XPYLISAU2303.75G HSPA Wireless Module

LISA-U series 3.75G HSPA / HSPA+ Wireless Modules System Integration Manual Abstract This document describes the features and the system integration of LISA-U1 series HSPA and LISA-U2 series HSPA+ wireless modules. These modules are complete and cost efficient 3.75G solutions offering up to six-band HSDPA/HSUPA and quad-band GSM/EGPRS voice and/or data transmission technology in a compact form factor. www.u-blox.com locate, communicate, accelerate LISA-U series - System Integration Manual 3G.G2-HW-10002-A3 Page 2 of 160 Document Information Title LISA-U series Subtitle 3.75G HSPA / HSPA+ Wireless Modules Document type System Integration Manual Document number 3G.G2-HW-10002-A3 Document status Preliminary Document status information Objective Specification This document contains target values. Revised and supplementary data will be published later. Advance Information This document contains data based on early testing. Revised and supplementary data will be published later. Preliminary This document contains data from product verification. Revised and supplementary data may be published later. Released This document contains the final product specification. This document applies to the following products: Name Type number Firmware version PCN / IN LISA-U100 LISA-U100-00S-00 10.72 3G.G2-SW-11000 LISA-U100-01S-00 11.40 n.a. LISA-U110 LISA-U110-00S-00 10.72 3G.G2-SW-11000 LISA-U110-01S-00 11.40 n.a. LISA-U120 LISA-U120-00S-00 10.72 3G.G2-SW-11000 LISA-U120-01S-00 11.40 n.a. LISA-U130 LISA-U130-00S-00 10.72 3G.G2-SW-11000 LISA-U130-01S-00 11.40 n.a. LISA-U130-01A-00 11.40 n.a. LISA-U200 LISA-U200-00S-00 21.21 n.a. LISA-U200-01S-00 TBD n.a. LISA-U230 LISA-U230-01S-00 TBD n.a. LISA-U230-01A-00 TBD n.a. This document and the use of any information contained therein, is subject to the acceptance of the u-blox terms and conditions. They can be downloaded from www.u-blox.com. u-blox makes no warranties based on the accuracy or completeness of the contents of this document and reserves the right to make changes to specifications and product descriptions at any time without notice. u-blox reserves all rights to this document and the information contained herein. Reproduction, use or disclosure to third parties without express permission is strictly prohibited. Copyright © 2012, u-blox AG. u-blox ® is a registered trademark of u-blox Holding AG in the EU and other countries. Trademark Notice Microsoft and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. All other registered trademarks or trademarks mentioned in this document are property of their respective owners. LISA-U series - System Integration Manual 3G.G2-HW-10002-A3 Preliminary Preface Page 3 of 160 Preface u-blox Technical Documentation As part of our commitment to customer support, u-blox maintains an extensive volume of technical documentation for our products. In addition to our product-specific technical data sheets, the following manuals are available to assist u-blox customers in product design and development. AT Commands Manual: This document provides the description of the supported AT commands by the LISA-U series modules to verify all implemented functionalities. System Integration Manual: This Manual provides hardware design instructions and information on how to set up production and final product tests. Application Note: document provides general design instructions and information that applies to all u-blox Wireless modules. See Section Related documents for a list of Application Notes related to your Wireless Module. How to use this Manual The LISA-U series System Integration Manual provides the necessary information to successfully design in and configure these u-blox wireless modules. This manual has a modular structure. It is not necessary to read it from the beginning to the end. The following symbols are used to highlight important information within the manual: An index finger points out key information pertaining to module integration and performance. A warning symbol indicates actions that could negatively impact or damage the module. Questions If you have any questions about u-blox Wireless Integration, please:  Read this manual carefully.  Contact our information service on the homepage http://www.u-blox.com  Read the questions and answers on our FAQ database on the homepage http://www.u-blox.com Technical Support Worldwide Web Our website (www.u-blox.com) is a rich pool of information. Product information, technical documents and helpful FAQ can be accessed 24h a day. By E-mail Contact the nearest of the Technical Support offices by email. Use our service pool email addresses rather than any personal email address of our staff. This makes sure that your request is processed as soon as possible. You will find the contact details at the end of the document. Helpful Information when Contacting Technical Support When contacting Technical Support please have the following information ready:  Module type (e.g. LISA-U100) and firmware version  Module configuration  Clear description of your question or the problem  A short description of the application  Your complete contact details LISA-U series - System Integration Manual 3G.G2-HW-10002-A3 Preliminary Contents Page 4 of 160 Contents Preface ................................................................................................................................ 3 Contents .............................................................................................................................. 4 1 System description ....................................................................................................... 7 1.1 Overview .............................................................................................................................................. 7 1.2 Architecture ........................................................................................…

Text truncated - open the document above for the full version.

Click to buy NOW! P D F - X C h a n g e V i e w e r w w w . d o c u - t r a c k . c o m Click to buy NOW! P D F - X C h a n g e V i e w e r w w w . d o c u - t r a c k . c o m Click to buy NOW! P D F - X C h a n g e V i e w e r w w w . d o c u - t r a c k . c o m Click to buy NOW! P D F - X C h a n g e V i e w e r w w w . d o c u - t r a c k . c o m

LISA-U230 Labeling u-blox Italia Roberto Pagano, tm Department April, 3 rd 2012 Confidential locate, communicate, accelerate Slide 2 © u-blox Italia S.p.A., April 3rd, 2012 IP07.TQ.PP.000001 LISA-U230 labeling •The label is placed on the shield which is soldered to the PCB •The shield is not removable from the PCB •FCC ID: XPYLISAU230, IC ID: 8595A-LISAU230 •Fields YY/MM represent Year (last two digits) and Calendar Week •Field PP represents the Panel Position Number LISA Top Side Model: LISA-U230 IMEI: XXXXXXXXXXXXXXX ® PP 0682 YY/WW 820200.XXXX.000 FCC ID: XPYLISAU230 IC ID: 8595A-LISAU230 Made in Austria xxS-00 Thank you! locate, communicate, accelerate

Page 1 of 57 The test results relate only to the individual items which have been tested. This report shall not be reproduced in parts without the written approval of the testing laboratory © Copyright: All rights reserved by CETECOM Laboratory Accreditation and Listings Reg. No.: 736496 MRA US-EU 0003 Industry Canada Reg. No.: 3462D-1 Reg. No.: 3462D-2 Reg. No.: 3462D-3 Voluntary Controls for Electromagnetic Emissions Reg. No.: R-2665, R-2666 C-2914, T-1967, G-301 accredited according to DIN EN ISO/IEC 17025 CETECOM GmbH Laboratory Radio Communications & Electromagnetic Compatibility Im Teelbruch 116 • 45219 Essen • Germany Registered in Essen, Germany, Reg. No.: HRB Essen 8984 Tel.: + 49 (0) 20 54 / 95 19-954 • Fax: + 49 (0) 20 54 / 95 19-964 E-mail: [email protected] • Internet: www.cetecom.com TEST REPORT No.: 6-0143-12-2-3b for RF-Module LISA-U230 FCC-ID: XPYLISAU230 IC-ID: 8595A-LISAU230 According to: FCC Regulations Part 15B IC-Regulations RSS-132, RSS-133, RSS-139 & RSS-Gen u-blox AG Test Report 6-0143-12-2-3b, Page 2 of 57 TR6-0143-12-2-3b.docx Table of contents 1. SUMMARY OF TEST RESULTS...................................................................................................................... 3 1.1. RX Mode TESTS OVERVIEW FCC (USA) and RSS (CANADA) Standards .............................................. 3 2. ADMINISTRATIVE DATA ............................................................................................................................... 4 2.1. Identification of the testing laboratory ............................................................................................................. 4 2.2. Test location .................................................................................................................................................... 4 2.3. Organizational items ........................................................................................................................................ 4 2.4. Applicant‟s details ........................................................................................................................................... 4 2.5. Manufacturer‟s details ..................................................................................................................................... 4 3. EQUIPMENT UNDER TEST (EUT) ................................................................................................................. 5 3.1. Additional declaration and description of main EUT ...................................................................................... 5 3.2. EUT: Type, S/N etc. and short descriptions used in this test report ................................................................ 6 3.3. Auxiliary Equipment (AE): Type, S/N etc. and short descriptions .................................................................. 6 3.4. EUT set-ups ..................................................................................................................................................... 7 3.5. EUT operating modes ...................................................................................................................................... 7 3.6. Parameter Settings on mobile phone and base station CMU200 ..................................................................... 8 4. DESCRIPTION OF TEST SET-UP’S ................................................................................................................ 10 4.1. Mode test set-up for conducted measurements ................................................................................................ 10 4.2. Test set-up for radiated measurements ............................................................................................................ 11 5. MEASUREMENTS AND DIAGRAMS ............................................................................................................. 12 5.1. Conducted emissions on AC-Power lines ........................................................................................................ 12 5.2. Radiated field strength emissions, 30 MHz - 1 GHz ....................................................................................... 20 5.3. Radiated emissions, below 1GHz .................................................................................................................... 34 5.4. Conducted emissions on antenna port (RX-Mode) .......................................................................................... 41 5.5. Measurement uncertainties .............................................................................................................................. 53 6. ACCREDITATION DETAILS OF CETECOM’S LABORATORIES AND TEST SITES ......................... 53 7. INSTRUMENTS AND ANCILLARY ................................................................................................................ 54 7.1. Used equipment “CTC” ................................................................................................................................... 54 Table of annex Total pages ANNEX 1: PHOTOGRAPHS OF MEASUREMENT SET UP‟S 4 Test Report 6-0143-12-2-3b, Page 4 of 57 TR6-0143-12-2-3b.docx 2. Administrative Data 2.1. Identification of the testing laboratory Company name: CETECOM GmbH Address: Im Teelbruch 116 45219 Essen - Kettwig Germany Responsible for testing laboratory: Dipl.-Ing. W. Richter Deputy: Dipl.-Ing. J. Schmitt Laboratory accreditations/Listings: DAkkS-Registration No. D-PL-12047-01-01 FCC-Registration No.: 736496, MRA US-EU 0003 IC-Registration No. 3462D-1, 3462D-2, 3462D-3 VCCI Reg. No. R-2665, R-2666, C-2914, T-1967, G-301 2.2. Test location 2.2.1. Test laboratory “CTC” Company name: see chapter 2.1. Identification of the testing laboratory 2.3. Organizational items Order No.: E600143002 Responsible for test report and project leader: Dipl.-Ing. B. Taslica Receipt of EUT: 2012-03-19 Date(s) of test: 2012-03…

Text truncated - open the document above for the full version.

Page 1 of 4 The test results relate only to the individual items which have been tested. This report shall not be reproduced in parts without the written approval of the testing laboratory © Copyright: All rights reserved by CETECOM Laboratory Accreditation and Listings D-PL-12047-01-01 Reg. No.: 736496 MRA US-EU 0003 Industry Canada Reg. No.: 3462D-1 3462D-2 3462D-3 Reg. No.: R-2665, R-2666 C-2914, T-1967 G-301 accredited according to DIN EN ISO/IEC 17025 CETECOM GmbH Laboratory Radio Communications & Electromagnetic Compatibility Im Teelbruch 116 • 45219 Essen • Germany Registered in Essen, Germany, Reg. No.: HRB Essen 8984 Tel.: + 49 (0) 20 54 / 95 19-954 • Fax: + 49 (0) 20 54 / 95 19-964 E-mail: [email protected] • Internet: www.cetecom.com Annex 1: Photographs of Measurement Setup’s to TEST REPORT No.: 6-0143-12-2-3b for u-blox AG RF Data-Module LISA-U230 FCC-ID: XPYLISAU230 IC-ID: 8595A-LISAU230 Annex 1 to Test Report 6-0143-12-2-3b, Page 2 of 4 TR6-0143-12-2-3b_A1.docx Table of contents 1. PHOTOGRAPHS OF MEASUREMENT SETUP’S ........................................................................................ 3 Annex 1 to Test Report 6-0143-12-2-3b, Page 3 of 4 TR6-0143-12-2-3b_A1.docx 1. Photographs of Measurement Setup’s Radiated field strength measurements in the FAR (Fully-Anechoic-Chamber), test setup 1 Emissions AC Power lines measurements, test setup 1 Annex 1 to Test Report 6-0143-12-2-3b, Page 4 of 4 TR6-0143-12-2-3b_A1.docx Conducted RF-measurements at the Radio laboratory 1 (in the climatic chamber), test setup 2 The project number has the same test setup as with extension ‘3b’. Electrical field strength measurements in the SAR (Semi-Anechoic-Chamber), test setup 1