SBDITTWB315F01Tire Pressure Monitoring System

PASSION for EXCELLENCE Installation The fixed method which used the valve The fixed method which used the belt Transmitter Base plate A transmitter is mounted on a base-plate. Slide in B mark B mark Slide in 1/3 PASSION for EXCELLENCE Lets a base-plate pass to a belt. Setting on a wheel Complete setting B mark B mark B mark Tire Valve B mark B mark Caution When mounting a tire for a wheel, don't make a tire collide with a transmitter. Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates use and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may 2/3 PASSION for EXCELLENCE cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT 3/3

External photograph

JAPAN QUALITY ASSURANCE ORGANIZATION 21-25, KINUTA 1-CHOME, SETAGAYA-KU, TOKYO 157-8573 JAPAN PHONE +81-3-3416-0111, FAX +81-3-3416-9691 JQA APPLICATION NO.: 400-40327 Issue Date : July 20, 2004 Page 1 of 31 EMI TEST REPORT JQA APPLICATION NO. : 400-40327 Model No. : ITTWB315F01 Type of Equipment : Tire Pressure Monitoring System (Transmitter) Regulations Applied : CFR 47 FCC Rules and Regulations Part 15 FCC ID : SBDITTWB315F01 Applicant : Bridgestone Corporation Address : 3-1-1, Ogawahigashi-cho, Kodaira-shi, Tokyo 187-8531, Japan Manufacture : Bridgestone Corporation Address : 3-1-1, Ogawahigashi-cho, Kodaira-shi, Tokyo 187-8531, Japan Received date of EUT : July 14, 2004 Final Judgment : Passed Test results in this report are obtained in use of equipment that is traceable to National Institute of Advanced Industrial Science and Technology (AIST) of Japan and National Institute of Information and Communications Technology(NICT) of Japan. The test results only respond to the tested sample. This report should not be reproduced except in full, without the written approval of JQA EMC Engineering Dept. Testing Div. JQA Application No. :400-40327 FCC ID :SBDITTWB315F01 Model No. :ITTWB315F01 Issue Date :July 20, 2004 Standard :CFR 47 FCC Rules Part 15 Page 2 of 31 JAPAN QUALITY ASSURANCE ORGANIZATION TABLE OF CONTENTS Page 1 Documentation 1.1 Test Regulation 3 1.2 General Information 3 1.3 Test Condition 4 – 8 1.4 EUT Modifications / Deviation from Standard 9 1.5 Test results 10 1.6 Summary 11 1.7 Test Configuration / Operation of EUT 12 1.8 EUT Arrangement(Drawing) 13 1.9 Preliminary Test and Test-setup (Drawings) 14 – 19 1.10 EUT Arrangement (Photographs) 20 – 21 2 Test Data 2.1 AC Power Line Conducted Emission N/A 2.2 Radiated Emission (Electric Field) 22 – 26 2.3 Frequency Stability N/A 2.4 Occupied Bandwidth 27 3 Appendix Test instruments List 28 – 31 JQA Application No. :400-40327 FCC ID :SBDITTWB315F01 Model No. :ITTWB315F01 Issue Date :July 20, 2004 Standard :CFR 47 FCC Rules Part 15 Page 3 of 31 JAPAN QUALITY ASSURANCE ORGANIZATION 1 DOCUMENTATION 1.1 TEST REGULATION FCC Rules and Regulations Part 15 Subpart A and C Intentional Radiators Test procedure : AC power line conducted emission, radiated emission, frequency stability and occupied bandwidth tests were performed according to the procedures in ANSI C63.4-2001. 1.2 GENERAL INFORMATION 1.2.1 Test facility : 1) Test Facility located at EMC Engineering Dept. Testing Div. : - No.2 and 3 Anechoic Chambers( 3 meters Site ). - Shielded Enclosure. Expiration date of FCC test facility filing : May 27, 2005 2) EMC Engineering Dept. Testing Div. is recognized under the National Voluntary Laboratory accreditation Program for satisfactory compliance established in title 15, Part 285 Code of Federal Regulations. NVLAP Lab Code : 200189-0 (Effective through : June 30, 2005) 1.2.2 Description of the Equipment Under Test (EUT) : 1) Type of Equipment : Tire Pressure Monitoring System (Transmitter) 2) Product Type : Prototype 3) Category : Security/Remote Control Transmitter 4) EUT Authorization : Certification 5) FCC ID : SBDITTWB315F01 6) Trade Name : - 7) Model No. : ITTWB315F01 8) Operating Frequency Range : 314.96 MHz 9) Highest Frequency Used in the EUT : 314.96 MHz 10) Serial No. : None 11) Date of Manufacture : None 12) Power Rating : DC 3.0V(Battery) 13) EUT Grounding : None 1.2.3 Definitions for symbols used in this test report : x - indicates that the listed condition, standard or equipment is applicable for this report. - indicates that the listed condition, standard or equipment is not applicable for this report. JQA Application No. :400-40327 FCC ID :SBDITTWB315F01 Model No. :ITTWB315F01 Issue Date :July 20, 2004 Standard :CFR 47 FCC Rules Part 15 Page 4 of 31 JAPAN QUALITY ASSURANCE ORGANIZATION 1.3 TEST CONDITION 1.3.1 The measurement of the AC Power Line Conducted Emission - was performed in the following test site. x - was not applicable. Test location : Safety & EMC Center EMC Engineering Dept. Testing Div. 21-25, Kinuta 1-chome, Setagaya-ku, Tokyo 157-8573, Japan - Shielded Enclosure - Anechoic Chamber No. 2 (portable Type) Used test instruments : Type Number of test instruments (Refer to Appendix) Test Receiver N/A Spectrum Analyzer N/A Cable N/A AMN(for EUT) N/A AMN(for Peripheral) N/A Termination N/A JQA Application No. :400-40327 FCC ID :SBDITTWB315F01 Model No. :ITTWB315F01 Issue Date :July 20, 2004 Standard :CFR 47 FCC Rules Part 15 Page 5 of 31 JAPAN QUALITY ASSURANCE ORGANIZATION 1.3.2 The measurement of the Radiated Emission(9 kHz – 30 MHz) x - was performed in the following test site. - was not applicable. Test location : Safety & EMC Center EMC Engineering Dept. Testing Div. 21-25, Kinuta 1-chome, Setagaya-ku, Tokyo 157-8573, Japan x - Anechoic Chamber No. 2 (3 meters) - Anechoic Chamber No. 3 (3 meters) Validation of Site Attenuation : 1) Last Confirmed Date : N/A 2) Interval : N/A Used test instruments : Type Number of test instruments (Refer to Appendix) Test Receiver TR07 Antenna AN01 Cable CA06 JQA Application No. :400-40327 FCC ID :SBDITTWB315F01 Model No. :ITTWB315F01 Issue Date :July 20, 2004 Standard :CFR 47 FCC Rules Part 15 Page 6 of 31 JAPAN QUALITY ASSURANCE ORGANIZATION 1.3.3 The measurement of the Radiated Emission(30 MHz – 1000 MHz) x - was performed in the following test site. - was not applicable. Test location : Safety & EMC Center EMC Engineering Dept. Testing Div. 21-25, Kinuta 1-chome, Setagaya-ku, Tokyo 157-8573, Japan x - Anechoic Chamber No. 2 (3 meters) - Anechoic Chamber No. 3 (3 meters) Validation of Site Attenuation : 1) Last Confirmed Date :March, 2004 2) Interval :1 year Used test instruments : Type Number of test instruments (Refer to Appendix) Test Receiver TR05 Antenna AN06, AN08 Cable CA01 RF Amplifier N/A JQA Application No. :400-40327 FCC ID :SBDITTWB315F01 Model No. :ITTWB315F01 Issue Date :July 20, 2004 Standard :CFR 47 FCC Rules Part 15 Page 7 of 31 JAPAN QUALITY ASSURANCE OR…

Text truncated - open the document above for the full version.

JQA Application No. :400-40327 FCC ID :SBDITTWB315F01 Model No. :ITTWB315F01 Issue Date :July 20, 2004 Standard :CFR 47 FCC Rules Part 15 Page 20 of 31 JAPAN QUALITY ASSURANCE ORGANIZATION 1.10 TEST ARRANGEMENT (PHOTOGRAPHS) PHOTOGRAPHS OF EUT CONFIGURATION FOR RADIATED EMISSIONS MEASUREMENT Photograph present configuration with maximum emission JQA Application No. :400-40327 FCC ID :SBDITTWB315F01 Model No. :ITTWB315F01 Issue Date :July 20, 2004 Standard :CFR 47 FCC Rules Part 15 Page 21 of 31 JAPAN QUALITY ASSURANCE ORGANIZATION