WEC-1502Outdoor Remote Sensor

TX05 Manual Features: Wireless Outdoor Sensor: — Wall Mount or Table Stand — One Wireless temperature Sensor Included — 433.92MHz RF transmitting frequency — 60 meter transmission range in an open area } Battery: 2 x LR03 AAA Main Unit Appearance A1: Breathable gate A2: Hanging hole A3: battery compartment Operation: } Replace Wireless Outdoor Sensor battery compartment cover ,Open main unit battery compartment cover ,Insert 2 x AAA batteries observing polarity [ “+” and “–“ marks] } Wireless Outdoor Sensor after electrify, 31 seconds automatically transmit one signal，At the same time, the LED lights inside the product 1 times Installation: The remote sensor should be securely mounted onto a horizontal surface. Note: Transmissions between receiver and transmitter can reach up to 60m in open area. Open Area: there are no interfering obstacles such as buildings, trees, vehicles, high voltage lines, etc. FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

MET Laboratories TCB - Samples Agent Authorization Letter 2015-08-14 MET Laboratories, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern: We, the undersigned, hereby authorize Most Technology Service Co., Ltd. to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). This agreement expires one year from the current date. Sincerely, Name: Jianxin Shi Position: Manager Company Name: Fuzhou Emax Electronic Co., Ltd. Address: Building #12-#16, Cangshan Industrial Area, Juyuanzhou, Jinshan District, Fuzhou, Fuzhou E-Mail: [email protected]

MET Laboratories TCB - Samples Long Term Confidentiality Request Letter 2015-08-14 MET Laboratories, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: CONFIDENTIALITY REQUEST FOR (Outdoor Remote Sensor/ TX05) To Whom It May Concern: This letter serves as an official request for confidentiality under sections 0.457 and 0.459 of CFR 47. We have requested that the - e.g. TX05_Block diagram - e.g. TX05_SCH - e.g. TX05_Operation Description required to be submitted with this application be permanently withheld from public review. SPECIFY REASON FOR REQUEST (i.e. the above documents are company proprietary information that could never get into the possession of your competition). Please contact me if there is any information you may need. Sincerely, Name: Jianxin Shi Position: Manager Company Name: Fuzhou Emax Electronic Co., Ltd. Address: Building #12-#16, Cangshan Industrial Area, Juyuanzhou, Jinshan District, Fuzhou, Fuzhou E-Mail: [email protected]

FCC ID: WEC-1502 Model No.: TX05 FRONT VIEW OF SAMPLE BACK VIEW OF SAMPLE FCC ID: WEC-1502 Model No.: TX05 LEFT VIEW OF SAMPLE RIGHT VIEW OF SAMPLE FCC ID: WEC-1502 Model No.: TX05 TOP VIEW OF SAMPLE BOTTOM VIEW OF SAMPLE FCC ID: WEC-1502 Model No.: TX05 PHOTO OF THE ENTIRE SAMPLE

23mm 24mm

FCC ID: WEC-1502 Model No.: TX05 INTERNAL PHOTO OF SAMPLE – 1 INTERNAL PHOTO OF SAMPLE – 2 FCC ID: WEC-1502 Model No.: TX05 INTERNAL PHOTO OF SAMPLE – 3

FCC 47 CFR PART 15 SUBPART C TEST REPORT For Applicant : FUZHOU EMAX ELECTRONIC CO., LTD Address : Building #12-#16, CangShan Industrial Area, JuYuanZhou JinShan District, FuZhou, China. Product Name : Outdoor Remote Sensor Model Name : TX05 Brand Name : TAYLOR FCC ID : WEC-1502 Report No. : MTE/DYY/A15080987 Date of Issue : Aug. 10, 2015 Issued by :Most Technology Service Co., Ltd. Address : No.5, Langshan 2nd Road, North District, Hi-tech Industrial Park, Nanshan, Shenzhen, Guangdong, China Tel : 86-755-86026850 Fax : 86-755-26013350 The report consists 22 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by MOST. The test results in the report only apply to the tested sample. The test report shall be invalid without all the signatures of testing engineers, reviewer and approver. FCC ID: WEC-1502 Report No.: MTE/DYY/A15080987 Page 2 of 22 TABLE OF CONTENTS 1．VERIFICATION OF CONFORMITY ........................................................................................ 3 2. GENERAL INFORMATION....................................................................................................... 4 2.1 Product Information ................................................................................................................ 4 2.2 Objective ................................................................................................................................ 5 2.3 Test Standards and Results .................................................................................................... 5 2.4 Environmental Conditions....................................................................................................... 5 3. TEST METHODOLOGY ........................................................................................................... 6 3.1 TEST FACILITY...................................................................................................................... 6 3.2 GENERAL TEST PROCEDURES .......................................................................................... 6 4 SETUP OF EQUIPMENT UNDER TEST .................................................................................. 8 4.1 SETUP CONFIGURATION OF EUT....................................................................................... 8 4.2 SUPPORT EQUIPMENT ........................................................................................................ 8 4.3 TEST EQUIPMENT LIST........................................................................................................9 5. 47 CFR Part 15 C Requirements............................................................................................ 10 5.1 DUTY CYCLE....................................................................................................................... 10 5.1.1 LIMIT ................................................................................................................................. 10 5.1.2Test Configuration .............................................................................................................. 10 5.1.3TEST PROCEDURE .......................................................................................................... 10 5.2.1 Definition ........................................................................................................................... 13 5.2.2 Test Configuration.............................................................................................................. 14 5.2.3 Test Description ................................................................................................................. 15 5.2.4 Test Result......................................................................................................................... 15 5.3 20dB Bandwidth ................................................................................................................... 18 5.3.1 Requirement...................................................................................................................... 18 5.3.2 Test Description ................................................................................................................. 18 5.2.3 Test Result .....................................................................................................................18 5.4 Transmission Cease Time ....................................................................................................19 5.4.1 Requirement...................................................................................................................... 19 5.4.2 Test Description ................................................................................................................. 19 5.4.3 Test Result......................................................................................................................... 19 5.5 Antenna Requirement........................................................................................................... 21 5.5.1 Definition ........................................................................................................................... 21 5.5.2 Evaluation Criteria ............................................................................................................. 21 5.5.3 Evaluation Results............................................................................................................. 21 APPENDIX 1 .............................................................................................................................. 22 PHOTOGRAPHS OF TEST SETUP........................................................................................... 22 FCC ID: WEC-1502 Report No.: MTE/DYY/A15080987 Page 3 of 21 1．VERIFICATION OF CONFO…

Text truncated - open the document above for the full version.

FCC ID: WEC-1502 Model No.: TX05 CONDUCTED EMISSION TEST SETUP RE TEST SETUP FCC ID: WEC-1502 Model No.: TX05 RE TEST SETUP