERATING CONDITIONS ......................................................................... 28 4.2.7 TEST RESULTS ................................................................................................... 29 4.3 6dB BANDWIDTH MEASUREMENT .................................................................... 39 4.3.1 LIMITS OF 6dB BANDWIDTH MEASUREMENT .................................................. 39 4.3.2 TEST INSTRUMENTS .......................................................................................... 39 4.3.3 TEST PROCEDURE ............................................................................................. 39 4.3.4 DEVIATION FROM TEST STANDARD…

Text truncated - open the document above for the full version.

Report No.: 120702E04 1 of 4 PYHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST (MODE 1) Report No.: 120702E04 2 of 4 CONDUCTED EMISSION TEST (MODE 2) Report No.: 120702E04 3 of 4 RADIATED EMISSION TEST (Below 1GHz) Report No.: 120702E04 4 of 4 RADIATED EMISSION TEST (Above 1GHz)