WONSA24103000SA TAG 2.4 GHZ

Precyse Technologies, Inc. Date: 22 May 2012 Page 1 of 10 Precyse Technologies 100 Ashford Center North Suite 360 Atlanta, GA 30338 Document No. 20110907-1 Revision 1.1 SA tag SA24/103000 User Manual Release Date: 07/09/2011 Prepared by: Lior Bilia Distribution (Check all appropriate): Precyse Only Project Team Only Customer and Supplier Precyse Technologies Date: 22 May 2012 Page 2 of 10 Precyse Technologies 100 Ashford Center North Suite 360 Atlanta, GA 30338 Revision Record Rev. Effective Date Description 1.0 7/9/2011 1 st release 1.1 22/05/2012 Removed block diagram 1.2 Replaced part number to SA24103000 Reference documents # Doc # Description 1 Precyse Technologies Date: 22 May 2012 Page 3 of 10 Precyse Technologies 100 Ashford Center North Suite 360 Atlanta, GA 30338 TABLE OF CONTENTS Section/Title Page Abstract ................................................................................................................. 4 Regulatory Information/disclaimers ....................................................................... 5 Product description ............................................................................................... 7 SA tag: ............................................................................................................... 7 Technical Data Sheet – SA Tag 2.4 ...................................................................... 7 Compatibility: ............................................................................................... 7 Performance: ................................................................................................ 7 Communication: .......................................................................................... 7 Electrical: ....................................................................................................... 7 Environmental: ............................................................................................ 7 Schematics ........................................................................................................... 8 System test configuration ...................................................................................... 8 SAT .................................................................................................................... 8 Theory of operation ............................................................................................... 8 iLocate system block diagram ............................................................................... 9 Unit definitions: ................................................................................................... 10 Precyse Technologies Date: 22 May 2012 Page 4 of 10 Precyse Technologies 100 Ashford Center North Suite 360 Atlanta, GA 30338 Abstract This document describes the Precyse tag model# SA24/103000 hardware: 1. Micro tag, Precyse part # SA24/103000, referred to as the SA tag. 2. PBC beacon, Precyse part # BC24/403000, referred to as the PBC. 3. PBS base station, Precyse part #BS24/103000, referred to as the PBS. Precyse Technologies Date: 22 May 2012 Page 5 of 10 Precyse Technologies 100 Ashford Center North Suite 360 Atlanta, GA 30338 Regulatory Information/disclaimers Installation and use of this Wireless Radio device must be in strict accordance with the instructions included in the user documentation provided with the product. Any changes or modifications made to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment. The Manufacturer is not responsible for any radio or television interference caused by unauthorized modification of this device, of the substitution or attachment. Manufacturer and its authorized resellers or distributors will assume no liability for any damage or violation of government regulations arising from failing to comply with these guidelines. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Instructions concerning human exposure to radio frequency electromagnetic fields: To comply with FCC Section 1.307 (b) (1) for human exposure to radio frequency electromagnetic fields, implement the following instruction: A distance of at least 20cm. between the equipment and all persons should be maintained during the operation of the equipment. The minimum distance will be determined after testing has been completed. This document is confidential and proprietary. No part of this document may be reproduced, stored, or transmitted in any form or by any means without prior written permission from Precyse technologies Inc. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation." Precyse Technologies Date: 22 May 2012 Page 6 of 10 Precyse Technologies 100 Ashford Center North Suite 360 Atlanta, GA 30338 The FCC Wants You to Know This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause ha…

Text truncated - open the document above for the full version.

Ha’amal 11, Park Afek Rosh Ha’ayin Israel 48092 To: Timco Engineering Inc. To Whom It May Concern We hereby authorize Mr. Shaike Raz of I.T.L. (Product Testing) Ltd (ITL) to act on our behalf regarding the FCC ID Certification Process for the following application: iLocate SA tag Model SA24103000 FCC ID: WONSA24103000 Thank you, Lior Bilia Hardware engineer Precyse Technologies Tel: 972-3-9227093 Mobile: 972-54-2467600 Fax: 972-3-9227515

Precyse Technologies 100 Ashford Center North Suite 360 Atlanta, GA 30338 To: Timco Engineering Inc. To Whom It May Concern We hereby authorize Mr. Shaike Raz of I.T.L. (Product Testing) Ltd (ITL) to sign FORM 731 on our behalf for the following application: FCC ID: WONSA24103000 Thank you, Lior Bilia HW engineer Precyse technologies LTD Tel: 972-3-9227093 Mobile: 972-54-2467600 Fax: 972-3-9227515 HW engineer Precyse technologies LTD Tel: 972-3-9227093 Mobile: 972-54-2467600 Fax: 972-3-9227515

1 www.PrecyseTech.com Precyse Technologies 100 Ashford Center North Suite 360 Atlanta, GA 30338 Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of FCC ID: WONSA24103000. Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, we hereby request confidential treatment of information accompanying this application as outlined below: CONF APPENDIX SA24103000 BlkDia.pdf CONF APPENDIX SA24103000 schem.pdf CONF APPENDIX SA24103000 Partlist.pdf The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Lior Bilia Hardware engineer

Ha’amal 11 Rosh Ha’ayin Israel 48092 +972-3-9227093 attn: Reviewing Engineer Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 To Whom It May Concern: The SA24103000 FCC ID: WONSA24103000 and label is so small that it cannot include the statement specified in FCC Part 15 Sub-part A, Section 15.19 (a) (3) “This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation." Due to this reason, we are using the provisions of Part 15 Sub-part A, Section 15.19 (a) (5) and this testament appears in a prominent location in the user manual. Please contact me if there is any information you may need. Sincerely, Lior Bilia HW engineer Precyse Technologies Inc Tel: 972-3-9227093 Mobile: 972-54-2467600 Fax: 972-3-9227515

The SAT method of communication is synchronized event based reporting, the SAT spends most of its time in low power sleep mode. When an event happens, the SAT sends a report to the base station. In order to avoid packet collisions and associated detection methods, the system uses a synchronous protocol, that is, An SAT can transmit data only after receiving a synchronization signal from the base station.

Precyse Technologies 100 Ashford Center North Suite 360 Atlanta, GA 30338 attn: Reviewing Engineer Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 To Whom It May Concern: The SA24/103000 FCC ID: WONSA24103000 does not require any Tuning procedures in order to function. The device operate within standard IEEE 802.15.4 at the 2.4GHz band (2410MHz to 2475MHz). There are no trimmers, variable capacitors or any other such components within the unit. Please contact me if there is any information you may need. Sincerely, Lior Bilia HW engineer Precyse Technologies Inc Tel: 972-3- 9227093 Mobile: 972-54-2467600 Fax: 972-3- 9227515

Test Report E112221.01 Precyse Technologies Inc. Page 1 of 48 FCC ACC M Ver 1.1 05Mayl 2000 DATE: 28 May 2012 I.T.L. (PRODUCT TESTING) LTD. FCC Radio Test Report for Precyse Technologies Inc. Equipment under test: SA Tag SA24/103000 Written by: _____________________________ D. Shidlowsky, Documentation Approved by: _____________________________ I. Siboni, Test Engineer Approved by: _____________________________ I. Raz, EMC Laboratory Manager This report must not be reproduced, except in full, without the written permission of I.T.L. (Product Testing) Ltd. This report relates only to items tested. Test Report E112221.01 Precyse Technologies Inc. Page 2 of 48 FCC ACC M Ver 1.1 05Mayl 2000 Measurement/Technical Report for Precyse Technologies Inc. SA Tag SA24/103000 FCC ID: WONSA24103000 This report concerns: Original Grant: X Class I Change: Class II Change: Equipment type: Digital Transmission System Limits used: 47CFR15 Section 15.247 Measurement procedure used is KDB 558074 D01 18 January 2012. Application for Certification Applicant for this device: prepared by: (different from "prepared by") Ishaishou Raz Lior Bilia ITL (Product Testing) Ltd. Precyse Technologies Ltd. Kfar Bin Nun 94 Em Hamoshavot St. D.N. Shimshon 99780 Petach Tikva 49527 Israel Israel e-mail [email protected] Tel: +972-3- 922-7093 Fax: +972-3- 922-7515 e-mail: [email protected] Test Report E112221.01 Precyse Technologies Inc. Page 3 of 48 FCC ACC M Ver 1.1 05Mayl 2000 TABLE OF CONTENTS 1. GENERAL INFORMATION ------------------------------------------------------------------------------- 5 1.1 Administrative Information ................................................................................. 5 1.2 List of Accreditations ......................................................................................... 6 1.3 Product Description ........................................................................................... 7 1.4 Test Methodology .............................................................................................. 7 1.5 Test Facility ....................................................................................................... 7 1.6 Measurement Uncertainty ................................................................................. 7 2. SYSTEM TEST CONFIGURATION --------------------------------------------------------------------- 8 2.1 Justification ........................................................................................................ 8 2.2 EUT Exercise Software ..................................................................................... 8 2.3 Special Accessories .......................................................................................... 8 2.4 Equipment Modifications ................................................................................... 8 2.5 Configuration of Tested System ........................................................................ 8 3. TEST SETUP PHOTOGRAPH --------------------------------------------------------------------------- 9 4. 6DB MINIMUM BANDWIDTH --------------------------------------------------------------------------- 10 4.1 Test Specification ............................................................................................ 10 4.2 Test procedure ................................................................................................ 10 4.3 Test Results..................................................................................................... 10 4.4 6dB Minimum Bandwidth Test Equipment Used ............................................. 13 5. RADIATED MAXIMUM POWER OUTPUT ----------------------------------------------------------- 14 5.1 Test Specification ............................................................................................ 14 5.2 Test procedure ................................................................................................ 14 5.3 Test Results..................................................................................................... 15 5.4 Radiated Maximum Power Output Test Equipment Used. .............................. 17 6. BAND EDGE ------------------------------------------------------------------------------------------------- 18 6.1 Test Specification ............................................................................................ 18 6.2 Test procedure ................................................................................................ 18 6.3 Test Results..................................................................................................... 18 6.4 Band Edge Test Equipment Used. .................................................................. 20 7. SPURIOUS RADIATED EMISSION, 9 KHZ – 30 MHZ ------------------------------------------- 21 7.1 Test Specification ............................................................................................ 21 7.2 Test Procedure ................................................................................................ 21 7.3 Test Results..................................................................................................... 21 7.4 Spurious Radiated Emission, 9 kHz – 30 MHz Test Equipment Used ............ 22 7.5 Field Strength Calculation ............................................................................... 22 8. SPURIOUS RADIATED EMISSION 30 – 25000 MHZ --------------------------------------------- 23 8.1 Test Specification ............................................................................................ 23 8.2 Test Procedure ................................................................................................ 23 8.3 Test Data ......................................................................................................... 24 8.4 Spurious Radiated Emission 30 MHz – 25 GHz, Test Equipment Used ......... 31 8.5 Field Strength Calculation 30 – 1000 MHz ...........…

Text truncated - open the document above for the full version.