
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
FCC ID: WEC-1220 Model No.: EM2516 Page 1 of 2 PHOTO of ENTIRE SAMPLE PHOTO of ENTIRE SAMPLE FCC ID: WEC-1220 Model No.: EM2516 Page 2 of 2 FRONT VIEW OF SAMPLE BACK VIEW OF SAMPLE
1220
Page 1 of 3 INTERNAL PHOTO OF SAMPLE – 1 INTERNAL PHOTO OF SAMPLE – 2 Page 2 of 3 INTERNAL PHOTO OF SAMPLE – 3 INTERNAL PHOTO OF SAMPLE – 4 Page 3 of 3 INTERNAL PHOTO OF SAMPLE – 5
No APPELLATIONSPECQTY 1 TOP CASE 1 2 BOTTOM CASE 1 3MIDDLE CASE1 4BRACKET1 5 BATTERY DOOR 1 6KEY2 7PC Panel 1EM25161 8PC Panel 2EM25161 9BATTERY LabelEM251761 10Fat cableA45/0.8mm*80mm-3P PE1 11 Connect plate LA07-21 12 WHORL PA1.7*5-φ2.9 8 13 WHORL PB1.7*4-φ2.9 2 14Aerial EM3331TX1 15Metal DomeD=6MM2 16PCB板EM-TX433-02 VER1.11 17RESISTOR0603-1/10W-10±5%1 18RESISTOR0603-1/10W-100±5%1 19RESISTOR0603-1/10W-22K±5%2 20CAPACITORNPO-0603-50V-3P(±0.25P)3 21CAPACITORNPO-0603-50V-10PF±5%1 22CAPACITORNPO-0603-50V-15P(±5%)2 23CAPACITORX7R-0603-50V-1NF(102)(±10%)1 24 winding0603-15nH-0.25nH(TDK) 3 25AUDIONH2D SOT-232 26acoustic wave resonator 433.92MHZ,±75Khz/-0 F-111 27PCBEM2516-TX PCB VER1.11 28CAPACITORY5V-0805-50V-0.1UF(104)±20%1 29RESISTOR0603-1/10W-510±5%2 30RESISTOR0603-1/10W-100K±5%2 31RESISTOR0805-1/10W-0±5%1 32LED6034 33ICHF21881 34 ANODE 11202 35 CATHODE 11202 36ELECT CAPCD-Ф4*7-10V-47μF(±20%)1 EM2516TX
FCC 47 CFR PART 15 SUBPART C TEST REPORT For Applicant: Fuzhou Emax Electronic Co., Ltd. Address: Building #12-#16, CangShan Industrial Area, JuYuanZhou JinShan District, FuZhou, China Product Name: Mini Key Finder Model Name: EM2516 Brand Name: N/A FCC ID: WEC-1220 Report No.: MTE/EAH/D12111694 Date of Issue: Nov. 27, 2012 Issued by: Most Technology Service Co., Ltd. Address : No.5, Langshan 2nd Road, North District, Hi-tech Industrial Park, Nanshan, Shenzhen, Guangdong, China Tel : 86-755-8617 0306 Fax : 86-755-8617 0310 The report consists 21 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by MOST. The test results in the report only apply to the tested sample. The test report shall be invalid without all the signatures of testing engineers, reviewer and approver. FCC ID: WEC-1220 Report No.: MTE/EAH/D12111694 Page 2 of 21 TABLE OF CONTENTS 1.VERIFICATION OF CONFORMITY........................................................................................3 2. GENERAL INFORMATION.......................................................................................................4 2.1 Product Information................................................................................................................4 2.2 Objective................................................................................................................................5 2.3 Test Standards and Results....................................................................................................5 2.4 Environmental Conditions.......................................................................................................5 3. TEST METHODOLOGY...........................................................................................................6 3.1 TEST FACILITY......................................................................................................................6 3.2 GENERAL TEST PROCEDURES..........................................................................................6 4 SETUP OF EQUIPMENT UNDER TEST...................................................................................7 4.1 SETUP CONFIGURATION OF EUT.......................................................................................7 4.2 SUPPORT EQUIPMENT........................................................................................................7 4.3 TEST EQUIPMENT LIST........................................................................................................8 5. 47 CFR Part 15 C Requirements..............................................................................................9 5.1 Radiated Emission.................................................................................................................9 5.1.1 Definition.............................................................................................................................9 5.1.2 Test Configuration..............................................................................................................10 5.1.3 Test Description..................................................................................................................11 5.1.4 Test Result..........................................................................................................................11 5.2 20dB Bandwidth...................................................................................................................15 5.2.1 Requirement......................................................................................................................15 5.2.2 Test Description.................................................................................................................15 5.2.3 Test Result.....................................................................................................................15 5.3 Transmission Cease Time....................................................................................................16 5.3.1 Requirement......................................................................................................................16 5.3.2 Test Description.................................................................................................................16 5.3.3 Test Result.........................................................................................................................16 5.4 Antenna Requirement...........................................................................................................18 5.4.1 Definition...........................................................................................................................18 5.4.2 Evaluation Criteria.............................................................................................................18 5.4.3 Evaluation Results.............................................................................................................18 APPENDIX 1..............................................................................................................................19 PHOTOGRAPHS OF TEST SETUP...........................................................................................19 FCC ID:WEC-1220 Report No.: MTE/EAH/D12111694 Page 3 of 21 1.VERIFICATION OF CONFORMITY Equipment Under Test: Mini Key Finder Brand Name: N/A Model Number: EM2516 FCC ID: WEC-1220 Fuzhou Emax Electronic Co., Ltd. Applicant: Building #12-#16, CangShan Industrial Area, JuYuanZhou JinShan District, FuZhou, China Fuzhou Emax Electronic Co., Ltd. Manufacturer: Building #12-#16, CangShan Industrial Area, JuYuanZhou JinShan District, FuZhou, China Technical Standards: 47 CFR Part 15 Subpart C File Number: MTE/EAH/D12111694 Date of test: Nov. 13, 2012 De…
Text truncated - open the document above for the full version.
Page 1 of 2 RE TEST Page 2 of 2 CONDUCTED TEST SETUP
| # | Rule Parts | Frequency Range | Power Output |
|---|---|---|---|
| 1 | 15C | 433.92 MHz - 433.92 MHz | - |

Professional weather station
Equipment Class
DTS - Digital Transmission System
Wireless Charging Pad
Equipment Class
DCD - Part 15 Low Power Transmitter Below 1705 kHzOutdoor Remote Sensor
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter
Outdoor Remote Sensor
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter
Bluetooth Smart Thermometer
Equipment Class
DTS - Digital Transmission System