SW8UB1200B1GWUSB Bluetooth V2.0+EDR Dongle Class 2

USB Bluetooth Dongle User’s Manual i Copyright Statement No part of this publication may be reproduced in any form by any means without the prior written permission. Other trademarks or brand names mentioned herein are trademarks or registered trademarks of their respective companies. Disclaimer Information in this document is subject to change without notice. The manufacturer does not make any representations or warranties (implied or otherwise) regarding the accuracy and completeness of this document and shall in no event be liable for any loss of profit or any commercial damage, including but not limited to special, incidental, consequential, or other damage. July 2006, Rev1.0 ii Safety Instructions Always read the safety instructions carefully „ Keep this User’s Manual for future reference „ Keep this equipment away from humidity „ Lay this equipment on a reliable flat surface before setting it up „ If any of the following situation arises, get the equipment checked by a service technician: • The equipment has been exposed to moisture. • The equipment has been dropped and damaged. • The equipment has obvious sign of breakage. • The equipment has not been working well or you cannot get it work according to User’s Manual. iii Table of Contents 1. Introduction ....................................................................................................... 5 2. Installation ......................................................................................................... 7 3. Basic Operations............................................................................................. 10 Bluetooth Tray Icon ........................................................................................................ 10 Starting or Stopping Bluetooth........................................................................................ 10 Creating a Connection..................................................................................................... 11 Option 1. Use Quick Connect via the Bluetooth Icon ............................................................. 11 Option 2. Use the Bluetooth Setup Wizard..............................................................................12 Option 3. From the Entire Bluetooth Neighborhood ...............................................................12 4. Configuring Your Bluetooth ........................................................................... 14 General Settings .............................................................................................................. 14 Accessibility Settings ...................................................................................................... 15 Allow Other Devices to Discover this Computer ....................................................................15 Control the Types of Devices that are Allowed to Connect to this Computer .........................15 Choose an Audio Notification File ..........................................................................................15 Discovery Settings .......................................................................................................... 16 Periodic Search for Devices.....................................................................................................16 Determine the Devices that Will be Reported .........................................................................17 Local Services Settings ................................................................................................... 17 Client Applications.......................................................................................................... 18 Diagnostics...................................................................................................................... 18 5. Using Bluetooth Applications ........................................................................ 20 Printer.............................................................................................................................. 20 Configure .................................................................................................................................20 Install a Bluetooth Printer ........................................................................................................20 Delete a Printer ........................................................................................................................21 Imaging ........................................................................................................................... 21 Overview .................................................................................................................................21 Image Format Conversion .......................................................................................................22 Create an Imaging Connection ................................................................................................22 Close an Imaging Connection..................................................................................................22 Configure .................................................................................................................................22 Remote Camera Operation ......................................................................................................23 Install an Imaging Device ........................................................................................................23 iv Uninstall an Imaging Device ...................................................................................................23 Audio Gateway ............................................................................................................... 23 Overview .................................................................................................................................23 Create an Audio Gateway Conne…

Text truncated - open the document above for the full version.

GOOD WAY TECHNOLOGY CO., LTD. FCC ID.: SW8UB1200B1GW 3F,No.135,Lane 235 Pau Chiao Rd., Hsin Tien, Taipei County, Taiwan Tel : 886-2-8919-1200 # 560 GOOD WAY TECHNOLOGY CO., LTD. 3F,No.135,Lane 235 Pau Chiao Rd., Hsin Tien, Taipei County, Taiwan Tel : 886-2-8919-1200 # 560 Fax: 886-2-8919-1220 Federal Communications Commission July 10, 2006 Authorization and Evaluation Division Confidentiality Request Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, the Applicant Hereby requests confidential treatment of information accompanying this Application As outlined below: Schematics, Block Diagram, Circuit description The above materials contain trade secrets and proprietary information not customarily Released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457, disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Peter Yang / Engineer . GOOD WAY TECHNOLOGY CO., LTD.

Report No.: 066L149-RF-US-P06V01 Page : 1 of 3 Version:1.0 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (2) EUT Photo

GOOD WAY TECHNOLOGY CO., LTD. FCC ID.: SW8UB1200B1GW 3F,No.135,Lane 235 Pau Chiao Rd., Hsin Tien, Taipei County, Taiwan. Tel : 886-2-89191200 # 560 FCC ID AND DoC Label The FCC ID will be placed on the equipment as shown in the photograph below.

Report No.: 066L149-RF-US-P06V01 Page : 2 of 3 Version:1.0 (3) EUT Photo (4) EUT Photo Report No.: 066L149-RF-US-P06V01 Page : 3 of 3 Version:1.0 (5) EUT Photo (6) EUT Photo

Report No. 066L149-RF-US-P06V01 Page: 1 of 43 Version:1.0 Test Report Product Name USB Bluetooth V2.0+EDR Dongle Class 2 Model No. UB1200B1 FCC ID. SW8UB1200B1GW Applicant GOOD WAY TECHNOLOGY CO., LTD. Address 3F., No. 135, Lane 235 Pau Chiao Rd., Hsin Tien, Taipei County, Taiwan Date of Receipt June 19, 2006 Issued Date July 19, 2006 Report No. 066L149-RF-US-P06V01 The Test Results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by NVLAP any agency of the U.S. Government Report No. 066L149-RF-US-P06V01 Page: 2 of 43 Version:1.0 Test Report Certification Issued Date: July 19, 2006 Report No.: 066L149-RF-US-P06V01 Product Name USB Bluetooth V2.0+EDR Dongle Class 2 Applicant GOOD WAY TECHNOLOGY CO., LTD. Address 3F., No. 135, Lane 235 Pau Chiao Rd., Hsin Tien, Taipei County, Taiwan Manufacturer GOOD WAY TECHNOLOGY CO., LTD. Model No. UB1200B1 FCC ID. SW8UB1200B1GW Rated Voltage AC 120V/60Hz Working Voltage DC 3.3V (via USB) Trade Name GOODWAY Applicable Standard FCC CFR Title 47 Part 15 Subpart C: 2005 ANSI C63.4: 2003 CISPR 22: 2005 Test Result Complied The Test Results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by NVLAP any agency of the U.S. Government Documented By : ( Rita Huang ) Tested By : ( Tim Sung ) Approved By : ( George Chen ) 0914 Report No. 066L149-RF-US-P06V01 Page: 3 of 43 Version:1.0 TABLE OF CONTENTS Description Page 1. GENERAL INFORMATION ...............................................................................................................5 1.1. EUT Description......................................................................................................................................5 1.2. Operational Description...........................................................................................................................7 1.3. Test System Details .................................................................................................................................8 1.4. Configuration of Test System ..................................................................................................................8 1.5. EUT Exercise Software ...........................................................................................................................8 1.6. Test Facility ...........................................................................................................................................10 2. CONDUCTED EMISSION ................................................................................................................ 11 2.1. Test Equipment ......................................................................................................................................11 2.2. Test Setup ..............................................................................................................................................11 2.3. Limits.....................................................................................................................................................12 2.4. Test Procedure .......................................................................................................................................12 2.5. Uncertainty ............................................................................................................................................12 2.6. Test Result of Conducted Emission .......................................................................................................13 3. PEAK POWER OUTPUT ..................................................................................................................15 3.1. Test Equipment ......................................................................................................................................15 3.2. Test Setup ..............................................................................................................................................15 3.3. Limit .....................................................................................................................................................15 3.4. Uncertainty ............................................................................................................................................15 3.5. Test Result of Peak Power Output .........................................................................................................16 4. RADIATED EMISSION .....................................................................................................................17 4.1. Test Equipment ......................................................................................................................................17 4.2. Test Setup ..............................................................................................................................................18 4.3. Limits.....................................................................................................................................................18 4.4. Test Procedure .......................................................................................................................................19 4.5. Uncertainty ............................................................................................................................................19 4.6. Test Result of Radiated Emission ..........................................................................................................20 5. BAND EDGE .......................................................................................................................................24 5.1. Test Equipment ....…

Text truncated - open the document above for the full version.

Report No.: 066L149-RF-US-P06V01 Page : 1 of 3 Version:1.0 Attachment 1: EUT Test Setup Photographs Front View of Conducted Test Back View of Conducted Test Report No.: 066L149-RF-US-P06V01 Page : 2 of 3 Version:1.0 Front View of Radiated Test Back View of Radiated Test Report No.: 066L149-RF-US-P06V01 Page : 3 of 3 Version:1.0 Front View of Radiated Test (Horn) Back View of Radiated Test (Horn)